An approach to the study of phase separation in ternary aqueous systems.
Ontology highlight
ABSTRACT:
SUBMITTER: Edmond E
PROVIDER: S-EPMC1186942 | biostudies-other | 1968 Oct
REPOSITORIES: biostudies-other
Similar Datasets
Project description:In this work, a simple experimental protocol to determine liquid-liquid phase diagrams of aqueous two-phase systems (ATPS) on a Chemical Engineering course is described. Throughout this laboratory set of experiments, the liquid-liquid ternary phase diagrams, tie-lines, tie-line lengths and critical points of ATPS will be determined. Ternary liquid-liquid phase diagrams composed of water, polyethylene glycol (PEG 200, 400 and 600 g·mol-1) and sodium carbonate (Na2CO3) were obtained by cloud-point titration method at room temperature. The respective tie-lines, tie-line lengths and critical points were also determined. Phase diagrams were represented both as conventional ternary phase diagrams and orthogonal phase diagrams. Through the analysis of the results obtained it was identified a higher ability to form ATPS with the increase of the polymer molecular weight. The interpretation of phase diagrams, particularly the most complex, the orthogonal ones, is not always easy to grasp by students, so this novel 3-hour-class educational approach could be potentially used to teach and help understanding 3-component liquid-liquid equilibrium and the formation of biphasic systems to undergraduate students, without requiring the use of volatile organic solvents.
| S-EPMC6448763 | biostudies-literature
Project description:BackgroundLevodopa is a precursor of several neurotransmitters, such as dopamine, and is used in the treatment of the Parkinson's disease. In this work, an alternative strategy was studied to separate levodopa from similar biomolecules using aqueous two-phase systems (ATPS).ResultsTernary ATPS composed of polyethylene glycol (PEG) 400 or ionic liquids (ILs), citrate buffer (K3C6H5O7/C6H8O7) at pH 7.0 and water, and quaternary ATPS composed of PEG 400, K3C6H5O7/C6H8O7 at pH 7.0, water and the same ILs at 5 wt%, were studied. The respective liquid-liquid phase diagrams were determined at 298 K to appraise the mixture compositions required to form two-phase systems, followed by studies of the partition of levodopa and structurally similar biomolecules (dopamine, L-phenylalanine, and L-tyrosine). Their partition coefficients and extraction efficiencies have been determined, and the selectivity of the ATPS to separate levodopa from the remaining biomolecules evaluated.ConclusionThe results obtained indicated that PEG-based ATPS were the most effective to separate levodopa from L-phenylalanine while the separation from the other biomolecules was better using IL-based ATPS, in particular those based on [P4444]Cl and [N4444]Cl, with extraction efficiencies of levodopa to the salt-rich phase ranging between 62.7 and 74.0%, and of the remaining biomolecules to polymer/IL-rich phase up to 91.5%.
| S-EPMC6161814 | biostudies-literature
Project description:(1) We have measured the incompatible phase separation that occurs in a polyethylene glycol-sodium dextran sulphate-sodium chloride-water system and have determined a critical point. (2) We have measured the activity coefficients of sodium chloride in critical-point concentrations of polyethylene glycol and sodium dextran sulphate respectively, and the osmotic coefficient of sodium dextran sulphate at the critical-point concentration. (3) With use of the relevant thermodynamic equations for a quaternary ionic system, we have determined the interaction coefficients between polyethylene glycol and dextran sulphate and between polyethylene glycol and sodium chloride. The former could be due mainly to volume exclusion, but the latter is too large to be explained on that basis.
