Proteoglycan breakdown of meniscal explants following dynamic compression using a novel bioreactor.
Ontology highlight
ABSTRACT:
SUBMITTER: McHenry JA
PROVIDER: S-EPMC1705544 | biostudies-other | 2006 Nov
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Previous cell culture and animal in vivo studies indicate the obvious effects of mechanical compression on disc cell biology. However, the effects of dynamic compression magnitude, frequency and duration on the immature nucleus pulposus (NP) from an organ-cultured disc are not well understood.To investigate the effects of a relatively wide range of compressive magnitudes, frequencies and durations on cell apoptosis and matrix composition within the immature NP using an intelligent and mechanically active bioreactor.Discs from the immature porcine were cultured in a mechanically active bioreactor for 7 days. The discs in various compressive magnitude groups (0.1, 0.2, 0.4, 0.8 and 1.3 MPa at a frequency of 1.0 Hz for 2 hours), frequency groups (0.1, 0.5, 1.0, 3.0 and 5.0 Hz at a magnitude of 0.4 MPa for 2 hours) and duration groups (1, 2, 4 and 8 hours at a magnitude of 0.4 MPa and frequency of 1.0 Hz) experienced dynamic compression once per day. Discs cultured without compression were used as controls. Immature NP samples were analyzed using the TUNEL assay, histological staining, glycosaminoglycan (GAG) content measurement, real-time PCR and collagen II immunohistochemical staining.In the 1.3 MPa, 5.0 Hz and 8 hour groups, the immature NP showed a significantly increase in apoptotic cells, a catabolic gene expression profile with down-regulated matrix molecules and up-regulated matrix degradation enzymes, and decreased GAG content and collagen II deposition. In the other compressive magnitude, frequency and duration groups, the immature NP showed a healthier status regarding NP cell apoptosis, gene expression profile and matrix production.Cell apoptosis and matrix composition within the immature NP were compressive magnitude-, frequency- and duration-dependent. The relatively high compressive magnitude or frequency and long compressive duration are not helpful for maintaining the healthy status of an immature NP.
| S-EPMC4773287 | biostudies-literature
Project description:Horizontal cleavage meniscus tears occur more frequently in older patient populations with degenerative changes within the meniscus. Traditionally, they have been managed with nonsurgical interventions or with partial meniscectomy. As increasing evidence demonstrates the link between partial meniscectomy and progressive osteoarthritis with these types of tears, as well as worse long-term outcomes and reduced cost savings, surgical repair of horizontal cleavage meniscal tears has increased in appropriate patients. This technique article highlights the evaluation, indications, and preferred repair technique for horizontal cleavage tears in appropriately selected patients. Technique Video Video 1 Demonstration of technique. The patient is placed in the supine position. A superolateral outflow portal is placed to allow for adequate intra-articular visualization followed by the creation of standard anteromedial and anterolateral portals. Initial diagnostic arthroscopy is performed viewing from the anterolateral portal. Once the tear has been identified, the meniscal tear is further visualized by preparation of the frayed edges with a combination of meniscal rasping, biting, and shaving. Following preparation, the meniscal repair is begun posteriorly working from the anteromedial portal to allow for direct access to the meniscus. In this case, the tear is of the medial meniscus. If the medial compartment is tight, prohibiting sufficient access, percutaneous trephination of the medial collateral ligament is performed to increase access. Using the Smith & Nephew NovoStitch Pro All-inside device, circumferential compression sutures are placed 3 to 4 mm apart working from posterior to anterior. At the mid-body of the meniscus, the working portal is switched to the anterolateral portal to allow for more direct access to the remainder of the more anterior portions of the meniscus.
| S-EPMC10466186 | biostudies-literature
Project description:Meniscus injuries are highly prevalent and are linked to the development of post-traumatic osteoarthritis (PTOA). The inflammatory cytokine IL-1 is elevated in synovial fluid following knee injuries, causes degradation of meniscus tissue, and inhibits meniscus repair. Dynamic mechanical compression of meniscus tissue has been shown to improve integrative repair in the presence of IL-1; however, there remains a dearth of knowledge on global effects of loading on meniscus cell phenotype and transcriptomic profiles. In this study, we performed mRNA-Seq on meniscus tissue explants from inner and outer zone regions of porcine menisci subjected to dynamic compression in the presence and absence of IL-1 to identify cellular responses to mechanical load, identify differences in response to load based on zonal characteristics, and identify IL-1 induced inflammatory responses modulated by load.
