Ultralow noise miniature external cavity semiconductor laser.
Ontology highlight
ABSTRACT:
SUBMITTER: Liang W
PROVIDER: S-EPMC4491184 | biostudies-other | 2015
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Utilizing a tunable photonic crystal resonant reflector as a mirror of an external cavity laser cavity, we demonstrate a new type of label-free optical biosensor that achieves a high quality factor through the process of stimulated emission, while at the same time providing high sensitivity and large dynamic range. The photonic crystal is fabricated inexpensively from plastic materials, and its resonant wavelength is tuned by adsorption of biomolecules on its surface. Gain for the lasing process is provided by a semiconductor optical amplifier, resulting in a simple detection instrument that operates by normally incident noncontact illumination of the photonic crystal and direct back-reflection into the amplifier. We demonstrate single-mode, biomolecule-induced tuning of the continuous-wave laser wavelength. Because the approach incorporates external optical gain that is separate from the transducer, the device represents a significant advance over previous passive optical resonator biosensors and laser-based biosensors.
| S-EPMC4610027 | biostudies-literature
Project description:At room temperature, mechanical motion driven by the quantum backaction of light has been observed only in pioneering experiments in which an optical restoring force controls the oscillator stiffness1,2. For solid-state mechanical resonators in which oscillations are controlled by the material rigidity, the observation of these effects has been hindered by low mechanical quality factors, optical cavity frequency fluctuations3, thermal intermodulation noise4,5 and photothermal instabilities. Here we overcome these challenges with a phononic-engineered membrane-in-the-middle system. By using phononic-crystal-patterned cavity mirrors, we reduce the cavity frequency noise by more than 700-fold. In this ultralow noise cavity, we insert a membrane resonator with high thermal conductance and a quality factor (Q) of 180 million, engineered using recently developed soft-clamping techniques6,7. These advances enable the operation of the system within a factor of 2.5 of the Heisenberg limit for displacement sensing8, leading to the squeezing of the probe laser by 1.09(1) dB below the vacuum fluctuations. Moreover, the long thermal decoherence time of the membrane oscillator (30 vibrational periods) enables us to prepare conditional displaced thermal states of motion with an occupation of 0.97(2) phonons using a multimode Kalman filter. Our work extends the quantum control of solid-state macroscopic oscillators to room temperature.
| S-EPMC10866701 | biostudies-literature
Project description:We report the design, fabrication, and testing of a photonic crystal (PC) biosensor structure that incorporates a porous high refractive index TiO2 dielectric film that enables immobilization of capture proteins within an enhanced surface-area volume that spatially overlaps with the regions of resonant electromagnetic fields where biomolecular binding can produce the greatest shifts in photonic crystal resonant wavelength. Despite the nanoscale porosity of the sensor structure, the PC slab exhibits narrowband and high efficiency resonant reflection, enabling the structure to serve as a wavelength-tunable element of an external cavity laser. In the context of sensing small molecule interactions with much larger immobilized proteins, we demonstrate that the porous structure provides 3.7× larger biosensor signals than an equivalent nonporous structure, while the external cavity laser (ECL) detection method provides capability for sensing picometer-scale shifts in the PC resonant wavelength caused by small molecule binding. The porous ECL achieves a record high figure of merit for label-free optical biosensors.
| S-EPMC4991988 | biostudies-other
Project description:Integrated plasmonic sources and detectors are imperative in the practical development of plasmonic circuitry for bio- and chemical sensing, nanoscale optical information processing, as well as transducers for high-density optical data storage. Here we show that vertical-cavity surface-emitting lasers (VCSELs) can be employed as an on-chip, electrically pumped source or detector of plasmonic signals, when operated in forward or reverse bias, respectively. To this end, we experimentally demonstrate surface plasmon polariton excitation, waveguiding, frequency conversion and detection on a VCSEL-based plasmonic platform. The coupling efficiency of the VCSEL emission to waveguided surface plasmon polariton modes has been optimized using asymmetric plasmonic nanostructures. The plasmonic VCSEL platform validated here is a viable solution for practical realizations of plasmonic functionalities for various applications, such as those requiring sub-wavelength field confinement, refractive index sensitivity or optical near-field transduction with electrically driven sources, thus enabling the realization of on-chip optical communication and lab-on-a-chip devices.
| S-EPMC4980450 | biostudies-literature
Project description:We report on the achievement of continuous wave bi-frequency operation in a membrane external-cavity surface-emitting laser (MECSEL), which is optically pumped with up to 4 W of 808 nm pump light. The presence of spatially specific loss of the intra-cavity high reflectivity mirror allows loss to be controlled on certain transverse cavity modes. The regions of spatially specific loss are defined through the removal of Bragg layers from the surface of the cavity high reflectivity mirror in the form of crosshair patterns with undamaged central regions, which are created using a laser ablation system incorporating a digital micromirror device (DMD). By aligning the laser cavity mode with the geometric centre of the loss patterns, the laser simultaneously operated on two Hermite-Gaussian spatial modes: the fundamental HG00 and the higher order HG11 mode. We demonstrate bi-frequency operation over a range of pump powers and sizes of spatial loss features, with a wavelength separation of approximately 5 nm centred at 1005 nm.
