Morphology of fibroblasts grown on substrates formed by dielectrophoretically aligned carbon nanotubes.
Ontology highlight
ABSTRACT:
SUBMITTER: Yuen FL
PROVIDER: S-EPMC2151970 | biostudies-other | 2008 Jan
REPOSITORIES: biostudies-other
Similar Datasets
Project description:New three-dimensional (3D) porous electrode concepts are required to overcome limitations in Li-ion batteries in terms of morphology (e.g., shapes, dimensions), mechanical stability (e.g., flexibility, high electroactive mass loadings), and electrochemical performance (e.g., low volumetric energy densities and rate capabilities). Here a new electrode concept is introduced based on the direct growth of vertically-aligned carbon nanotubes (VA-CNTs) on embroidered Cu current collectors. The direct growth of VA-CNTs was achieved by plasma-enhanced chemical vapor deposition (PECVD), and there was no application of any post-treatment or cleaning procedure. The electrochemical behavior of the as-grown VA-CNTs was analyzed by charge/discharge cycles at different specific currents and with electrochemical impedance spectroscopy (EIS) measurements. The results were compared with values found in the literature. The as-grown VA-CNTs exhibit higher specific capacities than graphite and pristine VA-CNTs found in the literature. This together with the possibilities that the Cu embroidered structures offer in terms of specific surface area, total surface area, and designs provide a breakthrough in new 3D electrode concepts.
| S-EPMC5746928 | biostudies-literature
Project description:The patterning of arrays of aligned multi-walled carbon nanotubes (MWCNTs) allows creating metastructures for terahertz (THz) applications. Here, the strips and columns from MWCNTs vertically grown on silicon substrates are prepared using CO2 laser treatment. The tops of the patterned arrays are flat when the laser power is between 15 and 22 W, and craters appear there with increasing power. Laser treatment does not destroy the alignment of MWCNTs while removing their poorly ordered external layers. The products of oxidative destruction of these layers deposit on the surfaces of newly produced arrays. The oxygen groups resulting from the CO2 laser treatment improve the wettability of nanotube arrays with an epoxy resin. We show that the patterned MWCNT arrays absorb the THz radiation more strongly than the as-synthesized arrays. Moreover, the pattern influences the frequency behavior of the absorbance.
| S-EPMC8231912 | biostudies-literature
Project description:We report a high yield synthesis of single-wall boron nitride nanotubes (SWBNNTs) inside single-wall carbon nanotubes (SWCNTs), a nano-templated reaction, using ammonia borane complexes (ABC) as a precursor. Transmission electron microscope (TEM), high angle annular dark field (HAADF)-scanning TEM (STEM), electron energy loss spectra (EELS) and high resolution EELS mapping using aberration-corrected TEM system clearly show the formation of thin SWBNNTs inside SWCNTs. We have found that the yield of the SWBNNT formation is high and that the most of ABC molecules decompose and fuse to form the thin BNNTs at a temperature of 1,673 K having a narrow diameter distribution of 0.7 ± 0.1 nm. Optical absorption measurements suggest that the band gap of the thin SWBNNTs is about 6.0 eV, which provide the ideal insulator nanotubes with very small diameters.
| S-EPMC3587887 | biostudies-literature
Project description:To assess the effect of carbon nanotubes substrated on dendritic cell (DCs) properties, DCs were generated from human monocytes of healthy donors as previously described (Aldinucci A et al, 2010). In particular, isolated monocytes were cultured for 6 days in medium supplemented with GM-CSF (1000U/ml) and IL-4 (1000U/ml), in presence or absence of multi-walled carbon nanotubes (MWCNT); then DCs were activated by 24 hours of incubation with LPS (1ug/ml). RNA extracted from floating and CNT adherent DCs were then used for transcriptional profilingthen used
2015-04-01 | E-MEXP-3560 | biostudies-arrayexpress
Project description:While the rapidly evolving nanotechnology has shown promise in electronics, energy, healthcare and many other fields, there is an increasing concern about the adverse health consequences of engineered nanomaterials. To accurately evaluate the toxicity of nanomaterials, in vitro models incorporated with in vivo microenvironment characteristics are desirable. This study aims to delineate the influence of nanotopography on fibrogenic response of normal human lung fibroblasts to multi-walled carbon nanotubes (MWCNTs). Nanoscale gratings and pillars of various heights were fabricated on polydimethylsiloxane substrates. Cell spreading and biomechanics were measured, and fibrogenic responses including proliferation, collagen production and reactive oxygen species generation of the fibroblasts grown on the nanostructured substrates in response to MWCNTs were assessed. It was observed that the cells could be largely stretched on shallow nanogratings, leading to stiffer cytoskeleton and nucleus, enhanced cell proliferation and collagen production, and consequently, toxic response sensitivity of the fibroblasts was undermined. In contrast, the cell spreading and stiffness could be reduced using tall, isotropic nanopillars, which significantly improved the cell toxic sensitivity to the MWCNTs. In addition to highlighting the significant influence of cell-nanotopography interactions on cell sensing CNTs, this study contributed to development of physiologically relevant in vitro models for nanotoxicology study.
