Heteroepitaxial Growth of Ferromagnetic MnSb(0001) Films on Ge/Si(111) Virtual Substrates.
Ontology highlight
ABSTRACT:
SUBMITTER: Burrows CW
PROVIDER: S-EPMC3880049 | biostudies-other | 2013 Nov
REPOSITORIES: biostudies-other
Similar Datasets
Project description:A thin, chemically inert 3C-SiC layer between GaN and Si helps not only to avoid the "melt-back" effect, but also to inhibit the crack generation in the grown GaN layers. The quality of GaN layer is heavily dependent on the unique properties of the available 3C-SiC/Si templates. In this paper, the parameters influencing the roughness, crystalline quality, and wafer bow are investigated and engineered to obtain high quality, low roughness 3C-SiC/Si templates suitable for subsequent GaN growth and device processing. Kinetic surface roughening and SiC growth mechanisms, which depend on both deposition temperature and off-cut angle, are reported for heteroepitaxial growth of 3C-SiC on Si substrates. The narrower terrace width on 4° off-axis Si enhances the step-flow growth at 1200 °C, with the roughness of 3C-SiC remaining constant with increasing thickness, corresponding to a scaling exponent of zero. Crack-free 3C-SiC grown on 150-mm Si substrate with a wafer bow of less than 20 μm was achieved. Both concave and convex wafer bow can be obtained by in situ tuning of the deposited SiC layer thicknesses. The 3C-SiC grown on off-axis Si, compared to that grown on on-axis Si, has lower surface roughness, better crystallinity, and smaller bow magnitude.
| S-EPMC4614071 | biostudies-other
Project description:During cooling, conventional martensitic transformation can only be realized from austenite to martensite. Recently, a so-called reentrant martensitic transformation attracted much interest due to an additional transformation from martensite to austenite during further cooling. Obviously, materials with this reentrant transformation will increase the number of physical effects and possible applications. However, until now, only bulk samples have been available, which are not suitable for applications in micro-devices. In this work, we focus on the Co-Cr-Ga-Si system and examine the suitability of this system for the growth of thin films. We observed that the films grow epitaxially on MgO (100) substrates and exhibit a martensitic transformation if deposited at a sufficiently high temperature or with an additional heat treatment. Films within the austenite state are ferromagnetic while films within the martensitic state just exhibit a very low ferromagnetic order.
| S-EPMC10496528 | biostudies-literature
Project description:The successful integration of graphene into microelectronic devices is strongly dependent on the availability of direct deposition processes, which can provide uniform, large area and high quality graphene on nonmetallic substrates. As of today the dominant technology is based on Si and obtaining graphene with Si is treated as the most advantageous solution. However, the formation of carbide during the growth process makes manufacturing graphene on Si wafers extremely challenging. To overcome these difficulties and reach the set goals, we proposed growth of high quality graphene layers by the CVD method on Ge(100)/Si(100) wafers. In addition, a stochastic model was applied in order to describe the graphene growth process on the Ge(100)/Si(100) substrate and to determine the direction of further processes. As a result, high quality graphene was grown, which was proved by Raman spectroscopy results, showing uniform monolayer films with FWHM of the 2D band of 32 cm(-1).
| S-EPMC4761869 | biostudies-other
Project description:The growth of α-quartz-based piezoelectric thin films opens the door to higher-frequency electromechanical devices than those available through top-down approaches. We report on the growth of SiO2/GeO2 thin films by pulsed laser deposition and their subsequent crystallization. By introducing a devitrifying agent uniformly within the film, we are able to obtain the α-quartz phase in the form of platelets with lateral sizes above 100 μm at accessible temperatures. Films containing different amounts of devitrifying agent are investigated, and their crystallinity is ascertained with X-ray diffraction and electron back-scatter diffraction. Our work highlights the difficulty in crystallization when competing phases arise that have markedly different crystalline orientation.
| S-EPMC8305750 | biostudies-literature
Project description:We investigate the formation of extended defects during molecular-dynamics (MD) simulations of GaN and InGaN growth on (0001) and ([Formula: see text]) wurtzite-GaN surfaces. The simulated growths are conducted on an atypically large scale by sequentially injecting nearly a million individual vapor-phase atoms towards a fixed GaN surface; we apply time-and-position-dependent boundary constraints that vary the ensemble treatments of the vapor-phase, the near-surface solid-phase, and the bulk-like regions of the growing layer. The simulations employ newly optimized Stillinger-Weber In-Ga-N-system potentials, wherein multiple binary and ternary structures are included in the underlying density-functional-theory training sets, allowing improved treatment of In-Ga-related atomic interactions. To examine the effect of growth conditions, we study a matrix of >30 different MD-growth simulations for a range of In x Ga 1-x N-alloy compositions (0???x???0.4) and homologous growth temperatures [0.50???T/T*m (x)???0.90], where T*m (x) is the simulated melting point. Growths conducted on polar (0001) GaN substrates exhibit the formation of various extended defects including stacking faults/polymorphism, associated domain boundaries, surface roughness, dislocations, and voids. In contrast, selected growths conducted on semi-polar ([Formula: see text]) GaN, where the wurtzite-phase stacking sequence is revealed at the surface, exhibit the formation of far fewer stacking faults. We discuss variations in the defect formation with the MD growth conditions, and we compare the resulting simulated films to existing experimental observations in InGaN/GaN. While the palette of defects observed by MD closely resembles those observed in the past experiments, further work is needed to achieve truly predictive large-scale simulations of InGaN/GaN crystal growth using MD methodologies.
