Determination of nitrogen dioxide, sulfur dioxide, ozone, and ammonia in ambient air using the passive sampling method associated with ion chromatographic and potentiometric analyses.
Ontology highlight
ABSTRACT:
SUBMITTER: Salem AA
PROVIDER: S-EPMC2770132 | biostudies-other | 2009 Sep
REPOSITORIES: biostudies-other
Similar Datasets
Project description: Not available
| S-EPMC11343771 | biostudies-literature
Project description:Stable, bioreactive, radicals known as environmentally persistent free radicals (EPFRs) have been found to exist on the surface of airborne PM2.5. These EPFRs have been found to form during many combustion processes, are present in vehicular exhaust, and persist in the environment for weeks and biological systems for up to 12 h. To measure EPFRs in PM samples, high volume samplers are required and measurements are less representative of community exposure; therefore, we developed a novel spatial phytosampling methodology to study the spatial patterns of EPFR concentrations using plants. Leaf samples for laboratory PM analysis were collected from 188 randomly drawn sampling sites within a 500-m buffer zone of pollution sources across a sampling grid measuring 32.9 × 28.4 km in Memphis, Tennessee. PM was isolated from the intact leaves and size fractionated, and EPFRs on PM quantified by electron paramagnetic resonance spectroscopy. The radical concentration was found to positively correlate with the EPFR g-value, thus indicating cumulative content of oxygen centered radicals in PM with higher EPFR load. Our spatial phytosampling approach reveals spatial variations and potential "hotspots" risk due to EPFR exposure across Memphis and provides valuable insights for identifying exposure and demographic differences for health studies.
| S-EPMC5792061 | biostudies-literature
Project description:The gaseous fraction of hydrophobic organic contaminants (HOCs) in ambient air appears to be responsible for a significant portion of aryl hydrocarbon receptor (AhR)-mediated activity, but the majority of compounds contributing to this activity remain unidentified. The present study investigated the use of polyethylene passive samplers to isolate gaseous HOCs from ambient air for use in in vitro bioassays and to improve our understanding of the toxicological relevance of the gaseous fraction of ambient air in urban and residential environments. Concentrations of polycyclic aromatic hydrocarbons (PAHs) and organic flame retardants were measured in polyethylene passive sampler extracts. Extracts were also analyzed using an in vitro bioassay to measure AhR-mediated activity. Bioassay-derived benzo[a]pyrene (BaP) equivalents (BaP-Eqbio ), a measure of potency of HOC mixtures, were greatest in the downtown Cleveland area and lowest at rural/residential sites further from the city center. The BaP-Eqbio was weakly correlated with concentrations of 2-ring alkyl/substituted PAHs and one organophosphate flame retardant, ethylhexyl diphenyl phosphate. Potency predicted based on literature-derived induction equivalency factors (IEFs) explained only 2 to 23% of the AhR-mediated potency observed in bioassay experiments. Our results suggests that health risks of gaseous ambient air pollution predicted using data from targeted chemical analysis may underestimate risks of exposure, most likely due to augmentation of potency by unmonitored chemicals in the mixture, and the lack of relevant IEFs for many targeted analytes. Environ Toxicol Chem 2019;38:748-759. © 2019 SETAC.
| S-EPMC6467651 | biostudies-literature
Project description:Passive air samplers (PAS) including polyurethane foam (PUF) are widely deployed as an inexpensive and practical way to sample semivolatile pollutants. However, concentration estimates from PAS rely on constant empirical mass transfer rates, which add unquantified uncertainties to concentrations. Here we present a method for modeling hourly sampling rates for semivolatile compounds from hourly meteorology using first-principle chemistry, physics, and fluid dynamics, calibrated from depuration experiments. This approach quantifies and explains observed effects of meteorology on variability in compound-specific sampling rates and analyte concentrations, simulates nonlinear PUF uptake, and recovers synthetic hourly concentrations at a reference temperature. Sampling rates are evaluated for polychlorinated biphenyl congeners at a network of Harner model samplers in Chicago, IL, during 2008, finding simulated average sampling rates within analytical uncertainty of those determined from loss of depuration compounds and confirming quasilinear uptake. Results indicate hourly, daily, and interannual variability in sampling rates, sensitivity to temporal resolution in meteorology, and predictable volatility-based relationships between congeners. We quantify the importance of each simulated process to sampling rates and mass transfer and assess uncertainty contributed by advection, molecular diffusion, volatilization, and flow regime within the PAS, finding that PAS chamber temperature contributes the greatest variability to total process uncertainty (7.3%).
