Browse
Submit Data
Databases
API
Help

Dataset Information

0 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Theoretical modeling of relative humidity on contact electrification of sand particles.

ABSTRACT: Contact electrification of identical insulating particles has crucial significance for industrial and environmental science, especially in wind-blown granular systems. At the same time, the experimental phenomena of charge transfer first increased and then decreased with the increase of relative humidity has attracted the interest of many researchers. Humidity can affect the charge transfer has been early observed in the experiment, but the reason always puzzles researchers. In this study, based on trapped high-energy electron transfer mechanism, we introduce the effect of the water film in the charge transfer model and consider the actual situations of the sand particles in the collision process. Furthermore, charge transfer between sand particles in a single collision under different humidity conditions is investigated. The predicted results agree well with the law obtained in existing experiments qualitatively and thereby a possible explanation why humidity can affect the charge transfer is given.

SUBMITTER: Zheng X

PROVIDER: S-EPMC3957149 | biostudies-other | 2014

REPOSITORIES: biostudies-other

ACCESS DATA

Json Xml

Similar Datasets

Fundamental investigation of photoacoustic signal generation from single aerosol particles at varying relative humidity.

Project description:Photoacoustic (PA) spectroscopy enjoys widespread applications across atmospheric sciences. However, experimental biases and limitations originating from environmental conditions and particle size distributions are not fully understood. Here, we combine single-particle photoacoustics with modulated Mie scattering to unravel the fundamental physical processes occurring during PA measurements on aerosols. We perform measurements on optically trapped droplets of varying sizes at different relative humidity. Our recently developed technique - photothermal single-particle spectroscopy (PSPS) - enables fundamental investigations of the interplay between the heat flux and mass flux from single aerosol particles. We find that the PA phase is more sensitive to water uptake by aerosol particles than the PA amplitude. We present results from a model of the PA phase, which sheds further light onto the dependence of the PA phase on the mass flux phenomena. The presented work provides fundamental insights into photoacoustic signal generation of aerosol particles.

| S-EPMC7082628 | biostudies-literature

Solid organic-coated ammonium sulfate particles at high relative humidity in the summertime Arctic atmosphere.

Project description:SignificancePhysical and chemical properties of individual atmospheric particles determine their climate impacts. Hygroscopic inorganic salt particles mixed with trace amounts of organic material are predicted to be liquid under typical tropospheric conditions in the summertime Arctic. Yet, we unexpectedly observed a significant concentration of solid particles composed of ammonium sulfate with an organic coating under conditions of high relative humidity and low temperature. These particle properties are consistent with marine biogenic-derived new particle formation and growth, with particle collision hypothesized to result in the solid phase. This particle source is predicted to have increasing relevance in the context of declining Arctic sea ice and increasing open water, with impacts on clouds, and therefore climate.

| S-EPMC9168484 | biostudies-literature

Relative humidity influences microbial communities

Project description:Relative humidity influences microbial communities

| PRJEB11542 | ENA

Effect of relative humidity, storage days, and packaging on pecan kernel texture: Analyses and modeling.

Project description:The studies expounding on the effects of storage conditions on texture changes are limited. The researchers have been proposing methods to measure pecan texture instrumentally. But current protocols and/or attributes fail to address huge variability during experimentation. Additionally, there are no predictive models to estimate changes in pecan texture during storage. This study addresses all the above concerns and investigates the effects of different relative humidity (RH, 30-90%) and packaging material (Polyethylene-Nylon [PEN], polypropylene [PP], low density polyethylene [LDPE], and metallic laminates [ML]) on pecan texture, introducing a rift ratio (F/H or fracturability to hardness ratio) to address variability in the data and predictive model to estimate changes in the textural attribute of pecans during storage. The textural analysis was conducted on pecan cores and intact pecans to measure the area under curve, fracturability, hardness, cohesiveness, chewiness, springiness, and rift ratio. It was observed that values for the rift ratio obtained using the intact pecan method had high R2 (0.72) as compared to the rest of the textural attributes. A three-parameter logistic model was employed to predict pecan texture during storage. The pecans stored at 75, 80, and 90% reached the rift ratio (F/H) of 0.5 at approx. 115, 3, and 0.15 days (~ 4 hr), respectively. Similarly, pecans stored in LDPE, PP, and PEN packs at 80% reached rift ratio (F/H) of 0.5 at approx. 26, 57, and 78 days, respectively. The presence of any kind of package delayed fracturability loss by at least eight folds at 80% RH. The pecans stored in ML did not experience a significant change in textural attributes.

| S-EPMC10092868 | biostudies-literature

Modeling the impact of indoor relative humidity on the infection risk of five respiratory airborne viruses.

