Seismic behavior and force-displacement characterization of neotype column-slab high piers.
Ontology highlight
ABSTRACT:
SUBMITTER: Zhou Y
PROVIDER: S-EPMC4032752 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Double seismic zones are two-layered distributions of intermediate-depth earthquakes that provide insight into the thermomechanical state of subducting slabs. We present new precise hypocenters of intermediate-depth earthquakes in the Tonga subduction zone obtained using data from local island-based, ocean-bottom, and global seismographs. The results show a downdip compressional upper plane and a downdip tensional lower plane with a separation of about 30 km. The double seismic zone in Tonga extends to a depth of about 300 km, deeper than in any other subduction system. This is due to the lower slab temperatures resulting from faster subduction, as indicated by a global trend toward deeper double seismic zones in colder slabs. In addition, a line of high seismicity in the upper plane is observed at a depth of 160 to 280 km, which shallows southward as the convergence rate decreases. Thermal modeling shows that the earthquakes in this "seismic belt" occur at various pressures but at a nearly constant temperature, highlighting the important role of temperature in triggering intermediate-depth earthquakes. This seismic belt may correspond to regions where the subducting mantle first reaches a temperature of ~500°C, implying that metamorphic dehydration of mantle minerals in the slab provides water to enhance faulting.
| S-EPMC5226644 | biostudies-literature
Project description:We analyze seismic anisotropy for the Eastern Alpine region by inspecting shear-wave splitting from SKS and SKKS phases. The Eastern Alpine region is characterized by a breakdown of the clear mountain-chain-parallel fast orientation pattern that has been previously documented for the Western Alps and for the western part of the Eastern Alps. The main interest of this paper is a more detailed analysis of the anisotropic character of the Eastern Alps, and the transition to the Carpathian-Pannonian region. SK(K)S splitting measurements reveal a rather remarkable lateral change in the anisotropy pattern from the west to the east of the Eastern Alps with a transition area at about 12°E. We also model the backazimuthal variation of the measurements by a vertical change of anisotropy. We find that the eastern part of the study area is characterized by the presence of two layers of anisotropy, where the deeper layer has characteristics similar to those of the Central Alps, in particular SW-NE fast orientations of anisotropic axes. We attribute the deeper layer to a detached slab from the European plate. Comparison with tomographic studies of the area indicates that the detached slab might possibly connect with the lithosphere that is still in place to the west of our study area, and may also connect with the slab graveyard to the East, at the depth of the upper mantle transition zone. On the other hand, the upper layer has NW-SE fast orientations coinciding with a low-velocity layer which is found above a more-or-less eastward dipping high-velocity body. The anisotropy of the upper layer shows large-scale NW-SE fast orientation, which is consistent with the presence of asthenospheric flow above the detached slab foundering into the deeper mantle.
| S-EPMC4376057 | biostudies-literature
Project description:The 2016-2017 Central Italy earthquake sequence struck the central Apennines between August 2016 and October 2016 with Mw ∈ [5.9; 6.5], plus four earthquakes occurring in January 2017 with Mw ∈ [5.0; 5.5]. We study Global Positioning System time series including near- and far-field domains. We use a variational Bayesian independent component analysis technique to separate the post-seismic deformation from signals caused by variation of the water content in aquifers at hundreds of meters of depth and of the soil moisture. For each independent component, realistic uncertainties and a plausible physical explanation are provided. We focus on the study of afterslip on the main structures surrounding the mainshock, highlighting the role played by faults that were not activated during the co-seismic phase in accommodating the post-seismic deformation. We report aseismic deformation occurring on the Paganica fault, which hosted the Mw 6.1 2009 L'Aquila earthquake, suggesting that static stress transfer and aseismic slip influence the recurrence time of nearby (∼50 km further south of the mainshocks) segments. A ∼2-3 km thick subhorizontal shear-zone, clearly illuminated by seismicity, which bounds at depth the west-dipping normal faults where the mainshocks nucleated, also shows aseismic slip. Since afterslip alone underestimates the displacement in the far-field domain, we consider the possibility that the shear zone marks the brittle-ductile transition, assuming the viscoelastic relaxation of the lower crust as a mechanism contributing to the post-seismic displacement. Our results suggest that multiple deformation processes are active in the first 2 years after the mainshocks.
| S-EPMC9285078 | biostudies-literature
Project description:A detailed 3D image of the Calabro-Ionian subduction system in the central Mediterranean was obtained by means of a seismic tomography, exploiting a large dataset of local earthquakes and computing algorithms able to build a dense grid of measure nodes. Results show that the slab is continuous below the southern sector of the Calabro-Peloritan Arc, but the deformation processes developing at its edges are leading to its progressive narrowing, influencing tectonics and magmatism at the surface, and with possible stress concentration in the tip zones. In the southwest, the deformation occurring at a free slab edge lead to propagation of a vertical lithospheric tear in the overriding plate, which extends along a NW-SE fault system (Aeolian-Tindari-Letojanni) up to about 30?km into the Ionian Sea; further southeast, the lithosphere appears only flexed and not broken yet. In the northeast, the slab seems to break progressively, parallel to the trench. Finally, northwest of Mt. Etna, the tomography highlights low VP that can be related to an upwelling of deep mantle material likely flowing laterally through a window opened by the complete slab detachment.
| S-EPMC5980090 | biostudies-other
Project description:We investigated the seismological structure beneath the equatorial Melanesian region, where is tectonically unique because an immense oceanic plateau, a volcanic chain and subduction zones meet. We conducted a multi-frequency P-wave tomography using data collected from an approximately 2-year-long seismic experiment around the Ontong Java Plateau (OJP). High-velocity anomalies were revealed beneath the center of the OJP at a depth of ~ 150 km, the middle-eastern edge of the OJP at depths of 200-300 km, and in the mantle transition zone beneath and around the OJP; low-velocity anomalies were observed along the Caroline volcanic island chain above 450 km depth. These anomalies are considered to be associated with the thick lithosphere of the OJP, remnant dipping Pacific slab, stagnant Pacific slab, and a sheet-like upwelling. The broad stagnant slab was formed due to rapid trench retreat from 48 to 25 Ma until when the OJP with thick lithosphere collided with a subduction boundary of the Pacific and Australian plates. This collision triggered slab breakoff beneath the arc where the dipping slab remained. The stagnant Pacific slab in the mantle transition zone restricted the plume upwelling from the lower mantle causing sheet-like deformed upwelling in the upper mantle.
| S-EPMC8553740 | biostudies-literature
Project description:This article contains information related to a recent study "Performance-based interpretation of in-plane cyclic tests on RC frames with strong masonry infills" (Morandi et al., 2017 [1]). Motivated by the necessity to improve the knowledge of the in-plane seismic response of rigid strong masonry infills, a wide experimental campaign based on in-plane cyclic tests on full-scale RC infilled frame specimens, supplemented with a complete characterization of the materials, has been conducted at the laboratory of the Department of Civil Engineering and Architecture of the University of Pavia. The masonry is constituted by vertically perforated 35 cm thick clay units with tongue and groove and dry head-joints and general-purpose mortar bed-joints. The paper reports the results of the mechanical characterization and of the force-displacement hysteretic curves from the in-plane cyclic tests.
| S-EPMC5848065 | biostudies-literature
Project description:On August 7, 2014, a new effusive vent opened on the northern flank of Stromboli. A characteristic pattern was observed in both seismic and infrasonic signal amplitudes prior to this effusive eruption. The pattern consisted of the repeating cycle: (1) quiet phase, (2) puffing phase, and (3) explosion phase. Correlation between seismic and infrasound signal suggests that pulses in the puffing phase were caused by repetitive bursts of small gas pockets at the central crater, while the explosion phase coincided with an explosion at the central crater. We show that degassing of the magma column occurred in cycles of increasing gas flux, which controlled the transition from a bubbly flow (puffing phase), to a slug flow (explosion phase) gas regime. The quiet phase was characterized by a constant time length of 150 s, indicating that the gas rose in the magma column as well-organized waves of gas layers. These cycles represent cyclic changes of the gas flux regime in the shallow magma column, associated with increases in the magma-gas supply input rate before the effusive eruption.
| S-EPMC6450954 | biostudies-literature
Project description:Oligonucleotides (ONs) are breaking through in the biopharmaceutical industry as a promising class of biotherapeutics. The main success of these molecules is due to their peculiar way of acting in the cellular process, regulating the gene expression and hence influencing the protein synthesis at a pretranslational level. Although the Food and Drug Administration (FDA) already approved a few ON-based therapeutics, their production cost strongly limits large-scale manufacturing: a situation that can be alleviated through process intensification. In this study, we address this problem by developing an efficient and continuous chromatographic purification process for ONs. In particular, we considered the chromatographic purification of an ON crude prepared by chemical synthesis using anion exchange resins. We demonstrate that in this system the competitive adsorption of the various species on the same sites of the resin leads to the displacement of the more weakly adsorbing species by the more strongly adsorbing ones. This phenomenon affects the behavior of the chromatographic units and it has been investigated in detail. Then, we developed a continuous countercurrent solvent gradient purification (MCSGP) process, which can significantly improve the productivity and buffer consumption compared to a classical single-column, batch chromatographic process.
| S-EPMC9322279 | biostudies-literature
Project description:The soft sensing system has drawn huge enthusiasm for the application of soft robots and healthcare recently. Most of them possess thin-film structures that are beneficial to monitoring strain and pressure, but are unfavorable for measuring normal displacement with high linearity. Here we propose soft tactile sensors based on uniform-strength cantilever beams that can be utilized to measure the normal displacement and force of soft objects simultaneously. First, the theoretical model of the sensors is constructed, on the basis of which, the sensors are fabricated for testing their sensing characteristics. Next, the test results validate the constructed model, and demonstrate that the sensors can measure the force as well as the displacement. Besides, the self-fabricated sensor can have such prominent superiorities as follows-it is ultra-soft, and its equivalent stiffness is only 0.31 N·m-1 (approximately 0.4% of fat); it has prominent sensing performance with excellent linearity (R2 = 0.999), high sensitivity of 0.533 pF·mm-1 and 1.66 pF·mN-1 for measuring displacement and force; its detection limit is as low as 70 μm and 20 μN that is only one-tenth of the touch of a female fingertip. The presented sensor highlights a new idea for measuring the force and displacement of the soft objects with broad application prospects in mechanical and medical fields.
| S-EPMC8037311 | biostudies-literature
Project description:In this study, research on a pile group system was conducted using shaking table tests under four working conditions: a natural foundation and pile-spacing conditions of 3D, 3.5D, and 4D (D is the diameter of the pile). The time histories of the excess pore pressure ratio and settlement were analyzed. It was determined that pile foundations improved the anti-liquefaction performance of the soil, and the effect was much greater when the pile spacing was 3D. In addition, the settlement dynamic amplification factor (SDAF) was proposed and calculated at different vibration times. The result was fitted with a linear relationship, and the correlation coefficient was relatively high. During the aseismic design of the pile foundation bearing capacity, the SDAF was multiplied by the static load, and the results showed that in the dynamic design of the pile foundation, the dynamic problem can be transformed into a static analysis, which can provide a reference for the design of the vertical bearing capacity of pile foundations under seismic force.
| S-EPMC7081995 | biostudies-literature