Nanoparticle image velocimetry at topologically structured surfaces.
Ontology highlight
ABSTRACT:
SUBMITTER: Parikesit GO
PROVIDER: S-EPMC2835291 | biostudies-other | 2009
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Highly reflective surfaces are notorious in the field of depth sensing and three-dimensional (3D) imaging because they can cause severe errors in perception of the depth. Despite recent progress in addressing this challenge, there are still no robust and error-free solutions. Here, we devise a polarization structured light 3D sensor for solving these problems, in which high-contrast-grating (HCG) vertical-cavity surface-emitting lasers (VCSELs) are used to exploit the polarization property. We demonstrate accurate depth measurements of the reflective surfaces and objects behind them in various imaging situations. In addition, the absolute error and effective measurement range are measured to prove the applicability for a wide range of 3D applications. Our work innovatively combines polarization and depth information, opening the way for fully understanding and applying polarization properties in the 3D domain.
| S-EPMC10611810 | biostudies-literature
Project description:The manipulation of fluids in micro/nanofabricated systems opens new avenues to engineer the transport of matter at the molecular level. Yet the number of methods for the in situ characterization of fluid flows in shallow channels is limited. Here we establish a simple method called nanoparticle velocimetry distribution analysis (NVDA) that relies on wide field microscopy to measure the flow rate and channel height based on the fitting of particle velocity distributions along and across the flow direction. NVDA is validated by simulations, showing errors in velocity and height determination of less than 1% and 8% respectively, as well as with experiments, in which we monitor the behavior of 200 nm nanoparticles conveyed in channels of ~1.8 μm in height. We then show the relevance of this assay for the characterization of flows in bulging channels, and prove its suitability to characterize the concentration of particles across the channel height in the context of visco-elastic focusing. Our method for rapid and quantitative flow characterization has therefore a broad spectrum of applications in micro/nanofluidics, and a strong potential for the optimization of Lab-on-Chips modules in which engineering of confined transport is necessary.
| S-EPMC4431396 | biostudies-literature
Project description:We demonstrate the viability of using four low-cost smartphone cameras to perform Tomographic PIV. We use colored shadows to imprint two or three different time-steps on the same image. The back-lighting is accomplished with three sets of differently-colored pulsed LEDs. Each set of Red, Green & Blue LEDs is shone on a diffuser screen facing each of the cameras. We thereby record the RGB-colored shadows of opaque suspended particles, rather than the conventionally used scattered light. We subsequently separate the RGB color channels, to represent the separate times, with preprocessing to minimize noise and cross-talk. We use commercially available Tomo-PIV software for the calibration, 3-D particle reconstruction and particle-field correlations, to obtain all three velocity components in a volume. Acceleration estimations can be done thanks to the triple pulse illumination. Our test flow is a vortex ring produced by forcing flow through a circular orifice, using a flexible membrane, which is driven by a pressurized air pulse. Our system is compared to a commercial stereoscopic PIV system for error estimations. We believe this proof of concept experiment will make this technique available for education, industry and scientists for a fraction of the hardware cost needed for traditional Tomo-PIV.
| S-EPMC5473851 | biostudies-literature
Project description:Here, we introduce Streamline Image Velocimetry, a method to derive fluid velocity fields in fully developed laminar flow from long-exposure images of streamlines. Streamlines confine streamtubes, in which the volumetric flow is constant for incompressible fluid. Using an explicit analytical solution as a boundary condition, velocity fields and emerging properties such as shear force and pressure can be quantified throughout. Numerical and experimental validations show a high correlation between anticipated and measured results, with R(2) > 0.91. We report spatial resolution of 2 μm in a flow rate of 0.15 m/s, resolution that can only be achieved with 75 kHz frame rate in traditional particle tracking velocimetry.
| S-EPMC3751964 | biostudies-other
Project description:Zebrafish is emerging as a species of choice for the study of a number of biomechanics problems, including balance development, schooling, and neuromuscular transmission. The precise quantification of the flow physics around swimming zebrafish is critical toward a mechanistic understanding of the complex swimming style of this fresh-water species. Although previous studies have elucidated the vortical structures in the wake of zebrafish swimming in placid water, the flow physics of zebrafish swimming against a water current remains unexplored. In an effort to illuminate zebrafish swimming in a dynamic environment reminiscent of its natural habitat, we experimentally investigated the locomotion and hydrodynamics of a single zebrafish swimming in a miniature water tunnel using particle image velocimetry. Our results on zebrafish locomotion detail the role of flow speed on tail beat undulations, heading direction, and swimming speed. Our findings on zebrafish hydrodynamics offer a precise quantification of vortex shedding during zebrafish swimming and demonstrate that locomotory patterns play a central role on the flow physics. This knowledge may help clarify the evolutionary advantage of burst and cruise swimming movements in zebrafish.
| S-EPMC5691796 | biostudies-literature
Project description:We describe the development of an optical flow visualization method for resolving the flow velocity vector field in lymphatic vessels in vitro. The aim is to develop an experimental protocol for accurately estimating flow parameters, such as flow rate and shear stresses, with high spatial and temporal resolution. Previous studies in situ have relied on lymphocytes as tracers, but their low density resulted in a reduced spatial resolution whereas the assumption that the flow was fully developed in order to determine the flow parameters of interest may not be valid, especially in the vicinity of the valves, where the flow is undoubtedly more complex. To overcome these issues, we have applied the time-resolved microparticle image velocimetry (μ -PIV) technique, a well-established method that can provide increased spatial and temporal resolution that this transient flow demands. To that end, we have developed a custom light source, utilizing high-power light-emitting diodes, and associated control and image processing software. This paper reports the performance of the system and the results of a series of preliminary experiments performed on vessels isolated from rat mesenteries, demonstrating, for the first time, the successful application of the μ -PIV technique in these vessels.
| S-EPMC8357335 | biostudies-literature
Project description:Pore-scale oil displacement behavior was investigated in a porous media micromodel using microscopic particle image velocimetry (μPIV). Porous media micromodels consisting of an ordered square array of cylindrical pillars with 50 and 70% porosities were fabricated with photolithography. The oil displacement was performed with the injection of water at flow rates of 37.5, 75, and 150 μL/h. These flow rates correspond to Reynolds number of 1.1 × 10-2, 2.2 × 10-2, and 4.4 × 10-2, respectively in the 50% porous channel, and 1.84 × 10-3, 3.69 × 10-3, and 7.38 × 10-3, respectively in the 70% porous channel. The capillary numbers for these flow rates are 2.18 × 10-5, 4.36 × 10-5, and 8.72 × 10-5, respectively in the 50% porous channel, and 1.56 × 10-5, 3.12 × 10-5, and 6.23 × 10-5, respectively in the 70% porous channel. The micromodel is initially saturated with oil, with the invading water phase following the path of least resistance as it displaces the oil. The μPIV data were used to construct probability density functions (PDFs) which show an initial, nonzero, peak in transverse velocity as the water enters the micromodel. The PDFs broaden with time, indicating that the water is spreading, before retracting to a peak velocity of 0 mm/s, indicating that the water displacement has achieved equilibrium. We developed a model based on conservation of mass to describe the efficiency of the displacement process. All flow conditions demonstrate peak displacement efficiency when the amount of oil phase displacement is ∼9 pore volumes in 50% porous channel and ∼4 pore volumes in 70% porous channel.
| S-EPMC11308009 | biostudies-literature
Project description:BACKGROUND:Normal gut function requires rhythmic and coordinated movements that are affected by developmental processes, physical and chemical stimuli, and many debilitating diseases. The imaging and characterization of gut motility, especially regarding periodic, propagative contractions driving material transport, are therefore critical goals. Previous image analysis approaches have successfully extracted properties related to the temporal frequency of motility modes, but robust measures of contraction magnitude, especially from in vivo image data, remain challenging to obtain. METHODS:We developed a new image analysis method based on image velocimetry and spectral analysis that reveals temporal characteristics such as frequency and wave propagation speed, while also providing quantitative measures of the amplitude of gut motion. KEY RESULTS:We validate this approach using several challenges to larval zebrafish, imaged with differential interference contrast microscopy. Both acetylcholine exposure and feeding increase frequency and amplitude of motility. Larvae lacking enteric nervous system gut innervation show the same average motility frequency, but reduced and less variable amplitude compared to wild types. CONCLUSIONS & INFERENCES:Our image analysis approach enables insights into gut dynamics in a wide variety of developmental and physiological contexts and can also be extended to analyze other types of cell movements.
| S-EPMC6150784 | biostudies-literature
Project description:An experimental set-up is presented for the in vitro characterization of the fluid dynamics in personalized phantoms of healthy and stenosed coronary arteries. The proposed set-up was fine-tuned with the aim of obtaining a compact, flexible, low-cost test-bench for biomedical applications. Technically, velocity vector fields were measured adopting a so-called smart-PIV approach, consisting of a smartphone camera and a low-power continuous laser (30 mW). Experiments were conducted in realistic healthy and stenosed 3D-printed phantoms of left anterior descending coronary artery reconstructed from angiographic images. Time resolved image acquisition was made possible by the combination of the image acquisition frame rate of last generation commercial smartphones and the flow regimes characterizing coronary hemodynamics (velocities in the order of 10 cm/s). Different flow regimes (Reynolds numbers ranging from 20 to 200) were analyzed. The smart-PIV approach was able to provide both qualitative flow visualizations and quantitative results. A comparison between smart-PIV and conventional PIV (i.e., the gold-standard experimental technique for bioflows characterization) measurements showed a good agreement in the measured velocity vector fields for both the healthy and the stenosed coronary phantoms. Displacement errors and uncertainties, estimated by applying the particle disparity method, confirmed the soundness of the proposed smart-PIV approach, as their values fell within the same range for both smart and conventional PIV measured data (≈5% for the normalized estimated displacement error and below 1.2 pixels for displacement uncertainty). In conclusion, smart-PIV represents an easy-to-implement, low-cost methodology for obtaining an adequately robust experimental characterization of cardiovascular flows. The proposed approach, to be intended as a proof of concept, candidates to become an easy-to-handle test bench suitable for use also outside of research labs, e.g., for educational or industrial purposes, or as first-line investigation to direct and guide subsequent conventional PIV measurements.
| S-EPMC9772456 | biostudies-literature
Project description:BackgroundThe technical development of imaging techniques in life sciences has enabled the three-dimensional recording of living samples at increasing temporal resolutions. Dynamic 3D data sets of developing organisms allow for time-resolved quantitative analyses of morphogenetic changes in three dimensions, but require efficient and automatable analysis pipelines to tackle the resulting Terabytes of image data. Particle image velocimetry (PIV) is a robust and segmentation-free technique that is suitable for quantifying collective cellular migration on data sets with different labeling schemes. This paper presents the implementation of an efficient 3D PIV package using the Julia programming language-quickPIV. Our software is focused on optimizing CPU performance and ensuring the robustness of the PIV analyses on biological data.ResultsQuickPIV is three times faster than the Python implementation hosted in openPIV, both in 2D and 3D. Our software is also faster than the fastest 2D PIV package in openPIV, written in C++. The accuracy evaluation of our software on synthetic data agrees with the expected accuracies described in the literature. Additionally, by applying quickPIV to three data sets of the embryogenesis of Tribolium castaneum, we obtained vector fields that recapitulate the migration movements of gastrulation, both in nuclear and actin-labeled embryos. We show normalized squared error cross-correlation to be especially accurate in detecting translations in non-segmentable biological image data.ConclusionsThe presented software addresses the need for a fast and open-source 3D PIV package in biological research. Currently, quickPIV offers efficient 2D and 3D PIV analyses featuring zero-normalized and normalized squared error cross-correlations, sub-pixel/voxel approximation, and multi-pass. Post-processing options include filtering and averaging of the resulting vector fields, extraction of velocity, divergence and collectiveness maps, simulation of pseudo-trajectories, and unit conversion. In addition, our software includes functions to visualize the 3D vector fields in Paraview.
| S-EPMC8642913 | biostudies-literature