Evading surface and detector frequency noise in harmonic oscillator measurements of force gradients.
Ontology highlight
ABSTRACT:
SUBMITTER: Moore EW
PROVIDER: S-EPMC2924902 | biostudies-other | 2010 Jul
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Circuits of excitatory and inhibitory neurons generate gamma-rhythmic activity (30-80 Hz). Gamma-cycles show spontaneous variability in amplitude and duration. To investigate the mechanisms underlying this variability, we recorded local-field-potentials (LFPs) and spikes from awake macaque V1. We developed a noise-robust method to detect gamma-cycle amplitudes and durations, which showed a weak but positive correlation. This correlation, and the joint amplitude-duration distribution, is well reproduced by a noise-driven damped harmonic oscillator. This model accurately fits LFP power-spectra, is equivalent to a linear, noise-driven E-I circuit, and recapitulates two additional features of gamma: (1) Amplitude-duration correlations decrease with oscillation strength; (2) amplitudes and durations exhibit strong and weak autocorrelations, respectively, depending on oscillation strength. Finally, longer gamma-cycles are associated with stronger spike-synchrony, but lower spike-rates in both (putative) excitatory and inhibitory neurons. In sum, V1 gamma-dynamics are well described by the simplest possible model of gamma: A damped harmonic oscillator driven by noise.
| S-EPMC9018758 | biostudies-literature
Project description:The nonlinear interaction between an AFM tip and a sample gives rise to oscillations of the cantilever at integral multiples (harmonics) of the fundamental resonance frequency. The higher order harmonics have long been recognized to hold invaluable information on short range interactions but their utilization has thus far been relatively limited due to theoretical and experimental complexities. In particular, existing approximations of the interaction force in terms of higher harmonic amplitudes generally require simultaneous measurements of multiple harmonics to achieve satisfactory accuracy. In the present letter we address the mathematical challenge and derive accurate, explicit formulae for both conservative and dissipative forces in terms of an arbitrary single harmonic. Additionally, we show that in frequency modulation-AFM (FM-AFM) each harmonic carries complete information on the force, obviating the need for multi-harmonic analysis. Finally, we show that higher harmonics may indeed be used to reconstruct short range forces more accurately than the fundamental harmonic when the oscillation amplitude is small compared with the interaction range.
| S-EPMC4311655 | biostudies-literature
Project description:A system of functions (signals) on the finite line, called the oscillator system, is described and studied. Applications of this system for discrete radar and digital communication theory are explained.
| S-EPMC2481336 | biostudies-literature
Project description:The frequency noise of an optical frequency comb is routinely measured through the hetherodyne beat of one comb tooth against a stable continuous-wave laser. After frequency-to-voltage conversion, the beatnote is sent to a spectrum analyzer to retrive the power spectral density of the frequency noise. Because narrow-linewidth continuous-wave lasers are available only at certain wavelengths, heterodyning the comb tooth can be challenging. We present a new technique for direct characterization of the frequency noise of an optical frequency comb, requiring no supplementary reference lasers and easily applicable in all spectral regions from the terahertz to the ultraviolet. The technique is based on the combination of a low finesse Fabry-Perot resonator and the so-called "fringe-side locking" method, usually adopted to characterize the spectral purity of single-frequency lasers, here generalized to optical frequency combs. The effectiveness of this technique is demonstrated with an Er-fiber comb source across the wavelength range from 1 to 2 μm.
| S-EPMC4637836 | biostudies-other
Project description:The shifts of bird song frequencies in urbanized areas provide a unique system to understand avian acoustic responses to urbanization. Using passive acoustic monitoring and automatic bird sound recognition technology, we explored the frequency variations of six common urban bird species and their associations with habitat structures. Our results demonstrated that bird song frequencies in urban areas were significantly higher than those in peri-urban and rural areas. Anthropogenic noise and habitat structure were identified as crucial factors shaping the acoustic space for birds. We found that noise, urbanization, and open understory spaces are factors contributing to the increase in the dominant frequency of bird sounds. However, habitat variables such as vegetation density and tree height can potentially slow down this upward trend. These findings offer essential insights into the behavioral response of birds in a variety of urban forest habitats, with implications for urban ecosystem management and habitat restoration.
| S-EPMC10867645 | biostudies-literature
Project description:The rupture forces and adhesion frequencies of single recognition complexes between an affinity selected peptide/MHC complex and a TCR at a murine hybridoma surface were measured using Atomic Force Microscopy. When the CD8 coreceptor is absent, the adhesion frequency depends on the nature of the peptide but the rupture force does not. When CD8 is present, no effect of the nature of the peptide is observed. CD8 is proposed to act as a time and distance lock, enabling the shorter TCR molecule to bridge the pMHC and have time to finely read the peptide. Ultimately, such experiments could help the dissection of the sequential steps by which the TCR reads the peptide/MHC complex in order to control T cell activation.