| S-EPMC5608452 | biostudies-literature
Project description:Near-field scanning optical microscopes are widely used in imaging of subwavelength features in various material systems and nanostructures. For a variety of applications, polarization-sensitive near-field probes can provide valuable information on the nature and symmetry of the imaged nanoparticles and emitters. Conventional near-field optical microscopy lacks in-plane polarization sensitivity. Here, we use aligned single-wall carbon nanotubes as polarization-sensitive molecular scale probes to image the transverse near-field components of an optical Hertzian dipole antenna. Because of the Raman "antenna effect" in carbon nanotubes, only the near-field components along the nanotube axis are detected. These findings demonstrate that aligned carbon nanotubes can be used as polarization-sensitive near-field detectors.
| S-EPMC2636739 | biostudies-literature
Project description:We report the one-step fabrication of aligned and high-quality carbon nanotubes (CNTs) using floating-catalyst chemical vapor deposition (FCCVD) with controlled fluidic properties assisted by a gas rectifier. The gas rectifier consists of one-dimensional straight channels for regulating the Reynolds number of the reaction gas. Our computational fluid dynamics simulation reveals that the narrow channels of the gas rectifier provide steady and accelerated laminar flow of the reaction gas. In addition, strong shear stress is induced near the side wall of the channels, resulting in the spontaneous formation of macroscopic CNT bundles aligned along the direction of the gas flow. After a wet-process using chlorosulfonic acid, the inter-tube voids inherently observed in as-grown CNT bundles are reduced from 16 to 0.3%. The resulting CNT fiber exhibits a tensile strength of 2.1 ± 0.1 N tex-1 with a Young's modulus of 39 ± 4 N tex-1 and an elongation of 6.3 ± 0.6%. FCCVD coupled with the strong shear stress of the reaction gas is an important pre-processing route for the fabrication of high-performance CNT fibers.
| S-EPMC8789815 | biostudies-literature
Project description:Grafting of fluorine species on carbon nanostructures has attracted interest due to the effective modification of physical and chemical properties of the starting materials. Various techniques have been employed to achieve a controlled fluorination yield; however, the effect of contaminants is rarely discussed, although they are often present. In the present work, the fluorination of vertically aligned multiwalled carbon nanotubes was performed using plasma treatment in a magnetron sputtering chamber with fluorine diluted in an argon atmosphere with an Ar/F2 ratio of 95:5. The effect of heavily diluted fluorine in the precursor gas mixture is investigated by evaluating the modifications in the nanotube structure and the electronic properties upon plasma treatment. The existence of oxygen-based grafted species is associated with background oxygen species present in the plasma chamber in addition to fluorine. The thermal stability and desorption process of the fluorine species grafted on the carbon nanotubes during the fluorine plasma treatment were evaluated by combining different spectroscopic techniques.
| S-EPMC4685895 | biostudies-literature
Project description:Recent studies reveal that carbon nanostructures show anomalous piezoelectric properties when the central symmetry of their structure is violated. Particular focus is given to carbon nanotubes (CNTs) with initial significant curvature of the graphene sheet surface, which leads to an asymmetric redistribution of the electron density. This paper presents the results of studies on the piezoelectric properties of aligned multi-walled CNTs. An original technique for evaluating the effective piezoelectric coefficient of CNTs is presented. For the first time, in this study, we investigate the influence of the growth temperature and thickness of the catalytic Ni layer on the value of the piezoelectric coefficient of CNTs. We establish the relationship between the effective piezoelectric coefficient of CNTs and their defectiveness and diameter, which determines the curvature of the graphene sheet surface. The calculated values of the effective piezoelectric coefficient of CNTs are shown to be between 0.019 and 0.413 C/m2, depending on the degree of their defectiveness and diameter.
| S-EPMC8617926 | biostudies-literature
Project description:Currently, there is a lack of ultrasensitive diagnostic tool to detect some diseases such as ischemic stroke, thereby impacting effective and efficient intervention for such diseases at an embryonic stage. In addition to the lack of proper detection of the neurological diseases, there is also a challenge in the treatment of these diseases. Carbon nanotubes have a potential to be employed in solving the theragnostic challenges in those diseases. In this study, carbon nanotubes were successfully synthesized for potential application in the detection and treatment of the neurological diseases such as ischemic stroke. Vertically aligned multiwalled carbon nanotubes (VA-MWCNTs) were purified with HCl, carboxylated with H2SO4:HNO3 (3:1) and acylated with SOCl2 for use in potential targeting studies and for the design of a carbon-based electrode for possible application in the diagnosis of neurological diseases, including ischemic stroke. MWCNTs were washed, extracted from the filter membranes and dried in a vacuum oven at 60 °C for 24 h prior to functionalization and PEGylation. CNTs were characterized by SEM, TEM, OCA, DLS, CV and EIS. The HCl-treated CNT obtained showed an internal diameter, outer diameter and thickness of 8 nm, 34 nm and 75 µm, while these parameters for the H2SO4-HNO3-treated CNT were 8 nm, 23 nm and 41µm, respectively. PEGylated CNT demonstrated zeta potential, polydispersive index and particle size distribution of 6 mV, 0.41 and 98 nm, respectively. VA-MWCNTs from quartz tube were successfully purified, carboxylated, acylated and PEGylated for potential functionalization for use in targeting studies. For designing the carbon-based electrode, VA-MWCNTs on silicon wafer were successfully incorporated into epoxy resin for diagnostic applications. Functionalized MWCNTs were nontoxic towards PC-12 neuronal cells. In conclusion, vertically super-aligned MWCNTs have been successfully synthesized and functionalized for possible theragnostic biomedical applications in neurological disorders such as ischemic stroke.
| S-EPMC7178230 | biostudies-literature