Browse
Submit Data
Databases
API
Help

Dataset Information

0 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

A rapid simple method for the assay of renin in rabbit plasma.

ABSTRACT: 1. EDTA (10mm), 2,3-dimercaptopropan-1-ol (10mm) and chlorhexidine gluconate (0.005%, w/v) cause complete inactivation of plasma enzymes that degrade angiotensin I, but have no effect on the reaction of renin with its substrate. The reagents were termed the selective inhibitors. 2. Thus it is possible to measure renin in plasma by its ability to catalyse the release of angiotensin I. 3. Sterile plasma, treated with the selective inhibitors, is incubated with renin substrate (500-1000ng. of angiotensin content/ml.) at pH6 at 42 degrees for 6hr. 4. Under these conditions the reaction obeys first-order kinetics. Renin activity is calculated in terms of the percentage release of the angiotensin content/hr. 5. As described, the assay is sufficiently sensitive to measure renin in the plasma of all normal rabbits. By extending the length of the incubation, much lower activities can be measured.

SUBMITTER: Ryan JW

PROVIDER: S-EPMC1198868 | biostudies-other | 1968 Jul

REPOSITORIES: biostudies-other

ACCESS DATA

Json Xml

Similar Datasets

Properties of renin substrate in rabbit plasma with a note on its assay.

Project description:1. Rabbit plasma enzymes that degrade angiotensin I are inhibited completely by the combination of 2,3-dimercaptopropan-1-ol (10mm), EDTA (10mm) and chlorhexidine gluconate (0.005%, w/v). These compounds do not modify the reaction of renin with renin substrate and are termed the selective inhibitors. 2. The renin substrate concentration of plasma can be measured as angiotensin I content by incubating plasma plus the selective inhibitors with renin for a time sufficient to allow complete utilization of renin substrate. 3. This reaction obeys first-order kinetics to substrate concentrations of at least 1000ng. of angiotensin I content/ml. In general, the renin substrate concentrations of normal rabbit plasmas are less than 1000ng. of angiotensin I content/ml. Thus the time required for the complete release of angiotensin I from normal plasma is inversely related to renin activity and is independent of renin substrate concentration. 4. A method for the assay of renin substrate, taking these reaction kinetics into account, is presented.

| S-EPMC1198869 | biostudies-other

The preparation of rabbit renin-substrate for the assay of minute amounts of renin.

Project description:1. By DEAE-cellulose chromatography and treatment with Cd(2+) a partially purified renin-substrate has been prepared from rabbit serum. 2. It has the following properties: (a) Angiotensinase activity is undetectable: 0.1mug. of angiotensin was recovered intact after incubation with the substrate at 37 degrees for 200hr. (b) It does not contain renin and does not generate vaso-active substances when incubated alone. (c) It is ten times as active as serum in terms of angiotensin produced/mg. of protein. (d) It has not deteriorated after storage for 3 months at 4 degrees at pH7.5.

| S-EPMC1207055 | biostudies-other

TLC-spectrodensitometric method for simultaneous determination of dapagliflozin and rosuvastatin in rabbit plasma: stability indicating assay and kinetic studies.

Project description:Herein, a sensitive and reliable eco-friendly TLC-spectrodensitometric method has been established for the simultaneous determination of dapagliflozin (DAPA) and rosuvastatin (ROSV) for the first time. TLC separation was carried out on silica gel F254 using ethyl acetate : methanol (5 : 0.1, v/v) as a mobile phase and UV measurement at 243 nm. The method was fully validated according to ICH guidelines. Acceptable separation was achieved with R f values of 0.23 and 0.44 for DAPA and ROSV, respectively. Regression plots revealed linear relationships in the concentration range 20-2500 ng per band and 10-2500 ng per band with LODs of 6.60 and 3.57 ng per band for both DAPA and ROSV, respectively. The relative standard deviations (RSDs%) were found to be 1.35 and 0.53 for DAPA and ROSV, respectively. Moreover, kinetic studies were conducted for measurement of degradation rate constant (k) and half life time (t 1/2) of DAPA and ROSV via forced photo-degradation.

| S-EPMC9057705 | biostudies-literature

EasyNAT MP Assay: A Simple, Rapid, and Low-Cost Method to Detect Mycoplasma pneumoniae Using Cross-Priming Amplification Technology.

