Dataset Information

Slow-release oral morphine for opioid maintenance treatment: a systematic review.

ABSTRACT: This review article summarizes the results of all available clinical trials considering the use of slow-release oral morphine (SROM) for opioid maintenance treatment (OMT). All studies published up to October 2010 and assessing SROM for OMT in adult patients are included. Three independent reviewers assessed the selected articles using a standardized checklist. Study design, study length and number of subjects included were recorded. Data about retention rate (proportion of participants remaining under maintenance treatment at the end of the study), quality of life, withdrawal symptoms, craving, additional drug consumption, driving capacity and adverse events were collected. We identified 13 articles corresponding to nine clinical trials considering the use of SROM for OMT. Among them, only one was a randomized trial and one was a controlled not randomized trial. All other studies were uncontrolled. Retention rates were good (from 80.6 to 95%) with SROM maintenance, but similar retention rates were obtained with methadone. Most of the studies showed that quality of life, withdrawal symptoms, craving and additional drug consumption improved with SROM. However, there was no comparison with other maintenance drugs. As most of the studies assessing SROM efficacy were uncontrolled, there is no definite evidence that SROM is an effective alternative to methadone for OMT.

SUBMITTER: Jegu J

PROVIDER: S-EPMC3099370 | biostudies-other | 2011 Jun

REPOSITORIES: biostudies-other

ACCESS DATA

Publications

Slow-release oral morphine for opioid maintenance treatment: a systematic review.

Jegu Jeremie J Gallini Adeline A Soler Pauline P Montastruc Jean-Louis JL Lapeyre-Mestre Maryse M

British journal of clinical pharmacology 20110601 6

This review article summarizes the results of all available clinical trials considering the use of slow-release oral morphine (SROM) for opioid maintenance treatment (OMT). All studies published up to October 2010 and assessing SROM for OMT in adult patients are included. Three independent reviewers assessed the selected articles using a standardized checklist. Study design, study length and number of subjects included were recorded. Data about retention rate (proportion of participants remainin ...[more]

PMID: 21265874

Similar Datasets

Project description:BackgroundThe injection of morphine from morphine sulfate capsules containing sustained-release microbeads (Skenan®) is a practice frequently described by French intravenous opioid users. They seek an injectable form of substitution for heroin. Depending on how the syringe is prepared, the morphine rates may vary. The dosage of the capsule, the temperature of the dissolving water and the type of filter used have been identified as the parameters most likely to influence the final quantity of morphine in solution before intravenous injection. The aim of our study was to determine the amounts of morphine actually injected, according to the different preparation modalities described by people who inject morphine and the harm reduction equipment made available to them.MethodsDifferent morphine syringes were prepared by varying the dosage of the capsule (100 or 200 mg), the temperature of the dissolving water before adding morphine, ambient (≈ 22 °C) or heat (≈ 80 °C) and four filtration devices: risk reduction Steribox® cotton, risk reduction filter "Sterifilt®", "Wheel" filter and cigarette filter. The quantification of the morphine in the syringe body was carried out by liquid phase chromatography coupled with a mass spectrometry detector.ResultsThe best extraction yields were obtained with heated water, independently of dosages (p < 0.01). Yields of 100 mg capsules varied according to the filter (p < 0.01) and the water temperature (p < 0.01), with maximum yields obtained for solutions dissolved in heated water, then filtered with the "Wheel" filter (83 mg). The yields of the 200 mg capsules varied according to the temperature of the water (p < 0.01), without difference according to the filter used (p > 0.01), and maximum yields obtained for solutions dissolved in heated water (95 mg).ConclusionsNo procedure for dissolving Skenan® led to the complete dissolution of the morphine it contains. Whatever the variations in preparation conditions, the extraction rates of the 200 mg morphine capsules were lower than those of 100 mg, without the risk reduction filters adversely impacting morphine extraction. Offering an injectable substitution to persons who inject morphine would make it possible to reduce the risks and damage, particularly overdoses, associated with variations in dosage due to preparation methods.

Project description:BackgroundInjections of mixtures prepared from crushed tablets contain insoluble particles which can cause embolisms and other complications. Although many particles can be removed by filtration, many injecting drug users do not filter due to availability, cost or performance of filters, and also due to concerns that some of the dose will be lost.MethodsInjection solutions were prepared from slow-release morphine tablets (MS Contin) replicating methods used by injecting drug users. Contaminating particles were counted by microscopy and morphine content analysed by liquid chromatography before and after filtration.ResultsUnfiltered tablet extracts contained tens of millions of particles with a range in sizes from < 5 microm to > 400 microm. Cigarette filters removed most of the larger particles (> 50 microm) but the smaller particles remained. Commercial syringe filters (0.45 and 0.22 microm) produced a dramatic reduction in particles but tended to block unless used after a cigarette filter. Morphine was retained by all filters but could be recovered by following the filtration with one or two 1 ml washes. The combined use of a cigarette filter then 0.22 microm filter, with rinses, enabled recovery of 90% of the extracted morphine in a solution which was essentially free of tablet-derived particles.ConclusionsApart from overdose and addiction itself, the harmful consequences of injecting morphine tablets come from the insoluble particles from the tablets and microbial contamination. These harmful components can be substantially reduced by passing the injection through a sterilizing (0.22 microm) filter. To prevent the filter from blocking, a preliminary coarse filter (such as a cigarette filter) should be used first. The filters retain some of the dose, but this can be recovered by following filtration with one or two rinses with 1 ml water. Although filtration can reduce the non-pharmacological harmful consequences of injecting tablets, this remains an unsafe practice due to skin and environmental contamination by particles and microorganisms, and the risks of blood-borne infections from sharing injecting equipment.

Dataset Information

Slow-release oral morphine for opioid maintenance treatment: a systematic review.

Publications

Slow-release oral morphine for opioid maintenance treatment: a systematic review.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets