Properties of signal-sequence peptides at an air-water interface.
Ontology highlight
ABSTRACT:
SUBMITTER: Fidelio GD
PROVIDER: S-EPMC1147130 | biostudies-other | 1986 Aug
REPOSITORIES: biostudies-other
Similar Datasets
Project description:The fabrication of inorganic nanomaterials is important for a wide range of disciplines. While many purely inorganic synthetic routes have enabled a manifold of nanostructures under well-controlled conditions, organisms have the ability to synthesize structures under ambient conditions. For example, magnetotactic bacteria, can synthesize tiny 'compass needles' of magnetite (Fe3O4). Here, we demonstrate the bio-inspired synthesis of extended, self-supporting, nanometer-thin sheets of iron oxide at the water-air interface through self-assembly using small histidine-rich peptides.
| S-EPMC9038006 | biostudies-literature
Project description:Differences in the extent of protonation of functional groups lying on either side of water-hydrophobe interfaces are deemed essential to enzymatic catalysis, molecular recognition, bioenergetic transduction, and atmospheric aerosol-gas exchanges. The sign and range of such differences, however, remain conjectural. Herein we report experiments showing that gaseous carboxylic acids RCOOH(g) begin to deprotonate on the surface of water significantly more acidic than that supporting the dissociation of dissolved acids RCOOH(aq). Thermodynamic analysis indicates that > 6 H(2)O molecules must participate in the deprotonation of RCOOH(g) on water, but quantum mechanical calculations on a model air-water interface predict that such event is hindered by a significant kinetic barrier unless OH(-) ions are present therein. Thus, by detecting RCOO(-) we demonstrate the presence of OH(-) on the aerial side of on pH > 2 water exposed to RCOOH(g). Furthermore, because in similar experiments the base (Me)(3)N(g) is protonated only on pH < 4 water, we infer that the outer surface of water is Brønsted neutral at pH ?3 (rather than at pH 7 as bulk water), a value that matches the isoelectric point of bubbles and oil droplets in independent electrophoretic experiments. The OH(-) densities sensed by RCOOH(g) on the aerial surface of water, however, are considerably smaller than those at the (>1 nm) deeper shear planes probed in electrophoresis, thereby implying the existence of OH(-) gradients in the interfacial region. This fact could account for the weak OH(-) signals detected by surface-specific spectroscopies.
| S-EPMC3503180 | biostudies-literature
Project description:In typical aqueous systems, including naturally occurring sweet and salt water and tap water, multiple ion species are co-solvated. At the water-air interface, these ions are known to affect the chemical reactivity, aerosol formation, climate, and water odor. Yet, the composition of ions at the water interface has remained enigmatic. Here, using surface-specific heterodyne-detected sum-frequency generation spectroscopy, we quantify the relative surface activity of two co-solvated ions in solution. We find that more hydrophobic ions are speciated to the interface due to the hydrophilic ions. Quantitative analysis shows that the interfacial hydrophobic ion population increases with decreasing interfacial hydrophilic ion population at the interface. Simulations show that the solvation energy difference between the ions and the intrinsic surface propensity of ions determine the extent of an ion's speciation by other ions. This mechanism provides a unified view of the speciation of monatomic and polyatomic ions at electrolyte solution interfaces.
| S-EPMC10197129 | biostudies-literature
Project description:The aggregation of proteins or peptides into amyloid fibrils is a hallmark of protein misfolding diseases (e.g., Alzheimer's disease) and is under intense investigation. Many of the experiments performed are in vitro in nature and the samples under study are ordinarily exposed to diverse interfaces, e.g., the container wall and air. This naturally raises the question of how important interfacial effects are to amyloidogenesis. Indeed, it has already been recognized that many amyloid-forming peptides are surface-active. Moreover, it has recently been demonstrated that the presence of a hydrophobic interface can promote amyloid fibrillization, although the underlying mechanism is still unclear. Here, we combine theory, surface property measurements, and amyloid fibrillogenesis assays on islet amyloid polypeptide and amyloid-? peptide to demonstrate why, at experimentally relevant concentrations, the surface activity of the amyloid-forming peptides leads to enriched fibrillization at an air-water interface. Our findings indicate that the key that links these two seemingly different phenomena is the surface-active nature of the amyloid-forming species, which renders the surface concentration much higher than the corresponding critical fibrillar concentration. This subsequently leads to a substantial increase in fibrillization.
| S-EPMC3296044 | biostudies-other
Project description:Assembly by amyloid-beta (Aβ) peptides is vital for various neurodegenerative diseases. The process can be accelerated by hydrophobic interfaces such as the cell membrane interface and the air-water interface. Elucidating the assembly mechanism for Aβ peptides at hydrophobic interface requires knowledge of the microscopic structure of interfacial peptides. Here we combine scanning force microscopy, sum-frequency generation spectroscopy, and metadynamics simulations to probe the structure of the central fragment of Aβ peptides at the air-water interface. We find that the structure of interfacial peptides depends on pH: at neutral pH, the peptides adopt a less folded, bending motif by forming intra-hydrogen bonds; at acidic pH, the peptides refold into extended β-strand fibril conformation, which further promotes their macroscopic assembly. The conformational transition of interfacial peptides is driven by the reduced hydrogen bonds, both with water and within peptides, resulting from the protonation of acidic glutamic acid side chains.
