Magnetic field tunable small-scale mechanical properties of nickel single crystals measured by nanoindentation technique.
Ontology highlight
ABSTRACT:
SUBMITTER: Zhou H
PROVIDER: S-EPMC3974134 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Nanoindentation enables the measurement of mechanical properties from single crystals with dimensions of a few micrometers. This experimental technique, however, has only recently been applied to molecular crystals. Key differences between the application of this technique to molecular crystals and metals and other inorganics are identified. From this, protocols for the measurement of hardness and elastic modulus of molecular crystals of pharmaceutical interest are proposed. Using form I aspirin as a model system, the impact of single crystal sample surface preparation (washing and cleaving) on the surface roughness is explored. We show the importance of using a calibration sample with hardness and stiffness close to that of molecular crystals for the acquisition of more accurate data. The issue of solvent occlusions formed during crystal growth is discussed as a source of material property variation as well as tip contamination. It is proposed that this in part explains the significantly larger variation of the measured mechanical properties among different single crystals compared to those performed on a unique sample. Because both the indentation modulus and the hardness can vary significantly for low depth indents, samples were tested over a wide range of depths, which revealed that a minimum depth of penetration is required for the acquisition of data. This experiment is crucial and needs to be carried out for every system under study since it allows for the determination of the minimum-working load. Post-indentation imaging combined with crystallographic analysis and molecular simulations allows for the characterization and rationalization of the material plastic deformation mechanisms.
| S-EPMC7587144 | biostudies-literature
Project description:This work presents an experimental study on the dislocation luminescence in GaN by nanoindentation, cathodoluminescence, and Raman. The dislocation luminescence peaking at 3.12 eV exhibits a series of special properties in the cathodoluminescence measurements, and it completely disappears after annealing at 500°C. Raman spectroscopy shows evidence for existence of vacancies in the indented region. A comprehensive investigation encompassing cathodoluminescence, Raman, and annealing experiments allow the assignment of dislocation luminescence to conduction-band-acceptor transition involving Ga vacancies. The nanoscale plasticity of GaN can be better understood by considering the dislocation luminescence mechanism.
| S-EPMC4275118 | biostudies-literature
Project description:Living cells sense the mechanical features of their environment and adapt to it by actively remodeling their peripheral network of filamentary proteins, known as cortical cytoskeleton. By mimicking this principle, we demonstrate an effective control strategy for a microtubule-based active nematic in contact with a hydrophobic thermotropic liquid crystal. By using well-established protocols for the orientation of liquid crystals with a uniform magnetic field, and through the mediation of anisotropic shear stresses, the active nematic reversibly self-assembles with aligned flows and textures that feature orientational order at the millimeter scale. The turbulent flow, characteristic of active nematics, is in this way regularized into a laminar flow with periodic velocity oscillations. Once patterned, the microtubule assembly reveals its intrinsic length and time scales, which we correlate with the activity of motor proteins, as predicted by existing theories of active nematics. The demonstrated commanding strategy should be compatible with other viable active biomaterials at interfaces, and we envision its use to probe the mechanics of the intracellular matrix.
| S-EPMC4878504 | biostudies-literature
Project description:Heat-resistant magnetic polymer composites were prepared by incorporating cerium-doped copper-nickel ferrite particles, having the general formula Ni1-xCuxFe1.92Ce0.08O4 (x: 0.0, 0.3, 0.6, 1.0), into a polyimide matrix. The effects of particle type and concentration on the thermal, magnetic, and electrical properties of the resulting composites were investigated. The samples were characterized by FTIR, scanning electron microscopy, X-ray diffractometry, thermogravimetric analysis, differential scanning calorimetry, vibrating sample magnetometer, and broadband dielectric spectroscopy. The composites exhibited high thermal stability, having initial decomposition temperatures between 495 and 509 °C. Saturation magnetization (Ms), magnetic remanence (Mr), and coercivity (Hc) were found in range of 2.37-10.90 emu g-1, 0.45-2.84 emu g-1, and 32-244 Oe, respectively. The study of dielectric properties revealed dielectric constant values of 3.0-4.3 and low dielectric losses of 0.016-0.197 at room temperature and a frequency of 1 Hz.
| S-EPMC8158717 | biostudies-literature
Project description:This article contains data related to the research article entitled "Atomistic simulation on nanomechanical response of indented graphene/nickel system" (Yan et al., 2017). There are five sets of data obtained by molecular dynamics simulations for nanoindentation of five different graphene/nickel systems, which are single nickel system, monolayer graphene on nickel system, double-layer graphene on nickel system, three-layer graphene on nickel system and four-layer graphene on nickel system. The calculated load-displacement of the five different indented systems is also listed.
