Quantification of in vivo ³¹P NMR brain spectra using LCModel.
Ontology highlight
ABSTRACT:
SUBMITTER: Deelchand DK
PROVIDER: S-EPMC4438275 | biostudies-other | 2015 Jun
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Extracting quantitative information about absolute concentrations from high-resolution (1)H NMR spectra of complex mixtures such as brain extracts remains challenging. Partial overlap of resonances complicates integration, whereas simple line fitting algorithms cannot accommodate the spectral complexity of coupled spin systems. Here, it is shown that high-resolution (1)H NMR spectra of rat brain extracts from 11 distinct brain regions can be reproducibly quantified using a basis set of 29 compounds. The basis set is simulated with the density matrix formalism using complete prior knowledge of chemical shifts and scalar couplings. A crucial aspect to obtain reproducible results was the inclusion of a line shape distortion common among all 73 resonances of the 29 compounds. All metabolites could be quantified with <10% and <3% inter- and intrasubject variation, respectively.
| S-EPMC3711472 | biostudies-literature
Project description:NMR spectroscopy in combination with (13)C-labeled substrate infusion is a unique technique to obtain information about dynamic metabolic fluxes noninvasively in vivo. In many cases, the in vivo information content obtained during dynamic (13)C studies in rodents can be enhanced by high-resolution (1)H-[(13)C] NMR spectroscopy on brain extracts. Previously, it has been shown that (1)H NMR spectra from rat brain extracts can be accurately quantified with a spectral fitting routine utilizing simulated basis sets using complete prior knowledge of chemical shifts and scalar couplings. The introduction of (13)C label into the various metabolites presents complications that demand modifications of the spectral fitting routine. As different multiplets within a given molecule accumulate various amounts of (13)C label, the fixed amplitude relationship between multiplets typical for (1)H NMR spectra must be abandoned. In addition, (13)C isotope effects lead to spectral multiplet patterns that become dependent on the amount of (13)C label accumulation, thereby preventing the use of a common basis set. Here a modified spectral fitting routine is presented that accommodates variable (13)C label accumulation and (13)C isotope effects. Spectral fitting results are quantitatively compared to manual integration on column-separated samples in which spectral overlap is minimized.
| S-EPMC4033633 | biostudies-literature
Project description:Human plasma is a biofluid that is high in information content, making it an excellent candidate for metabolomic studies. 1H NMR has been a popular technique to detect several dozen metabolites in blood plasma. In order for 1H NMR to become an automated, high-throughput method, challenges related to (1) the large signal from lipoproteins and (2) spectral overlap between different metabolites have to be addressed. Here diffusion-weighted 1H NMR is used to separate lipoprotein and metabolite signals based on their large difference in translational diffusion. The metabolite 1H NMR spectrum is then quantified through spectral fitting utilizing full prior knowledge on the metabolite spectral signatures. Extension of the scan time by 3 minutes or 15% per sample allowed the acquisition of a 1H NMR spectrum with high diffusion weighting. The metabolite 1H NMR spectra could reliably be modeled with 28 metabolites. Excellent correlation was found between results obtained with diffusion NMR and ultrafiltration. The combination of minimal sample preparation together with minimal user interaction during processing and quantification provides a metabolomics technique for automated, quantitative 1H NMR of human plasma.
