Purification and properties of nitrogenase in ethylene glycol at sub-zero temperatures.
Ontology highlight
ABSTRACT:
SUBMITTER: Tsopanakis AD
PROVIDER: S-EPMC1161184 | biostudies-other | 1979 Aug
REPOSITORIES: biostudies-other
Similar Datasets
Project description:The CuO-La2O3/ZrO2 catalysts calcined at different temperatures from 500 to 800 °C were studied for the hydrogenation of oxalates to ethylene glycol (EG). Along with the increase of calcination temperatures, the BET surface area, pore volume, and Cu dispersion decreased, whereas the crystallite sizes of Cu species increased. Interestingly, the superior performance such as a 98% selectivity of EG in dimethyl oxalate hydrogenation or a 96.5% selectivity of EG in diethyl oxalate hydrogenation was obtained over the catalyst calcined at 700 °C. Essentially, the surface synergism between Cu species and monoclinic ZrO2 was enhanced by the higher calcination temperature, resulting in the remarkable surface adsorption and activation of H2. Besides, the increase of calcination temperature significantly reduced the surface acidity and basicity, which could effectively suppress the byproduct formation.
| S-EPMC7643250 | biostudies-literature
Project description:As one of the simplest polyols with chemical properties of alcohol, ethylene glycol is considered as a renewable energy source and a model fuel for pyrolysis oil. In this work, autoignition characteristics of ethylene glycol have been investigated behind reflected shock waves. Experiments were conducted at pressures of 2, 5, and 10 atm, equivalence ratios of 0.5, 1.0, and 2.0, and temperatures ranging from approximately 1200 to 1600 K. The fuel concentration was also varied. Results show that the ignition delay time increases with decreasing the pressure or fuel concentration. A strong positive dependence upon the equivalence ratio was found. A quantitative relationship has been yielded by the regression analysis of the experimental data. Simulations were carried out using chemical kinetic mechanisms available in the literature to assess the reliability of mechanism. Reaction pathway and sensitivity analysis confirmed the importance of H-abstraction reactions in ethylene glycol oxidation process. Finally, a comparison between ethylene glycol and ethanol ignition was conducted. Ethylene glycol ignites faster than ethanol because of the early accumulation of H and OH radicals in the oxidation of ethylene glycol.
| S-EPMC8928564 | biostudies-literature
Project description:In this work, graphene oxide (GO)/ethylene glycol (EG) membranes were designed by a vacuum filtration method for molecular separation and water purification. The composite membranes were characterized by scanning electron microscopy (SEM), field emission scanning electron microscopy (FESEM), Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), atomic force microscopy (AFM) and X-ray photoelectron spectroscopy (XPS). The interlayer spacing of GO membranes (0.825 nm) and GO/EG membranes (0.634 nm) are measured by X-ray diffraction (XRD). Using the vacuum filtration method, the membrane thickness can be controlled by selecting the volume of the solution from which the membrane is prepared, to achieve high water permeance and high rejection of Rhodamine B (RhB). The membrane performance was evaluated on a dead-end filtration device. The water permeance and rejection of RhB of the membranes are 103.35 L m-2 h-1 bar-1 and 94.56% (GO), 58.17 L m-2 h-1 bar-1 and 97.13% (GO/EG), respectively. The permeability of GO/EG membrane is about 40 × 10-6 L m-1 h-1 bar-1. Compared with the GO membrane, the GO/EG membrane has better separation performance because of its proper interlayer spacing. In this study, the highest rejection of RhB (99.92%) is achieved. The GO/EG membranes have potential applications in the fields of molecular separation and water purification.
| S-EPMC6418752 | biostudies-literature
Project description:The elastic modulus of the extracellular matrix is a dynamic property that changes during various biological processes, such as disease progression or wound healing. Most cell culture platforms, however, have traditionally exhibited static properties, making it necessary to replate cells to study the effects of different elastic moduli on cell phenotype. Recently, much progress has been made in the development of substrates with mechanisms for either increasing or decreasing stiffness in situ, but there are fewer examples of substrates that can both stiffen and soften, which may be important for simulating the effects of repeated ECM injury and resolution. In the work presented here, poly(ethylene glycol)-based hydrogels reversibly stiffen and soften with multiple light stimuli via photoisomerization of an azobenzene-containing cross-linker. Upon irradiation with cytocompatible doses of 365 nm light (10 mW/cm(2), 5 min), isomerization to the azobenzene cis configuration leads to a softening of the hydrogel up to 100-200 Pa (shear storage modulus, G'). This change in gel properties is maintained over a time scale of several hours due to the long half-life of the cis isomer. The initial modulus of the gel can be recovered upon irradiation with similar doses of visible light. With applications in mechanobiology in mind, cytocompatibility with a mechanoresponsive primary cell type is demonstrated. Porcine aortic valvular interstitial cells were encapsulated in the developed hydrogels and shown to exhibit high levels of survival, as well as a spread morphology. The developed hydrogels enable a route to the noninvasive control of substrate modulus independent of changes in the chemical composition or network connectivity, allowing for investigations of the effect of dynamic matrix stiffness on adhered cell behavior.
| S-EPMC4547937 | biostudies-literature
Project description:Self-assembled monolayers (SAMs) can be formed at the interface between solids and fluids, and are often used to modify the surface properties of the solid. One of the most widely employed SAM systems is exploiting thiol-gold chemistry, which, together with alkane-chain-based molecules, provides a reliable way of SAM formation to modify the surface properties of electrodes. Oligo ethylene-glycol (OEG) terminated alkanethiol monolayers have shown excellent antifouling properties and have been used extensively for the coating of biosensor electrodes to minimize nonspecific binding. Here, we report the investigation of the dielectric properties of COOH-capped OEG monolayers and demonstrate a strategy to improve the dielectric properties significantly by mixing the OEG SAM with small concentrations of 11-mercaptoundecanol (MUD). The monolayer properties and composition were characterized by means of impedance spectroscopy, water contact angle, ellipsometry and X-ray photoelectron spectroscopy. An equivalent circuit model is proposed to interpret the EIS data and to determine the conductivity of the monolayer. We find that for increasing MUD concentrations up to about 5% the resistivity of the SAM steadily increases, which together with a considerable decrease of the phase of the impedance, demonstrates significantly improved dielectric properties of the monolayer. Such monolayers will find widespread use in applications which depend critically on good dielectric properties such as capacitive biosensor.
| S-EPMC4065163 | biostudies-literature
Project description:In this investigation, a parametric study was performed using the transient cold-start model presented in our previous paper, in which the ice melting process and additional constitutive relations were newly included for transient cold-start simulations of polymer electrolyte fuel cells (PEFCs) from a sub-zero temperature (-20°C) to a normal operating temperature (80°C). The focus is placed on exploring the transient cold-start behavior of a PEFC for different porous properties of the catalyst layer (CL) and gas diffusion layer (GDL). This work elucidates the detailed effects of these properties on key cold-start phenomena such as ice freezing/melting and membrane hydration/dehydration processes. In particular, the simulation results highlight that designing a cathode CL with a high ionomer fraction helps to retard the rate of ice growth whereas a high ionomer fraction in the anode CL is not effective to mitigate the anode dry-out and membrane dehydration issues during PEFC cold-start.
| S-EPMC4340360 | biostudies-other
Project description:Graphical abstractThis paper found the correlation between molecular arrangement and self-assembly and inspired us to tune block compositions to achieve desired nanostructure and drug loading.Image 1
| S-EPMC7332608 | biostudies-literature
Project description:A pH-sensitive amphiphilic polymer based on poly(vinyl alcohol) (PVA), modified with poly(ethylene glycol) (PEG) and adamantane (Ad) pendant groups, has been synthesized and the self-assembly properties of this PEG-PVA-Ad construct investigated. PEG-PVA-Ad polymer forms micelles via self-assembly at concentrations as low as 26 mg L-1. These polymer micelles can be destroyed by low pH or the addition of ?-CD.
| S-EPMC6906925 | biostudies-literature
Project description:The surface structure and DNA hybridization performance of thiolated single-strand DNA (HS-ssDNA) covalently attached to a maleimide-ethylene glycol disulfide (MEG) monolayer on gold have been investigated. Monolayer immobilization chemistry and surface coverage of reactive ssDNA probes were studied by X-ray photoelectron spectroscopy and time-of-flight secondary ion mass spectrometry. Orientation of the ssDNA probes was determined by near-edge X-ray absorption fine structure (NEXAFS). Target DNA hybridization on the DNA-MEG probe surfaces was measured by surface plasmon resonance (SPR) to demonstrate the utility of these probe surfaces for detection of DNA targets from both purified target DNA samples and complex biological mixtures such as blood serum. Data from complementary techniques showed that immobilized ssDNA density is strongly dependent on the spotted bulk DNA concentration and buffer ionic strength. Variation of the immobilized ssDNA density had a profound influence on the DNA probe orientation at the surface and subsequent target hybridization efficiency. With increasing surface probe density, NEXAFS polarization dependence results (followed by monitoring the N 1s --> pi* transition) indicate that the immobilized ssDNA molecules reorient toward a more upright position on the MEG monolayer. SPR assays of DNA targets from buffer and serum showed that DNA hybridization efficiency increased with decreasing surface probe density. However, target detection in serum was better on the "high-density" probe surface than on the "high-efficiency" probe surface. The amounts of target detected for both ssDNA surfaces were several orders of magnitude poorer in serum than in purified DNA samples due to nonspecific serum protein adsorption onto the sensing surface.
| S-EPMC2518630 | biostudies-literature
Project description:The objective of this work was to create 3D hydrogel matrices with defined mechanical properties as well as tunable degradability for use in applications involving protein delivery and cell encapsulation. Therefore, we report the synthesis and characterization of a novel hydrolytically degradable poly(ethylene glycol) (PEG) hydrogel composed of PEG vinyl sulfone (PEG-VS) cross-linked with PEG-diester-dithiol. Unlike previously reported degradable PEG-based hydrogels, these materials are homogeneous in structure, fully hydrophilic, and have highly specific cross-linking chemistry. We characterized hydrogel degradation and associated trends in mechanical properties, that is, storage modulus (G'), swelling ratio (Q(M)), and mesh size (xi). Degradation time and the monitored mechanical properties of the hydrogel correlated with cross-linker molecular weight, cross-linker functionality, and total polymer density; these properties changed predictably as degradation proceeded (G' decreased, whereas Q(M) and xi increased) until the gels reached complete degradation. Balb/3T3 fibroblast adhesion and proliferation within the 3D hydrogel matrices were also verified. In sum, these unique properties indicate that the reported degradable PEG hydrogels are well poised for specific applications in protein and cell delivery to repair soft tissue.
| S-EPMC3050024 | biostudies-literature