The high-speed sliding friction of graphene and novel routes to persistent superlubricity.
Ontology highlight
ABSTRACT:
SUBMITTER: Liu Y
PROVIDER: S-EPMC4007076 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:The origin of ultra-low friction exhibited by heterogeneous junctions of graphene and hexagonal boron nitride (h-BN) is revealed. For aligned interfaces, we identify a characteristic contact size, below which the junction behaves like its homogeneous counterparts with friction forces that grow linearly with the contact area. Superlubricity sets in due to the progressive appearance of Moiré patterns resulting in a collective stick-slip motion of the elevated super-structure ridges that turns into smooth soliton-like gliding with increasing contact size. Incommensurability effects are enhanced in misaligned contacts, where the friction coefficients further drop by orders of magnitude. Our fully atomistic simulations show that the superlubric regime in graphene/h-BN heterostructures persists up to significantly higher loads compared to the well-studied twisted homogeneous graphene interface. This indicates the potential of achieving robust superlubricity in practical applications using two-dimensional layered materials heterojunctions.
| S-EPMC5589749 | biostudies-literature
Project description:Sliding contact experiments and first-principles calculations were performed to elucidate the roles of structural defects and water dissociative adsorption process on the tribo-chemical mechanisms responsible for low friction of graphene. Sliding friction tests conducted in ambient air and under a dry N2 atmosphere showed that in both cases a high running-in coefficient of friction (COF) occurred initially but a low steady-state COF was reached only when the sliding was continued in air with moisture. Density functional theory (DFT) calculations indicated that the energy barrier (E b ) for dissociative adsorption of H2O was significantly lower in case of reconstructed graphene with a monovacancy compared to pristine graphene. Cross-sectional transmission electron microscopy of graphene transferred to the counterface revealed a partly amorphous structure incorporating damaged graphene layers with d-spacings larger than that of the original layers. DFT calculations on the reconstructed bilayer AB graphene systems revealed an increase of d-spacing due to the chemisorption of H, O, and OH at the vacancy sites and a reduction in the interlayer binding energy (E B ) between the bilayer graphene interfaces compared to pristine graphene. Thus, sliding induced defects facilitated dissociative adsorption of water molecules and reduced COF of graphene for sliding tests under ambient and humid environments but not under an inert atmosphere.
| S-EPMC5760666 | biostudies-literature
Project description:Friction is a complicated phenomenon involving nonlinear dynamics at different length and time scales. Understanding its microscopic origin requires methods for measuring force on nanometer-scale asperities sliding at velocities reaching centimetres per second. Despite enormous advances in experimental technique, this combination of small length scale and high velocity remain elusive. We present a technique for rapidly measuring the frictional forces on a single asperity over a velocity range from zero to several centimetres per second. At each image pixel we obtain the velocity dependence of both conservative and dissipative forces, revealing the transition from stick-slip to smooth sliding friction. We explain measurements on graphite using a modified Prandtl-Tomlinson model, including the damped elastic deformation of the asperity. With its improved force sensitivity and small sliding amplitude, our method enables rapid and detailed surface mapping of the velocity dependence of frictional forces with less than 10 nm spatial resolution.
| S-EPMC5159861 | biostudies-literature
Project description:In a pioneer experiment, Bohlein et al. realized the controlled sliding of two-dimensional colloidal crystals over laser-generated periodic or quasi-periodic potentials. Here we present realistic simulations and arguments that besides reproducing the main experimentally observed features give a first theoretical demonstration of the potential impact of colloid sliding in nanotribology. The free motion of solitons and antisolitons in the sliding of hard incommensurate crystals is contrasted with the soliton-antisoliton pair nucleation at the large static friction threshold F(s) when the two lattices are commensurate and pinned. The frictional work directly extracted from particles' velocities can be analyzed as a function of classic tribological parameters, including speed, spacing, and amplitude of the periodic potential (representing, respectively, the mismatch of the sliding interface and the corrugation, or "load"). These and other features suggestive of further experiments and insights promote colloid sliding to a unique friction study instrument.
| S-EPMC3478638 | biostudies-literature
Project description:In order to achieve speed control of high-speed permanent magnet synchronous motor with high precision, the sliding mode control (SMC) is usually adopted. However, the inherent chattering phenomenon affects the speed control performance. In order to solve this problem, a composite speed regulator is proposed in this paper, which is made up of two parts: the adaptive full-order SMC and extended state observer (ESO). Switching gain adaption law is proposed for minimizing chattering as much as possible while ensuring the robustness of sliding mode control. The total disturbance is estimated by the ESO and through feedforward, thus improving the system anti-disturbance ability. Finally, the effectiveness of the proposed speed regulator has been validated in the test bench.
| S-EPMC10110560 | biostudies-literature
Project description:In sliding friction, different energy dissipation channels have been proposed, including phonon and electron systems, plastic deformation, and crack formation. However, how energy is coupled into these channels is debated, and especially, the relevance of electronic dissipation remains elusive. Here, we present friction experiments of a single-asperity sliding on a high-T c superconductor from 40 to 300 kelvin. Overall, friction decreases with temperature as generally expected for nanoscale energy dissipation. However, we also find a large peak around T c. We model these results by a superposition of phononic and electronic friction, where the electronic energy dissipation vanishes below T c. In particular, we find that the electronic friction constitutes a constant offset above T c, which vanishes below T c with a power law in agreement with Bardeen-Cooper-Schrieffer theory. While current point contact friction models usually neglect such friction contributions, our study shows that electronic and phononic friction contributions can be of equal size.
| S-EPMC7083612 | biostudies-literature
Project description:Oxidative wet-chemical delamination of graphene from graphite is expected to become a scalable production method. However, the formation process of the intermediate stage-1 graphite sulfate by sulfuric acid intercalation and its subsequent oxidation are poorly understood and lattice defect formation must be avoided. Here, we demonstrate film formation of micrometer-sized graphene flakes with lattice defects down to 0.02% and visualize the carbon lattice by transmission electron microscopy at atomic resolution. Interestingly, we find that only well-ordered, highly crystalline graphite delaminates into oxo-functionalized graphene, whereas other graphite grades do not form a proper stage-1 intercalate and revert back to graphite upon hydrolysis. Ab initio molecular dynamics simulations show that ideal stacking and electronic oxidation of the graphite layers significantly reduce the friction of the moving sulfuric acid molecules, thereby facilitating intercalation. Furthermore, the evaluation of the stability of oxo-species in graphite sulfate supports an oxidation mechanism that obviates intercalation of the oxidant.
| S-EPMC5826935 | biostudies-literature
Project description:Interfaces of van der Waals (vdW) materials, such as graphite and hexagonal boron nitride (hBN), exhibit low-friction sliding due to their atomically flat surfaces and weak vdW bonding. We demonstrate that microfabricated gold also slides with low friction on hBN. This enables the arbitrary post-fabrication repositioning of device features both at ambient conditions and in situ to a measurement cryostat. We demonstrate mechanically reconfigurable vdW devices where device geometry and position are continuously tunable parameters. By fabricating slidable top gates on a graphene-hBN device, we produce a mechanically tunable quantum point contact where electron confinement and edge-state coupling can be continuously modified. Moreover, we combine in situ sliding with simultaneous electronic measurements to create new types of scanning probe experiments, where gate electrodes and even entire vdW heterostructure devices can be spatially scanned by sliding across a target.
| S-EPMC10081839 | biostudies-literature
Project description:Graphene has attracted considerable interest as a potential new electronic material. With its high carrier mobility, graphene is of particular interest for ultrahigh-speed radio-frequency electronics. However, conventional device fabrication processes cannot readily be applied to produce high-speed graphene transistors because they often introduce significant defects into the monolayer of carbon lattices and severely degrade the device performance. Here we report an approach to the fabrication of high-speed graphene transistors with a self-aligned nanowire gate to prevent such degradation. A Co(2)Si-Al(2)O(3) core-shell nanowire is used as the gate, with the source and drain electrodes defined through a self-alignment process and the channel length defined by the nanowire diameter. The physical assembly of the nanowire gate preserves the high carrier mobility in graphene, and the self-alignment process ensures that the edges of the source, drain and gate electrodes are automatically and precisely positioned so that no overlapping or significant gaps exist between these electrodes, thus minimizing access resistance. It therefore allows for transistor performance not previously possible. Graphene transistors with a channel length as low as 140?nm have been fabricated with the highest scaled on-current (3.32?mA??m(-1)) and transconductance (1.27?mS??m(-1)) reported so far. Significantly, on-chip microwave measurements demonstrate that the self-aligned devices have a high intrinsic cut-off (transit) frequency of f(T) = 100-300?GHz, with the extrinsic f(T) (in the range of a few gigahertz) largely limited by parasitic pad capacitance. The reported intrinsic f(T) of the graphene transistors is comparable to that of the very best high-electron-mobility transistors with similar gate lengths.
| S-EPMC2965636 | biostudies-literature
Project description:We propose Graphene Klein tunnel transistors (GKTFET) as a way to enforce current saturation while maintaining large mobility for high speed radio frequency (RF) applications. The GKTFET consists of a sequence of angled graphene p-n junctions (GPNJs). Klein tunneling creates a collimation of electrons across each GPNJ, so that the lack of substantial overlap between transmission lobes across successive junctions creates a gate-tunable transport gap without significantly compromising the on-current. Electron scattering at the device edge tends to bleed parasitic states into the gap, but the resulting pseudogap is still sufficient to create a saturated output (I D -V D ) characteristic and a high output resistance. The modulated density of states generates a higher transconductance (g m ) and unity current gain cut-off frequency (f T ) than GFETs. More significantly the high output resistance makes the unity power gain cut-off frequency (f max ) of GKTFETs considerably larger than GFETs, making analog GKTFET potentially useful for RF electronics. Our estimation shows the f T /f max of a GKTFET with 1 ?m channel reaches 33 GHz/17 GHz, and scale up to 350 GHz/53 GHz for 100 nm channel (assuming a single, scalable trapezoidal gate). The f max of a GKTFET is 10 times higher than a GFET with the same channel length.
| S-EPMC5575307 | biostudies-literature