Plasmonic hotspots of dynamically assembled nanoparticles in nanocapillaries: Towards a micro ribonucleic acid profiling platform.
Ontology highlight
ABSTRACT:
SUBMITTER: Liu S
PROVIDER: S-EPMC3869822 | biostudies-other | 2013
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Fabricating nanocavities in which optically active single quantum emitters are precisely positioned is crucial for building nanophotonic devices. Here we show that self-assembly based on robust DNA-origami constructs can precisely position single molecules laterally within sub-5 nm gaps between plasmonic substrates that support intense optical confinement. By placing single-molecules at the center of a nanocavity, we show modification of the plasmon cavity resonance before and after bleaching the chromophore and obtain enhancements of ≥4 × 103 with high quantum yield (≥50%). By varying the lateral position of the molecule in the gap, we directly map the spatial profile of the local density of optical states with a resolution of ±1.5 nm. Our approach introduces a straightforward noninvasive way to measure and quantify confined optical modes on the nanoscale.
| S-EPMC5806994 | biostudies-literature
Project description:In this paper, micro droplets are generated in a microfluidic focusing contactor and then they move sequentially in a free-flowing mode (no wall contact). For this purpose, two different micro-flow glass devices (hydrophobic and hydrophilic) were used. During the study, the influence of the flow rate of the water phase and the oil phase on the droplet size and size distribution was investigated. Moreover, the influence of the oil phase viscosity on the droplet size was analyzed. It was found that the size and size distribution of the droplets can be controlled simply by the aqueous phase flow rate. Additionally, 2D simulations to determine the droplet size were performed and compared with the experiment.
| S-EPMC6187485 | biostudies-literature
Project description:Directed concentrating of micro- and nanoparticles via laser-generated plasmonic microbubbles in a liquid environment is an emerging technology. For effective heating, visible light has been primarily employed in existing demonstrations. In this paper, we demonstrate a new plasmonic platform based on nanoporous gold disk (NPGD) array. Thanks to the highly tunable localized surface plasmon resonance of the NPGD array, microbubbles of controlled size can be generated by near-infrared (NIR) light. Using NIR light provides several key advantages over visible light in less interference with standard microscopy and fluorescence imaging, preventing fluorescence photobleaching, less susceptible to absorption and scattering in turbid biological media, and much reduced photochemistry, phototoxicity, and so forth. The large surface-to-volume ratio of NPGD further facilitates the heat transfer from these gold nanoheaters to the surroundings. While the microbubble is formed, the surrounding liquid circulates and direct microparticles randomly dispersed in the liquid to the bottom NPGD surface, which can be made to yield a unique collection of 3D hollow dome microstructures with bubbles larger than 5 μm. Such capability can also be employed in concentrating suspended colloidal nanoparticles at desirable sites and with the preferred configuration enhancing the sensor performance. Specifically, the interaction among concentrated nanoparticles and their interactions with the underlying substrate have been investigated for the first time. These collections have been characterized using optical microscopy, scanning electron microscopy, hyperspectral localized surface plasmon resonance imaging, and hyperspectral Raman imaging. In addition to various micro- and nanoparticles, the plasmonic microbubbles are also shown to collect biological cells and extracellular nanovesicles such as exosomes. By using a spatial light modulator to project the laser in arbitrary patterns, parallel concentrating can be achieved to fabricate an array of clusters.
| S-EPMC7758966 | biostudies-literature
Project description:This paper demonstrates the design, synthesis, simulation, and testing of three distinct geometries of plasmonic gold nanoparticles for on-chip DNA screening towards liquid biopsy. By employing a seed-mediated growth method, we have synthesized gold nanospheres, nanorods, and nanobipyramids. In parallel, we developed numerical simulations to understand the effects of nanoparticle geometry on the resonance features and refractive index sensitivity. Both experimental and simulation results were compared through a series of studies including in-solution and on-chip tests. We have thoroughly characterized the impact of nanoparticle geometry on the sensitivity to circulating tumor DNA, with immediate implications for liquid biopsy. The results agree well with theoretical predictions and simulations, including both bulk refractive index sensitivity and thin film sensitivity. Importantly, this work quantitatively establishes the link between nanoparticle geometry and efficacy in detecting rare circulating biomarkers. The nanobipyramids provided the highest sensitivity, approximately doubling the sensitivity compared to nanorods. To the best of our knowledge this is the first report carrying through geometric effects of simulation to clinically relevant biosensing. We put forth here synthesis and testing of three nanoparticle geometries, and a framework for both experimental and theoretical validation of plasmonic sensitivities towards liquid biopsy.
