Charge-to-mass ratio of saltating particles in wind-blown sand.
Ontology highlight
ABSTRACT:
SUBMITTER: Bo TL
PROVIDER: S-EPMC4083261 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Incident angle of saltating particles plays a very important role in aeolian events. In this paper, the incident angles of sand particles near the sand bed were measured in wind tunnel. It reveals that the incident angles range widely from 0° to 180° and thereby the means of angles are larger than published data. Surprisingly, it is found the proportion that angles of 5°-15° occupy is far below previous reports. The measuring height is probably the most important reason for the measurement differences between this study and previous investigations.
| S-EPMC3706613 | biostudies-literature
Project description:Charge detection mass spectrometry (CDMS) is a single-molecule technique particularly well-suited to measuring the mass and charge distributions of heterogeneous, MDa-sized ions. In this work, CDMS has been used to analyze the assembly products of two coat protein variants of bacteriophage P22. The assembly products show broad mass distributions extending from 5 to 15 MDa for A285Y and 5 to 25 MDa for A285T coat protein variants. Because the charge of large ions generated by electrospray ionization depends on their size, the charge can be used to distinguish hollow shells from more compact structures. A285T was found to form T = 4 and T = 7 procapsids, and A285Y makes a small number of T = 3 and T = 4 procapsids. Owing to the decreased stability of the A285Y and A285T particles, chemical cross-linking was required to stabilize them for electrospray CDMS.Graphical Abstract.
| S-EPMC5095694 | biostudies-literature
Project description:Wind-blown sand movement often occurs in a very complicated desert environment where sand dunes and ripples are the basic forms. However, most current studies on the theoretic and numerical models of wind-blown sand movement only consider ideal conditions such as steady wind velocity, flat sand surface, etc. In fact, the windward slope gradient plays a great role in the lift-off and sand particle saltation. In this paper, we propose a numerical model for the coupling effect between wind flow and saltating sand particles to simulate wind-blown sand movement over the slope surface and use the SIMPLE algorithm to calculate wind flow and simulate sands transport by tracking sand particle trajectories. We furthermore compare the result of numerical simulation with wind tunnel experiments. These results prove that sand particles have obvious effect on wind flow, especially that over the leeward slope. This study is a preliminary study on windblown sand movement in a complex terrain, and is of significance in the control of dust storms and land desertification.
| S-EPMC4248282 | biostudies-other
Project description:The masses of particles in a bovine milk extracellular vesicle (EV) preparation enriched for exosomes were directly determined for the first time by charge detection mass spectrometry (CDMS). In CDMS, both the mass-to-charge ratio (m/z) and z are determined simultaneously for individual particles, enabling mass determinations for particles that are far beyond the mass limit (?1.0 MDa) of conventional mass spectrometry (MS). Particle masses and charges span a wide range from m ? 2 to ?90 MDa and z ? 50 to ?1300 e (elementary charges) and are highly dependent upon the conditions used to extract and isolate the EVs. EV particles span a continuum of masses, reflecting the highly heterogeneous nature of these samples. However, evidence for unique populations of particles is obtained from correlation of the charges and masses. An analysis that uses a two-dimensional Gaussian model, provides evidence for six families of particles, four of which having masses in the range expected for exosomes. Complementary proteomics measurements and electron microscopy (EM) imaging are used to further characterize the EVs and confirm that these samples have been enriched in exosomes. The ability to characterize such extremely heterogeneous mixtures of large particles with rapid, sensitive, and high-resolution MS techniques is critical to ongoing analytical efforts to separate and purify exosomes and exosome subpopulations. Direct measurement of each particle's mass and charge is a new means of characterizing the physical and chemical properties of exosomes and other EVs.
| S-EPMC7236431 | biostudies-literature
Project description:The pulmonary response to inhalation exposure to diesel exhaust particles (DEP) and fracking sand particles (FSD) was investigated in a rat model. Healthy adult male Sprague-Dawley rats were exposed by whole-body inhalation to air (control) or an aerosol containing DEP at a concentration of 1.0 mg/m3 combined with FSD at concentrations of 30 mg/m3, 6 hours/day for 4 days. The control and DEP/FSD exposed rats were euthanized at post-exposure time intervals of 1, 7, or 27 days and pulmonary inflammatory, cytotoxic, and oxidant responses were determined. Analysis of bronchoalveolar lavage parameters of toxicity such as lactate dehydrogenase activity, oxidant generation, and inflammation revealed only minimal changes in pulmonary toxicity in the DEP/FSD-exposed rats, compared with the time-matched controls. The lung gene expression profiles showed only minimal changes in the DEP/FSD exposed rats compared with the controls. Specifically, there were a total of 6 genes significantly differentially expressed (fold change >1.5 and FDR p<0.05) only at the one-day post-exposure group. The data obtained from the present study demonstrated that DEP/FSD inhalation exposure, under the conditions employed in the present study, resulted in only minimal changes in lung toxicity and gene expression profile in the rats.
