Fiber-laser-based photoacoustic microscopy and melanoma cell detection.
Ontology highlight
ABSTRACT:
SUBMITTER: Wang Y
PROVIDER: S-EPMC3033874 | biostudies-other | 2011 Jan-Feb
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Tendons are tough, flexible, and ubiquitous tissues that connect muscle to bone. Tendon injuries are a common musculoskeletal injury, which affect 7% of all patients and are involved in up to 50% of sports-related injuries in the United States. Various imaging modalities are used to evaluate tendons, and both magnetic resonance imaging and sonography are used clinically to evaluate tendons with non-invasive and non-ionizing radiation. However, these modalities cannot provide 3-dimensional (3D) structural images and are limited by angle dependency. In addition, anisotropy is an artifact that is unique to the musculoskeletal system. Thus, great care should be taken during tendon imaging. The present study evaluated a functional photoacoustic microscopy system for in-vivo tendon imaging without labeling. Tendons have a higher density of type 1 collagen in a cross-linked triple-helical formation (65-80% dry-weight collagen and 1-2% elastin in a proteoglycan-water matrix) than other tissues, which provides clear endogenous absorption contrast in the near-infrared spectrum. Therefore, photoacoustic imaging with a high sensitivity to absorption contrast is a powerful tool for label-free imaging of tendons. A pulsed near-infrared fiber-based laser with a centered wavelength of 780 nm was used for the imaging, and this system successfully provided a 3D image of mouse tendons with a wide field of view (5 × 5 mm2).
| S-EPMC5859263 | biostudies-literature
Project description:Photoacoustic imaging, especially for intravascular and endoscopic applications, requires ultrasound probes with miniature size and high sensitivity. In this paper, we present a new photoacoustic sensor based on a small-sized fiber laser. Incident ultrasound waves exert pressures on the optical fiber laser and induce harmonic vibrations of the fiber, which is detected by the frequency shift of the beating signal between the two orthogonal polarization modes in the fiber laser. This ultrasound sensor presents a noise-equivalent pressure of 40?Pa over a 50-MHz bandwidth. We demonstrate this new ultrasound sensor on an optical-resolution photoacoustic microscope. The axial and lateral resolutions are 48??m and 3.3??m. The field of view is up to 1.57?mm2. The sensor exhibits strong resistance to environmental perturbations, such as temperature changes, due to common-mode cancellation between the two orthogonal modes. The present fiber laser ultrasound sensor offers a new tool for all-optical photoacoustic imaging.
| S-EPMC5241646 | biostudies-literature
Project description:We present a methodology to measure absolute flow velocity using laser-scanning photoacoustic microscopy. To obtain the Doppler angle, the angle between ultrasonic detection axis and flow direction, we extracted the distances between the transducer and three adjacent scanning points along the flow and repeatedly applied the law of cosines. To measure flow velocity along the ultrasonic detection axis, we calculated the time shift between two consecutive photoacoustic waves at the same scanning point, then converted the time shift to velocity according to the sound velocity and time interval between two laser illuminations. We verified our method by imaging flow phantoms.
| S-EPMC3676371 | biostudies-other
Project description:Photoacoustic microscopy (PAM) is an attractive imaging tool complementary to established optical microscopic modalities by providing additional molecular specificities through imaging optical absorption contrast. While the development of optical resolution photoacoustic microscopy (ORPAM) offers high lateral resolution, the acoustically-determined axial resolution is limited due to the constraint in ultrasonic detection bandwidth. ORPAM with isometric spatial resolution along both axial and lateral direction is yet to be developed. Although recently developed sophisticated optical illumination and reconstruction methods offer improved axial resolution in ORPAM, the image acquisition procedures are rather complicated, limiting their capabilities for high-speed imaging and being easily integrated with established optical microscopic modalities. Here we report an isometric ORPAM based on an optically transparent micro-ring resonator ultrasonic detector and a commercial inverted microscope platform. Owing to the superior spatial resolution and the ease of integrating our ORPAM with established microscopic modalities, single cell imaging with extrinsic fluorescence staining, intrinsic autofluorescence, and optical absorption can be achieved simultaneously. This technique holds promise to greatly improve the accessibility of PAM to the broader biomedical researchers.
| S-EPMC5969522 | biostudies-literature
Project description:We have developed a photoacoustic (PA) sensor using a low-power, continuous- wave laser and a kHz-range microphone. The sensor is simple, flexible, cost-effective, and compatible with commercial optical microscopes. The sensor enables noncontact PA measurements through air, whereas most current existing PA techniques require an acoustic coupling liquid for detection. The PA sensor has three main components: one is the chamber that holds the sample, the second is a resonator column used to amplify the weak PA signals generated within the sample chamber, and the third is a microphone at the end of the resonator column to detect the amplified signals. The chamber size was designed to be 8??mm??×??3??mm as the thermal diffusion length and viscous-thermal damping of air at room pressure and temperature are 2 and 1 mm, respectively. We numerically and experimentally examined the effect of the resonator column size on the frequency response of the PA sensor. The quality factor decreased significantly when the sample chamber size was reduced from 4??mm??×??3??mm to 2??mm??×??3??mm due to thermos-viscous damping of the air. The quality factor decreased by 27%, demonstrating the need for optimal design for the sample chamber and resonator column size. The system exhibited noise equivalent molecular sensitivity (NEM) per unit bandwidth (NEM??/??????f) of ?19,966??Hz?^?1/2 or 33??×??10^?21??mol or 33 zeptomol, which is an improvement of 2.2 times compared to the previous system design. This PA sensor has the potential for noncontact high-resolution PA imaging of materials without the need for coupling fluids.
| S-EPMC7005906 | biostudies-literature
Project description:Near-infrared photoacoustics receives increasing interest as an intravital modality to sense key biomolecules. One of the most central types of biomolecules of interest are lipids as they constitute essential bio-hallmarks of cardiovascular and metabolic diseases and their in-vivo detection holds insightful information about disease progression and treatment monitoring. However, the full potential of near-infrared photoacoustic for high-resolution and high-sensitivity biomedical studies of lipids has so far not been exploited due a lack of appropriate excitation sources delivering short-pulses at high-repetition-rate, high-pulse-energy, and wavelength around 1200 nm. Here, we demonstrate a custom-built SRS fiber amplifier that provides optical excitations at 1192.8 nm, repetition rates of 200 kHz, pulse durations below 2 ns, and pulse energies beyond 5 μJ. We capitalize on the performance of our excitation source and show near-infrared photoacoustics resolving intrinsic lipid contrast in biomedically relevant specimens ranging from single cells to lipid-rich tissue with subcellular resolution.
| S-EPMC8783138 | biostudies-literature
Project description:Circulating tumor cell (CTC) clusters, arising from multicellular groupings in a primary tumor, greatly elevate the metastatic potential of cancer compared with single CTCs. High-throughput detection and quantification of CTC clusters are important for understanding the tumor metastatic process and improving cancer therapy. Here, we applied a linear-array-based photoacoustic tomography (LA-PAT) system and improved the image reconstruction for label-free high-throughput CTC cluster detection and quantification <italic<in vivo</italic<. The feasibility was first demonstrated by imaging CTC cluster <italic<ex vivo</italic<. The relationship between the contrast-to-noise ratios (CNRs) and the number of cells in melanoma tumor cell clusters was investigated and verified. Melanoma CTC clusters with a minimum of four cells could be detected, and the number of cells could be computed from the CNR. Finally, we demonstrated imaging of injected melanoma CTC clusters in rats <italic<in vivo</italic<. Similarly, the number of cells in the melanoma CTC clusters could be quantified. The data showed that larger CTC clusters had faster clearance rates in the bloodstream, which agreed with the literature. The results demonstrated the capability of LA-PAT to detect and quantify melanoma CTC clusters <italic<in vivo</italic< and showed its potential for tumor metastasis study and cancer therapy.