| S-EPMC8270934 | biostudies-literature
Project description:Hydrophobic contaminants in food and the environment seriously threaten human health. The ultrasensitive detection of these pollutants can minimize their damage. However, current ultrasensitive sensing strategies are limited to solid substrate-based surface-enhanced Raman spectroscopy (SERS) detection. Herein, we report a controllable and reproducible solution-based SERS detection platform for the direct and ultrasensitive detection of hydrophobic contaminants by using self-assembled three-dimensional plasmonic vesicles. To this end, amphiphilic gold nanoparticles (AuNPs) tethered with linear block copolymer (BCP) of polystyrene-b-poly (ethylene oxide) (PS-b-PEO) were designed, which display dual functions for improving detection sensitivity, including serving as building blocks for the construction of plasmonic vesicles to yield large numbers of hot-spots for SERS enhancement, and providing hydrophobic PS layers to enrich and concentrate target hydrophobic molecules for direct SERS detection with hydrophobic interaction. By modulating the AuNP size and the length of BCP chains, the ultrahigh detection sensitivity, down to the picomolar level, was obtained via using 80 nm AuNPs tethered with BCP of PEO45-b-PS900-SH. In addition, the proposed method exhibits excellent reproducibility, universality, practicability, as well as multiplexing detection capacity in actual contaminant-spiked soil samples. Briefly, the designed self-assembled plasmonic vesicle-based SERS platform provides an ideal generic methodology for the ultrasensitive detection of hydrophobic contaminants that can greatly accelerate on-site testing in food and environmental monitoring.
| S-EPMC6069524 | biostudies-literature
Project description:Metal-insulator-metal (MIM) nanogaps in the canonical nanoparticle-on-mirror geometry (NPoM) provide deep-subwavelength confinement of light with mode volumes smaller than V/V λ < 10-6. However, access to these hotspots is limited by the impendence mismatch between the high in-plane k ∥ of trapped light and free-space plane-waves, making the in- and out-coupling of light difficult. Here, by constructing a nanoparticle-on-foil (NPoF) system with thin metal films, we show the mixing of insulator-metal-insulator (IMI) modes and MIM gap modes results in MIMI modes. This mixing provides multichannel access to the plasmonic nanocavity through light incident from both sides of the metal film. The red-tuning and near-field strength of MIMI modes for thinner foils is measured experimentally with white-light scattering and surface-enhanced Raman scattering from individual NPoFs. We discuss further the utility of NPoF systems, since the geometry allows tightly confined light to be accessed simply through different ports.
| S-EPMC8447257 | biostudies-literature
Project description:Paclitaxel (PTX) is used as a major antitumor agent for the treatment of recurrent and metastatic breast cancer. For the clinical application of PTX, it needs to be dissolved in an oil/detergent-based solvent due to its poor solubility in an aqueous medium. However, the formulation often causes undesirable complications including hypersensitivity reactions and limited tumor distribution, resulting in a lower dose-dependent antitumor effect. Herein, we introduce a facile and oil-free method to prepare albumin-based PTX nanoparticles for efficient systemic cancer therapy using a conjugate of human serum albumin (HSA) and poly(ethyleneglycol) (PEG). PTX were efficiently incorporated in the self-assembled HSA-PEG nanoparticles (HSA-PEG/PTX) using a simple film casting and re-hydration procedure without additional processes such as application of high pressure/shear or chemical crosslinking. The spherical HSA-PEG nanoparticle with a hydrodynamic diameter of ca. 280?nm mediates efficient cellular delivery, leading to comparable or even higher cytotoxicity in various breast cancer cells than that of the commercially available Abraxane®. When systemically administered in a mouse xenograft model for human breast cancer, the HSA-PEG-based nanoparticle formulation exhibited an extended systemic circulation for more than 96?h and enhanced intratumoral accumulation, resulting in a remarkable anticancer effect and prolonged survival of the animals.
