The influence of red pepper powder on the density of Weissella koreensis during kimchi fermentation.
Ontology highlight
ABSTRACT:
SUBMITTER: Kang BK
PROVIDER: S-EPMC4620494 | biostudies-other | 2015
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Weissella cibaria has been found in Korean kimchi and other sources, including fermented foods, Greek salami, Spanish sausages, and animal and human excrement. W. cibaria was recently reported to show anticancer, immunomodulatory, anti-inflammatory and antioxidant properties. Nevertheless, fundamental ecological succession studies are required to scientifically confirm the probiotic action of W. cibaria under various conditions, such as fermentation. Therefore, in the present study, we mined the W. cibaria KACC11862 genome in search of species-specific genes to use as new PCR targets for the detection and quantification of W. cibaria in kimchi. The sensitivity and specificity of the identified primer set from the putative outer membrane protein gene for the detection of W. cibaria KACC11862 in kimchi were analysed. Primer set specificity was evaluated using genomic DNA from eight W. cibaria isolates, 10 different species of Weissella and 13 other reference lactic acid bacteria (LAB) strains. Interestingly, by using the qPCR assay developed herein, we found that red pepper powder markedly affects the ontogeny of W. cibaria during kimchi fermentation.
| S-EPMC4911571 | biostudies-other
Project description:whole metagenomic sequencing of red pepper fermentation Raw sequence reads
| PRJNA473190 | ENA
Project description:In this study, furan analysis was conducted on dried red pepper powder treated by three cooking methods (boiling, roasting, and frying). A total of 144 samples were prepared and their furan levels were analysed using automated solid-phase micro-extraction gas chromatography-mass spectrometry. The furan concentration in boiled soup ranged from 1.26 to 4.65 ng/g, and from 7.37 to 27.68 ng/g for boiled red pepper samples. For the roasting method, a furan concentration between 6.66 and 761.37 ng/g was detected. For the frying method, the furan level of edible oils ranged from 3.93 to 125.88 ng/g, and a concentration ranging from 4.88 to 234.52 ng/g was detected for the fried red pepper samples. The cooking method using edible oil obtained a higher furan concentration than the water-based method. Samples using corn germ oil (linoleic acid-rich oil) obtained the highest furan concentration among the four edible oils. In all cooking methods, the higher the heating temperature and time, the higher the furan concentration detected. A kinetic study was conducted using the roasting model system and the apparent activation energy was 60.5 kJ/mol. The results of this study could be useful as a database for furan concentration in dried red pepper powder according to various cooking methods.
| S-EPMC9149621 | biostudies-literature
Project description:ImportanceProduction of ethanol from sugars and yeast is an ancient, ostensibly simple process. The source of sugars varies depending on the desired product and can include fruits, vegetables, molasses, honey, or grains, among other things. The source of yeast can be natural in the case of spontaneous ferments, but dry yeast addition is typical for large-scale fermentations. While the polymicrobial nature of some alcoholic fermentations is appreciated (e.g., for wine), most grain-based ethanol producers view microbes, apart from the added yeast, as "contaminants" meant to be controlled in order to maximize efficiency of ethanol production per unit of sugar. Nonetheless, despite rigorous cleaning-in-place measures and cooking the mash, bacteria are routinely cultured from these fermentations. We now know that bacteria can contribute to fermentation efficiency on an industrial scale, yet nothing is known about the makeup and stability of microbial communities in distilled spirit fermentations. The work here establishes the roles of mash recipes and distillery practices in microbial community assembly and dynamics over the course of fermentation. This represents an important first step in appreciating the myriad roles of bacteria in the production of distilled spirits.