| S-EPMC4624446 | biostudies-literature
Project description:Developments in untargeted nuclear magnetic resonance (NMR) metabolomics enable the profiling of thousands of biological samples. The exploitation of this rich source of information requires a detailed quantification of spectral features. However, the development of a consistent and automatic workflow has been challenging because of extensive signal overlap. To address this challenge, we introduce the software Spectral Automated NMR Decomposition (SAND). SAND follows on from the previous success of time-domain modeling and automatically quantifies entire spectra without manual interaction. The SAND approach uses hybrid optimization with Markov chain Monte Carlo methods, employing subsampling in both time and frequency domains. In particular, SAND randomly divides the time-domain data into training and validation sets to help avoid overfitting. We demonstrate the accuracy of SAND, which provides a correlation of ∼0.9 with ground truth on cases including highly overlapped simulated data sets, a two-compound mixture, and a urine sample spiked with different amounts of a four-compound mixture. We further demonstrate an automated annotation using correlation networks derived from SAND decomposed peaks, and on average, 74% of peaks for each compound can be recovered in single clusters. SAND is available in NMRbox, the cloud computing environment for NMR software hosted by the Network for Advanced NMR (NAN). Since the SAND method uses time-domain subsampling (i.e., random subset of time-domain points), it has the potential to be extended to a higher dimensionality and nonuniformly sampled data.
| S-EPMC10896553 | biostudies-literature
Project description:MotivationTime-series nuclear magnetic resonance (NMR) has advanced our knowledge about metabolic dynamics. Before analyzing compounds through modeling or statistical methods, chemical features need to be tracked and quantified. However, because of peak overlap and peak shifting, the available protocols are time consuming at best or even impossible for some regions in NMR spectra.ResultsWe introduce Ridge Tracking-based Extract (RTExtract), a computer vision-based algorithm, to quantify time-series NMR spectra. The NMR spectra of multiple time points were formulated as a 3D surface. Candidate points were first filtered using local curvature and optima, then connected into ridges by a greedy algorithm. Interactive steps were implemented to refine results. Among 173 simulated ridges, 115 can be tracked (RMSD < 0.001). For reproducing previous results, RTExtract took less than 2 h instead of ∼48 h, and two instead of seven parameters need tuning. Multiple regions with overlapping and changing chemical shifts are accurately tracked.Availability and implementationSource code is freely available within Metabolomics toolbox GitHub repository (https://github.com/artedison/Edison_Lab_Shared_Metabolomics_UGA/tree/master/metabolomics_toolbox/code/ridge_tracking) and is implemented in MATLAB and R.Supplementary informationSupplementary data are available at Bioinformatics online.
| S-EPMC7755419 | biostudies-literature
Project description:Ascorbate (Asc, vitamin C) was quantified in the human brain noninvasively using two different (1)H NMR spectroscopy methods: short-echo time STEAM and MEGA-PRESS homonuclear editing. Taking advantage of increased sensitivity and chemical shift dispersion at 7 T, Asc was quantified with increased reliability relative to our previous study accomplished at 4 T. Asc concentration quantified from short-echo time spectra measured from the occipital lobe of eight healthy subjects ([Asc] = 1.1 +/- 0.3 micromol/g, mean +/- SD) was in excellent agreement with Asc concentration quantified from the same volume of interest using homonuclear editing ([Asc] = 1.2 +/- 0.2 micromol/g). This agreement indicates that at 7 T, Asc can be reliably quantified in the human brain simultaneously with 15 other metabolites. Additional advantages of the short-echo time approach were: shorter measurement time than homonuclear editing and minimal effect of T(2) relaxation on Asc quantification. High magnetic field was also beneficial for Asc quantification with MEGA-PRESS because increased chemical shift dispersion enabled editing with full efficiency, which resulted in a supra-linear gain in signal-to-noise ratio relative to 4 T.
| S-EPMC3274383 | biostudies-other
Project description:MotivationNuclear magnetic resonance (NMR) spectroscopy is widely used for high-throughput characterization of metabolites in complex biological mixtures. However, accurate interpretation of the spectra in terms of identities and abundances of metabolites can be challenging, in particular in crowded regions with heavy peak overlap. Although a number of computational approaches for this task have recently been proposed, they are not entirely satisfactory in either accuracy or extent of automation.ResultsWe introduce a probabilistic approach Bayesian Quantification (BQuant), for fully automated database-based identification and quantification of metabolites in local regions of (1)H NMR spectra. The approach represents the spectra as mixtures of reference profiles from a database, and infers the identities and the abundances of metabolites by Bayesian model selection. We show using a simulated dataset, a spike-in experiment and a metabolomic investigation of plasma samples that BQuant outperforms the available automated alternatives in accuracy for both identification and quantification.AvailabilityThe R package BQuant is available at: http://www.stat.purdue.edu/~ovitek/BQuant-Web/.
| S-EPMC3106181 | biostudies-literature
Project description:Nuclear Magnetic Resonance (NMR) spectroscopy is, together with liquid chromatography-mass spectrometry (LC-MS), the most established platform to perform metabolomics. In contrast to LC-MS however, NMR data is predominantly being processed with commercial software. Meanwhile its data processing remains tedious and dependent on user interventions. As a follow-up to speaq, a previously released workflow for NMR spectral alignment and quantitation, we present speaq 2.0. This completely revised framework to automatically analyze 1D NMR spectra uses wavelets to efficiently summarize the raw spectra with minimal information loss or user interaction. The tool offers a fast and easy workflow that starts with the common approach of peak-picking, followed by grouping, thus avoiding the binning step. This yields a matrix consisting of features, samples and peak values that can be conveniently processed either by using included multivariate statistical functions or by using many other recently developed methods for NMR data analysis. speaq 2.0 facilitates robust and high-throughput metabolomics based on 1D NMR but is also compatible with other NMR frameworks or complementary LC-MS workflows. The methods are benchmarked using a simulated dataset and two publicly available datasets. speaq 2.0 is distributed through the existing speaq R package to provide a complete solution for NMR data processing. The package and the code for the presented case studies are freely available on CRAN (https://cran.r-project.org/package=speaq) and GitHub (https://github.com/beirnaert/speaq).
| S-EPMC5849334 | biostudies-literature
Project description:NMR spectroscopy continues to provide important molecular level details of dynamics in different polymer materials, ranging from rubbers to highly crosslinked composites. It has been argued that thermoset polymers containing dynamic and chemical heterogeneities can be fully cured at temperatures well below the final glass transition temperature (Tg). In this paper, we described the use of static solid-state 1H NMR spectroscopy to measure the activation of different chain dynamics as a function of temperature. Near Tg, increasing polymer segmental chain fluctuations lead to dynamic averaging of the local homonuclear proton-proton (1H-1H) dipolar couplings, as reflected in the reduction of the NMR line shape second moment (M2) when motions are faster than the magnitude of the dipolar coupling. In general, for polymer systems, distributions in the dynamic correlation times are commonly expected. To help identify the limitations and pitfalls of M2 analyses, the impact of activation energy or, equivalently, correlation time distributions, on the analysis of 1H NMR M2 temperature variations is explored. It is shown by using normalized reference curves that the distributions in dynamic activation energies can be measured from the M2 temperature behavior. An example of the M2 analysis for a series of thermosetting polymers with systematically varied dynamic heterogeneity is presented and discussed.
| S-EPMC7432559 | biostudies-literature
Project description:Fluorine (19F) NMR has emerged as a useful tool for characterization of slow dynamics in 19F-labeled proteins. One-dimensional (1D) 19F NMR spectra of proteins can be broad, irregular and complex, due to exchange of probe nuclei between distinct electrostatic environments; and therefore cannot be deconvoluted and analyzed in an objective way using currently available software. We have developed a Python-based deconvolution program, decon1d, which uses Bayesian information criteria (BIC) to objectively determine which model (number of peaks) would most likely produce the experimentally obtained data. The method also allows for fitting of intermediate exchange spectra, which is not supported by current software in the absence of a specific kinetic model. In current methods, determination of the deconvolution model best supported by the data is done manually through comparison of residual error values, which can be time consuming and requires model selection by the user. In contrast, the BIC method used by decond1d provides a quantitative method for model comparison that penalizes for model complexity helping to prevent over-fitting of the data and allows identification of the most parsimonious model. The decon1d program is freely available as a downloadable Python script at the project website (https://github.com/hughests/decon1d/).
| S-EPMC4524620 | biostudies-literature