Artificially produced rare-earth free cosmic magnet.
Ontology highlight
ABSTRACT:
SUBMITTER: Makino A
PROVIDER: S-EPMC4644987 | biostudies-other | 2015
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Permanent magnets are fundamental constituents in key sectors such as energy and transport, but also robotics, automatization, medicine, etc. High-performance magnets are based on rare earth elements (RE), included in the European list of critical raw materials list. The volatility of their market increased the research over the past decade to develop RE-free magnets to fill the large performance/cost gap existing between ferrites and RE-based magnets. The improvement of hard ferrites and Mn-Al-C permanent magnets plays into this important technological role in the near future. The possible substitution advantage was widely discussed in the literature considering both magnetic properties and economic aspects. To evaluate further sustainability aspects, the present paper gives a life cycle assessment quantifying the environmental gain resulting from the production of RE-free magnets based on traditional hexaferrite and Mn-Al-C. The analysis quantified an advantage of both magnets that overcomes the 95% in all the considered impact categories (such as climate change, ozone depletion, human toxicity) compared to RE-based technologies. The benefit also includes the health and safety of working time aspects, proving possible reduction of worker risks by 3-12 times. The results represent the fundamentals for the development of green magnets that are able to significantly contribute to an effective sustainable transition.
| S-EPMC10498492 | biostudies-literature
Project description:There is considerable interest in extraction of rare earth elements from NdFeB magnets to enable recycling of these elements. In practical extraction methods using wet processes, the acid waste solution discharge is a problem that must be resolved to reduce the environmental impact of the process. Here, we present an encouraging demonstration of rare earth element extraction from a NdFeB magnet using a closed-loop hydrochloric acid (HCl)-based process. The extraction method is based on corrosion of the magnet in a pretreatment stage and a subsequent ionic liquid technique for Fe extraction from the HCl solution. The rare earth elements are then precipitated using oxalic acid. Triple extraction has been conducted and the recovery ratio of the rare earth elements from the solution is approximately 50% for each extraction process, as compared to almost 100% recovery when using a one-shot extraction process without the ionic liquid but with sufficient oxalic acid. Despite its reduced extraction efficiency, the proposed method with its small number of procedures at almost room temperature is still highly advantageous in terms of both cost and environmental friendliness. This study represents an initial step towards realization of a closed-loop acid process for recycling of rare earth elements.
| S-EPMC5556000 | biostudies-literature
Project description:Background Based on prior reports of the use of magnets to treat pain, our goal was to determine if a concentric rare-earth alternating-pole magnet reduced period pain versus a sham-magnet. Methods Participants were females (N=36, 18 to 35 years) who regularly experienced menstrual period pain ? six on the numeric pain rating scale (NPRS) of 0-10. Subjects were excluded if they took pain medication on the study day or had implanted pacemakers/metallic devices or secondary dysmenorrhea. Participants were randomized to wear a concentric neodymium-iron boron active-magnet (surface-field of 0.4 Tesla) or a sham magnet. The participant and investigator applying the device were blinded to the device used. The device was placed at the abdominal location of the reported greatest pain for 40-minutes, during which time the subject was able to conduct the normal activity. Pain scores were reported prior to device wearing and afterward. Participants with post-treatment NPRS ratings reduced by ? 35% from their pretreatment pain ratings were scored as having reduced pain; reductions < 35% were scored as no meaningful pain change. The threshold of 35% was chosen based on a survey of 10 women as to the level of pain reduction they viewed as meaningful to them. Of the 36 women in this pilot study, 19 wore an active-magnet and 17 wore a sham-magnet. Analyses were based on chi-square and Mann-Whitney statistical tests. Results Pre-treatment pain scores (mean ± SD) were similar for both groups. Magnet-vs-sham pre-treatment scores were, respectively, 7.16 ± 0.85 vs. 6.94 ± 1.20 (p=0.330). Corresponding median values for the magnet (N=19) and sham (N=17) groups respectively were seven pre-treatment and four post-treatment vs. six pre-treatment and six post-treatment. Post-treatment scores for magnet treated subjects (4.16 ± 2.20) were significantly less (p=0.027) than for sham-treated (5.53 ± 1.50). Of the 19 who wore a magnet, 11 experienced meaningful pain-reduction, and eight did not. Of the 17 who wore a sham, three experienced meaningful pain-reduction, and 14 did not. Magnet and sham wearing responses were statistically significant via chi-square analysis (chi-square=6.12, p=0.013). Percentage reduction in pain score was 41.8% ± 31.1% for magnet-treated vs. 20.8% ± 16.1%, for sham-treated (p<0.05). Conclusions Results suggest that short-term wearing of the magnet herein investigated, produces a meaningful menstrual-pain reduction in some women. Thus, further expanded research seems warranted to determine if longer wearing times result in even greater pain reductions.