| S-EPMC10714749 | biostudies-literature
Project description:In five regions of Korea, a total of 963 hot pepper powder samples were analyzed for 113 pesticides and one synergist using gas chromatography-mass spectrometry. For three years, sampling was performed every producing day in production plants according to ISO 24153 : 2009 methods. The limit of detection and limit of quantification ranges were 0.17-1.46 and 0.52-4.44 µg kg-1, respectively. The recovery ranges were 62.8-128.6% when spiked with 10 and 100 µg kg-1 of pesticides. Certified reference materials, such as chlorfenapyr and indoxacarb, were used for the validation of the analytical method. In total, 21 pesticides and one synergist were detected. Six pesticides, chlorfenapyr, indoxacarb, chlorantraniliprole, cypermethrin, difenoconazole, and pendimethalin, were detected at more than 50%, and nine pesticides, cyhalothrin, fenvalerate, picoxystrobin, deltamethrin, pyridalyl, propiconazole, iprodione, prochloraz, and bifenthrin, were detected at more than 10%. All monitoring results were under the Korean maximum residue limit.
| S-EPMC9641238 | biostudies-literature
Project description:Habanero pepper is recognized for its appealing aroma and flavor. Lactic acid fermentation can improve these sensory properties, especially aroma, by the synthesis of volatile compounds, which might also increase the consumer preference. Thus, the aim of this research was to compare the volatile composition as well as different sensory parameters such as preference and emotions related to the lactic acid fermentation of Habanero pepper by two strains (wild and commercial) of Lactiplantibacillus plantarum. A multiple factor ANOVA was used to compare the volatile composition with different fermentation times and strains. The results demonstrated that the interaction between the strain and fermentation time had significant effects on the volatile compound production that includes 1-hexanol, cis-3-hexenyl hexanoate, linalool, and 3,3 dimethyl-1-hexanol while only time influenced the production of trans-2-hexen-1-al. The wild strain (WIL) at 48 h of fermentation produced the highest concentration of 3,3 dimethyl-1-hexanol and trans-2-hexen-1-al. On the other hand, the commercial strain (COM) presented the highest concentration of 1-hexanol and cis-3-hexenyl hexanoate with a 72 h fermentation. The most preferred sample was that fermented by WIL for 48 h for the attribute of odor, while for taste, the most preferred sample was that fermented for 72 h with COM.
| S-EPMC9689949 | biostudies-literature
Project description:Red, yellow, and green peppers are vegetables rich in natural pigments. However, they belong to seasonal vegetables and need to be treated to prolong their shelf life. One new approach to processing vegetables is to pickle them using lactic acid bacteria. The use of such a process creates a new product with high health value, thanks to the active ingredients and lactic acid bacteria. Therefore, this study aimed to evaluate the effect of the applied strain of lactic acid bacteria (LAB) on the chemical properties, including the content of active compounds (pigments) and the physical properties of the peppers. Levilactobacillus brevis, Limosilactobacillus fermentum, and Lactoplantibacillus plantarum were used for fermentation and spontaneous fermentation. The pigments, polyphenols content, and antioxidant properties were determined in the pickled peppers, as well as sugar content, color, dry matter, texture properties, and the count of lactic acid bacteria. In all samples, similar growth of LAB was observed. Significant degradation of chlorophylls into pheophytins was observed after the fermentation process. No significant differences were observed in the parameters tested, depending on the addition of dedicated LAB strains. After the fermentation process, the vitamin C and total polyphenols content is what influenced the antioxidant activity of the samples. It can be stated that the fermentation process changed the red bell pepper samples in the smallest way and the green ones in the highest way.