| S-EPMC1178833 | biostudies-other
Project description:Aqueous biphasic systems (ABS) composed of polypropylene glycol and carbohydrates, two benign substances are proposed to separate two food colorants (E122 and E133). ABS are promising extractive platforms, particularly for biomolecules, due to their aqueous and mild nature (pH and temperature), reduced environmental impact and processing costs. Another major aspect considered, particularly useful in downstream processing, is the "tuning" ability for the extraction and purification of these systems by a proper choice of the ABS components. In this work, our intention is to show the concept of ABS as an alternative and volatile organic solvent-free tool to separate two different biomolecules in a simple way, so simple that teachers can effectively adopt it in their classes to explain the concept of bioseparation processes. Informative documents and general information about the preparation of binodal curves and their use in the partition of biomolecules is available in this work to be used by teachers in their classes. In this sense, the students use different carbohydrates to build ABS, then study the partition of two food color dyes (synthetic origin), thus evaluating their ability on the separation of both food colorants. Through these experiments, the students get acquainted with ABS, learn how to determine solubility curves and perform extraction procedures using colorant food additives, that can also be applied in the extraction of various (bio)molecules. © 2018 by The International Union of Biochemistry and Molecular Biology, 46:390-397, 2018.
| S-EPMC6161818 | biostudies-literature
Project description:To artificially construct a three-dimensional cell assembly, we investigated the availability of long-duration microdroplets that emerged near a critical point in an aqueous two-phase system (ATPS) with the hydrophilic binary polymers, polyethylene glycol (PEG), and dextran (DEX), as host containers. We found that erythrocytes (horse red blood cells; RBCs) and NAMRU mouse mammary gland epithelial cells (NMuMG cells) were completely and spontaneously entrapped inside DEX-rich microdroplets. RBCs and NMuMG cells were located in the interior and at the periphery of the droplets at PEG/DEX = 5%:5%. In contrast, the cells exhibited opposite localizations at PEG/DEX = 10%:5%, where, interestingly, NMuMG cells apparently assembled to achieve cell adhesion. We simply interpreted such specific localizations by considering the alternative responses of these cells to the properties of the PEG/DEX interfaces with different gradients in polymer concentrations.
| S-EPMC6367680 | biostudies-literature
Project description:In the present work, we investigate the dynamic phenomena induced by solvent evaporation from ternary solutions confined in a Hele-Shaw cell. The model solutions consist of ethanol, water, and oil, and with the decrease in ethanol concentration by selective evaporation, they may undergo microdroplet formation via the ouzo effect or macroscopic liquid-liquid phase separation. We varied the initial concentration of the three components of the solutions. For all ternary solutions, evaporation of the good solvent ethanol from the gas-liquid interface, aligned with one side of the cell, leads to a Marangoni instability at the early stage of the evaporation process. The presence of the Marangoni instability is in agreement with our recent predictions based on linear stability analysis of binary systems. However, the location and onset of subsequent microdroplet formation and phase separation are the result of the interplay between the Marangoni instability and the initial composition of the ternary mixtures. We classified the ternary solutions into different groups according to the initial concentration of oil. For each group, based on the ternary diagram of the mixture, we offer a rationale for the way phase separation takes place and discuss how the instability influences droplet nucleation. Our work helps us to understand under what conditions and where droplet nucleation can take place when advection is present during phase separation inside a microfluidic device.
| S-EPMC8427745 | biostudies-literature
Project description:6-Aminopenicillanic acid (6-APA) is used for synthesis of semisynthetic antibiotics. Polymer-salt aqueous two-phase systems (ATPSs) were applied for separation of 6-APA and phenyl acetic acid (PAA), as the products of hydrolyzation reaction of Penicillin G/Penicillin V. The binodal curves of ATPS composed of a copolymer (reverse Pluronic 10R5, Pluronic L35 and PEG-ran-PPG) and a salt (Tri-sodium citrate, tri-potassium citrate, di-potassium phosphate, sodium sulphate and magnesium sulphate) were obtained. The results show that, at a fixed PPG/PEG ratio, block copolymers have larger two-phase region compared with random copolymer. After screening on the partition coefficient of PAA and 6-APA separately, Na2SO4 was selected for studying the effect of the copolymer structure and the composition of salt and copolymer on partitioning, considering higher selectivity of PAA and 6-APA. 10R5-Na2SO4 ATPS was selected as the most appropriate system for separation of 6-APA and PAA. This system was used for separation of mixture of 6-APA and PAA. The results show that selectivity was [Formula: see text] 53 and smaller in a system, containing a mixture of 6-APA and PAA. This observation can be justified by the interaction between 6-APA and PAA. Molecular interaction between these two molecules were investigated by the Flory-Huggins interaction parameter.