2024-12-01 | GSE242155 | GEO
Project description:Triboelectric charging is common in desert sandstorms and dust devils on Earth; however, it remains poorly understood. Here we show a charging mechanism of sands with the adsorbed water on micro-porous surface in wind-blown sand based on the fact that water content is universal but usually a minor component in most particle systems. The triboelectric charging could be resulted due to the different mobility of H(+)/OH(-) between the contacting sands with a temperature difference. Computational fluid dynamics (CFD) and discrete element method (DEM) were used to demonstrate the dynamics of the sand charging. The numerically simulated charge-to-mass ratios of sands and electric field strength established in wind tunnel agreed well with the experimental data. The charging mechanism could provide an explanation for the charging process of all identical granular systems with water content, including Martian dust devils, wind-blown snow, even powder electrification in industrial processes.
| S-EPMC3580324 | biostudies-other
Project description:The size distribution of manufactured sand particles has a significant influence on the quality of concrete. To overcome the shortcomings of the traditional vibration-sieving method, a manufactured sand casting/dispersing system was developed, based on the characteristics of the sand particle contours (as determined by backlit image acquisition) and an extraction mechanism. Algorithms for eliminating particles from the image that had be repeatedly captured, as well as for identifying incomplete particles at the boundaries of the image, granular contour segmentation, and the determination of an equivalent particle size, are studied. The hardware and software for the image-based detection device were developed. A particle size repeatability experiment was carried out on the single-grade sands, grading the size fractions of the manufactured sand over a range of 0.6-4.75 mm. A method of particle-size correction is proposed to compensate for the difference in the results obtained by the image-based method and those obtained by the sieving method. The experimental results show that the maximum repeatability error of single-grade fractions is 3.46% and the grading size fraction is 0.51%. After the correction of the image method, the error between the grading size fractions obtained by the two methods was reduced from 7.22%, 6.10% and 5% to 1.47%, 1.65%, and 3.23%, respectively. The accuracy of the particle-size detection can thus satisfy real-world measuring requirements.
| S-EPMC6294553 | biostudies-literature
Project description:Iron is prone to change its form and speciation in phases. Thus, several methods have been developed to estimate iron partitioning in the mineral phases of soils. However, the accuracy of these methods to evaluate the iron contribution from minor phases, such as actinolite, almandine, biotite, chlorite, epidote, hornblende, muscovite, and Fe-diospide, remains low. Furthermore, most of the current iron speciation research is focused on bulk samples, and only applies to soil samples that are mostly composed of clays or clay minerals, without a wide-ranging evaluation of soil particles with different grain sizes. In this study, we classified several iron phases using a mineral liberation analyzer on desert soil particles with diameters ranging from silt- to fine-sand (5-20 µm, 20-45 µm, 45-63 µm, 63-75 µm, and > 75 µm). The iron containing minor phases were identified, the modal mineral abundances were determined via matching with the standard energy dispersive spectra library, and a particle size analysis was performed using mineral processing tools on each of the examined 40,000 particles. The iron partition results were ultimately established based on the standard iron concentration in the mineral phases and the modal mineral abundances.•This new method could be automated, thereby facilitating high efficiency identification of iron-containing phases that would allow, for the first time, the generation of a dataset for iron partitioning in soil particles.•This method allows the identification of minor iron phases in soil particles, and permits in situ mapping of iron mineralogy in fine sand- to silt-sized soil particles.•Not restricted by single mineral particles, this method considers multi-phase complex particles. Thus, it largely improves the accuracy for estimating the iron partition parameter.
| S-EPMC8374201 | biostudies-literature
Project description:Contact electrification of identical insulating particles has crucial significance for industrial and environmental science, especially in wind-blown granular systems. At the same time, the experimental phenomena of charge transfer first increased and then decreased with the increase of relative humidity has attracted the interest of many researchers. Humidity can affect the charge transfer has been early observed in the experiment, but the reason always puzzles researchers. In this study, based on trapped high-energy electron transfer mechanism, we introduce the effect of the water film in the charge transfer model and consider the actual situations of the sand particles in the collision process. Furthermore, charge transfer between sand particles in a single collision under different humidity conditions is investigated. The predicted results agree well with the law obtained in existing experiments qualitatively and thereby a possible explanation why humidity can affect the charge transfer is given.
| S-EPMC3957149 | biostudies-other
Project description:Charge detection mass spectrometry is a single particle technique where the masses of individual ions are determined from simultaneous measurements of each ion's m/z ratio and charge. The ions pass through a conducting cylinder, and the charge induced on the cylinder is detected. The cylinder is usually placed inside an electrostatic linear ion trap so that the ions oscillate back and forth through the cylinder. The resulting time domain signal is analyzed by fast Fourier transformation; the oscillation frequency yields the m/z, and the charge is determined from the magnitudes. The mass resolving power depends on the uncertainties in both quantities. In previous work, the mass resolving power was modest, around 30-40. In this work we report around an order of magnitude improvement. The improvement was achieved by coupling high-accuracy charge measurements (obtained with dynamic calibration) with higher resolution m/z measurements. The performance was benchmarked by monitoring the assembly of the hepatitis B virus (HBV) capsid. The HBV capsid assembly reaction can result in a heterogeneous mixture of intermediates extending from the capsid protein dimer to the icosahedral T = 4 capsid with 120 dimers. Intermediates of all possible sizes were resolved, as well as some overgrown species. Despite the improved mass resolving power, the measured peak widths are still dominated by instrumental resolution. Heterogeneity makes only a small contribution. Resonances were observed in some of the m/z spectra. They result from ions with different masses and charges having similar m/z values. Analogous resonances are expected whenever the sample is a heterogeneous mixture assembled from a common building block.
| S-EPMC8587657 | biostudies-literature