| S-EPMC9741357 | biostudies-literature
Project description:BackgroundTo explore the optimum fermentation conditions for tobacco leaves and also screen the microbiota and metabolites that are beneficial for fermentation.MethodsTobacco leaves were fermented at 25 °C, 35 °C, and 45 °C for 2, 4, and 6 weeks, respectively. For identification of the best fermentation temperature, physicochemical properties and sensory quality of fermented tobacco were investigated. Subsequently, based on the appropriate temperature, 16 s rRNA sequencing and metabolomics analysis of tobacco were performed to monitor the change of microbes and metabolites during fermentation process (from 2 to 6 weeks).ResultsSensory quality analysis indicated that fermentation at 45 °C for 6 weeks represented the optimum condition. Metabolomics analysis showed that a total of 415 metabolites were annotated. The increase of fermentation period led to significant changes of metabolites. Results revealed an increase in concentration of L-phenylalanine and sphingosine as well as decreased concentration of betaine and phytosphingosine with the prolongation of fermentation period (2 to 6 weeks). Distinct changes in the microbiota were also observed with prolongation of the fermentation time. Results revealed that Pseudomonas, Pantoea, and Burkholderia were dominant bacteria in fermentation at 45 °C for 6 weeks. With the extension of the fermentation time, the abundance of Pseudomonas increased, while that of Sphingomonas and Methylobacterium decreased. Furthermore, microbiota profiles were tightly relevant to the altered metabolites, especially compounds involved in the sphingolipid metabolism.ConclusionSuitable fermentation conditions were 45 °C for 6 weeks; phytosphingosine and sphingosine might affect tobacco fermentation via the sphingolipid metabolism pathway. This study provides a theoretical basis for guiding tobacco fermentation and gives insights into reducing harmful substances during tobacco fermentation.
| S-EPMC7678276 | biostudies-literature
Project description:Three-dimensional printing used to be a rapid prototyping process, but nowadays it is establishing as an additive manufacturing (AM) process. One of these AM techniques is selective laser sintering (SLS), which most often involves partial melting of the particles and therefore belongs to the category of powder bed fusion processes. Much progress has been made in this field by research on process parameters like laser power, hatch distance, and scanning speed while still lacking a fundamental understanding of the powder deposition and its influence on parts. A critical issue for economic manufacturing is the building time of parts with good mechanical properties, which can be reduced by lower surface roughness due to less or missing post processing. Therefore, the influence of three blade shapes on powder bed surface roughness has been evaluated for PA12 powder with three different grain size distributions by using advanced X-ray micro computed tomography (XMT) and a confocal laser scanning microscope (LSM). Along with those methods, new techniques for powder characterization were tested and compared. Lowest roughness has been achieved with a flat blade, based on a higher compression due to a larger contact zone between blade and powder bed. Furthermore, an anisotropic effect of the mechanical properties resulting from different building directions has been detected which can be explained by varying amounts of solid contact paths through the powder bed depending on powder application direction. In addition, an optimal combination of process parameters with an even compression of the powder bed leads to low surface roughness, complementing the advantages of additive manufacturing.
| S-EPMC6357138 | biostudies-other
Project description:To understand the individual enological function of different unsaturated fatty acids (UFAs), the separated effects of three different UFAs, linoleic acid (LA), oleic acid (OA), and α-linolenic acid (ALA), on yeast fermentation and aroma compounds were investigated in the alcoholic fermentation of Cabernet Sauvignon wine. The results showed that, besides concentration, UFAs types could also influence fermentation process and volatiles in final wine. Low concentrations of UFAs (12 and 60 mg/L), especially LA and OA, significantly promoted fermentation activity and most volatiles when compared to the control, however, the effect became the inhibition with increasing concentrations of UFAs (120 and 240 mg/L). It was interesting to find that OA addition (12 and 60 mg/L) could generate more acetate esters (especially isoamyl acetate) in wine, while 12 mg/L LA facilitated more fatty acids formation (octanoic acid and decanoic acid). In comparison, 120 and 240 mg/L ALA produced more amount of C6 alcohols (1-hexanol) and higher alcohols (isobutyl alcohol and 2,3-butanediol). UFAs additions were unfavorable for ethyl esters formation, except for an increment of ethyl hexanoate in 12 mg/L OA wine. As a result, different aromatic profiles of wines were generated by variations of UFAs types and levels, as shown by PCA. The transcriptional data revealed that the expressions of aroma-related genes, such as BAT1, BAT2, PDC1, PDC5, PDC6, ACC1, FAS1, ATF1, EEB1, and EHT1 were correlated with aroma compounds productions in different treatments. Our data suggested that the three UFAs have different enological functions and they could generate different aromatic profiles. Thus, besides concentrations, it is essential to consider the types of UFAs when applying the strategy to adjust UFAs contents to modulate the aromatic quality of wines.
| S-EPMC6384975 | biostudies-literature