| S-EPMC7875977 | biostudies-literature
Project description:Protamines are natural polyguanidiniums, arginine(R)-rich proteins involved in the compaction of chromatin during vertebrate spermatogenesis. Salmine, a protamine isolated from salmon sperm, contains 65 mol% R residues, with positively charged guanidino (Gdm⁺) sidechains, and no other amino acids with ionizable or aromatic sidechains. Salmine sulfate solutions undergo liquid-liquid phase separation (LLPS) with a concentration-dependent upper critical solution temperature (UCST). The condensed liquid phase comprises 50 wt % water and >600 mg·ml-¹ salmine with a constant 1:2 ratio of sulfate (SO₄²-) to Gdm⁺. Isothermal titration calorimetry, titrating Na₂SO₄ into salmine chloride above and below the UCST, allowed isolation of exothermic sulfate binding to salmine chloride from subsequent endothermic condensation and exothermic phase separation events. Synthetic random polyacrylate analogs of salmine, with 3-guanidinopropyl sidechains, displayed similar counterion dependent phase behavior, demonstrating that the LLPS of polyguanidiniums does not depend upon subunit sequence or polymer backbone chirality, and was due entirely to Gdm⁺ sidechain interactions. The results provide experimental evidence for like-charge pairing of Gdm⁺ sidechains, and an experimental approach for further characterizing these interactions.
| S-EPMC6523547 | biostudies-literature
Project description:Hollow fiber (HF) membrane geometry is the preferred choice for most commercial membrane operations. Such fibers are conventionally prepared via the non-solvent-induced phase separation technique, which heavily relies on hazardous and reprotoxic organic solvents such as N-methyl pyrrolidone. A more sustainable alternative, i.e., aqueous phase separation (APS), was introduced recently that utilizes water as a solvent and non-solvent for the production of polymeric membranes. Herein, for the first time, we demonstrate the preparation of sustainable and functional HF membranes via the APS technique in a dry-jet wet spinning process. The dope solution comprising poly(sodium 4-styrenesulfonate) (PSS) and polyethyleneimine (PEI) at high pH along with an aqueous bore liquid is pushed through a single orifice spinneret into a low pH acetate buffer coagulation bath. Here, PEI becomes charged resulting in the formation of a polyelectrolyte complex with PSS. The compositions of the bore liquid and coagulation bath were systematically varied to study their effect on the structure and performance of the HF membranes. The microfiltration-type membranes (permeability ∼500 to 800 L·m-2·h-1·bar-1) with complete retention of emulsion droplets were obtained when the precipitation rate was slow. Increasing the concentration of the acetate buffer in the bath led to the increase in precipitation rate resulting in ultrafiltration-type membranes (permeability ∼12 to 15 L·m-2·h-1·bar-1) having molecular weight cut-offs in the range of ∼7.8-11.6 kDa. The research presented in this work confirms the versatility of APS and moves it another step closer to large-scale use.
| S-EPMC8845049 | biostudies-literature
Project description:A ternary phase-separation investigation of the ethyl silicate 40 (ES40) sol-gel process was conducted using ethanol and water as the solvent and hydrolysing agent, respectively. This oligomeric silica precursor underwent various degrees of phase separation behaviour in solution during the sol-gel reactions as a function of temperature and H2O/Si ratios. The solution composition within the immiscible region of the ES40 phase-separated system shows that the hydrolysis and condensation reactions decreased with decreasing reaction temperature. A mesoporous structure was obtained at low temperature due to weak drying forces from slow solvent evaporation on one hand and formation of unreacted ES40 cages in the other, which reduced network shrinkage and produced larger pores. This was attributed to the concentration of the reactive sites around the phase-separated interface, which enhanced the condensation and crosslinking. Contrary to dense silica structures obtained from sol-gel reactions in the miscible region, higher microporosity was produced via a phase-separated sol-gel system by using high H2O/Si ratios. This tailoring process facilitated further condensation reactions and crosslinking of silica chains, which coupled with stiffening of the network, made it more resistant to compression and densification.
| S-EPMC4585945 | biostudies-literature