Contribution of the reverse endoprosthesis to glenohumeral kinematics.
Ontology highlight
ABSTRACT:
SUBMITTER: Bergmann JH
PROVIDER: S-EPMC2505217 | biostudies-other | 2008 Mar
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Scapula and humerus motion associated with common manual wheelchair tasks is hypothesized to reduce the subacromial space. However, previous work relied on either marker-based motion capture for kinematic measures, which is prone to skin-motion artifact; or ultrasound imaging for arthrokinematic measures, which are 2D and acquired in statically-held positions. The aim of this study was to use a fluoroscopy-based approach to accurately quantify glenohumeral kinematics during manual wheelchair use, and compare tasks for a subset of parameters theorized to be associated with mechanical impingement. Biplane images of the dominant shoulder were acquired during scapular plane elevation, propulsion, sideways lean, and weight-relief raise in ten manual wheelchair users with spinal cord injury. A computed tomography scan of the shoulder was obtained, and model-based tracking was used to quantify six-degree-of-freedom glenohumeral kinematics. Axial rotation and superior/inferior and anterior/posterior humeral head positions were characterized for full activity cycles and compared between tasks. The change in the subacromial space was also determined for the period of each task defined by maximal change in the aforementioned parameters. Propulsion, sideways lean, and weight-relief raise, but not scapular plane elevation, were marked by mean internal rotation (8.1°, 10.8°, 14.7°, -49.2° respectively). On average, the humeral head was most superiorly positioned during the weight-relief raise (1.6 ± 0.9 mm), but not significantly different from the sideways lean (0.8 ± 1.1 mm) (p = 0.191), and much of the task was characterized by inferior translation. Scaption was the only task without a defined period of superior translation on average. Pairwise comparisons revealed no significant differences between tasks for anterior/posterior position (task means range: 0.1-1.7 mm), but each task exhibited defined periods of anterior translation. There was not a consistent trend across tasks between internal rotation, superior translation, and anterior translation with reductions in the subacromial space. Further research is warranted to determine the likelihood of mechanical impingement during these tasks based on the measured task kinematics and reductions in the subacromial space.
| S-EPMC7036020 | biostudies-literature
Project description:In this study, we investigated the backward free flight of a dragonfly, accelerating in a flight path inclined to the horizontal. The wing and body kinematics were reconstructed from the output of three high-speed cameras using a template-based subdivision surface reconstruction method, and numerical simulations using an immersed boundary flow solver were conducted to compute the forces and visualize the flow features. During backward flight, the dragonfly maintained an upright body posture of approximately 90° relative to the horizon. The upright body posture was used to reorient the stroke plane and the flight force in the global frame; a mechanism known as 'force vectoring' which was previously observed in manoeuvres of other flying animals. In addition to force vectoring, we found that while flying backward, the dragonfly flaps its wings with larger angles of attack in the upstroke (US) when compared with forward flight. Also, the backward velocity of the body in the upright position enhances the wings' net velocity in the US. The combined effect of the angle of attack and wing net velocity yields large aerodynamic force generation in the US, with the average magnitude of the force reaching values as high as two to three times the body weight. Corresponding to these large forces was the presence of a strong leading edge vortex (LEV) at the onset of US which remained attached up until wing reversal. Finally, wing-wing interaction was found to enhance the aerodynamic performance of the hindwings (HW) during backward flight. Vorticity from the forewings' trailing edge fed directly into the HW LEV to increase its circulation and enhance force production.
| S-EPMC6030641 | biostudies-literature
Project description:The treatment of recurrent glenohumeral instability, especially with a concomitant bony lesion, remains challenging. This is especially true in the case of posterior instability given its less common incidence. Moreover, the presence of an engaging reverse Hill-Sachs lesion in combination with posterior instability will result in the need for a more aggressive treatment option. In comparison with a Hill-Sachs lesion, a reverse Hill-Sachs lesion features greater chondral deficiency that must be addressed during treatment. We propose the talus allograft as a potential allograft for treatment of an engaging reverse Hill-Sachs lesion. The superior articular surface of the talus may be used to reconstruct the articular surface of the humeral head. In this technical note, we describe our preferred primary technique for treatment of an engaging reverse Hill-Sachs lesion with recurrent glenohumeral instability through use of a fresh osteochondral talus allograft, as well as discuss the advantages and disadvantages of this allograft option.
| S-EPMC5382574 | biostudies-literature
Project description:Chronic posterior glenohumeral joint instability can be a challenging clinical entity for patients and surgeons alike. In the setting of a posterior dislocation, a large anterior humeral impaction injury (reverse Hill-Sachs [HS]) may occur, leading to engagement of the humerus with the posterior glenoid bone, especially during internal rotation of the joint. A reverse HS is especially debilitating because of the significant portion of affected humeral head cartilage, and is made worse in the setting of ligamentous disruption such as a posterior humeral avulsion of the glenohumeral ligament (HAGL) lesions. Although several nonanatomic procedures to address these defects have been previously described, recent interest in anatomic reconstructions capable of restoring the cartilage surface of the humeral head has led to the use of bone grafts (autografts and allografts) to restore the articular contour of the humeral head in conjunction with anatomic repair of associated soft tissue injuries. We present our preferred technique for an anatomic repair of a posterior HAGL lesion in combination with reconstruction of an engaging reverse HS lesion using an unmatched hemitalar allograft.
| S-EPMC5621160 | biostudies-literature
Project description:PurposeTo report mid- to long-term clinical and radiological outcomes after microfracturing for symptomatic chondral defects of the glenohumeral joint.MethodsAll patients who underwent glenohumeral arthroscopic microfracturing between 2002 and 2012 at a single center were considered for inclusion in this retrospective study. Clinical outcome was evaluated using the Constant Score, Oxford Shoulder Score, and Subjective Shoulder Value. Progression of joint space narrowing, sclerosis, marginal osteophytes, and presence of cysts over time were assessed using 4 different radiological grading systems.ResultsA total of 16 patients (n = 9 female, n = 7 male) with a mean age of 51.8 ± 12.6 years at the time of surgery and a mean follow-up of 122 ± 51.2 months (range, 61-204 months) were included in this retrospective study. Nine patients (56.3%) showed an isolated chondral defect, while 7 patients (43.8%) had concomitant pathologies. Constant Score (60.3 ± 12.7 vs. 85.9 ± 9.3; P < .001), Oxford Shoulder Score (29.0 ± 5.8 vs. 42.4 ± 4.5; P < .001), and Subjective Shoulder Value (23.9 ± 7.4 vs. 84.3 ± 10.9; P < .001) changed significantly from pre- to postoperative. The majority of patients (88%) were able to return to their preoperative level of activity. Three patients (19.8%) developed radiological signs of progressive glenohumeral degeneration during the study period. However, only 1 patient (6.25%) showed a progression of arthritic changes of more than 1 grade according to radiographic classifications. Two patients (12.5%) underwent revision surgery to a hemi shoulder arthroplasty during the study period at 12 and 36 months after the initial procedure.ConclusionsGlenohumeral microfracturing is commonly performed together with other procedures, but seems to be a feasible treatment option for contained cartilage lesions in active patients reproducibly yielding good mid- to long-term outcome.Level of evidenceLevel IV, therapeutic case series.
| S-EPMC7451850 | biostudies-literature
Project description:Objective: Shoulder pain after spinal cord injury (SCI) is attributed to increased mobility demands on the arms and negatively impacts independence and quality of life. Repetitive superior and posterior shoulder joint forces produced during traditional wheelchair (WC) locomotion can result in subacromial impingement if unopposed, as with muscular fatigue or weakness. ROWHEELS® (RW), geared rear wheels that produce forward WC movement with backward rim pulling, could alter these forces. Design: Cross sectional. Setting: Research laboratory at a rehabilitation hospital. Participants: Ten manual WC users with paraplegia. Outcome measures: Propulsion characteristics and right upper extremity/trunk kinematics and shoulder muscle activity were collected during ergometer propulsion: (1) self-selected free speed reverse propulsion with RW, (2) matched-speed reverse (rSW), and (3) forward propulsion (fSW) with instrumented Smartwheels (SW). Inverse dynamics using right-side SW rim kinetics and kinematics compared shoulder kinetics during rSW and fSW. Results: Free propulsion velocity, cycle distance and cadence were similar during RW, rSW and fSW. Overall shoulder motion was similar except that peak shoulder extension was significantly reduced in both RW and rSW versus fSW. Anteriorly and inferiorly directed SW rim forces were decreased during rSW versus fSW propulsion, but posteriorly and superiorly directed rim forces were significantly greater. Superior and posterior shoulder joint forces and flexor, adductor, and external rotation moments were significantly less during rSW, without a significant difference in net shoulder forces and moments. Traditional propulsive-phase muscle activity was significantly reduced and recovery-phase muscle activity was increased during reverse propulsion. Conclusion: These results suggest that reverse propulsion may redirect shoulder demands and prevent subacromial impingement, thereby preventing injury and preserving independent mobility for individuals with paraplegia.
