Dataset Information

Comparison of precision and accuracy of linear measurements performed by two different imaging software programs and obtained from 3D-CBCT images for Le Fort I osteotomy.

ABSTRACT: OBJECTIVE: The purpose of this study was to compare the precision and accuracy of linear measurements for Le Fort I osteotomy performed by two different imaging software programs and obtained from three-dimensional cone beam CT (3D-CBCT) images. METHODS: The study population consisted of 11 dried skulls submitted to CBCT, which generated 3D images. Linear measurements were based on craniometric anatomical landmarks pre-defined by the authors as specifically used for Le Fort I osteotomy and were identified by two radiologists twice each, independently, using Vitrea 3.8.1 (Vital Images Inc., Plymouth, MN) and open-source digital imaging communication in medicine viewer OsiriX 1.2 64-bit (Pixmeo, Geneva, Switzerland). Subsequently, a third examiner made physical measurements using a digital caliper (167 series; Mitutoyo Sul Americana Ltd, Suzano, SP, Brazil). RESULTS: The results demonstrated a statistically significant difference between OsiriX and the gold standard, especially in the pterygoid process (TPtg L = 0.019, LLpPtg R = 0.016 and LLpPtg L = 0.012). Vitrea showed no statistical difference in comparison with the gold standard, and showed a high level of accuracy in all the measurements performed. The major difference found was 0.42 mm (LLpPtg R). Interexaminer analysis ranged from 0.90 to 0.97 using Vitrea and from 0.8 to 0.97 using OsiriX. Intraexaminer correlation coefficient ranged from 0.90 to 0.98 and from 0.84 to 0.98 for Examiners 1 and 2, respectively, using Vitrea and from 0.93 to 0.99 for Examiner 1 and from 0.64 to 0.96 for Examiner 2 using OsiriX. CONCLUSION: Vitrea may be considered as precise and accurate, insofar as it was able to perform all the 3D linear measurements. On the other hand, linear measurements performed using OsiriX were not successful in producing accurate linear measurements for Le Fort I osteotomy.

SUBMITTER: Gaia BF

PROVIDER: S-EPMC3635772 | biostudies-other | 2013

REPOSITORIES: biostudies-other

ACCESS DATA

Similar Datasets

Project description:PurposeTo assess the impact of a multimodal antiemetic protocol on postoperative nausea and vomiting (PONV) after Le Fort I osteotomy.Materials and methodsConsecutive patients undergoing Le Fort I osteotomy with or without additional procedures at a single academic institution were recruited as the intervention cohort for an institutional review board-approved prospective clinical trial with a retrospective comparison group. The intervention cohort was managed with a multimodal antiemetic protocol, including total intravenous anesthesia; prophylactic ondansetron, steroids, scopolamine, and droperidol; gastric decompression at surgery end; opioid-sparing analgesia; avoidance of morphine and codeine; prokinetic erythromycin; and fluids at a minimum of 25 mL/kg. The comparison group consisted of consecutive patients from a larger study who underwent similar surgical procedures before protocol implementation. Data, including occurrence of PONV, were extracted from medical records. Data were analyzed in bivariate fashion with the Fisher exact and Wilcoxon rank-sum tests. Logistic regression was used to compare the likelihood of nausea and vomiting in the 2 cohorts after controlling for demographic and surgical characteristics. A P value less than .05 was considered significant.ResultsThe intervention (n = 93) and comparison (n = 137) groups were similar in gender (58% and 65% female patients; P = .29), race (72% and 71% Caucasian; P = .85), age (median, 19 and 20 years old; P = .75), proportion of patients with known risk factors for PONV (P = .34), percentage undergoing bimaxillary surgery (60% for the 2 groups), and percentage for whom surgery time was longer than 180 minutes (63% and 59%; P = .51). Prevalence of postoperative nausea was significantly lower in the intervention group than in the comparison group (24% vs 70%; P < .0001). Prevalence of postoperative vomiting was likewise significantly lower in the intervention group (11% vs 28%; P = .0013). The likelihood that patients in the comparison group would develop nausea was 8.9 and that for vomiting was 3.7 times higher than in the intervention group.ConclusionThis multimodal protocol was associated with substantially decreased prevalence of PONV in patients undergoing Le Fort I osteotomy.

Project description:PurposeTo determine the rate of complications and occurrence of pterygoid plate fractures comparing two techniques of Le Fort I osteotomy i.e., Classic Pterygomaxillary Dysjunction technique and Trimble technique and to know whether the dimensions of pterygomaxillary junction [determined preoperatively by computed tomography (CT) scan] have any influence on pterygomaxillary separation achieved during surgery.Materials and methodsThe study group consisted of eight South Indian patients with maxillary excess. A total of 16 sides were examined by CT. Preoperative CT was analyzed for all the patients. The thickness and width of the pterygomaxillary junction and the distance of the greater palatine canal from the pterygomaxillary junction was noted. Pterygomaxillary dysjunction was achieved by two techniques, the classic pterygomaxillary dysjunction technique (Group I) and Trimble technique (Group II). Patients were selected randomly and equally for both the techniques. Dysjunction was analyzed by postoperative CT.ResultsThe average thickness of the pterygomaxillary junction on 16 sides was 4.5 ± 1.2 mm. Untoward pterygoid plate fractures occurred in Group I in 3 sides out of 8. In Trimble technique (Group II), no pterygoid plate fractures were noted. The average width of the pterygomaxillary junction was 7.8 ± 1.5 mm, distance of the greater palatine canal from pterygomaxillary junction was 7.4 ± 1.6 mm and the length of fusion of pterygomaxillary junction was 8.0 ± 1.9 mm.DiscussionThe Le Fort I osteotomy has become a standard procedure for correcting various dentofacial deformities. In an attempt to make Le Fort I osteotomy safer and avoid the problems associated with sectioning with an osteotome between the maxillary tuberosity and the pterygoid plates, Trimble suggested sectioning across the posterior aspect of the maxillary tuberosity itself. In our study, comparison between the classic pterygomaxillary dysjunction technique and the Trimble technique was made by using postoperative CT scan. It was found that unfavorable pterygoid plate fractures occurred only in dysjunction group and not in Trimble technique group. Preoperative CT scan assessment was done for all the patients to determine the dimension of the pterygomaxillary region. Preoperative CT scan proved to be helpful in not only determining the dimensions of the pterygomaxillary region but we also found out that thickness of the pterygomaxillary junction was an important parameter which may influence the separation at the pterygomaxillary region.ConclusionNo untoward fractures of the pterygoid plates were seen in Trimble technique (Group II) which makes it a safer technique than classic dysjunction technique. It was noted that pterygoid plate fractures occurred in patients in whom the thickness of the pterygomaxillary junction was <3.6 mm (preoperatively). Therefore, preoperative evaluation is important, on the basis of which we can decide upon the technique to be selected for safer and acceptable separation of pterygomaxillary region.

Project description:ObjectivesThis study aimed to investigate the accuracy of deep learning algorithms to diagnose tooth caries and classify the extension and location of dental caries in cone beam computed tomography (CBCT) images. To the best of our knowledge, this is the first study to evaluate the application of deep learning for dental caries in CBCT images.MethodsThe CBCT image dataset comprised 382 molar teeth with caries and 403 noncarious molar cases. The dataset was divided into a development set for training and validation and test set. Three images were obtained for each case, including axial, sagittal, and coronal. The test dataset was provided to a multiple-input convolutional neural network (CNN). The network made predictions regarding the presence or absence of dental decay and classified the lesions according to their depths and types for the provided samples. Accuracy, sensitivity, specificity, and F1 score values were measured for dental caries detection and classification.ResultsThe diagnostic accuracy, sensitivity, specificity, and F1 score for caries detection in carious molar teeth were 95.3%, 92.1%, 96.3%, and 93.2%, respectively, and for noncarious molar teeth were 94.8%, 94.3%, 95.8%, and 94.6%. The CNN network showed high sensitivity, specificity, and accuracy in classifying caries extensions and locations.ConclusionsThis research demonstrates that deep learning models can accurately identify dental caries and classify their depths and types with high accuracy, sensitivity, and specificity. The successful application of deep learning in this field will undoubtedly assist dental practitioners and patients in improving diagnostic and treatment planning in dentistry.Clinical significanceThis study showed that deep learning can accurately detect and classify dental caries. Deep learning can provide dental caries detection accurately. Considering the shortage of dentists in certain areas, using CNNs can lead to broader geographic coverage in detecting dental caries.

Project description:PurposeTo analyze the change in rotational alignment caused by double level osteotomy (DLO) based on comparative three-dimensional image analysis of pre- and postoperative CT images.MethodsPre- and postoperative CT examination of the lower extremities were performed with informed consent for 39 consecutive knees undergoing DLO for varus knee deformity. The DLO procedure consisted of closed wedge distal femoral osteotomy (CWDFO) and open wedge high tibial osteotomy (OWHTO). Among those cases, 20 knees complicated with hinge fracture at the osteotomy site were excluded from the analysis to eliminate a confounding factor affecting the results. Consequently, data obtained from 19 knees were subjected to the study analysis while osteotomies with hinge fractures complications were excluded from the study. In the three-dimensional CT image analysis of axial plane images, femoral torsion (the angle between midline along the femoral neck axis and the tangent of the posterior edges of the medial/lateral femoral condyles) and tibial torsion (the angle between the tangent of the posterior edges of the medial/lateral tibial condyles and the transmalleolar axis) were measured. The torsion angle was measured in each of the femurs and the tibias on both pre- and postoperative CT axial images, and the change induced by the osteotomy was calculated and statistically(using Wilcoxon signed-rank test) compared.ResultsThe mean pre- and postoperative femoral torsion (anteversion) angles were 29.3° and 31.4° with a significant postoperative increase in internal rotation of the bony segment distal to the osteotomy(P = 0.002). On the tibial side, the mean pre- and postoperative torsion angles were 26.5° and 25.7°, indicating no significant postoperative change(P = 0.199)（NS）.ConclusionsThis study showed that the DLO procedure (combining CWDFO and OWHTO) increased torsion (anteversion) of the femur by 2.1° on average while inducing no significant rotational change on the tibial side.

Dataset Information

Comparison of precision and accuracy of linear measurements performed by two different imaging software programs and obtained from 3D-CBCT images for Le Fort I osteotomy.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets