Probe pressure effects on human skin diffuse reflectance and fluorescence spectroscopy measurements.
Ontology highlight
ABSTRACT: Diffuse reflectance and fluorescence spectroscopy are popular research techniques for noninvasive disease diagnostics. Most systems include an optical fiber probe that transmits and collects optical spectra in contact with the suspected lesion. The purpose of this study is to investigate probe pressure effects on human skin spectroscopic measurements. We conduct an in-vivo experiment on human skin tissue to study the short-term (<2 s) and long-term (>30 s) effects of probe pressure on diffuse reflectance and fluorescence measurements. Short-term light probe pressure (P0<9 mN∕mm2) effects are within 0 ± 10% on all physiological properties extracted from diffuse reflectance and fluorescence measurements, and less than 0±5% for diagnostically significant physiological properties. Absorption decreases with site-specific variations due to blood being compressed out of the sampled volume. Reduced scattering coefficient variation is site specific. Intrinsic fluorescence shows a large standard error, although no specific pressure-related trend is observed. Differences in tissue structure and morphology contribute to site-specific probe pressure effects. Therefore, the effects of pressure can be minimized when the pressure is small and applied for a short amount of time; however, long-term and large pressures induce significant distortions in measured spectra.
Project description:Diffuse reflectance spectroscopy with a fiber optic probe is a powerful tool for quantitative tissue characterization and disease diagnosis. Significant systematic errors can arise in the measured reflectance spectra and thus in the derived tissue physiological and morphological parameters due to real-time instrument fluctuations. We demonstrate a novel fiber optic probe with real-time, self-calibration capability that can be used for UV-visible diffuse reflectance spectroscopy in biological tissue in clinical settings. The probe is tested in a number of synthetic liquid phantoms over a wide range of tissue optical properties for significant variations in source intensity fluctuations caused by instrument warm up and day-to-day drift. While the accuracy for extraction of absorber concentrations is comparable to that achieved with the traditional calibration (with a reflectance standard), the accuracy for extraction of reduced scattering coefficients is significantly improved with the self-calibration probe compared to traditional calibration. This technology could be used to achieve instrument-independent diffuse reflectance spectroscopy in vivo and obviate the need for instrument warm up and post∕premeasurement calibration, thus saving up to an hour of precious clinical time.
Project description:Salicylic acid (SA) has been frequently used as a facial chemical peeling agent (FCPA) in various cosmetics for facial rejuvenation and dermatological treatments in the clinic. However, there is a tradeoff between therapeutic effectiveness and possible adverse effects caused by this agent for cosmetologists. To optimize the cosmetic efficacy with minimal concentration, we proposed a chemical permeation enhancer (CPE) azone to synergistically work with SA on human skin in vivo. The optical properties of human skin after being treated with SA alone and SA combined with azone (SA@azone) were successively investigated by diffuse reflectance spectroscopy (DRS) and optical coherence tomography (OCT). Our results revealed that as the SA concentration increased, the light reflectance decreased and the absorption increased. We also found that SA@azone exhibited a synergistic effect on enhancing light penetration and OCT imaging depth. We demonstrated that the combination of DRS and OCT techniques could be used as a noninvasive, rapid and accurate measurement method to monitor the subtle changes of skin tissue after treatment with FCPA and CPE. The approach will greatly benefit the development of clinical cosmetic surgery, dermatosis diagnosis and therapeutic effect inspection in related biomedical studies.
Project description:Psoriasis affects more than 125 million people worldwide, and the diagnosis and treatment efficacy evaluation of the disease mainly rely on clinical assessments that could be subjective. Our previous study showed that the skin erythema level could be quantified using diffuse reflectance spectroscopy (DRS), and the hemoglobin concentration of most psoriatic lesion was higher than that of its adjacent uninvolved skin. While the compromised epidermal barrier function has been taken as the major cause of clinical manifestation of skin dryness and inflammation of psoriasis, very few methods can be used to effectively evaluate this function. In this study, we investigate the near infrared spectroscopic features of psoriatic (n = 21) and normal (n = 21) skin that could link to the epidermal barrier function. From the DRS measurements, it was found that the water bonding status and light scattering properties of psoriasis are significantly different from those of uninvolved or normal skin. The connection between these parameters to the epidermal barrier function and morphology will be discussed. Our results suggest that objective evaluation of epidermal barrier function of psoriasis could be achieved using a simple DRS system.
Project description:We introduce a new approach to transient spectroscopy, fluorescence-detected pump-probe (F-PP) spectroscopy, that overcomes several limitations of traditional PP. F-PP suppresses excited-state absorption, provides background-free detection, removes artifacts resulting from pump-pulse scattering, from non-resonant solvent response, or from coherent pulse overlap, and allows unique extraction of excited-state dynamics under certain conditions. Despite incoherent detection, time resolution of F-PP is given by the duration of the laser pulses, independent of the fluorescence lifetime. We describe the working principle of F-PP and provide its theoretical description. Then we illustrate specific features of F-PP by direct comparison with PP, theoretically and experimentally. For this purpose, we investigate, with both techniques, a molecular squaraine heterodimer, core-shell CdSe/ZnS quantum dots, and fluorescent protein mCherry. F-PP is broadly applicable to chemical systems in various environments and in different spectral regimes.
Project description:By augmentation of the collection optics utilized in transmission-based femtosecond stimulated Raman spectroscopy (FSRS), two novel diffuse reflectance-based femtosecond stimulated Raman spectroscopy (drFSRS) techniques were developed. These techniques were then used to collect the Raman spectra of opaque systems, those being cyclohexane-intercalated poly(tetrafluoroethylene) microbeads and ethanol in 1% intralipid solutions. The resulting drFSRS data from the cyclohexane:PTFE system show significant distortion of the depolarization ratio of the 803 cm-1 cyclohexane peak, indicating a loss of incident pump:probe polarization in a scattering environment. The drFSRS data from the ethanol in 1% intralipid solution demonstrate less signal strength but equal spectral resolution when compared to transmission-based FSRS of the same sample. The results presented in this Technical Note demonstrate the current capabilities of collecting stimulated Raman spectra of opaque systems using drFSRS.
Project description:SignificanceEfficacious photodynamic therapy (PDT) of abscess cavities requires personalized treatment planning. This relies on knowledge of abscess wall optical properties, which we report for the first time in human subjects.AimThe objective was to extract optical properties and photosensitizer concentration from spatially resolved diffuse reflectance measurements of abscess cavities prior to methylene blue (MB) PDT, as part of a phase 1 clinical trial.ApproachDiffuse reflectance spectra were collected at the abscess wall of 13 human subjects using a custom fiber-optic probe and optical spectroscopy system, before and after MB administration. A Monte Carlo lookup table was used to extract optical properties.ResultsPre-MB abscess wall absorption coefficients at 665 nm were 0.15±0.1 cm-1 (0.03 to 0.36 cm-1) and 10.74±15.81 cm-1 (0.08 to 49.3 cm-1) post-MB. Reduced scattering coefficients at 665 nm were 8.45±2.37 cm-1 (4.8 to 13.2 cm-1) and 5.6±2.26 cm-1 (1.6 to 9.9 cm-1) for pre-MB and post-MB, respectively. Oxygen saturations were found to be 58.83%±35.78% (5.6% to 100%) pre-MB and 36.29%±25.1% (0.0001% to 76.4%) post-MB. Determined MB concentrations were 71.83±108.22 μM (0 to 311 μM).ConclusionsWe observed substantial inter-subject variation in both native wall optical properties and MB uptake. This underscores the importance of making these measurements for patient-specific treatment planning.
Project description:The diversity of human skin phenotypes and the ubiquitous exposure to ultraviolet radiation (UVR) underscore the need for a non-invasive tool to predict an individual's UVR sensitivity. We analysed correlations between UVR sensitivity, melanin content, diffuse reflectance spectroscopy (DR) and UVR-induced DNA damage in the skin of subjects from three racial/ethnic groups: Asian, black or African American and White. UVR sensitivity was determined by evaluating each subject's response to one minimal erythemal dose (MED) of UVR one day after the exposure. Melanin content was measured using DR and by densitometric analysis of Fontana-Masson staining (FM) in skin biopsies taken from unexposed areas. An individual's UVR sensitivity based on MED was highly correlated with melanin content measured by DR and by FM. Therefore, a predictive model for the non-invasive determination of UVR sensitivity using DR was developed. The MED precision was further improved when we took race/ethnicity into consideration. The use of DR serves as a tool for predicting UVR sensitivity in humans that should be invaluable for determining appropriate UVR doses for therapeutic, diagnostic and/or cosmetic devices.
Project description:Cellulitis is frequently misdiagnosed owing to its clinical mimickers, collectively known as pseudocellulitis. This study investigated diffuse reflectance spectroscopy (DRS) alone and in combination with infrared thermography (IRT) for the differentiation of cellulitis from pseudocellulitis. A prospective cohort study at an urban academic hospital was conducted from March 2017 to March 2018. Patients presenting to the emergency department with presumed cellulitis were screened for eligibility, and 30 adult patients were enrolled. Dermatology consultation conferred a final diagnosis of cellulitis or pseudocellulitis. DRS measurements yielded a spectral ratio between 556 nm (deoxyhemoglobin peak) and 542 nm (oxyhemoglobin peak), and IRT measurements yielded temperature differentials between the affected and unaffected skin. Of the 30 enrolled patients, 30% were diagnosed with pseudocellulitis. DRS revealed higher spectral ratios in patients with cellulitis (P = 0.005). A single parameter model using logistic regression on DRS measurements alone demonstrated a classification accuracy of 77.0%. A dual parameter model using linear discriminant analysis on DRS and IRT measurements combined demonstrated a 95.2% sensitivity, 77.8% specificity, and 90.0% accuracy for cellulitis prediction. DRS and IRT combined diagnoses cellulitis with an accuracy of 90%. DRS and IRT are inexpensive and noninvasive, and their use may reduce cellulitis misdiagnosis.
Project description:The feasibility of using a diffuse reflectance probe attached to a near infrared spectrometer to monitor the total ammonia nitrogen (TAN) content in an anaerobic digester run on cattle manure was investigated; as a previous study has indicated that this probe can be easily attached to an anaerobic digester. Multivariate modelling techniques such as partial least squares regression and interval partial least squares methods were used to build models. Various data pre-treatments were applied to improve the models. The TAN concentrations measured were in the range of 1.5 to 5.5 g/L. An R(2) of 0.91 with an RMSEP of 0.32 was obtained implying that the probe could be used for monitoring and screening purposes.