Dataset Information

Determination of haloacetic acids in bottled and tap water sources by dispersive liquid-liquid microextraction and GC-MS analysis.

ABSTRACT: Haloacetic acids are toxic organic pollutants that can be formed as by-products of disinfection of water by chlorination. In this study, we developed a fast and efficient method for the determination of six species of these compounds in water using dispersive liquid-liquid microextraction followed by GC-MS analysis. To be suitable for GC analysis, the acidic analytes were derivatized using n-octanol. One-factor-at-a-time optimization was carried out on several factors including temperature, extraction time, amount of catalyst, and dispersive solvent. The optimized conditions were then used to determine calibration parameters. Linearity, as demonstrated by coefficient of determination, ranged between 0.9900 and 0.9966 for the concentration range of 0.05-0.57 µg/L. The proposed method has good repeatability; intraday precision was calculated as %RSD of 2.38-9.34%, while interday precision was 4.69-8.06%. The method was applied to real samples in bottled water and tap water sources. Results indicated that the total concentrations of the analytes in these sources (2.97-5.30 µg/L) were far below the maximum contaminant levels set by both the World Health Organization and the United States Environmental Protection Agency. The proposed method compared favorably with methods reported in the literature.

SUBMITTER: Al-shatri MA

PROVIDER: S-EPMC4176914 | biostudies-other | 2014

REPOSITORIES: biostudies-other

ACCESS DATA

Similar Datasets

Project description:An ionic liquid-based dispersive liquid-liquid microextraction (IL-DLLME) of 20 anthelmintic drugs followed and detected by liquid chromatography-tandem mass spectrometry (LC-MS/MS) has been developed, optimized, and validated. The parameters affecting the anthelmintic extraction efficiencies such as selection of extraction solvent (ionic liquids), selection of disperser solvent, volume of extraction solvent, volume of disperser solvent, pH of the aqueous phase, extraction time, salt addition, and centrifugation time were optimized. Validation was conducted according to ISO/IEC 17025:2017 and Commission Implementing Regulation (EU) 2021/808 of 22 March 2021. Validation parameters such as calibration function, matrix effect, limit of detection (LOD), limit of quantification (LOQ), decision limit (CCα), accuracy, and precision were established. Coefficient of determination (R 2) values ranging from .99938 to .99995 were obtained using the matrix calibration curve spiked at 0, 0.25, 1.0, 1.5, and 2.0 times MRL. The LODs and LOQs were calculated using the standard deviation of the response and the slopes of the calibration curves ranged from 0.35 to 26.1 μg/kg and from 1.2 to 87.0 μg/kg, respectively, and were dependent on calibration range. The CCα values ranged from 23 to 1022.0 μg/kg and are also dependent on the MRL concentration levels. The coefficient of variation (CV) values calculated are within the reproducibility range of 16%-30% adapted from the Horwitz Equation CV = 2(1-0.5 log C) and ranged from 1.7% to 16.9%. The developed and validated and the standard QuEChERS method were compared. The IL-DLLME LC-MS/MS method was applied to 32 small stock (18 caprine [goat] and 14 ovine [sheep]) liver samples received from municipal abattoirs at Botswana National Veterinary Laboratory for the analysis of anthelmintic drug residues. The results obtained indicated that the anthelmintic drug residues were all below the detection capability, and therefore, the samples were passed as fit for human consumption.

Dataset Information

Determination of haloacetic acids in bottled and tap water sources by dispersive liquid-liquid microextraction and GC-MS analysis.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets