Dataset Information

Phospholipid-subclass-specific partitioning of lipophilic ions in membrane-water systems.

ABSTRACT: Herein, we systematically investigate phospholipid-subclass-specific alterations in the partitioning of both cationic and anionic amphiphiles to identify the importance of ester, ether and vinyl ether linkages at the sn-1 position of phospholipids in the partitioning of charged amphiphiles. The results demonstrated that the membrane-water partition coefficient of a prototypic cationic amphiphile (i.e. 3,3'-dipropylthiadicarbocyanine iodide) was approximately 2.5 times higher in membranes comprised of plasmenylcholine in comparison with membranes comprised of either phosphatidylcholine or plasmanylcholine. In striking contrast, the membrane-water partition coefficient of a prototypic anionic amphiphile [i.e. bis-(1,3-dibutylbarbituric acid)trimethine oxonol] in membranes comprised of plasmenylcholine was approximately 2.5 times lower than that manifest in membranes comprised of phosphatidylcholine or plasmanylcholine. Utilizing theseexperimentally determined partition coefficients,the relative membrane dipole potential of membranes comprised of plasmenylcholine was calculated and found to be approximately 25 mV lower than in membranes comprised of phosphatidylcholine or plasmanylcholine. This lower membrane dipole potential in membranes comprised of plasmenylcholine is equivalent to the membrane potential induced by incorporation of approximately 25 mol% of anionic phospholipids in membranes comprised of phosphatidylcholine. Collectively, these results demonstrate that phospholipid-subclass-specific differences in the membrane dipole potential contribute to alterations in the partitioning of lipophilic ions in membrane bilayers comprised of distinct phospholipid subclasses. Moreover, they suggest that these physicochemical differences can be exploited to facilitate the targeting of charged lipophilic drugs to specific cells and subcellular membrane compartments.

SUBMITTER: Zeng Y

PROVIDER: S-EPMC1220099 | biostudies-other | 1999 Mar

REPOSITORIES: biostudies-other

ACCESS DATA

Similar Datasets

Project description:BackgroundPeptide-membrane interactions play a key role in the binding, partitioning and folding of membrane proteins, the activity of antimicrobial and fusion peptides, and a number of other processes. To gain a better understanding of the thermodynamics of such interactions, White and Wimley created an interfacial hydrophobicity scale based of the transfer free energy from water to octanol or lipid bilayers of a series of synthetic peptapeptides (Ace-WLXLL, with X being any of the twenty natural amino acids) (White and Wimley (1996) Nat. Struct. Biol. 3, 842-848). In this study, we performed molecular dynamics simulations of a representative set of ten of these peptides (X = D, K, R, N, A, T, S, I, F and W) in two membrane mimetic interfaces: water-cyclohexane (10 ns) and a fully solvated dioleoylphosphatidylcholine (DOPC) bilayer (50 ns) using both constant pressure and constant area ensembles. We focus on partitioning of the ten peptides at the cyclohexane/water and lipid/water interfaces.ResultsThe peptides rapidly equilibrate (< 2 ns) and partition at the cyclohexane/water interface. The X3 guest residue assumes average orientations that depend on the nature of the side chain. At the DOPC/water interface, dynamics is much slower and convergence is difficult to achieve on a 50 ns timescale. Nonetheless, all peptides partition to the lipid/water interface with distributions with widths of 1-2 nm. The peptides assume a broad range of side chain and backbone orientations and have only a small effect on the area of the unit cell. On average, hydrophobic guest residues partition deeper into the hydrophobic core than hydrophilic residues. In some cases the peptides penetrate sufficiently deep to somewhat affect the distribution of the C=C double bond in DOPC. The relative distribution of the X3 guest residue compared to W1 and L5 is similar in the water/cyclohexane and water/lipid simulations. Snapshots show mostly extended backbone conformations in both environments. There is little difference between simulations at a constant area of 0.66 nm2 and simulations at constant pressure that approximately yield the same average area of 0.66 nm2.ConclusionThese peptides were designed to assume extended conformations, which is confirmed by the simulations. The distribution of the X3 side chain depends on its nature, and can be determined from molecular dynamics simulations. The time scale of peptide motion at a phospholipids-water interface is too long to directly calculate the experimentally measured hydrophobicity scale to test and improve the simulation parameters. This should be possible at the water/cyclohexane interface and likely will become feasible in the future for the phospholipids/water case.

Dataset Information

Phospholipid-subclass-specific partitioning of lipophilic ions in membrane-water systems.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets