Blue-phase liquid crystal droplets.
Ontology highlight
ABSTRACT:
SUBMITTER: Martinez-Gonzalez JA
PROVIDER: S-EPMC4629366 | biostudies-other | 2015 Oct
REPOSITORIES: biostudies-other
Similar Datasets
Project description:A liquid crystal laser using a polymer-stabilized simple cubic blue phase (BPII) platform has been scarcely reported because the polymer stabilization of a BPII is relatively difficult compared to that of a body-centered-cubic BP (BPI). In this study, we succeeded in fabricating a dye-doped polymer-stabilized BPII laser with wide operating-temperature ranges over 15 °C including room temperature. A narrow and sharp single laser peak with a full width at half maximum of approximately 2 nm was derived from the photonic band edge effect of the BPII-distributed feedback optical resonator. As a result, the laser emission was a circularly polarized light, which matched the chirality of the proposed pure BPII.
| S-EPMC9073273 | biostudies-literature
Project description:Drop drying and deposition phenomena reveal a rich interplay of fundamental science and engineering, give rise to fascinating everyday effects (coffee rings), and influence technologies ranging from printing to genotyping. Here we investigate evaporation dynamics, morphology, and deposition patterns of drying lyotropic chromonic liquid crystal droplets. These drops differ from typical evaporating colloidal drops primarily due to their concentration-dependent isotropic, nematic, and columnar phases. Phase separation occurs during evaporation, and in the process creates surface tension gradients and significant density and viscosity variation within the droplet. As a result, the drying multiphase drops exhibit different convective currents, drop morphologies, and deposition patterns (coffee-rings).
| S-EPMC5460001 | biostudies-literature
Project description:Biosensing using liquid crystals has a tremendous potential by coupling the high degree of sensitivity of their alignment to their surroundings with clear optical feedback. Many existing set-ups use birefringence of nematic liquid crystals, which severely limits straightforward and frugal implementation into a sensing platform due to the sophisticated optical set-ups required. In this work, we instead utilize chiral nematic liquid crystal microdroplets, which show strongly reflected structural color, as sensing platforms for surface active agents. We systematically quantify the optical response of closely related biological amphiphiles and find unique optical signatures for each species. We detect signatures across a wide range of concentrations (from micromolar to millimolar), with fast response times (from seconds to minutes). The striking optical response is a function of the adsorption of surfactants in a nonhomogeneous manner and the topology of the chiral nematic liquid crystal orientation at the interface requiring a scattering, multidomain structure. We show that the surface interactions, in particular, the surface packing density, to be a function of both headgroup and tail and thus unique to each surfactant species. We show lab-on-a-chip capability of our method by drying droplets in high-density two-dimensional arrays and simply hydrating the chip to detect dissolved analytes. Finally, we show proof-of-principle in vivo biosensing in the healthy as well as inflamed intestinal tracts of live zebrafish larvae, demonstrating CLC droplets show a clear optical response specifically when exposed to the gut environment rich in amphiphiles. Our unique approach shows clear potential in developing on-site detection platforms and detecting biological amphiphiles in living organisms.
| S-EPMC9412956 | biostudies-literature
Project description:We show that micron-scale two-dimensional (2D) honeycomb microwells can significantly improve the stability of blue phase liquid crystals (BPLCs). Polymeric microwells made by direct laser writing improve various features of the blue phase (BP) including a dramatic extension of stable temperature range and a large increase both in reflectivity and thermal stability of the reflective peak wavelength. These results are mainly attributed to the omnidirectional anchoring of the isotropically oriented BP molecules at the polymer walls of the hexagonal microwells and at the top and bottom substrates. This leads to an omnidirectional stabilization of the entire BPLC system. This study not only provides a novel insight into the mechanism for the BP formation in the 2D microwell but also points to an improved route to stabilize BP using 2D microwell arrays.
| S-EPMC6275947 | biostudies-literature
Project description:A number of 1,4-bis(phenylethynyl)benzene derivatives (BPEBs) and their analogues with different numbers of side-substitute fluorine atoms on benzene rings, and alkyl chains, ethoxyl groups, fluorine atoms and trifluoromethyl groups as the end groups have been synthesized. The effects of the different substituents on their properties such as thermal behavior of melting point and clearing point, the temperature of nematic phase, optical anisotropy and dielectric anisotropy have been well investigated, and it has been found that some BPEBs have a wide range of the nematic phase temperature with high optical anisotropy (?n) and acceptable dielectric anisotropy (??), which have been applied as the crucial compositions to constitute a liquid crystal mixture having the properties of ??=29.0 and ?n=0.283 at 25 °C. With the addition of the chiral dopant to the obtained liquid crystal mixture, blue phase liquid crystal with a blue phase temperature range of 8 °C has been achieved.
| S-EPMC3876042 | biostudies-literature
Project description:Common nematic oils, such as 5CB, experience planar anchoring at aqueous interfaces. When these oils are emulsified, this anchoring preference and the resulting topological constraints lead to the formation of droplets that exhibit one or two point defects within the nematic phase. Here, we explore the interactions of adsorbed particles at the aqueous interface through a combination of experiments and coarse-grained modeling, and demonstrate that surface-active particles, driven by elastic forces in the droplet, readily localize to these defect regions in a programmable manner. When droplets include two nanoparticles, these preferentially segregate to the two poles, thereby forming highly regular dipolar structures that could serve for hierarchical assembly of functional structures. Addition of sufficient concentrations of surfactant changes the interior morphology of the droplet, but pins defects to the interface, resulting in aggregation of the two particles.
| S-EPMC4434594 | biostudies-literature
Project description:The optical characteristics of materials, such as their magnetooptical effects, birefringence, optical activities, linear and circular dichroism, are probed via the polarisation states of light transmitted through or reflected from the specimens. As such, the measurements of the polarisation states play an important role in many research disciplines. Experimentally, Stokes parameters provide a full description of the polarisation states of light. We report the implementation of a dual- photoelastic modulator based polarimeter in a light microscope, enabling the determination of Stokes parameters at each pixel. As a case study, polarimetric images of liquid crystal droplets of different internal structures are obtained, showing their distinct polarisation characteristics. We demonstrate that the prototype Stokes polarimetric microscope allows the quantitative determination of the polarisation characteristics of light at the object plane and enables the access of the information of full polarisation states as compared to a conventional cross polariser microscope. This work shows that Stokes polarimetric microscopy may find potential applications in a wide range of research fields.
| S-EPMC8358033 | biostudies-literature
Project description:Nanoparticles adsorbed at the interface of nematic liquid crystals are known to form ordered structures whose morphology depends on the orientation of the underlying nematic field. The origin of such structures is believed to result from an interplay between the liquid crystal orientation at the particles' surface, the orientation at the liquid crystal's air interface, and the bulk elasticity of the underlying liquid crystal. In this work, we consider nanoparticle assembly at the interface of nematic droplets. We present a systematic study of the free energy of nanoparticle-laden droplets in terms of experiments and a Landau-de Gennes formalism. The results of that study indicate that, even for conditions under which particles interact only weakly at flat interfaces, particles aggregate at the poles of bipolar droplets and assemble into robust, quantized arrangements that can be mapped onto hexagonal lattices. The contributions of elasticity and interfacial energy corresponding to different arrangements are used to explain the resulting morphologies, and the predictions of the model are shown to be consistent with experimental observations. The findings presented here suggest that particle-laden liquid crystal droplets could provide a unique and versatile route toward building blocks for hierarchical materials assembly.
| S-EPMC4418874 | biostudies-literature
Project description:Blue-phase liquid crystals (BPLCs) are regarded as potential materials for the exploitation of next-generation optical devices due to the rapid response, wide viewing angle, and simple industrial production procedures. However, practical application of traditional BPLCs is limited by their narrow temperature range and high driving voltage. Herein, we demonstrated that doping of chiral molecular isosorbide hexyloxybenzoate (R811) into BPLCs is able to increase the temperature range. More importantly, addition of InP/ZnS quantum dots (QDs) with oleylamine surface groups could also effectively broaden the temperature range of the BPLCs further while decreasing the driving voltage, which is attributed to the quantum dot trapped by BPLCs lattice defect that reduces its free energy. Since the trapped quantum dot subsequently forms a local electric field under electric field, the effective electric field of the surrounding liquid crystal molecules is enhanced and the rotation of the liquid crystal molecules is accelerated. Specially, the temperature range is widened by 1.4 °C, and the driving voltage is reduced by 57%, under the optimal concentration of R811 and lnP/ZnS QDs. The accomplishment we proposed in this work is a prospective optimization which makes the practical application of blue phase liquid crystals one step closer.
| S-EPMC7582920 | biostudies-literature
Project description:We demonstrate that the assembly of an amphiphilic polyamine on the interfaces of micrometer-sized droplets of a thermotropic liquid crystal (LC) dispersed in aqueous solutions can be used to facilitate the immobilization of LC droplets on chemically functionalized surfaces. Polymer 1 was designed to contain both hydrophobic (alkyl-functionalized) and hydrophilic (primary and tertiary amine-functionalized) side chain functionality. The assembly of this polymer at the interfaces of aqueous dispersions of LC droplets was achieved by the spontaneous adsorption of polymer from aqueous solution. Polymer adsorption triggered transitions in the orientational ordering of the LCs, as observed by polarized light and bright-field microscopy. We demonstrate that the presence of polymer 1 on the interfaces of these droplets can be exploited to immobilize LC droplets on planar solid surfaces through covalent bond formation (e.g., for surfaces coated with polymer multilayers containing reactive azlactone functionality) or through electrostatic interactions (e.g., for surfaces coated with multilayers containing hydrolyzed azlactone functionality). The characterization of immobilized LC droplets by polarized, fluorescence, and laser scanning confocal microscopy revealed the general spherical shape of the polymer-coated LC droplets to be maintained after immobilization, and that immobilization led to additional ordering transitions within the droplets that were dependent on the nature of the surfaces with which they were in contact. Polymer 1-functionalized LC droplets were not immobilized on polymer multilayers treated with poly(ethylene imine) (PEI). We demonstrate that the ability to design surfaces that promote or prevent the immobilization of polymer-functionalized LC droplets can be exploited to pattern the immobilization of LC droplets on surfaces. The results of this investigation provide the basis of an approach that could be used to tailor the properties of dispersed LC emulsions and to immobilize these droplets on functional surfaces of interest in a broad range of fundamental and applied contexts.
| S-EPMC2883006 | biostudies-literature