| S-EPMC5995136 | biostudies-literature
Project description:Multispectral photoacoustic microscopy uses a wavelength-dependent absorption difference as a contrast mechanism to image the target molecule. In this paper, we present a novel multispectral pulsed fiber laser source, which selectively alternates the excitation wavelengths between green and red colors based on the stimulated Raman scattering (SRS) effect for imaging. This laser has a high pulse repetition rate (PRR) of 300 kHz and high pulse energy of more than 200 nJ meeting the real-time requirements of optical-resolution photoacoustic microscopy imaging. By switching the polarization state of the pump light and optical paths of the pump light, the operating wavelengths of the light source can be selectively alternated at the same fast PRR for any two SRS peak wavelengths between 545 and 655 nm. At 545 nm excitation wavelength, molecular photoacoustic signals from both blood vessels and gold nanorods were obtained simultaneously. However, at 655 nm, the photoacoustic signals of gold nanorods were dominant because the absorption of light by the blood vessels decreased drastically in the spectral region over 600 nm. Thus the multispectral photoacoustic system designed using the novel laser source implemented here could simultaneously monitor the time-dependent fast movement of two molecules independently, having different wavelength-dependent absorption properties at a high repetition rate of 0.49 frames per second (fps).
| S-EPMC7522855 | biostudies-literature
Project description:Development of novel mid-infrared (MIR) lasers could ultimately boost emerging detection technologies towards innovative spectroscopic and imaging solutions. Photoacoustic (PA) modality has been heralded for years as one of the most powerful detection tools enabling high signal-to-noise ratio analysis. Here, we demonstrate a novel, compact and sensitive MIR-PA system for carbon dioxide (CO2) monitoring at its strongest absorption band by combining a gas-filled fiber laser and PA technology. Specifically, the PA signals were excited by a custom-made hydrogen (H2) based MIR Raman fiber laser source with a pulse energy of ⁓ 18 μJ, quantum efficiency of ⁓ 80% and peak power of ⁓ 3.9 kW. A CO2 detection limit of 605 ppbv was attained from the Allan deviation. This work constitutes an alternative method for advanced high-sensitivity gas detection.
| S-EPMC7876039 | biostudies-literature
Project description:The circulating tumor cell (CTC) count has been shown as a prognostic marker for metastasis development. However, its clinical utility for metastasis prevention remains unclear, because metastases may already be present at the time of initial diagnosis with existing assays. Their sensitivity ex vivo is limited by a small blood sample volume, whereas in vivo examination of larger blood volumes may be clinically restricted by the toxicity of labels used for targeting of CTCs. We introduce a method for in vivo photoacoustic blood cancer testing with a high-pulse-repetition-rate diode laser that, when applied to melanoma, is free of this limitation. It uses the overexpression of melanin clusters as intrinsic, spectrally-specific cancer markers and signal amplifiers, thus providing higher photoacoustic contrast of melanoma cells compared with a blood background. In tumor-bearing mouse models and melanoma-spiked human blood samples, we showed a sensitivity level of 1 CTC/mL with the potential to improve this sensitivity 10(3)-fold in humans in vivo, which is impossible with existing assays. Additional advances of this platform include decreased background signals from blood through changes in its oxygenation, osmolarity, and hematocrit within physiologic norms, assessment of CTCs in deep vessels, in vivo CTC enrichment, and photoacoustic-guided photothermal ablation of CTCs in the bloodstream. These advances make feasible the early diagnosis of melanoma during the initial parallel progression of primary tumor and CTCs, and laser blood purging using noninvasive or hemodialysis-like schematics for the prevention of metastasis.
| S-EPMC2828368 | biostudies-literature