Project description:BackgroundMycoplasma pneumoniae (MP) is the most common pathogen of atypical pneumonia and the main cause of community-acquired pneumonia (CAP) in infants and older adults. This study aimed at investigating a method based on the cross-priming amplification (CPA) technique for the rapid detection of MP in clinical specimens collected from patients with CAP.MethodsThe sensitivity and specificity of the EasyNAT MP assay were determined. Oropharyngeal swab specimens were collected from 162 in-patients of Hangzhou First People's Hospitals from January 2018 to December 2020. The patients were aged between 1 and 15 years with symptoms, signs, and chest radiographs consistent with CAP. This study evaluated the presence of MP in the clinical specimens using the EasyNAT method and the conventional fluorescence quantitative PCR technique.ResultsThe limit of detection using the EasyNAT MP assay was 500 copies/mL, while the test results of the other 13 common pathogens causing CAP or colonizing in the upper respiratory tract showed no cross-reactivity. Of 162 specimens, EasyNAT MP gave a positive indication in 82 specimens. Compared with conventional fluorescence quantitative PCR, the positive coincidence rate and the negative coincidence rate of EasyNAT MP was found to be 100.00% and 97.56%, respectively. Of the 82 specimens, two specimens were determined to be negative by the conventional fluorescence quantitative PCR, but were positive for EasyNAT MP. The two samples were re-extracted and confirmed to be positive by conventional fluorescence quantitative PCR.ConclusionEasyNAT MP is suitable as an initial test for MP diagnosis due to its simplicity, low turnaround time, and high sensitivity and specificity.

| S-EPMC9098574 | biostudies-literature

Simple and Rapid Method for Detecting Biofilm Forming Bacteria.

Project description:Biofilm forming bacteria play a vital role in causing infectious diseases and for enhancing the efficiency of the bioremediation process through immobilization. Different media and conditions have been reported for detecting biofilm forming bacteria, however, they are not quite rapid. Here, we propose the use of a simple medium which can be used for detecting biofilm former, and also provide a mechanism to regulate the expression of biofilm formation process.

| S-EPMC5243243 | biostudies-literature

A rapid, simple and sensitive LC-MS/MS method for lenvatinib quantification in human plasma for therapeutic drug monitoring.

Project description:Lenvatinib (LENVA) is an oral antineoplastic drug used for the treatment of hepatocellular carcinoma and thyroid carcinoma. LENVA therapeutic drug monitoring (TDM) should be mandatory for a precision medicine to optimize the drug dosage. To this end, the development of a sensitive and robust quantification method to be applied in the clinical setting is essential. The aim of this work was to develop and validate a sensitive, rapid, and cost-effective LC-MS/MS method for the quantification of LENVA in human plasma. On this premise, sample preparation was based on a protein precipitation and the chromatographic separation was achieved on a Synergi Fusion RP C18 column in 4 min. The method was completely and successfully validated according to European Medicines Agency (EMA) and Food and Drug Administration (FDA) guidelines, with good linearity in the range of 0.50-2000 ng/mL (R≥0.9968). Coefficient of variation (CV) for intra- and inter-day precision was ≤11.3% and accuracy ranged from 96.3 to 109.0%, internal standard normalized matrix effect CV% was ≤2.8% and recovery was ≥95.6%. Successful results were obtained for sensitivity (signal to noise (S/N) ratio >21) and selectivity, dilution integrity (CV% ≤ 4.0% and accuracy 99.9-102%), and analyte stability under various handling and storage conditions both in matrix and solvents. This method was applied to quantify LENVA in patient's plasma samples and covered the concentration range achievable in patients. In conclusion, a sensitive and robust quantification method was developed and validated to be applied in the clinical setting.

| S-EPMC8547652 | biostudies-literature

A radiochemical renin assay.