2021-12-24 | GSE191175 | GEO
Project description:Secondary bone fracture healing is a physiological process that leads to functional tissue regeneration via endochondral bone formation. In vivo studies have demonstrated that early mobilization and the application of mechanical loads enhances the process of fracture healing. However, the influence of specific mechanical stimuli and particular effects during specific phases of fracture healing remain to be elucidated. In this work, we have developed and provided proof-of-concept of an in vitro human organotypic model of physiological loading of a cartilage callus, based on a novel perfused compression bioreactor (PCB) system. We then used the fracture callus model to investigate the regulatory role of dynamic mechanical loading. Our findings provide a proof-of-principle that dynamic mechanical loading applied by the PCB can enhance the maturation process of mesenchymal stromal cells toward late hypertrophic chondrocytes and the mineralization of the deposited extracellular matrix. The PCB provides a promising tool to study fracture healing and for the in vitro assessment of alternative fracture treatments based on engineered tissue grafts or pharmaceutical compounds, allowing for the reduction of animal experiments.
| S-EPMC4313709 | biostudies-literature
Project description:Our goal was to test the hypothesis that specific integrin receptors regulate chondrocyte biosynthetic response to dynamic compression at early times in 3D gel culture, during initial evolution of the pericellular matrix, but prior to significant accumulation of further-removed matrix. The study was motivated by increased use of dynamic loading, in vitro, for early stimulation of tissue engineered cartilage, and the need to understand the effects of loading, in vivo, at early times after implantation of constructs.Bovine articular chondrocytes were seeded in 2% agarose gels (15x10(6)cells/mL) and incubated for 18 h with and without the presence of specific integrin blockers (small-molecule peptidomimetics, function-blocking antibodies, and RGD-containing disintegrins). Samples were then subjected to a 24-h dynamic compression regime found previously to stimulate chondrocyte biosynthesis in 3D gel as well as cartilage explant culture (1 Hz, 2.5% dynamic strain amplitude, 7% static offset strain). At the end of loading, proteoglycan (PG) synthesis ((35)S-sulfate incorporation), protein synthesis ((3)H-proline incorporation), DNA content (Hoechst dye 33258) and total glycosaminoglycan (GAG) content (dimethyl methylene blue (DMMB) dye binding) were assessed.Consistent with previous studies, dynamic compression increased PG synthesis and total GAG accumulation compared to free-swelling controls. Blocking alphavbeta3 abolished this response, independent of effects on controls, while blocking beta1 abolished the relative changes in synthesis when changes in free-swelling synthesis rates were observed.This study suggests that both alphavbeta3 and beta1 play a role in pathways that regulate stimulation of PG synthesis and accumulation by dynamic compression, but through distinct complementary mechanisms.
| S-EPMC2818306 | biostudies-literature
Project description:The effects of mechanical stress on cells and their extracellular matrix, especially in gliding sections of tendon, are still poorly understood. This study sought to compare the effects of uniaxial stretching on both gliding and traction areas in the same tendon. Flexor digitorum longus muscle tendons explanted from rats were subjected to stretching in a bioreactor for 6, 24, or 48 h, respectively, at 1 Hz and an amplitude of 2.5%. After stimulation, marker expression was quantified by histological and immunohistochemical staining in both gliding and traction areas. We observed a heightened intensity of scleraxis after 6 and 24 h of stimulation in both tendon types, though it had declined again 48 h after stimulation. We observed induced matrix metalloproteinase-1 and -13 protein expression in both tendon types. The bioreactor produced an increase in the mechanical structural strength of the tendon during the first half of the loading time and a decrease during the latter half. Uniaxial stretching of flexor tendon in our set-up can serve as an overloading model. A combination of mechanical and histological data allows us to improve the conditions for cultivating tendon tissues.
| S-EPMC7215532 | biostudies-literature
Project description:A greater understanding of the deleterious consequences that a meniscal root tear brings to the knee joint and how its surgical repair can be advantageous over the previously used treatment strategies brings the need for the development of surgical techniques that make the procedure less complex and more reproducible. When meniscal root rupture occurs, a mechanical overload occurs in the affected compartment similar to a total meniscectomy. Several authors have concluded that meniscal root reinsertion significantly improves postoperative outcomes and patient satisfaction, regardless of age or laterality of the meniscal injury. The Meniscus 4 A-II device (Rio de Janeiro, Brazil) allows stitching at the root of the medial and lateral menisci. In this article, we describe the surgical repair technique for posterior-medial and -lateral meniscal root tears using this meniscal suture device. This technique is fast and effective.