| S-EPMC5995748 | biostudies-literature
Project description:Results from nanoindentation of aluminum single crystals deliver valuable information as model systems for understanding technical aluminum alloys. The effect of the crystal orientation and the azimuthal indenter orientation on indentation hardness and modulus was studied by Vickers indentation (max. load 10 mN) on single crystal surfaces with (100), (110), and (111) orientations. The average indentation hardness varied, depending on the crystallographic orientation, by 1.8%. The anisotropy of the elastic modulus (1.1% of the average modulus) is lowered (indentation averaging effect). This is predicted by explicit approximation of the contact problem (conical indenter, orthotropic material). It was found that indentation hardness and modulus vary periodically with the azimuthal indenter orientation on (100)- and (110)-oriented surfaces (relative amplitude of 1.8% for indentation hardness and 2.6% of the modulus). This is attributed to the combined effect of the indenter geometry and crystal symmetry. For the first time, this effect was quantified for aluminum single crystals.
| S-EPMC6887952 | biostudies-literature
Project description:This article focuses on mapping the Sun's large-scale magnetic fields. In particular, the model considers how photospheric fields evolve in time. Our solar field mapping method uses Netlogo's cellular automata software via algorithms to carry out the movement of magnetic field on the Sun via agents. This model's entities consist of two breeds: blue and red agents. The former carry a fixed amount of radially outward magnetic flux: 10(23) Mx, and the latter, the identical amount of inward directed flux. The individual agents are distinguished, for clarity, by various shades of blue and red arrows whose orientation indicates the direction the agents are moving, relative to the near-steady bulk fluid motions. The fluid motions generally advect the field with the well known meridional circulation and differential rotation. Our model predominantly focuses on spatial and temporal variations from the bulk fluid motions owing to magnetic interactions. There are but a few effects that agents have on each other: i) while at the poles, field agents are connected via the Babcock - Leighton (B - L) subsurface field to other latitudes. This allows them to undertake two duties there: A) the B - L subsurface field spawns the next generation of new magnetic field via new agents, and B) the B - L subsurface field attracts lower-latitude fields via the "long-range" magnetic stress tension; ii) nearby agents affect each other's motion by short-range interactions; and iii) through annihilation: when opposite field agents get too close to each other, they disappear in pairs. The behavior of the agents' long- and short-range magnetic forces is discussed within this paper as well as the model's use of internal boundary conditions. The workings of the model may be seen in the accompanying movies and/or by using the software available via SpringerPlus' website, or on the Netlogo (TM) community website, where help is readable available, and should all these fail, some help from the author.
| S-EPMC3601253 | biostudies-literature
Project description:We report the observation of synthesized spin-orbit coupling (SOC) for ultracold spin-1 (87)Rb atoms. Different from earlier experiments where a one dimensional (1D) atomic SOC of pseudo-spin-1/2 is synthesized with Raman laser fields, the scheme we demonstrate employs a gradient magnetic field (GMF) and ground-state atoms, thus is immune to atomic spontaneous emission. The strength of SOC we realize can be tuned by changing the modulation amplitude of the GMF, and the effect of the SOC is confirmed through the studies of: 1) the collective dipole oscillation of an atomic condensate in a harmonic trap after the synthesized SOC is abruptly turned on; and 2) the minimum energy state at a finite adiabatically adjusted momentum when SOC strength is slowly ramped up. The condensate coherence is found to remain very good after driven by modulating GMFs. Our scheme presents an alternative means for studying interacting many-body systems with synthesized SOC.
| S-EPMC4707438 | biostudies-literature
Project description:The interplay between transcription factors, chromatin remodelers, 3-D organization, and mechanical properties of the chromatin fiber controls genome function in eukaryotes. Besides the canonical histones which fold the bulk of the chromatin into nucleosomes, histone variants create distinctive chromatin domains that are thought to regulate transcription, replication, DNA damage repair, and faithful chromosome segregation. Whether histone variants translate distinctive biochemical or biophysical properties to their associated chromatin structures, and whether these properties impact chromatin dynamics as the genome undergoes a multitude of transactions, is an important question in biology. Here, we describe single-molecule nanoindentation tools that we developed specifically to determine the mechanical properties of histone variant nucleosomes and their complexes. These methods join an array of cutting-edge new methods that further our quantitative understanding of the response of chromatin to intrinsic and extrinsic forces which act upon it during biological transactions in the nucleus.
| S-EPMC7529419 | biostudies-literature
Project description:This work presents the nanoindentation and XPS results of a newly-developed biomaterial of titanium TNZ alloy after different surface treatments. The investigations were performed on the samples AR (as received), EP (after a standard electropolishing) and MEP (after magnetoelectropolishing). The electropolishing processes, both EP and MEP, were conducted in the same proprietary electrolyte based on concentrated sulfuric acid. The mechanical properties of the titanium TNZ alloy biomaterial demonstrated an evident dependence on the surface treatment method, with MEP samples revealing extremely different behavior and mechanical properties. The reason for that different behavior appeared to be influenced by the surface film composition, as revealed by XPS study results displayed in this work. The increase of niobium and zirconium in the surface film of the same titanium TNZ alloy after magnetoelectropolishing MEP treatment is meaningful and especially advantageous considering the application of this alloy as a biomaterial.
| S-EPMC5455239 | biostudies-other