Project description:1. A synthetic 3-([(14)C]valine)-labelled tetradecapeptide renin substrate was used to measure renin concentration. Renin liberated (14)C-labelled angiotensin I, which was separated from the labelled substrate by paper chromatography. The conversion of substrate into angiotensin I was quantitated by liquid-scintillation counting of radioactivity. 2. The rate of conversion of the substrate into angiotensin I was shown to be linearly related to renin concentration and time under suitable conditions. Angiotensin generation measured in this system agrees well with that measured by bioassay. 3. It is suggested that the use of a pure substrate offers advantages that include the standardization of current units of renin measurement.

| S-EPMC1176561 | biostudies-other

A Simple Paper-Based Colorimetric Device for Rapid Mercury(II) Assay.

Project description:Contamination of the environment by mercury(II) ions (Hg(2+)) poses a serious threat to human health and ecosystems. Up to now, many reported Hg(2+) sensors require complex procedures, long measurement times and sophisticated instrumentation. We have developed a simple, rapid, low cost and naked-eye quantitative method for Hg(2+) environmental analysis using a paper-based colorimetric device (PCD). The sample solution to which platinum nanoparticles (PtNPs) have been added is dispensed to the detection zone on the PCD, where the 3,3,5,5-tetramethylbenzidine (TMB) substrate has been pre-loaded. The PtNPs effect a rapid oxidization of TMB, inducing blue colorization on the PCD. However, Hg(2+) in the solution rapidly interact with the PtNPs, suppressing the oxidation capacity and hence causing a decrease in blue intensity, which can be observed directly by the naked eye. Moreover, Hg(2+) at concentrations as low as 0.01 uM, can be successfully monitored using a fiber optic device, which gives a digital readout proportional to the intensity of the blue color change. This paper-based colorimetric device (PCD) shows great potential for field measurement of Hg(2+).

| S-EPMC4995402 | biostudies-literature

ZyFISH: a simple, rapid and reliable zygosity assay for transgenic mice.

Project description:Microinjection of DNA constructs into fertilized mouse oocytes typically results in random transgene integration at a single genomic locus. The resulting transgenic founders can be used to establish hemizygous transgenic mouse lines. However, practical and experimental reasons often require that such lines be bred to homozygosity. Transgene zygosity can be determined by progeny testing assays which are expensive and time-consuming, by quantitative Southern blotting which is labor-intensive, or by quantitative PCR (qPCR) which requires transgene-specific design. Here, we describe a zygosity assessment procedure based on fluorescent in situ hybridization (zyFISH). The zyFISH protocol entails the detection of transgenic loci by FISH and the concomitant assignment of homozygosity using a concise and unbiased scoring system. The method requires small volumes of blood, is scalable to at least 40 determinations per assay, and produces results entirely consistent with the progeny testing assay. This combination of reliability, simplicity and cost-effectiveness makes zyFISH a method of choice for transgenic mouse zygosity determinations.

| S-EPMC3362593 | biostudies-literature

A rapid and simple method to quantify per- and polyfluoroalkyl substances (PFAS) in plasma and serum using 96-well plates.

Project description:Per- and polyfluoroalkyl substances (PFAS) are synthetic organic compounds that over the past several years, have witnessed a dramatic increase in scientific attention. As PFAS are predominantly accumulated in plasma, monitoring individual burden levels in plasma are typically achieved via some combination of protein precipitation and/or solid phase extraction (SPE), either in online or offline modes. This work describes an updated PFAS extraction workflow, using 96-well plate technology and protein precipitation that is rapid, simple, inexpensive, and amenable for large cohort studies. In brief, plasma proteins were precipitated using methanol and the resulting centrifuged supernatant was directly analyzed using UHPLC-MS/MS. We monitored 51 PFAS, which were quantified via isotope dilution and the effectiveness of the method was demonstrated by using NIST blood-based Standard Reference Materials (SRMs). This method resulted in recoveries ranging between 70 and 89% for all analytes. The 96-well design exhibited low limits of detection and only required sample volumes of 100 µL, thus resulting in an amenable method for high-throughput plasma/serum PFAS screening. • PFAS were directly quantified in plasma and serum samples; • No SPE needed after protein precipitation; • SRMs can be used to validate PFAS measurement in plasma/serum.

| S-EPMC7588704 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data