| S-EPMC3764502 | biostudies-literature
Project description:Evidence concerning the association between ambient gaseous air pollutant exposures and semen quality is sparse, and findings in previous studies remain largely inconsistent. We enrolled 1759 men and performed 2184 semen examinations at a large reproductive medical center in Wuhan, China, between 2013 and 2015. Inverse distance weighting interpolation was performed to estimate individual exposures to SO2, NO2, CO, and O3 during the entire period (lag 0-90 days) and key periods (lag 0-9, 10-14, 70-90 days) of sperm development. Linear mixed models were used to analyze exposure-response relationships. SO2 exposure with 0-90 days lag was significantly associated with monotonically decreased sperm concentration (β for each interquartile range increase of exposure: -0.14; 95% CI: -0.23, -0.05), sperm count (-0.21; -0.30, -0.12) and total motile sperm count (-0.16; -0.25, -0.08). Significant associations were observed for total and progressive motility only when SO2 exposure was at the highest quintile (all Ptrend < 0.05). Similar trends were observed for SO2 exposure with 70-90 days lag. NO2, CO, or O3 exposure was not significantly associated with semen quality. Our results suggest that ambient SO2 exposure adversely affects semen quality and highlight the potential to improve semen quality by reducing ambient SO2 exposure during early stages of sperm development.
| S-EPMC5822717 | biostudies-literature
Project description:There has been relatively little bioanalytical effect based monitoring conducted using samples derived from polyurethane foam (PUF) passive air samplers. Combining these techniques may provide a more convenient and cost effective means of monitoring the potential for biological effects resulting from exposure to complex mixtures in a range of scenarios. Seasonal polycyclic aromatic hydrocarbon (PAH) levels were monitored at sites around Australia using direct chemical analysis. In addition, both indirect acting genotoxicity (umuC assay) and aryl hydrocarbon receptor (AhR) activity (chemically activated fluorescent gene expression [CAFLUX assay]), which are effects potentially relevant to subsequent carcinogenesis for these compounds, were measured. The levels of PAHs as well as genotoxicity and AhR activity were all higher in winter compared to summer and for sites in urban capital cities compared to other locations. Statistically significant relationships were found between the levels of PAHs and both genotoxicity and AhR activity. The dominant contributors to the total AhR activity, were found to be for compounds which are not resistant to H(2)SO(4)/silica gel treatment and were relatively rapidly metabolised that is consistent with a PAH type response. Relative potency estimates for individual PAHs determined for the first time on the CAFLUX assay were used to estimate the proportion of total AhR activity (? 3.0%) accounted by PAHs monitored. Observed responses are thus largely due to non-quantified AhR active compounds.
| S-EPMC3087176 | biostudies-literature
Project description:The N≡N bond (225 kcal mol⁻¹) in dinitrogen is one of the strongest bonds in chemistry therefore artificial synthesis of ammonia under mild conditions is a significant challenge. Based on current knowledge, only bacteria and some plants can synthesise ammonia from air and water at ambient temperature and pressure. Here, for the first time, we report artificial ammonia synthesis bypassing N₂ separation and H₂ production stages. A maximum ammonia production rate of 1.14 × 10⁻⁵ mol m⁻² s⁻¹ has been achieved when a voltage of 1.6 V was applied. Potentially this can provide an alternative route for the mass production of the basic chemical ammonia under mild conditions. Considering climate change and the depletion of fossil fuels used for synthesis of ammonia by conventional methods, this is a renewable and sustainable chemical synthesis process for future.
| S-EPMC3557446 | biostudies-literature
Project description:A wide range of semivolatile organic compounds (SOCs), including pesticides and polycyclic aromatic hydrocarbons (PAHs), were measured in lichen, conifer needles, snowpack and XAD-based passive air sampling devices (PASDs) collected from 19 different U.S. national parks in order to compare the magnitude and mechanism of SOC accumulation in the different passive sampling media. Lichen accumulated the highest SOC concentrations, in part because of its long (and unknown) exposure period, whereas PASDs accumulated the lowest concentrations. However, only the PASD SOC concentrations can be used to calculate an average atmospheric gas-phase SOC concentration because the sampling rates are known and the media is uniform. Only the lichen and snowpack SOC accumulation profiles were statistically significantly correlated (r = 0.552, p-value <0.0001) because they both accumulate SOCs present in the atmospheric particle-phase. This suggests that needles and PASDs represent a different composition of the atmosphere than lichen and snowpack and that the interpretation of atmospheric SOC composition is dependent on the type of passive sampling media used. All four passive sampling media preferentially accumulated SOCs with relatively low air-water partition coefficients, while snowpack accumulated SOCs with higher log K(OA) values compared to the other media. Lichen accumulated more SOCs with log K(OA) > 10 relative to needles and showed a greater accumulation of particle-phase PAHs.