| S-EPMC6060380 | biostudies-literature
Project description:Collagen mimetic peptides (CMPs) provide critical insight into the assembly, stability, and structure of the triple helical collagen protein. The majority of natural fibrous collagens are aab or abc heterotrimers, yet few examples of heterotrimeric CMPs have been reported. Previously, CMP heterotrimers have only been accessible by total syntheses or by introducing complementary interstrand electrostatic or steric interactions. Here, we describe an abc CMP heterotrimer in which each contributing CMP consists of only three amino acids: glycine, proline and 4-hydroxyproline. Assembly of the heterotrimeric triple helix is directed by a combination of metal-ion coordination to set the relative register of the CMPs, and minimization of valence frustration to direct heterotrimerization. Assembly of the four-component mixture is facile and extremely rapid, and equilibration to the abc heterotrimer occurs within a few hours at modestly elevated temperatures. The melting temperatures of the metal-assembled collagen trimers are higher by some 30°C than the apopeptide assemblies. Two iterations of the design are described, and the outcomes suggest possibilities for designing self-assembling abc and abb heterotrimers.
| S-EPMC3202058 | biostudies-literature
Project description:BACKGROUND: Few genetic markers useful for the screening of lung cancer risk exist. Although related research has shown that certain expression profiles of micro ribonucleic acids (miRNAs) are different in lung cancer versus the normal lung, such as miR-29a and miR-29s, the precise molecular mechanism of lung cancer remains obscure. In order to get a better understanding of the pathogenetic mechanism of lung cancer, we analyzed the differentially expressed genes (DEGs) and identified featured miRNAs in lung cancer tissues. METHODS: We used the gene expression profile GSE10072, including 49 gene chips of non-tumor tissues and 58 gene chips of lung tumor specimens. The DEGs between these two groups were identified by Limma package in R language. The TarBase database was used to construct the networks of miRNA regulating DEGs related to lung cancer. After ordering miRNAs regulating DEGs, we further screened featured miRNAs combined with the miR2Disease database. RESULTS: A total of 5572 DEGs were obtained between lung cancer and control specimens. After constructing a miRNA regulatory network, a total of 398 regulations between 57 miRNAs and 321 target genes existed. By intergrating the miR2Disease database and using a sorting algorithm, a total of six featured miRNAs related to lung cancer were identified, including miR-520h, miR-133a, miR-34, miR-103, miR-370, and miR-148. They might be involved in lung cancer progression by regulating ABCG2, PKM2, VAMP2, GPD1, MAP3K8, and DNMT3B, respectively. CONCLUSION: The top 10 significant miRNAs, such as miR-520h, miR-133a, miR-34, and miR-103 may be potential therapeutic targets for lung cancer.
| S-EPMC4511330 | biostudies-literature
Project description:The optical properties of metallic nanoparticles with plasmon resonances have been studied extensively, typically by measuring the transmission of light, as a function of wavelength, through a nanoparticle suspension. One question that has not yet been addressed, however, is how an image is transmitted through such a suspension of absorber-scatterers, in other words, how the various spatial frequencies are attenuated as they pass through the nanoparticle host medium. Here, we examine how the optical properties of a suspension of plasmonic nanoparticles affect the transmitted image. We use two distinct ways to assess transmitted image quality: the structural similarity index (SSIM), a perceptual distortion metric based on the human visual system, and the modulation transfer function (MTF), which assesses the resolvable spatial frequencies. We show that perceived image quality, as well as spatial resolution, are both dependent on the scattering and absorption cross-sections of the constituent nanoparticles. Surprisingly, we observe a nonlinear dependence of image quality on optical density by varying optical path length and nanoparticle concentration. This work is a first step toward understanding the requirements for visualizing and resolving objects through media consisting of subwavelength absorber-scatterer structures, an approach that should also prove useful in the assessment of metamaterial or metasurface-based optical imaging systems.
| S-EPMC4878496 | biostudies-literature