Effect of grain orientations of Cu seed layers on the growth of <111>-oriented nanotwinned Cu.
Ontology highlight
ABSTRACT:
SUBMITTER: Liu CM
PROVIDER: S-EPMC4137260 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:The epitaxial growth of graphene on catalytically active metallic surfaces via chemical vapor deposition (CVD) is known to be one of the most reliable routes toward high-quality large-area graphene. This CVD-grown graphene is generally coupled to its metallic support resulting in a modification of its intrinsic properties. Growth on oxides is a promising alternative that might lead to a decoupled graphene layer. Here, we compare graphene on a pure metallic to graphene on an oxidized copper surface in both cases grown by a single step CVD process under similar conditions. Remarkably, the growth on copper oxide, a high-k dielectric material, preserves the intrinsic properties of graphene; it is not doped and a linear dispersion is observed close to the Fermi energy. Density functional theory calculations give additional insight into the reaction processes and help explaining the catalytic activity of the copper oxide surface.
| S-EPMC4411207 | biostudies-literature
Project description:Direct Cu-to-Cu bonding was achieved at temperatures of 150-250 °C using a compressive stress of 100 psi (0.69 MPa) held for 10-60 min at 10(-3) torr. The key controlling parameter for direct bonding is rapid surface diffusion on (111) surface of Cu. Instead of using (111) oriented single crystal of Cu, oriented (111) texture of extremely high degree, exceeding 90%, was fabricated using the oriented nano-twin Cu. The bonded interface between two (111) surfaces forms a twist-type grain boundary. If the grain boundary has a low angle, it has a hexagonal network of screw dislocations. Such network image was obtained by plan-view transmission electron microscopy. A simple kinetic model of surface creep is presented; and the calculated and measured time of bonding is in reasonable agreement.
| S-EPMC4649891 | biostudies-other
Project description:The self-assembly of 1,3,5-benzenetribenzoic acid (BTB) molecules on both Cu(111) and epitaxial graphene grown on Cu(111) were studied by scanning tunneling microscopy (STM) and low-energy electron diffraction (LEED) under ultrahigh vacuum conditions. On Cu(111), the BTB molecules were found to mainly arrange in close-packed structures through H-bonding between the (partially) deprotonated carboxylic acid groups. In addition, porous structures formed by intact BTB molecules-and also based on H-bonding-were observed. On graphene grown on Cu(111) the BTB molecules mainly form porous structures accompanied by small patches of disordered close-packed structures. Upon annealing, BTB adsorbed on Cu(111) is fully deprotonated and arranges in the close-packed structure while in contrast on graphene/Cu(111) the porous network is exclusively formed. This shows that the molecular self-assembly behavior is highly dependent on the first substrate layer: one graphene layer is sufficient to considerably alter the interplay of molecule substrate and intermolecular interactions in favor of the latter interactions.
| S-EPMC5002934 | biostudies-literature
Project description:High density grain boundaries provide high strength, but may introduce undesirable features, such as high Fermi levels and instability. We investigated the kinetics of recovery and recrystallization of Cu that was manufactured to include both nanotwins (NT) and high-angle columnar boundaries. We used the isothermal Johnson-Mehl-Avrami-Kolmogorov (JMAK) model to estimate activation energy values for recovery and recrystallization and compared those to values derived using the non-isothermal Kissinger equation. The JMAK model hinges on an exponent that expresses the growth mechanism of a material. The exponent for this Cu was close to 0.5, indicating low-dimensional microstructure evolution, which is associated with anisotropic twin coarsening, heterogeneous recrystallization, and high stability. Since this Cu was of high purity, there was a negligible impurity-drag-effect on boundaries. The twin coarsening and heterogeneous recrystallization resulted from migration of high-angle columnar boundaries with their triple junctions in one direction, assisted by the presence of high concentration vacancies at boundaries. Analyses performed by electron energy loss spectroscopy of atomic columns at twin boundaries (TBs) and in the interior showed similar plasma peak shapes and L3 edge positions. This implies that values for conductivity and Fermi level are equal for atoms at TBs and in the interior.
| S-EPMC4981844 | biostudies-literature
Project description:Driven by tensile strain, GaAs quantum dots (QDs) self-assemble on In0.52Al0.48As(111)A surfaces lattice-matched to InP substrates. In this study, we show that the tensile-strained self-assembly process for these GaAs(111)A QDs unexpectedly deviates from the well-known Stranski-Krastanov (SK) growth mode. Traditionally, QDs formed via the SK growth mode form on top of a flat wetting layer (WL) whose thickness is fixed. The inability to tune WL thickness has inhibited researchers' attempts to fully control QD-WL interactions in these hybrid 0D-2D quantum systems. In contrast, using microscopy, spectroscopy, and computational modeling, we demonstrate that for GaAs(111)A QDs, we can continually increase WL thickness with increasing GaAs deposition, even after the tensile-strained QDs (TSQDs) have begun to form. This anomalous SK behavior enables simultaneous tuning of both TSQD size and WL thickness. No such departure from the canonical SK growth regime has been reported previously. As such, we can now modify QD-WL interactions, with future benefits that include more precise control of TSQD band structure for infrared optoelectronics and quantum optics applications.
| S-EPMC6890744 | biostudies-literature
Project description:Oxidized copper surfaces have attracted significant attention in recent years due to their unique catalytic properties, including their enhanced hydrocarbon selectivity during the electrochemical reduction of CO2. Although oxygen plasma has been used to create highly active copper oxide electrodes for CO2RR, how such treatment alters the copper surface is still poorly understood. Here, we study the oxidation of Cu(100) and Cu(111) surfaces by sequential exposure to a low-pressure oxygen plasma at room temperature. We used scanning tunnelling microscopy (STM), low energy electron microscopy (LEEM), X-ray photoelectron spectroscopy (XPS), near edge X-ray absorption fine structure spectroscopy (NEXAFS) and low energy electron diffraction (LEED) for the comprehensive characterization of the resulting oxide films. O2-plasma exposure initially induces the growth of 3-dimensional oxide islands surrounded by an O-covered Cu surface. With ongoing plasma exposure, the islands coalesce and form a closed oxide film. Utilizing spectroscopy, we traced the evolution of metallic Cu, Cu2O and CuO species upon oxygen plasma exposure and found a dependence of the surface structure and chemical state on the substrate's orientation. On Cu(100) the oxide islands grow with a lower rate than on the (111) surface. Furthermore, while on Cu(100) only Cu2O is formed during the initial growth phase, both Cu2O and CuO species are simultaneously generated on Cu(111). Finally, prolonged oxygen plasma exposure results in a sandwiched film structure with CuO at the surface and Cu2O at the interface to the metallic support. A stable CuO(111) surface orientation is identified in both cases, aligned to the Cu(111) support, but with two coexisting rotational domains on Cu(100). These findings illustrate the possibility of tailoring the oxidation state, structure and morphology of metallic surfaces for a wide range of applications through oxygen plasma treatments.
| S-EPMC8565394 | biostudies-literature
Project description:The structural properties and binding motif of a strongly ?-electron-donating N-heterocyclic carbene have been investigated on different transition-metal surfaces. The examined cyclic (alkyl)(amino)carbene (CAAC) was found to be mobile on surfaces, and molecular islands with short-range order could be found at high coverage. A combination of scanning tunneling microscopy (STM), X-ray photoelectron spectroscopy (XPS), and density functional theory (DFT) calculations highlights how CAACs bind to the surface, which is of tremendous importance to gain an understanding of heterogeneous catalysts bearing CAACs as ligands.
| S-EPMC7496406 | biostudies-literature
Project description:The stiff compromise between reliability and conductivity of copper interconnects used in sub-nanometer nodes has brought into focus the choice of encapsulation material. While reliability was the primary driver so far, herein, we investigate how electronic conductivity of Cu(111) thin films is influenced by the encapsulation material using density functional theory and Boltzmann transport equation. Atomically thin 2D materials, namely conducting graphene and insulating graphane both retain the conductivity of Cu films whereas partially hydrogenated graphene (HGr) results in reduction of surface density of states and a reduction in Cu film conductivity. Among transition metal elements, we find that atoms in Co encapsulation layer, which essentially act as magnetic impurities, serve as electron scattering centres resulting in a decrease in conductivity by at least 15% for 11 nm thick Cu film. On the other hand, Mo, Ta, and Ru have more favorable effect on conductivity when compared to Co. The cause of decrease in conductivity for Co and HGr is discussed by investigating the electronic band structure and density of states. Our DFT calculations suggest that pristine graphene sheet is a good encapsulation material for advanced Cu interconnects both from chemical protection and conductivity point of view.
| S-EPMC6401372 | biostudies-other
Project description:The growth of nanocrystals has widely been researched recently through an in situ high-resolution transmission electron microscopy technique, which reveals the process of morphological and structural evolutions. For nanocrystals, the underlying growth modes are mostly determined by growth environment and crystal morphology. Here, the direct growth process of the PbSe nanocrystals via controlling the temperature is clearly observed. The results show that the PbSe nanocrystals start growth following oriented attachment growth mode, and then change to growth with grain boundary migration at moderate temperature as the heat activated nanocrystals gather together with decreased degree of freedom for crystal rotation. During the grain boundary migration, the smaller nanocrystals are inclined to be assimilated by larger ones through interfacial atom reconfigurations, which are observed to take place through strain mediated atom migration. The growth mode changes in different growth states with a hybrid growth mode of oriented attachment and grain boundary migration during the whole growth process.
| S-EPMC6498134 | biostudies-literature
Project description:The electrochemical carbon dioxide reduction reaction (CO2RR) is a promising route to close the carbon cycle by reducing CO2 into valuable fuels and chemicals. Electrocatalysts with high selectivity toward a single product are economically desirable yet challenging to achieve. Herein, we demonstrated a highly (111)-oriented Cu foil electrocatalyst with dense twin boundaries (TB) (tw-Cu) that showed a high Faradaic efficiency of 86.1 ± 5.3% toward CH4 at -1.2 ± 0.02 V vs the reversible hydrogen electrode. Theoretical studies suggested that tw-Cu can significantly lower the reduction barrier for the rate-determining hydrogenation of CO compared to planar Cu(111) under working conditions, which suppressed the competing C-C coupling, leading to the experimentally observed high CH4 selectivity.
| S-EPMC10141442 | biostudies-literature