| S-EPMC7372309 | biostudies-literature
Project description:Mechanical training of engineered tissue constructs is believed necessary to improve regeneration of cartilaginous grafts. Nevertheless, molecular mechanisms underlying mechanical activation are not clear. This is partly due to unavailability of appropriate scaffolds allowing exposure of cells to dynamic compressive strains (DCS) in vitro while permitting subsequent molecular analyses. We demonstrate that three-dimensional macroporous electrospun poly(epsilon-caprolactone) scaffolds can be fabricated that are suitable for the functional and molecular analysis of dynamically loaded chondrocytes. These scaffolds encourage chondrocytic proliferation promoting expression of collagen type II, aggrecan, and Sox9 while retaining mechanical strength after prolonged dynamic compression. Further, they exhibit superior infiltration of exogenous agents into the cells and permit easy retrieval of cellular components postcompression to allow exploration of molecular mechanisms of DCS. Using these scaffolds, we observed that chondrocytes responded to DCS in a magnitude-dependent manner exhibiting antiinflammatory and proanabolic responses at low physiological magnitudes. Proinflammatory responses and decreased cellular viability were observed at hyperphysiological magnitudes. These scaffolds provide a means of unraveling the mechanotransduction-induced transcriptional and posttranslational activities involved in cartilage regeneration and repair.
| S-EPMC2770088 | biostudies-literature
Project description:Knee osteoarthritis (OA) results, at least in part, from overloading and inflammation leading to cartilage degradation. Prostaglandin E2 (PGE2) is one of the main catabolic factors involved in OA. Its synthesis is the result of cyclooxygenase (COX) and prostaglandin E synthase (PGES) activities whereas NAD+-dependent 15 hydroxy prostaglandin dehydrogenase (15-PGDH) is the key enzyme implicated in the catabolism of PGE2. For both COX and PGES, three isoforms have been described: in cartilage, COX-1 and cytosolic PGES are constitutively expressed whereas COX-2 and microsomal PGES type 1 (mPGES-1) are inducible in an inflammatory context. COX-3 (a variant of COX-1) and mPGES-2 have been recently cloned but little is known about their expression and regulation in cartilage, as is also the case for 15-PGDH. We investigated the regulation of the genes encoding COX and PGES isoforms during mechanical stress applied to cartilage explants. Mouse cartilage explants were subjected to compression (0.5 Hz, 1 MPa) for 2 to 24 hours. After determination of the amount of PGE2 released in the media (enzyme immunoassay), mRNA and proteins were extracted directly from the cartilage explants and analyzed by real-time RT-PCR and western blotting respectively. Mechanical compression of cartilage explants significantly increased PGE2 production in a time-dependent manner. This was not due to the synthesis of IL-1, since pretreatment with interleukin 1 receptor antagonist (IL1-Ra) did not alter the PGE2 synthesis. Interestingly, COX-2 and mPGES-1 mRNA expression significantly increased after 2 hours, in parallel with protein expression, whereas COX-3 and mPGES-2 mRNA expression was not modified. Moreover, we observed a delayed overexpression of 15-PGDH just before the decline of PGE2 synthesis after 18 hours, suggesting that PGE2 synthesis could be altered by the induction of 15-PGDH expression. We conclude that, along with COX-2, dynamic compression induces mPGES-1 mRNA and protein expression in cartilage explants. Thus, the mechanosensitive mPGES-1 enzyme represents a potential therapeutic target in osteoarthritis.
| S-EPMC1779392 | biostudies-literature
Project description:Recently, spectral methods have been extensively used in the processing of 3D meshes. They usually take advantage of some unique properties that the eigenvalues and the eigenvectors of the decomposed Laplacian matrix have. However, despite their superior behavior and performance, they suffer from computational complexity, especially while the number of vertices of the model increases. In this work, we suggest the use of a fast and efficient spectral processing approach applied to dense static and dynamic 3D meshes, which can be ideally suited for real-time denoising and compression applications. To increase the computational efficiency of the method, we exploit potential spectral coherence between adjacent parts of a mesh and then we apply an orthogonal iteration approach for the tracking of the graph Laplacian eigenspaces. Additionally, we present a dynamic version that automatically identifies the optimal subspace size that satisfies a given reconstruction quality threshold. In this way, we overcome the problem of the perceptual distortions, due to the fixed number of subspace sizes that is used for all the separated parts individually. Extensive simulations carried out using different 3D models in different use cases (i.e., compression and denoising), showed that the proposed approach is very fast, especially in comparison with the SVD based spectral processing approaches, while at the same time the quality of the reconstructed models is of similar or even better reconstruction quality. The experimental analysis also showed that the proposed approach could also be used by other denoising methods as a preprocessing step, in order to optimize the reconstruction quality of their results and decrease their computational complexity since they need fewer iterations to converge.
| S-EPMC8321066 | biostudies-literature