| S-EPMC5432374 | biostudies-literature
Project description:Perovskite oxynitrides have been studied with regard to their visible light-driven photocatalytic activity and novel electronic functionalities. The assessment of the intrinsic physical and/or electrochemical properties of oxynitrides requires the epitaxial growth of single-crystalline films. However, the heteroepitaxy of perovskite oxynitrides has not yet matured compared to the progress realized in work with perovskite oxides. Herein, we report the heteroepitaxial growth of CaTaO2N thin films with (100)pc, (110)pc, and (111)pc crystallographic surface orientations (where the subscript pc denotes a pseudocubic cell) on SrTiO3 substrates using reactive radio frequency magnetron sputtering, along with investigations of crystallinity and surface morphology. Irrespective of surface orientation, stoichiometric CaTaO2N epitaxial thin films were grown coherently on SrTiO3 substrates and showed clear step and terrace surfaces in the case of low values of film thickness of approximately 20 nm. A (110)pc-oriented film was also more highly crystalline than (100)pc- and (111)pc-oriented specimens. This relationship between crystallinity and surface orientation is ascribed to the number of inequivalent in-plane rotational domains, which stems from the symmetry mismatch between the orthorhombic CaTaO2N and cubic SrTiO3. A CaTaO2N thin film grown on a lattice- and symmetry-matched orthorhombic DyScO3 substrate exhibited a significant crystallinity and a clear step and terrace surface even though the film was thick (?190 nm). These results are expected to assist in developing the heteroepitaxial growth of high-quality perovskite oxynitride thin films.
| S-EPMC7288696 | biostudies-literature
Project description:The epitaxial growth of silicene has been the subject of many investigations, controversies and non-classical results. In particular, the initially promising deposition of Si on a metallic substrate such as Ag(111) has revealed unexpected growth modes where Si is inserted at the beginning of the growth in the first atomic plane of the substrate. In order to rationalize this anomalous growth mode, we develop an out-of-equilibrium description of a lattice-based epitaxial growth model, which growth dynamics are analyzed via kinetic Monte-Carlo simulations. This model incorporates several effects revealed by the experiments such as the intermixing between Si and Ag, and surface effects. It is parametrized thanks to an approach in which we show that relatively precise estimates of energy barriers can be deduced by meticulous analysis of atomic microscopy images. This analysis enables us to reproduce both qualitatively and quantitatively the anomalous growth patterns of Si on Ag(111). We show that the dynamics results in two modes, a classical sub-monolayer growth mode at low temperature, and an inserted growth mode at higher temperatures, where the deposited Si atoms insert in the first layer of the substrate by replacing Ag atoms. Furthermore, we reproduce the non-standard [Formula: see text] shape of the experimental plot of the island density as a function of temperature, with a shift in island density variation during the transition between the submonoloyer and inserted growth modes.
| S-EPMC10825137 | biostudies-literature
Project description:Over the past three decades, the growth of Bi thin films has been extensively explored due to their potential applications in various fields such as thermoelectrics, ferroelectrics, and recently for topological and neuromorphic applications, too. Despite significant research efforts in these areas, achieving reliable and controllable growth of high-quality Bi thin-film allotropes has remained a challenge. Previous studies have reported the growth of trigonal and orthorhombic phases on various substrates yielding low-quality epilayers characterized by surface morphology. In this study, we present a systematic growth investigation, enabling the high-quality growth of Bi epilayers on Bi-terminated Si (111) 1 × 1 surfaces using molecular beam epitaxy. Our work yields a phase map that demonstrates the realization of trigonal, orthorhombic, and pseudocubic thin-film allotropes of Bi. In-depth characterization through X-ray diffraction (XRD) techniques and scanning transmission electron microscopy (STEM) analysis provides a comprehensive understanding of phase segregation, phase stability, phase transformation, and phase-dependent thickness limitations in various Bi thin-film allotropes. Our study provides recipes for the realization of high-quality Bi thin films with desired phases, offering opportunities for the scalable refinement of Bi into quantum and neuromorphic devices and for revisiting technological proposals for this versatile material platform from the past 30 years.
| S-EPMC10386495 | biostudies-literature
Project description:High-quality AlN epitaxial films have been grown on Si substrates by pulsed laser deposition (PLD) by effective control of the interfacial reactions between AlN films and Si substrates. The surface morphology, crystalline quality and interfacial property of as-grown AlN/Si hetero-interfaces obtained by PLD have been systemically studied. It is found that the amorphous SiAlN interfacial layer is formed during high temperature growth, which is ascribed to the serious interfacial reactions between Si atoms diffused from the substrates and the AlN plasmas produced by the pulsed laser when ablating the AlN target during the high temperature growth. On the contrary, abrupt and sharp AlN/Si hetero-interfaces can be achieved by effectively controlling the interfacial reactions at suitable growth temperature. The mechanisms for the evolution of interfacial layer from the amorphous SiAlN layer to the abrupt and sharp AlN/Si hetero-interfaces by PLD are hence proposed. This work of obtaining the abrupt interfaces and the flat surfaces for AlN films grown by PLD is of paramount importance for the application of high-quality AlN-based devices on Si substrates.
| S-EPMC4473646 | biostudies-other
Project description:The heteroepitaxial growth of vertically aligned gallium
| S-EPMC9631740 | biostudies-literature