Characterization of individual airborne particles in Taiyuan City, China.
Ontology highlight
ABSTRACT:
SUBMITTER: Xie RK
PROVIDER: S-EPMC2770128 | biostudies-other | 2009 Sep
REPOSITORIES: biostudies-other
Similar Datasets
Project description:A pilot study was undertaken to characterize the concentration, duration and particle size distribution of the talc cloud that forms in the personal breathing zone (PBZ) during application of certain talc-containing cosmetics. Multiple direct-reading instruments were employed to simultaneously monitor PM4 concentrations (particulate matter with aerodynamic diameter < 4 µm; mg/m3) at different distances from each of three subjects while they applied talc products. Results indicated that the purpose and method of applying the talc product, combined with behavioral and physical differences amongst subjects, all strongly influenced airborne talc concentrations and the duration of the cloud. Air concentrations of talc in the PBZ averaged around 1.0 mg/m3, and the duration of exposure varied from less than one minute to more than ten minutes. The real-time monitors captured the occasional formation of secondary clouds, likely caused by resuspension of talc particles from skin or other surfaces. Measurements of aerosolized baby powder, face powder, and two adult body powders indicated that the median aerodynamic diameter of the talc cloud ranged from 1.7 to 2.0 µm. These direct-reading approaches were valuable for providing detailed characterization of short duration exposures to airborne talc particles, and will be useful to support future exposure assessments of talc and other powders in consumer products.
| S-EPMC6843753 | biostudies-literature
Project description:BackgroundCoronavirus disease 2019 (COVID-19) is an emerging infectious disease, which has caused numerous deaths and health problems worldwide. This study aims to examine the effects of airborne particulate matter (PM) pollution and population mobility on COVID-19 across China.MethodsWe obtained daily confirmed cases of COVID-19, air particulate matter (PM2.5, PM10), weather parameters such as ambient temperature (AT) and absolute humidity (AH), and population mobility scale index (MSI) in 63 cities of China on a daily basis (excluding Wuhan) from January 01 to March 02, 2020. Then, the Generalized additive models (GAM) with a quasi-Poisson distribution were fitted to estimate the effects of PM10, PM2.5 and MSI on daily confirmed COVID-19 cases.ResultsWe found each 1 unit increase in daily MSI was significantly positively associated with daily confirmed cases of COVID-19 in all lag days and the strongest estimated RR (1.21, 95% CIs:1.14 ~ 1.28) was observed at lag 014. In PM analysis, we found each 10 μg/m3 increase in the concentration of PM10 and PM2.5 was positively associated with the confirmed cases of COVID-19, and the estimated strongest RRs (both at lag 7) were 1.05 (95% CIs: 1.04, 1.07) and 1.06 (95% CIs: 1.04, 1.07), respectively. A similar trend was also found in all cumulative lag periods (from lag 01 to lag 014). The strongest effects for both PM10 and PM2.5 were at lag 014, and the RRs of each 10 μg/m3 increase were 1.18 (95% CIs:1.14, 1.22) and 1.23 (95% CIs:1.18, 1.29), respectively.ConclusionsPopulation mobility and airborne particulate matter may be associated with an increased risk of COVID-19 transmission.
| S-EPMC7576551 | biostudies-literature
Project description:More than 7 thousand wildfires were recorded over Mexico in 2019, affecting almost 640 thousand hectares. Most of these fires occurred during the spring season generating dense smoke plumes, impacting urban areas in the central part of the Mexican plateau. From May 10 to 17, 2019, biomass burning (BB) plumes affected Mexico City (MC) and diffused across the basin, producing PM2.5 levels ~ 2 times higher than the nation's air quality standards. Average PM2.5 concentrations increased sharply from 29.4 ± 7.2 µg m-3 to 65.1 ± 13.6 µg m-3 when the dense smoke plumes were detected. The higher particle concentration impacted the aerosol optical depth (AOD) as values ~ 3 times greater than the annual mean (0.32 ± 0.12) were measured, which resulted in a 17% loss of global horizontal irradiation (GHI). Under these severe pollution conditions, the visibility (Va) was reduced by ~ 80%. The high incidence of strong absorbent particles, such as soot and tarballs was revealed through electron microscopy and X-ray fluorescence (XRF) analysis. These techniques show chemical similarities between MC aerosols and those from the high-altitude (~ 4010 m. a. g. l.) Altzomoni Atmospheric Observatory, evidencing a strong influence of the BB emissions, suggesting a regional transport of these pollutants.