| S-EPMC10374101 | biostudies-literature
Project description:High-throughput screening has enabled the identification of small molecule modulators of important drug targets via well-established colorimetric or fluorimetric activity assays. However, existing methods to identify small molecule binders of nonenzymatic protein targets lack either the simplicity (e.g., require labeling one of the binding partners with a reporter) or throughput inherent in enzymatic assays widely used for HTS. Thus, there is intense interest in the development of high-throughput technologies for label-free detection of protein-small molecule interactions. Here we describe a novel self-referencing external cavity laser (ECL) biosensor approach that achieves high resolution and high sensitivity, while eliminating thermal noise with subpicometer wavelength accuracy. Using the self-referencing ECL biosensor, we demonstrate detection of binding between small molecules and a variety of immobilized protein targets, pairs that have binding affinities or inhibition constants ranging from subnanomolar to low micromolar. Finally, a "needle-in-the-haystack" screen for inhibitors against carbonic anhydrase isozyme II is performed, in which known inhibitors are clearly differentiated from inactive molecules within a compound library.
| S-EPMC4333586 | biostudies-literature
Project description:To improve the ability of an external cavity laser (ECL) biosensor to more easily distinguish true signals caused by biomolecular binding from a variety of sources of background noise, two photonic crystal (PC) resonant reflectors were incorporated into a single flow cell, with one of the PCs performing the detection function and the other one serving as a reference sensor. The ECL-based sensor system simultaneously emits at two distinct wavelengths corresponding to two different longitudinal cavity modes selected by the sensing and reference PC reflectors. The surface of the sensing PC filter was functionalized by a biomolecule recognition layer and exhibited narrowband reflection with the peak reflection wavelength at 856 nm. The reference PC was untreated and had the peak reflection wavelength at 859 nm. The PCs were bond to the upper and lower surfaces of a thin chamber frame, forming a flow cell. Utilizing the reference external cavity mode, the dual-mode ECL sensor system eliminated common-mode noise sources, including thermal drift, refractive index variations of the analyte solution, and nonspecific biomolecule binding.
| S-EPMC3683028 | biostudies-other
Project description:Fourier transform infrared (FTIR) and circular dichroism (CD) spectroscopy are analytical techniques employed for the analysis of protein secondary structure. The use of CD spectroscopy is limited to low protein concentrations (<2?mg ml(-1)), while FTIR spectroscopy is commonly used in a higher concentration range (>5?mg ml(-1)). Here we introduce a quantum cascade laser (QCL)-based IR transmission setup for analysis of protein and polypeptide secondary structure at concentrations as low as 0.25?mg ml(-1) in deuterated buffer solution. We present dynamic QCL-IR spectra of the temperature-induced ?-helix to ?-sheet transition of poly-L-lysine. The concentration dependence of the ?-? transition temperature between 0.25 and 10?mg ml(-1) was investigated by QCL-IR, FTIR and CD spectroscopy. By using QCL-IR spectroscopy it is possible to perform IR spectroscopic analysis in the same concentration range as CD spectroscopy, thus enabling a combined analysis of biomolecules secondary structure by CD and IR spectroscopy.
| S-EPMC5025714 | biostudies-literature
Project description:Creating micro and nano lasers, high threshold gain is an inherent problem that have critically restricted their great technological potentials. Here, we propose an inverse-cavity laser structure where its threshold gain in the shortest-cavity regime is order-of-magnitude lower than the conventional cavity configurations. In the proposed structure, a resonant feedback mechanism efficiently transfers external optical gain to the cavity mode at a higher rate for a shorter cavity, hence resulting in the threshold gain reducing with decreasing cavity length in stark contrast to the conventional cavity structures. We provide a fundamental theory and rigorous numerical analyses confirming the feasibility of the proposed structure. Remarkably, the threshold gain reduces down by a factor ~ 10-3 for a vertical-cavity surface-emitting laser structure and ~ 0.17 for a lattice-plasmonic nanocavity structure. Therefore, the proposed approach may produce extremely efficient miniature lasers desirable for variety of applications potentially beyond the present limitations.
| S-EPMC9256698 | biostudies-literature
Project description:A transportable prototype Faraday rotation spectroscopic system based on a tunable external cavity quantum cascade laser has been developed for ultrasensitive detection of nitric oxide (NO). A broadly tunable laser source allows targeting the optimum Q(3/2)(3/2) molecular transition at 1875.81 cm(-1) of the NO fundamental band. For an active optical path of 44 cm and 1-s lock-in time constant minimum NO detection limits (1sigma) of 4.3 parts per billion by volume (ppbv) and 0.38 ppbv are obtained by using a thermoelectrically cooled mercury-cadmium-telluride photodetector and liquid nitrogen-cooled indium-antimonide photodetector, respectively. Laboratory performance evaluation and results of continuous, unattended monitoring of atmospheric NO concentration levels are reported.
| S-EPMC2722329 | biostudies-literature