Project description:With a modified version of the Wells-Riley model, we simulated the size distribution and dynamics of five airborne viruses (measles, influenza, SARS-CoV-2, human rhinovirus, and adenovirus) emitted from a speaking person in a typical residential setting over a relative humidity (RH) range of 20-80% and air temperature of 20-25 °C. Besides the size transformation of virus-containing droplets due to evaporation, respiratory absorption, and then removal by gravitational settling, the modified model also considered the removal mechanism by ventilation. The trend and magnitude of RH impact depended on the respiratory virus. For rhinovirus and adenovirus humidifying the indoor air from 20/30 to 50% will be increasing the relative infection risk, however, this relative infection risk increase will be negligible for rhinovirus and weak for adenovirus. Humidification will have a potential benefit in decreasing the infection risk only for influenza when there is a large infection risk decrease for humidifying from 20 to 50%. Regardless of the dry solution composition, humidification will overall increase the infection risk via long-range airborne transmission of SARS-CoV-2. Compared to humidification at a constant ventilation rate, increasing the ventilation rate to moderate levels 0.5 → 2.0 h-1 will have a more beneficial infection risk decrease for all viruses except for influenza. Increasing the ventilation rate from low values of 0.5 h-1 to higher levels of 6 h-1 will have a dominating effect on reducing the infection risk regardless of virus type.

| S-EPMC9261129 | biostudies-literature

What's the relative humidity in tropical caves?

Project description:Relative humidity (RH) was measured at hourly intervals for approximately one year in two caves at seven stations near Playa del Carmen in Quintana Roo, Mexico. Sistema Muévelo Rico is a 1.1 km long cave with 12 entrances and almost no dark zone. Río Secreto (Tuch) is a large river cave with more than 40 km of passages, and an extensive dark zone. Given the need for cave specialists to adapt to saturated humidity, presumably by cuticular thinning, the major stress of RH would be its deviation from saturation. RH in Río Secreto (Tuch) was invariant at three sites and displayed short deviations from 100% RH at the other four sites. These deviations were concentrated at the end of the nortes and beginning of the rainy season. Three of the sites in Sistema Muévelo Rico showed a similar pattern although the timing of the deviations from 100% RH was somewhat displaced. Four sites in Sistema Muévelo Rico were more variable, and were analyzed using a measure of amount of time of deviation from 100% RH for each 24 hour period. Strong seasonality was evident but, remarkably, periods of constant high humidity were not the same at all sites. In most Sistema Muévelo Rico sites, there was a detectable 24 hour cycle in RH, although it was quite weak in about half of them. For Río Secreto (Tuch) only one site showed any sign of a 24 hour cycle. The troglomorphic fauna was more or less uniformly spread throughout the caves and did not concentrate in any one area or set of RH conditions. Compared to temperature, RH is much more constant, perhaps even more constant than the amount of light. However, changes in RH as a result of global warming may have a major negative effect on the subterranean fauna.

| S-EPMC8457490 | biostudies-literature

Wind-blown Sand Electrification Inspired Triboelectric Energy Harvesting Based on Homogeneous Inorganic Materials Contact: A Theoretical Study and Prediction.

Project description:Triboelectric nanogenerator (TENG) based on contact electrification between heterogeneous materials has been widely studied. Inspired from wind-blown sand electrification, we design a novel kind of TENG based on size dependent electrification using homogeneous inorganic materials. Based on the asymmetric contact theory between homogeneous material surfaces, a calculation of surface charge density has been carried out. Furthermore, the theoretical output of homogeneous material based TENG has been simulated. Therefore, this work may pave the way of fabricating TENG without the limitation of static sequence.

| S-EPMC4730222 | biostudies-other

Modeling and simulation of the transient response of temperature and relative humidity sensors with and without protective housing.

Project description:Based on the necessity for enclosure protection of temperature and relative humidity sensors installed in a hostile environment, a wind tunnel was used to quantify the time that the sensors take to reach equilibrium in the environmental conditions to which they are exposed. Two treatments were used: (1) sensors with polyvinyl chloride (PVC) enclosure protection, and (2) sensors with no enclosure protection. The primary objective of this study was to develop and validate a 3-D computational fluid dynamics (CFD) model for analyzing the temperature and relative humidity distribution in a wind tunnel using sensors with PVC enclosure protection and sensors with no enclosure protection. A CFD simulation model was developed to describe the temperature distribution and the physics of mass transfer related to the airflow relative humidity. The first results demonstrate the applicability of the simulation. For verification, a sensor device was successfully assembled and tested in an environment that was optimized to ensure fast change conditions. The quantification setup presented in this paper is thus considered to be adequate for testing different materials and morphologies for enclosure protection. The results show that the boundary layer flow regime has a significant impact on the heat flux distribution. The results indicate that the CFD technique is a powerful tool which provides a detailed description of the flow and temperature fields as well as the time that the relative humidity takes to reach equilibrium with the environment in which the sensors are inserted.

| S-EPMC4031210 | biostudies-literature

Fecal indicators in sand, sand contact, and risk of enteric illness among beachgoers.

Project description:BackgroundBeach sand can harbor fecal indicator organisms and pathogens, but enteric illness risk associated with sand contact remains unclear.MethodsIn 2007, visitors at 2 recreational marine beaches were asked on the day of their visit about sand contact. Ten to 12 days later, participants answered questions about health symptoms since the visit. F+ coliphage, Enterococcus, Bacteroidales, fecal Bacteroides, and Clostridium spp. in wet sand were measured using culture and molecular methods.ResultsWe analyzed 144 wet sand samples and completed 4999 interviews. Adjusted odds ratios (aORs) were computed, comparing those in the highest tertile of fecal indicator exposure with those who reported no sand contact. Among those digging in sand compared with those not digging in sand, a molecular measure of Enterococcus spp. (calibrator cell equivalents/g) in sand was positively associated with gastrointestinal (GI) illness (aOR = 2.0 [95% confidence interval (CI) = 1.2-3.2]) and diarrhea (2.4 [1.4-4.2]). Among those buried in sand, point estimates were greater for GI illness (3.3 [1.3-7.9]) and diarrhea (4.9 [1.8-13]). Positive associations were also observed for culture-based Enterococcus (colony-forming units/g) with GI illness (aOR digging = 1.7 [1.1-2.7]) and diarrhea (2.1 [1.3-3.4]). Associations were not found among nonswimmers with sand exposure.ConclusionsWe observed a positive relationship between sand-contact activities and enteric illness as a function of concentrations of fecal microbial pollution in beach sand.

| S-EPMC3240855 | biostudies-literature

Modeling microbial growth in carpet dust exposed to diurnal variations in relative humidity using the "Time-of-Wetness" framework.

Project description:Resuspension of microbes in floor dust and subsequent inhalation by human occupants is an important source of human microbial exposure. Microbes in carpet dust grow at elevated levels of relative humidity, but rates of this growth are not well established, especially under changing conditions. The goal of this study was to model fungal growth in carpet dust based on indoor diurnal variations in relative humidity utilizing the time-of-wetness framework. A chamber study was conducted on carpet and dust collected from 19 homes in Ohio, USA and exposed to varying moisture conditions of 50%, 85%, and 100% relative humidity. Fungal growth followed the two activation regime model, while bacterial growth could not be evaluated using the framework. Collection site was a stronger driver of species composition (P = 0.001, R2 = 0.461) than moisture conditions (P = 0.001, R2 = 0.021). Maximum moisture condition was associated with species composition within some individual sites (P = 0.001-0.02, R2 = 0.1-0.33). Aspergillus, Penicillium, and Wallemia were common fungal genera found among samples at elevated moisture conditions. These findings can inform future studies of associations between dampness/mold in homes and health outcomes and allow for prediction of microbial growth in the indoor environment.

| S-EPMC7496831 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data