| S-EPMC8602652 | biostudies-literature
Project description:In 2012 air pollutants were responsible of seven million human death worldwide, and among them particulate matter with an aerodynamic diameter of 2.5 micrometers or less (PM2.5) are the most hazardous because they are small enough to invade even the smallest airways and penetrate to the lungs. During the last decade the size, shape, composition, sources and effect of these particles on human health have been studied. However, the noxiousness of these particles not only relies on their chemical toxicity, but particle morphology and mechanical properties affect their thermodynamic behavior, which has notable impact on their biological activity. Therefore, correlating the physical, mechanical and chemical properties of PM2.5 airborne pollutants should be the first step to characterize their interaction with other bodies but, unfortunately, such analysis has never been reported before. In this work, we present the first nanomechanical characterization of the most abundant and universal groups of PM2.5 airborne pollutants and, by means of atomic force microscope (AFM) combined with other characterization tools, we observe that fluffy soot aggregates are the most sticky and unstable. Our experiments demonstrate that such particles show strong adhesiveness and aggregation, leading to a more diverse composition and compiling all possible toxic chemicals.
| S-EPMC4503936 | biostudies-literature
Project description:The intensive use of pesticides such as herbicides, insecticides, fungicides and acaricides has been lead to ubiquitous contamination, being present not only in soils, water bodies and/or crops, but also in the atmosphere. Considering the massive amount of pesticides employed globally, together to their persistence, this may be an important concern regarding air quality and human health worldwide. In the present study we developed a green sensitive sample preparation method for determination of nine organophosphates, two pyrethroids, one carbamate, and one strobirulin in PM2.5 collected in a tropical coastal area in the Southern Hemisphere for the first time. Extraction of PM2.5 sample masses, as low as 206 µg, were performed in a miniaturized device using 500 μL of a mixture containing 18% acetonitrile in dichloromethane followed by sonication for 23 minutes and injection into GC-MS. A total of 12 pesticides were identified and quantified successfully, among them, eight banned pesticides. A risk assessment exposure and cancer risk for possible carcinogenic pesticides (bifenthrin, malathion, parathion and permethrin) were performed for exposure of adults, children and infants. Hazard Quotient and cumulative exposure for organophosphate and pyrethroid pesticides were less than 1, showing that cumulative risk is within acceptable range.
| S-EPMC5442112 | biostudies-literature
Project description:Medical procedures that produce aerosolized particles are under great scrutiny due to the recent concerns surrounding the COVID-19 virus and increased risk for nosocomial infections. For example, thoracostomies, tracheotomies and intubations/extubations produce aerosols that can linger in the air. The lingering time is dependent on particle size where, e.g., 500 μm (0.5 mm) particles may quickly fall to the floor, while 1 μm particles may float for extended lengths of time. Here, a method is presented to characterize the size of <40 μm to >600 μm particles resulting from surgery in an operating room (OR). The particles are measured in-situ (next to a patient on an operating table) through a 75mm aperture in a ∼400 mm rectangular enclosure with minimal flow restriction. The particles and gasses exiting a patient are vented through an enclosed laser sheet while a camera captures images of the side-scattered light from the entrained particles. A similar optical configuration was described by Anfinrud et al.; however, we present here an extended method which provides a calibration method for determining particle size. The use of a laser sheet with side-scattered light provides a large FOV and bright image of the particles; however, the particle image dilation caused by scattering does not allow direct measurement of particle size. The calibration routine presented here is accomplished by measuring fixed particle distribution ranges with a calibrated shadow imaging system and mapping these measurements to the in-situ imaging system. The technique used for generating and measuring these particles is described. The result is a three-part process where 1) particles of varying sizes are produced and measured using a calibrated, high-resolution shadow imaging method, 2) the same particle generators are measured with the in-situ imaging system, and 3) a correlation mapping is made between the (dilated) laser image size and the measured particle size. Additionally, experimental and operational details of the imaging system are described such as requirements for the enclosure volume, light management, air filtration and control of various laser reflections. Details related to the OR environment and requirements for achieving close proximity to a patient are discussed as well.