| S-EPMC9340808 | biostudies-literature
Project description:The importance of water-air interfaces (WAI) on microorganism activities has been recognized by many researchers. In this paper, we report a novel phenomenon: the entrapment of ciliates Tetrahymena at the WAI. We first characterized the behavior of cells at the interface and showed that the cells' swimming velocity was considerably reduced at the WAI. To verify the possible causes of the entrapment, we investigated the effects of positive chemotaxis for oxygen, negative geotaxis and surface properties. Even though the taxes were still effective, the entrapment phenomenon was not dependent on the physiological conditions, but was instead affected by the physical properties at the interface. This knowledge is useful for a better understanding of the physiology of microorganisms at interfaces in nature and in industry.
| S-EPMC3794946 | biostudies-literature
Project description:We report on a self-propelled gel using ionic liquid as a new type of self-propellant that generates a powerful and durable motion at an air-water interface. The gel is composed of 1-ethyl-3-methylimidazolium-bis(trifluoromethylsulfonyl)imide (EMIM-TFSI) and poly(vinylidene fluoride-co-hexafluoropropylene) (P(VDF-co-HFP)). A long rectangular ion gel piece placed on the interface shows rapid rotation motion with maximum frequency close to 10?Hz, corresponding to the velocity over 300 mms-1 at an outmost end of the piece. The rotation continues for ca. 102?s, followed by a reciprocating motion (<~103?s) and a nonlinear motion in long-time observations (>~103?s). The behaviours can be explained by the model considering elution of EMIM-TFSI to the air-water interface, rapid dissolution into water, and slow diffusion in an inhomogeneous polymer gel network. Because the self-propellants are promptly removed from the interface by dissolution, durable self-propelled motions are observed also at limited interface areas close in size to the gel pieces. A variety of motions are induced in such systems where the degree of freedom in motion is limited. As the ion gel possesses formability and processability, it is also advantageous for practical applications. We demonstrate that the gel does work as an engine.
| S-EPMC5571170 | biostudies-literature
Project description:Although the role of methanesulfonic acid (HMSA) in particle formation in the gas phase has been extensively studied, the details of the HMSA-induced ion pair particle formation at the air-water interface are yet to be examined. In this work, we have performed Born-Oppenheimer molecular dynamics simulations and density functional theory calculations to investigate the ion pair particle formation from HMSA and (R1)(R2)NH (for NH3, R1 = R2 = H; for CH3NH2, R1 = H and R2 = CH3; and for CH3NH2, R1 = R2 = CH3) at the air-water interface. The results show that, at the air-water interface, HMSA deprotonates within a few picoseconds and results in the formation of methanesulfonate ion (MSA-)??H3O+ ion pair. However, this ion pair decomposes immediately, explaining why HMSA and water alone are not sufficient for forming stable particles in atmosphere. Interestingly, the particle formation from the gas-phase hydrogen-bonded complexes of HMSA with (R1)(R2)NH on the water droplet is observed with a few femtoseconds, suggesting a mechanism for the gas to particle conversion in aqueous environments. The reaction involves a direct proton transfer between HMSA and (R1)(R2)NH, and the resulting MSA-??(R1)(R2)NH2+ complex is bound by one to four interfacial water molecules. The mechanistic insights gained from this study may serve as useful leads for understanding about the ion pair particle formation from other precursors in forested and polluted urban environments.
| S-EPMC5703292 | biostudies-literature
Project description:Quasi-two-dimensional (2D) nanolayers, such as graphene oxide or clay layers, adhere to gas-liquid or liquid-liquid interfaces. Particularly, clays are of wide general interest in this context because of their extensive and crucial use as Pickering emulsion stabilizers, as well as for their ability to provide colloidosome capsules. So far, clays could only be localized at oil-water or air-saline-water interfaces in aggregated states, while our results now show that clay nanosheets without any modification can be located at air-deionized-water interfaces. The clay mineral used in the present work is synthetic fluorohectorite with a very high aspect ratio and superior quality in homogeneity and charge distribution compared to other clay minerals. This clay mineral is more suitable for achieving unmodified clay anchoring to fluid interfaces compared to other clay minerals used in previous works. In this context, we studied clay nanosheet organization at the air-water interface by combining different experimental methods: Langmuir-Blodgett trough studies, scanning electron microscopy (SEM) studies of film deposits, grazing-incidence X-ray off-specular scattering (GIXOS), and Brewster angle microscopy (BAM). Clay films formed at the air-water interface could be transferred to solid substrates by the Langmuir-Schaefer method. The BAM results indicate a dynamic equilibrium between clay sheets on the interface and in the subphase. Because of this dynamic equilibrium, the Langmuir monolayer surface pressure does not change significantly when pure clay sheets are spread on the liquid surface. However, also, GIXOS results confirm that there are clay nanosheets at the air-water interface. In addition, we find that clay sheets modified by a branched polymer are much more likely to be confined to the interface.
| S-EPMC8154875 | biostudies-literature
Project description:The adsorption of large, polarizable anions from aqueous solution on the air/water interface controls important atmospheric chemistry and is thought to resemble anion adsorption at hydrophobic interfaces generally. While the favourability of adsorption of such ions is clear, quantifying adsorption thermodynamics has proven challenging because it requires accurate description of the structure of the anion and its solvation shell at the interface. In principle anion polarizability offers a structural window, but to the best of our knowledge there has so far been no experimental technique that allowed its characterization with interfacial specificity. Here, we meet this challenge using interface-specific vibrational spectroscopy of Cl-O vibrations of the [Formula: see text] anion at the air/water interface and report that the interface breaks the symmetry of the anion, the anisotropy of [Formula: see text]'s polarizability tensor is more than two times larger than in bulk water and concentration dependent, and concentration-dependent polarizability changes are consistent with correlated changes in surface tension.
| S-EPMC5882839 | biostudies-other