Fractionation of microsomal membranes on the basis of their surface properties.
Ontology highlight
ABSTRACT:
SUBMITTER: Ohlsson R
PROVIDER: S-EPMC1185679 | biostudies-other | 1978 Apr
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Cell fractionations and other biological separations frequently require several steps. They could be much more effectively done by filtration, if isoporous membranes would be available with high pore density, and sharp pore size distribution in the micro- and nanoscale. We propose a combination of two scalable methods, photolithography and dry reactive ion etching, to fabricate a series of polyester membranes with isopores of size 0.7 to 50 μm and high pore density with a demonstrated total area of 38.5 cm2. The membranes have pore sizes in the micro- and submicro-range, and pore density 10-fold higher than track-etched analogues, which are the only commercially available isoporous polymeric films. Permeances of 220,000 L m-2 h-1bar-1 were measured with pore size 787 nm. The method does not require organic solvents and can be applied to many homopolymeric materials. The pore reduction from 2 to 0.7 μm was obtained by adding a step of chemical vapor deposition. The isoporous system was successfully demonstrated for the organelle fractionation of Arabidopsis homogenates and could be potentially extended to other biological fractionations.
| S-EPMC7145805 | biostudies-literature
Project description:1. Antiserum to purified mouse liver plasma membranes was prepared and the partially purified gamma-globulin antibody fraction was iodinated with (125)I. The reaction of the (125)I-labelled gamma-globulin antibody with isolated mouse liver plasma membranes was studied. 2. The gammaglobulin antibody bound specifically to mouse liver plasma membranes and there was little reaction with mouse liver intracellular membranes or with surface-membrane fractions from either rat liver or pig lymphocytes. 3. ;Light' and ;heavy' mouse liver plasma-membrane subfractions bound similar amounts of gamma-globulin antibody, and this is consistent with a surface origin for the light fraction. 5. Plasma membranes were fractionated by sequential extraction with 50mm-NaHCO(3)-Na(2)CO(3) buffer, pH10.2, containing 10mm-EDTA and aq. 33% (v/v) pyridine. The alkali-soluble and -insoluble fractions and the pyridine-soluble and -insoluble fractions all reacted with the antiserum, and the cross-reactivity among the various fractions and with the total plasma membranes was investigated. 5. The results are discussed in terms of the arrangement of the antigenic determinants within the membrane.
| S-EPMC1174324 | biostudies-other
Project description:Although membrane environment is known to boost drug metabolism by mammalian cytochrome?P450s, the factors that stabilize the structural folding and enhance protein function are unclear. In this study, we use peptide-based lipid nanodiscs to "trap" the lipid boundaries of microsomal cytochrome?P450 2B4. We report the first evidence that CYP2B4 is able to induce the formation of raft domains in a biomimetic compound of the endoplasmic reticulum. NMR experiments were used to identify and quantitatively determine the lipids present in nanodiscs. A combination of biophysical experiments and molecular dynamics simulations revealed a sphingomyelin binding region in CYP2B4. The protein-induced lipid raft formation increased the thermal stability of P450 and dramatically altered ligand binding kinetics of the hydrophilic ligand BHT. These results unveil membrane/protein dynamics that contribute to the delicate mechanism of redox catalysis in lipid membrane.
| S-EPMC6289274 | biostudies-literature
Project description:Fractionation of the bovine glycomacropeptide (GMP) from the other proteins in cheese whey was examined using ultrafiltration membranes surface modified to contain positively charged polymer brushes made of polyhexamethylene biguanide. By placing a strong positive charge on a 1000 kDa ultrafiltration membrane and adjusting the pH of whey close to the isoelectric point of GMP, a 14-fold increase in selectivity was observed compared to unmodified membranes. A one stage membrane system gave 90% pure GMP and a three-stage rectification system gave 97% pure GMP. The charged membrane was salt-tolerant up to 40 mS cm-1 conductivity, allowing fractionation of GMP directly from cheese whey without first lowering the whey conductivity by water dilution. Thus, similarly sized proteins that differed somewhat in isoelectric points and were 50?100 fold smaller than the membrane molecular weight cut-off (MWCO), were cleanly fractionated using charged ultrafiltration membranes without water addition. This is the first study to report on the use of salt-tolerant charged ultrafiltration membranes to produce chromatographically pure protein fractions from whey, making ultrafiltration an attractive alternative to chromatography for dairy protein fractionation.
| S-EPMC6210718 | biostudies-literature
Project description:We studied the subcellular localization of dystrophin in rabbit skeletal muscle. In Western-blot analysis of membrane preparations, dystrophin was associated with the sarcolemmal fraction, as indicated by cholesterol content and co-purification with ouabain-binding activity and beta-adrenergic receptor. Dystrophin was also found with junctional T-tubules, but not with 'free' T-tubules, longitudinal portions or terminal cisternae of the sarcoplasmic reticulum. Dystrophin was not solubilized by high salt solutions, but it was solubilized by low concentrations of detergents (Triton X-100 and deoxycholate), suggesting that it is a peripheral membrane protein.
| S-EPMC1138440 | biostudies-other
Project description:In this work, we report the transfer of graphene onto eight commercial microfiltration substrates having different pore sizes and surface characteristics. Monolayer graphene grown on copper by the chemical vapor deposition (CVD) process was transferred by the pressing method over the target substrates, followed by wet etching of copper to obtain monolayer graphene/polymer membranes. Scanning electron microscopy (SEM), atomic force microscopy (AFM), and contact angle (CA) measurements were carried out to explore the graphene layer transferability. Three factors, namely, the substrate roughness, its pore size, and its surface wetting (degree of hydrophobicity) are found to affect the conformality and coverage of the transferred graphene monolayer on the substrate surface. A good quality graphene transfer is achieved on the substrate with the following characteristics; being hydrophobic (CA > 90°), having small pore size, and low surface roughness, with a CA to RMS (root mean square) ratio higher than 2.7°/nm.
| S-EPMC5344567 | biostudies-literature
Project description:Rhamnolipids are among the glycolipids that have been investigated intensively in the last decades, mostly produced by the facultative pathogen Pseudomonas aeruginosa using plant oils as carbon source and antifoam agent. Simplification of downstream processing is envisaged using hydrophilic carbon sources, such as glucose, employing recombinant non-pathogenic Pseudomonas putida KT2440 for rhamnolipid or 3-(3-hydroxyalkanoyloxy)alkanoic acid (HAA, i.e., rhamnolipid precursors) production. However, during scale-up of the cultivation from shake flask to bioreactor, excessive foam formation hinders the use of standard fermentation protocols. In this study, the foam was guided from the reactor to a foam fractionation column to separate biosurfactants from medium and bacterial cells. Applying this integrated unit operation, the space-time yield (STY) for rhamnolipid synthesis could be increased by a factor of 2.8 (STY = 0.17 gRL/L·h) compared to the production in shake flasks. The accumulation of bacteria at the gas-liquid interface of the foam resulted in removal of whole-cell biocatalyst from the reactor with the strong consequence of reduced rhamnolipid production. To diminish the accumulation of bacteria at the gas-liquid interface, we deleted genes encoding cell-surface structures, focusing on hydrophobic proteins present on P. putida KT2440. Strains lacking, e.g., the flagellum, fimbriae, exopolysaccharides, and specific surface proteins, were tested for cell surface hydrophobicity and foam adsorption. Without flagellum or the large adhesion protein F (LapF), foam enrichment of these modified P. putida KT2440 was reduced by 23 and 51%, respectively. In a bioreactor cultivation of the non-motile strain with integrated rhamnolipid production genes, biomass enrichment in the foam was reduced by 46% compared to the reference strain. The intensification of rhamnolipid production from hydrophilic carbon sources presented here is an example for integrated strain and process engineering. This approach will become routine in the development of whole-cell catalysts for the envisaged bioeconomy. The results are discussed in the context of the importance of interacting strain and process engineering early in the development of bioprocesses.
| S-EPMC7658403 | biostudies-literature
Project description:Superhydrophilic zwitterions have been extensively exploited for surface modification to improve antifouling properties. However, it remains challenging to form layers of < 20 nm with high zwitterion content on the surfaces with different degrees of hydrophilicity. We demonstrate that amine-functionalized sulfobetaine (SBAm) can be co-deposited with dopamine on ultrafiltration (UF) membranes, leading to a thickness of 10 nm to 50 nm and an SBAm content of up to 31 mass% in the coating layers. The covalently grafted SBAm is stable underwater and improves the antifouling properties, as evidenced by the lower trans-membrane pressure required to retain targeted water fluxes than that required for the pristine membranes. The SBAm is also more effective than conventionally used sulfobetaine methacrylate (SBMA) for the zwitterion grafting on the surface to improve antifouling properties.
| S-EPMC7539668 | biostudies-literature
Project description:Isolation of a microsomal membrane fraction is a common procedure in studies involving membrane proteins. By conventional definition, microsomal membranes are collected by centrifugation of a postmitochondrial fraction at 100,000g in an ultracentrifuge, a method originally developed for large amounts of mammalian tissue. We present a method for isolating microsomal-type membranes from small amounts of Arabidopsis thaliana plant material that does not rely on ultracentrifugation but instead uses the lower relative centrifugal force (21,000g) of a microcentrifuge. We show that the 21,000g pellet is equivalent to that obtained at 100,000g and that it contains all of the membrane fractions expected in a conventional microsomal fraction. Our method incorporates specific manipulation of sample density throughout the procedure, with minimal preclearance, minimal volumes of extraction buffer, and minimal sedimentation pathlength. These features allow maximal membrane yields, enabling membrane isolation from limited amounts of material. We further demonstrate that conventional ultracentrifuge-based protocols give submaximal yields due to losses during early stages of the procedure; that is, extensive amounts of microsomal-type membranes can sediment prematurely during the typical preclearance steps. Our protocol avoids such losses, thereby ensuring maximal yield and a representative total membrane fraction. The principles of our method can be adapted for nonplant material.
| S-EPMC3685806 | biostudies-literature
Project description:The mussel-inspired method has been investigated to modify commercial ultrafiltration membranes to induce antifouling characteristics. Such features are essential to improve the feasibility of using membrane processes in protein recovery from waste streams, wastewater treatment, and reuse. However, some issues still need to be clarified, such as the influence of membrane pore size and the polymer concentration used in modifying the solution. The aim of the present work is to study a one-step deposition of dopamine (DA) and polyethyleneimine (PEI) on ultrafiltration membrane surfaces. The effects of different membrane molecular weight cut-offs (MWCO, 20, 30, and 50 kDa) and DA/PEI concentrations on membrane performance were assessed by surface characterization (FTIR, AFM, zeta potential, contact angle, protein adsorption) and permeation of protein solution. Results indicate that larger MWCO membranes (50 kDa) are most benefited by modification using DA and PEI. Moreover, PEI is primarily responsible for improving membrane performance in protein solution filtration. The membrane modified with 0.5:4.0 mg mL-1 (DA: PEI) presented a better performance in protein solution filtration, with only 15% of permeate flux drop after 2 h of filtration. The modified membrane can thus be potentially applied to the recovery of proteins from waste streams.
| S-EPMC7559832 | biostudies-literature