| S-EPMC8021156 | biostudies-literature
Project description:Airborne particles have been associated with a range of adverse cardiopulmonary outcomes, which has driven its monitoring at stationary central sites throughout the world. Individual exposures, however, can differ substantially from concentrations measured at central sites due to spatial variability across a region and sources unique to the individual, such as cooking or cleaning in homes, traffic emissions during commutes, and widely varying sources encountered at work. Personal monitoring with small, battery-powered instruments enables the measurement of an individual's exposure as they go about their daily activities. Personal monitoring can substantially reduce exposure misclassification and improve the power to detect relationships between particulate pollution and adverse health outcomes. By partitioning exposures to known locations and sources, it may be possible to account for variable toxicity of different sources. This review outlines recent advances in the field of personal exposure assessment for particulate pollution. Advances in battery technology have improved the feasibility of 24-h monitoring, providing the ability to more completely attribute exposures to microenvironment (e.g., work, home, commute). New metrics to evaluate the relationship between particulate matter and health are also being considered, including particle number concentration, particle composition measures, and particle oxidative load. Such metrics provide opportunities to develop more precise associations between airborne particles and health and may provide opportunities for more effective regulations.
| S-EPMC4807653 | biostudies-literature
Project description:Understanding the carbon flux of forests is critical for constraining the global carbon cycle and managing forests to mitigate climate change. Monitoring forest growth and mortality rates is critical to this effort, but has been limited in the past, with estimates relying primarily on field surveys. Advances in remote sensing enable the potential to monitor tree growth and mortality across landscapes. This work presents an approach to measure tree growth and loss using multidate lidar campaigns in a high-biomass forest in California, USA. Individual tree crowns were delineated in 2008 and again in 2013 using a 3D crown segmentation algorithm, with derived heights and crown radii extracted and used to estimate individual tree aboveground biomass. Tree growth, loss, and aboveground biomass were analyzed with respect to tree height and crown radius. Both tree growth and loss rates decrease with increasing tree height, following the expectation that trees slow in growth rate as they age. Additionally, our aboveground biomass analysis suggests that, while the system is a net source of aboveground carbon, these carbon dynamics are governed by size class with the largest sources coming from the loss of a relatively small number of large individuals. This study demonstrates that monitoring individual tree-based growth and loss can be conducted with multidate airborne lidar, but these methods remain relatively immature. Disparities between lidar acquisitions were particularly difficult to overcome and decreased the sample of trees analyzed for growth rate in this study to 21% of the full number of delineated crowns. However, this study illuminates the potential of airborne remote sensing for ecologically meaningful forest monitoring at an individual tree level. As methods continue to improve, airborne multidate lidar will enable a richer understanding of the drivers of tree growth, loss, and aboveground carbon flux.
| S-EPMC5980410 | biostudies-literature
Project description:Patients with influenza release aerosol particles containing the virus into their environment. However, the importance of airborne transmission in the spread of influenza is unclear, in part because of a lack of information about the infectivity of the airborne virus. The purpose of this study was to determine the amount of viable influenza A virus that was expelled by patients in aerosol particles while coughing. Sixty-four symptomatic adult volunteer outpatients were asked to cough 6 times into a cough aerosol collection system. Seventeen of these participants tested positive for influenza A virus by viral plaque assay (VPA) with confirmation by viral replication assay (VRA). Viable influenza A virus was detected in the cough aerosol particles from 7 of these 17 test subjects (41%). Viable influenza A virus was found in the smallest particle size fraction (0.3 μm to 8 μm), with a mean of 142 plaque-forming units (SD 215) expelled during the 6 coughs in particles of this size. These results suggest that a significant proportion of patients with influenza A release small airborne particles containing viable virus into the environment. Although the amounts of influenza A detected in cough aerosol particles during our experiments were relatively low, larger quantities could be expelled by influenza patients during a pandemic when illnesses would be more severe. Our findings support the idea that airborne infectious particles could play an important role in the spread of influenza.
| S-EPMC4734406 | biostudies-literature
Project description:Airborne fungal community in Tianjin, China Raw sequence reads
| PRJNA694361 | ENA