| S-EPMC7534316 | biostudies-literature
Project description:BackgroundWe assessed the contribution of reverse shoulder arthroplasty to overall utilization of primary shoulder arthroplasty and present age- and sex-stratified national rates of shoulder arthroplasty. We also assessed contemporary complication rates, mortality rates, and indications for shoulder arthroplasty, as well as estimates and indications for revision arthroplasty.MethodsWe used the Nationwide Inpatient Samples for 2009 through 2011 to calculate estimates of shoulder arthroplasty and assessed trends using Joinpoint (National Cancer Institute, Bethesda, MD) regression.ResultsThe cumulative estimated utilization of primary shoulder arthroplasty (anatomic total shoulder arthroplasty, hemiarthroplasty, and reverse shoulder arthroplasty) increased significantly from 52,397 procedures (95% confidence interval [CI], 47,093-57,701) in 2009 to 67,184 cases (95% CI, 60,638-73,731) in 2011. Reverse shoulder arthroplasty accounted for 42% of all primary shoulder arthroplasty procedures in 2011. The concomitant diagnosis of osteoarthritis and rotator cuff impairment was found in only 29.8% of reverse shoulder arthroplasty cases. The highest rate of reverse shoulder arthroplasty was in the 75- to 84-year-old female subgroup (77 per 100,000 persons; 95% CI, 67-87). Revision cases comprised 8.8% and 8.2% of all shoulder arthroplasties in 2009 and 2011, respectively, and 35% of revision cases were because of mechanical complications/loosening whereas 18% were because of dislocation.ConclusionsThe utilization of primary shoulder arthroplasty significantly increased in just a 3-year time span, with a major contribution from reverse shoulder arthroplasty in 2011. Indications appear to have expanded because a large percentage of patients did not have rotator cuff pathology. The burden from revision arthroplasties was also substantial, and efforts to optimize outcomes and longevity of primary shoulder arthroplasty are needed.
| S-EPMC4252758 | biostudies-literature
Project description:PurposeThe purpose of this study was to clarify rotational relationships between the anatomical landmarks of the glenohumeral joint in maximum elevation.MethodsTwenty-five healthy volunteers (20 men, 5 women; mean age, 31 years) held the arm in maximum elevation in an open MRI system. In each three-dimensionally computer-generated image, elevation angle of the humerus in the plane of elevation was measured, based on the glenoid and the scapular planes. Using the equator set on the head surface by the plane parallel to the humeral axis, involving the head center and the bicipital groove, glenoid location and rotational relationships were investigated.ResultsThe elevation angle was 102° ± 9° in the plane 7° ± 8° anterior to the scapular plane, and axial rotation was fixed with the glenoidal long axis parallel to the equator (within 2°). Each glenoid center located on antero-superior portion of the humeral head, and the direction from the top of the head to its location was the same as that of the shaft tilting, indicating the glenoid only translated without rotation after reaching the top of the head on the equator.ConclusionsBefore reaching maximum elevation, the glenohumeral joint would be locked in axial rotation. The position when the glenoid is on the top of the humeral head with the humeral shaft perpendicular to the glenoid is considered to be essentially the final position of elevation, above which the glenohumeral joint only translates without axial rotation even if the humerus is more elevated.
| S-EPMC4171591 | biostudies-literature
Project description:Sports-related shoulder pain and injuries represent a common problem. In this context, glenohumeral instability is currently believed to play a central role either as a recognized or as an unrecognized condition. Shoulder instabilities can roughly be divided into traumatic, atraumatic, and microtraumatic glenohumeral instabilities. In athletes, atraumatic and microtraumatic instabilities can lead to secondary impingement syndromes and chronic damage to intraarticular structures. Magnetic resonance (MR) arthrography is superior to conventional MR imaging in the diagnosis of labro-ligamentous injuries, intrinsic impingement, and SLAP (superior labral anteroposterior) lesions, and thus represents the most informative imaging modality in the overall assessment of glenohumeral instability. This article reviews the imaging criteria for the detection and classification of instability-related injuries in athletes with special emphasis on the influence of MR findings on therapeutic decisions.
| S-EPMC1705542 | biostudies-other
Project description:Glenohumeral arthrodesis is an end-stage salvage operation that has traditionally been performed in an open fashion. In recent years an arthroscopic approach has been described. The purpose of this report was to present an arthroscopic glenohumeral arthrodesis technique with the assistance of O-arm-based navigation. An illustrative case example is presented. This technique allows not only a minimally invasive glenohumeral arthrodesis but also precise screw fixation by navigation, which may be particularly useful in cases of limited bone stock and/or bony deformity.
| S-EPMC4044498 | biostudies-literature