| S-EPMC3142151 | biostudies-literature
Project description:Force variability during constant force tasks is directly related to oscillations below 0.5 Hz in force. However, it is unknown whether such oscillations exist in muscle activity. The purpose of this paper, therefore, was to determine whether oscillations below 0.5 Hz in force are evident in the activation of muscle. Fourteen young adults (21.07 ± 2.76 years, 7 women) performed constant isometric force tasks at 5% and 30% MVC by abducting the left index finger. We recorded the force output from the index finger and surface EMG from the first dorsal interosseous (FDI) muscle and quantified the following outcomes: 1) variability of force using the SD of force; 2) power spectrum of force below 2 Hz; 3) EMG bursts; 4) power spectrum of EMG bursts below 2 Hz; and 5) power spectrum of the interference EMG from 10-300 Hz. The SD of force increased significantly from 5 to 30% MVC and this increase was significantly related to the increase in force oscillations below 0.5 Hz (R(2) = 0.82). For both force levels, the power spectrum for force and EMG burst was similar and contained most of the power from 0-0.5 Hz. Force and EMG burst oscillations below 0.5 Hz were highly coherent (coherence = 0.68). The increase in force oscillations below 0.5 Hz from 5 to 30% MVC was related to an increase in EMG burst oscillations below 0.5 Hz (R(2) = 0.51). Finally, there was a strong association between the increase in EMG burst oscillations below 0.5 Hz and the interference EMG from 35-60 Hz (R(2) = 0.95). In conclusion, this finding demonstrates that bursting of the EMG signal contains low-frequency oscillations below 0.5 Hz, which are associated with oscillations in force below 0.5 Hz.
| S-EPMC4220917 | biostudies-literature
Project description:The detection of local dielectric properties is of great importance in a wide variety of scientific studies and applications. Here, we report a novel method for the characterization of local dielectric distributions based on surface adhesion mapping by atomic force microscopy (AFM). The two-dimensional (2D) materials graphene oxide (GO), and partially reduced graphene oxide (RGO), which have similar thicknesses but large differences in their dielectric properties, were studied as model systems. Through direct imaging of the samples with a biased AFM tip in PeakForce Quantitative Nano-Mechanics (PF-QNM) mode, the local dielectric properties of GO and RGO were revealed by mapping their surface adhesion forces. Thus, GO and RGO could be conveniently differentiated. This method provides a simple and general approach for the fast characterization of the local dielectric properties of graphene-based materials and will further facilitate their applications in energy generation and storage devices.
| S-EPMC5870145 | biostudies-literature
Project description:In objective physical activity (PA) measurements, applying wider frequency filters than the most commonly used ActiGraph (AG) filter may be beneficial when processing accelerometry data. However, the vulnerability of wider filters to noise has not been investigated previously. This study explored the effect of wider frequency filters on measurements of PA, sedentary behavior (SED), and capturing of noise. Apart from the standard AG band-pass filter (0.29-1.63 Hz), modified filters with low-pass component cutoffs at 4 Hz, 10 Hz, or removed were analyzed. Calibrations against energy expenditure were performed with lab data from children and adults to generate filter-specific intensity cut-points. Free-living accelerometer data from children and adults were processed using the different filters and intensity cut-points. There was a contribution of acceleration related to PA at frequencies up to 10 Hz. The contribution was more pronounced at moderate and vigorous PA levels, although additional acceleration also occurred at SED. The classification discrepancy between AG and the wider filters was small at SED (1-2%) but very large at the highest intensities (>90%). The present study suggests an optimal low-pass frequency filter with a cutoff at 10 Hz to include all acceleration relevant to PA with minimal effect of noise.
| S-EPMC6539652 | biostudies-literature
Project description:Objective.We developed a method using cardiovascular magnetic resonance imaging to model the untwisting of the left ventricle (LV) as a damped torsional harmonic oscillator to estimate shear modulus (intrinsic myocardial stiffness) and frictional damping, then applied this method to evaluate the torsional stiffness of patients with resistant hypertension (RHTN) compared to a control group.Approach.The angular displacement of the LV during diastole was measured. Myocardial shear modulus and damping constant were determined by solving a system of equations modeling the diastolic untwisting as a damped, unforced harmonic oscillator, in 100 subjects with RHTN and 36 control subjects.Main Results.Though overall torsional stiffness was increased in RHTN (41.7 (27.1-60.7) versus 29.6 (17.3-35.7) kdyn*cm;p = 0.001), myocardial shear modulus was not different between RHTN and control subjects (0.34 (0.23-0.50) versus 0.33 (0.22-0.46) kPa;p= 0.758). RHTN demonstrated an increase in overall diastolic frictional damping (6.13 ± 3.77 versus 3.35 ± 1.70 kdyn*cm*s;p< 0.001), but no difference in damping when corrected for the overlap factor (74.3 ± 25.9 versus 68.0 ± 24.0 dyn*s/cm3;p = 0.201). There was an increase in the polar moment (geometric component of stiffness; 11.47 ± 6.95 versus 7.58 ± 3.28 cm4;p<0.001).Significance.We have developed a phenomenological method, estimating the intrinsic stiffness and relaxation properties of the LV based on restorative diastolic untwisting. This model finds increased overall stiffness in RHTN and points to hypertrophy, rather than tissue- level changes, as the major factor leading to increased stiffness.
| S-EPMC9066283 | biostudies-literature