| S-EPMC3245801 | biostudies-other
Project description:The outbreak of coronavirus named COVID-19, initially identified in Wuhan, China in December 2019, has spread rapidly at the global scale. Most countries have rapidly stopped almost all activities including industry, services and transportation of goods and people, thus decreasing air pollution in an unprecedented way, and providing a unique opportunity to study air pollutants. While satellite data have provided visual evidence for the global reduction in air pollution such as nitrogen dioxide (NO2) worldwide, precise and quantitative information is missing at the local scale. Here we studied changes in particulate matter (PM2.5, PM10), carbon monoxide (CO), NO2, sulfur dioxide (SO2) and ozone (O3) at 10 urban sites in Hangzhou, a city of 7.03 million inhabitants, and at 1 rural site, before city lockdown, January 1-23, during city lockdown, January 24-February 15, and during resumption, February 16-28, in 2020. Results show that city lockdown induced a sharp decrease in PM2.5, PM10, CO, and NO2 concentrations at both urban and rural sites. The NO2 decrease is explained by reduction in traffic emissions in the urban areas, and by lower regional transport in rural areas during lockdown, as expected. SO2 concentrations decreased from 6.3 to 5.3 ?g m-3 in the city, but increased surprisingly from 4.7 to 5.8 ?g m-3 at the rural site: this increase is attributed both to higher coal consumption for heating and emissions from traditional fireworks of the Spring Eve and Lantern Festivals during lockdown. Unexpectedly, O3 concentrations increased by 145% from 24.6 to 60.6 ?g m-3 in the urban area, and from 42.0 to 62.9 ?g m-3 in the rural area during the lockdown. This finding is explained by the weakening of chemical titration of O3 by NO due to reductions of NOx fresh emissions during the non-photochemical reaction period from 20:00 PM to 9:00 AM (local time). During the lockdown, compared to the same period in 2019, the daily average concentrations in the city decreased by 42.7% for PM2.5, 47.9% for PM10, 28.6% for SO2, 22.3% for CO and 58.4% for NO2, which is obviously explained by the absence of city activities. Overall, we observed not only the expected reduction in some atmospheric pollutants (PM, SO2, CO, NO2), but also unexpected increases in SO2 in the rural areas and of ozone (O3) in both urban and rural areas, the latter being paradoxically due to the reduction in nitrogen oxide levels. In other words, the city lockdown has improved air quality by reducing PM2.5, PM10, CO, and NO2, but has also decreased air quality by augmenting O3 and SO2.
| S-EPMC7292245 | biostudies-literature
Project description:In this work, the cause of abnormal color in ammonium sulfate products formed by flue gas desulfurization is revealed by investigating the conversion relationship between different sulfur-containing ions and their behavior in a sulfuric acid medium. Both thiosulfate (S2O32-) and sulfite (SO32- ＆ HSO3-) impurities affect the quality of ammonium sulfate. The S2O32- is the main reason for the yellowing of the product due to the formation of sulfur impurities in concentrated sulfuric acid. To address the yellowing of ammonium sulfate products, a unified technology (US/O3), using ozone (O3) and ultrasonic waves (US) simultaneously, is exploited to remove both thiosulfate and sulfite impurities from the mother liquor. The effect of different reaction parameters on the degree of removal of thiosulfate and sulfite is investigated. The synergistic effect of ultrasound and ozone on ion oxidation is further explored and demonstrated by the comparative experiments with O3 and US/O3. Under the optimized conditions, the thiosulfate and sulfite concentration in the solution is 2.07 and 5.93 g/L, respectively, and the degree of removal is 91.39 and 90.83%, respectively. The product obtained after evaporation and crystallization is pure white and meets the national standard requirements for ammonium sulfate products. Under the same conditions, the US/O3 process has apparent advantages, such as saving reaction time compared with the O3 process alone. Introducing an ultrasonically intensified field improves the generation of oxidation radicals ·OH, 1O2, and ·O2- in the solution. Furthermore, the effectiveness of different oxidation components in the decolorization process is studied by adding other radical shielding agents using the US/O3 process supplemented with EPR analysis. The order of the different oxidation components is O3(86.04%) > 1O2(6.53%) > •OH(4.45%) > •O2-(2.97%) for the oxidation of thiosulfate, and it is O3(86.28%) > •OH(7.49%) > 1O2(4.99%) > •O2-(1.25%) for the oxidation of sulfite.
| S-EPMC10457592 | biostudies-literature