Preparation of three-dimensional entanglement for distant atoms in coupled cavities via atomic spontaneous emission and cavity decay.
Ontology highlight
ABSTRACT:
SUBMITTER: Su SL
PROVIDER: S-EPMC4271254 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:In a cavity quantum electrodynamics (QED) system, where atoms coherently interact with photons in a cavity, the eigenstates of the system are the superposition states of atoms and cavity photons, the so-called dressed states of atoms. When two cavities are connected by an optical fiber with negligible loss, the coherent coupling between the cavities gives rise to photonic normal modes. One of these normal modes is the fiber-dark mode, in which photons are delocalized in the two distant cavities. Here we demonstrate the setting of coupled-cavities QED, where two nanofiber cavity-QED systems are coherently connected by a meter-long low-loss channel in an all-fiber fashion. Specifically, we observe dressed states of distant atoms with delocalized photons of the fiber-dark normal mode. Our system will provide a platform for the study of delocalized atomic and photonic states, photonic many-body physics, and distributed quantum computation.
| S-EPMC6411748 | biostudies-literature
Project description:Luminescence arising from β -decay of radiotracers has garnered much interest recently as a viable in-vivo imaging technique. The emitted Cerenkov radiation can be directly detected by high sensitivity cameras or used to excite highly efficient fluorescent dyes. Here, we investigate the enhancement of visible and infrared emission driven by β -decay of radioisotopes in the presence of a hyperbolic nanocavity. By means of a transfer matrix approach, we obtain quasi-analytic expressions for the fluorescence enhancement factor at the dielectric core of the metalodielectric cavity, reporting a hundred-fold amplification in periodic structures. A particle swarm optimization of the layered shell geometry reveals that up to a ten-thousand-fold enhancement is possible thanks to the hybridization and spectral overlapping of whispering-gallery and localized-plasmon modes. Our findings may find application in nuclear-optical medical imaging, as they provide a strategy for the exploitation of highly energetic gamma rays, Cerenkov luminescence, and visible and near-infrared fluorescence through the same nanotracer.
| S-EPMC8635087 | biostudies-literature
Project description:The enhancement of the photophysical response of fluorophores is a crucial factor for photonic and optoelectronic technologies that involve fluorophores as gain media. Recent advances in the development of an extreme light propagation regime, called epsilon-near-zero (ENZ), provide a promising approach in this respect. In this work, we design metal/dielectric nanocavities to be resonant with the absorption and emission bands of the employed fluorophores. Using CsPbBr3 perovskite nanocrystal films as light emitters, we study the spontaneous emission and decay rate enhancement induced by a specifically tailored double-epsilon-near-zero (double ENZ) structure. We experimentally demonstrate the existence of two ENZ wavelengths, by directly measuring their dielectric permittivity via ellipsometric analysis. The double ENZ nature of this plasmonic nanocavity has been exploited to achieve both surface plasmon enhanced absorption (SPEA) and surface plasmon coupled emission (SPCE), inducing a significant enhancement of both the spontaneous emission and the decay rate of the perovskite nanocrystal film that is placed on top of the nanocavity. Finally, we discuss the possibility of tailoring the two ENZ wavelengths of this structure within the visible spectrum simply by finely designing the thickness of the two dielectric layers, which enables resonance matching with a broad variety of dyes. Our device design is appealing for many practical applications, ranging from sensing to low threshold amplified spontaneous emission, since we achieve a strong PL enhancement with structures that allow for straightforward fluorophore deposition on a planar surface that keeps the fluorophores exposed and accessible.
| S-EPMC6906952 | biostudies-literature
Project description:Bi-exponential decay of dye fluorescence near the surface of plasmonic metamaterials and core-shell nanoparticles is shown to be an intrinsic property of the coupled system. Indeed, the Dicke, cooperative states involve two groups of transitions: super-radiant, from the most excited to the ground states and sub-radiant, which cannot reach the ground state. The relaxation in the sub-radiant system occurs mainly due to the interaction with the plasmon modes. Our theory shows that the relaxation leads to the population of the sub-radiant states by dephasing the super-radiant Dicke states giving rise to the bi-exponential decay in agreement with the experiments. We use a set of metamaterial samples consisting of gratings of paired silver nanostrips coated with Rh800 dye molecules, having resonances in the same spectral range. The bi-exponential decay is demonstrated for Au\SiO2\ATTO655 core-shell nanoparticles as well, which persists even when averaging over a broad range of the coupling parameter.
| S-EPMC6014996 | biostudies-literature
Project description:We study the Kitaev model on a finite-size square lattice with periodic boundary conditions in one direction and open boundary conditions in the other. Based on the fact that the Majorana representation of Kitaev model is equivalent to a brick wall model under the condition t?=???=??, this system is shown to support perfect Majorana bound states which is in strong localization limit. By introducing edge-mode fermionic operator and pseudo-spin representation, we find that such edge modes are always associated with maximal entanglement between two edges of the tube, which is independent of the size of the system.
| S-EPMC6093940 | biostudies-literature
Project description:We propose a scheme to realize heralded quantum entanglement between two distant matter qubits using two ? atom systems. Our proposal does not need any photon interference. We also present a general theory of outcome state of non-monochromatic incident light and finite interaction time.
| S-EPMC4455230 | biostudies-literature
Project description:Hyperbolic metamaterial (HMM), a sub-wavelength periodic artificial structure with hyperbolic dispersion, can enhance the spontaneous emission of quantum emitters. Here, we demonstrate the large spontaneous emission rate enhancement of an organic dye placed in a grating coupled hyperbolic metamaterial (GCHMM). A two-dimensional (2D) silver diffraction grating coupled with an Ag/Al2O3 HMM shows 18-fold spontaneous emission decay rate enhancement of dye molecules with respect to the same HMM without grating. The experimental results are compared with analytical models and numerical simulations, which confirm that the observed enhancement of GCHMM is due to the outcoupling of non-radiative plasmonic modes as well as strong plasmon-exciton coupling in HMM via diffracting grating.
| S-EPMC4160708 | biostudies-literature
Project description:All fluorescent assays would benefit from greater signal-to-noise ratios (SNRs), which enable detection of disease biomarkers at lower concentrations for earlier disease diagnosis and detection of genes that are expressed at the lowest levels. Here, we report an approach to enhance fluorescence in which surface adsorbed fluorophore-tagged biomolecules are excited on a photonic crystal surface that is coupled to an underlying Fabry-Perot type cavity through a gold mirror reflector beneath the photonic crystal. This approach leads to 6× increase in signal-to-noise ratio of a dye labeled polypeptide compared to ordinary photonic crystal enhanced fluorescence.
| S-EPMC3689753 | biostudies-other
Project description:There is a continuing need to increase the brightness and photostability of fluorophores for use in biotechnology, medical diagnostics, and cell imaging. One approach developed during the past decade is to use metallic surfaces and nanostructures. It is now known that excited state fluorophores display interactions with surface plasmons, which can increase the radiative decay rates, modify the spatial distribution of emission, and result in directional emission. One important example is surface plasmon-coupled emission (SPCE). In this phenomenon, the fluorophores at close distances from a thin metal film, typically silver, display emission over a small range of angles into the substrate. A disadvantage of SPCE is that the emission occurs at large angles relative to the surface normal and at angles that are larger than the critical angle for the glass substrate. The large angles make it difficult to collect all of the coupled emission and have prevented the use of SPCE with high-throughput and/or array applications. In the current article, we describe a simple multilayer metal-dielectric structure that allows excitation with light that is perpendicular (normal) to the plane and provides emission within a narrow angular distribution that is normal to the plane. This structure consists of a thin silver film on top of a multilayer dielectric Bragg grating, with no nanoscale features except for the metal or dielectric layer thicknesses. Our structure is designed to support optical Tamm states, which are trapped electromagnetic modes between the metal film and the underlying Bragg grating. We used simulations with the transfer matrix method to understand the optical properties of Tamm states and localization of the modes or electric fields in the structure. Tamm states can exist with zero in-plane wavevector components and can be created without the use of a coupling prism. We show that fluorophores on top of the metal film can interact with the Tamm state under the metal film and display Tamm state-coupled emission (TSCE). In contrast to SPCE, the Tamm states can display either S or P polarization. The TSCE angle is highly sensitive to wavelength, which suggests the use of Tamm structures to provide both directional emission and wavelength dispersion. Metallic structures can modify fluorophore decay rates but also have high losses. Photonic crystals have low losses but may lack the enhanced light-induced fields near metals. The combination of plasmonic and photonic structures offers the opportunity for radiative decay engineering to design new formats for clinical testing and other fluorescence-based applications.
| S-EPMC4127489 | biostudies-literature
Project description:Fluorescence spectroscopy and imaging are now used throughout the biosciences. Fluorescence microscopes, spectrofluorometers, microwell plate readers and microarray imagers all use multiple optical components to collect, redirect and focus the emission onto single point or array imaging detectors. For almost all biological samples, except those with regular nanoscale features, emission occurs in all directions. With the exception of complex microscope objectives with large collection angles (NA ≤ 0.5), all these instruments collect only a small fraction of the total emission. Because of the increasing knowledge base on fluorophores within near-field (<200 nm) distances from plasmonic and photonic structures we can anticipate the development of compact devices in which the sample to be detected is located directly on solid state detectors such as CCDs or CMOS cameras. Near-field interactions of fluorophores with metallic or dielectric multi-layer structures (MLSs) can capture a large fraction of the total emission. Depending on the composition and dimensions of the MLSs, the spatial distribution of the sample emission results in distinct optical patterns on the detector surface. With either plain glass slides or MLSs the most commonly used front focal plane (FFP) images reveal the x-y spatial distribution of emission from the sample. Another approach, which is often used with two or three-dimensional nanostructures, is back focal plane (BFP) imaging. The BFP images reveal the angular distribution of the emission. The FFP and BFP images occur at certain distances from the sample which is determined by the details of the optical components. Obtaining these images requires multiple optical components and distances which are too large for the compact devices. For devices described in this paper, the images will be detected at a fixed distance between the sample and some arbitrary distance below the MLS which is determined by the geometry and thicknesses of the components. We refer to measurements at these locations as out-of-focal plane (OFP) imaging. Herein we describe a method to measure the optical fields at micron and multi-micron distances below the MLS, which will represent the images seen by an optically coupled array detector. The possibility of sub-surface optical images is illustrated using five different multi-layer structures. This is accomplished using an optical configuration which allows measurement at a front focal plane (FFP), back focal plane (BFP) or any OFP locations. Our OFP imaging method provides a link between the FFP images which reveals the surface distribution of fluorophores with the BFP images that reveal the angular distribution of emission. This linkage can be useful when examining structures which have nanoscale features due to fluorescence or leakage radiation from nanostructures.
| S-EPMC5530754 | biostudies-literature