| S-EPMC7894227 | biostudies-literature
Project description:Tremendous success has been achieved in photovoltaic (PV) applications, but PV-generated electricity still cannot compete with traditional power in terms of price. Chemically stable and nontoxic all-oxide solar cells made from earth-abundant resources fulfill the requirements for low-cost manufacturing under ambient conditions and thus are promising as the next-generation approach to solar cells. However, the main obstacles to developing all-oxide solar cells are the spectral absorbers. Besides photovoltaics, novel chemically stable, nontoxic, and earth-abundant narrow-bandgap semiconductors are desired for photochemical applications in photodetectors, photoelectrodes, or photocatalysts. Herein, were report novel lead-free perovskite narrow-bandgap rare-earth semiconductors, YMnO3, HoMnO3, ErMnO3, and YbMnO3, which were identified by screening a family of perovskite rare-earth manganates, RMnO3 (R = Y, La, Ce, Pr, Nd, Sm, Gd, Tb, Dy, Ho, Er, and Yb). The sharp edge observed in their absorption spectra indicates the existence of band gaps, further confirmed with laser Raman fluorescence spectra. Good periodic on-off photoelectronic response was observed in 8 of the 12 members (i.e., R = La, Pr, Nd, Sm, Gd, Tb, Dy, and Yb). Among them, YbMnO3 is approved as an n-type semiconductor with a direct band gap near 1.35 eV, whose theoretical Shockley-Queisser efficiency is approximately 33.7% for single-p-n-junction solar cells. This work sheds light on exploring stable oxide semiconductors with a narrow band gap for future applications.
| S-EPMC7178806 | biostudies-literature
Project description:All-optical helicity-dependent switching in ferromagnetic layers has revealed an unprecedented route to manipulate magnetic configurations by circularly polarized femtosecond laser pulses. In this work, rare-earth free synthetic ferrimagnetic heterostructures made from two antiferromagnetically exchange coupled ferromagnetic layers are studied. Experimental results, supported by numerical simulations, show that the designed structures enable all-optical switching which is controlled, not only by light helicity, but also by the relative Curie temperature of each ferromagnetic layer. Indeed, through the antiferromagnetic exchange coupling, the layer with the larger Curie temperature determines the final orientation of the other layer and so the synthetic ferrimagnet. For similar Curie temperatures, helicity-independent back switching is observed and the final magnetic configuration is solely determined by the initial magnetic state. This demonstration of electrically-detected, optical control of engineered rare-earth free heterostructures opens a novel route toward practical opto-spintronics.
| S-EPMC6918116 | biostudies-literature
Project description:Lightweight, recyclable, and plentiful Mg alloys are receiving increased attention due to an exceptional combination of strength and ductility not possible from pure Mg. Yet, due to their alloying elements, such as rare-earths or aluminum, they are either not economical or biocompatible. Here we present a new rare-earth and aluminum-free magnesium-based alloy, with trace amounts of Zn, Ca, and Mn (≈ 2% by wt.). We show that the dilute alloy exhibits outstanding high strength and high ductility compared to other dilute Mg alloys. By direct comparison with annealed material of the same chemistry and using transmission electron microscopy (TEM), high-resolution TEM (HR-TEM) and atom probe tomography analyses, we show that the high strength can be attributed to a number of very fine, Zn/Ca-containing nanoscale precipitates, along with ultra-fine grains. These findings show that forming a hierarchy of nanometer precipitates from just miniscule amounts of solute can invoke simultaneous high strength and ductility, producing an affordable, biocompatible Mg alloy.
| S-EPMC7522977 | biostudies-literature
Project description:The surface free energy of rare earth oxides (REOs) has been debated during the last decade, with some reporting REOs to be intrinsically hydrophilic and others reporting hydrophobic. Here, we investigate the wettability and surface chemistry of pristine and smooth REO surfaces, conclusively showing that hydrophobicity stems from wettability transition due to volatile organic compound adsorption. We show that, for indoor ambient atmospheres and well-controlled saturated hydrocarbon atmospheres, the apparent advancing and receding contact angles of water increase with exposure time. We examined the surfaces comprehensively with multiple surface analysis techniques to confirm hydrocarbon adsorption and correlate it to wettability transition mechanisms. We demonstrate that both physisorption and chemisorption occur on the surface, with chemisorbed hydrocarbons promoting further physisorption due to their high affinity with similar hydrocarbon molecules. This study offers a better understanding of the intrinsic wettability of REOs and provides design guidelines for REO-based durable hydrophobic coatings.
| S-EPMC8752908 | biostudies-literature
Project description:Type-I clathrates possess extremely low thermal conductivities, a property that makes them promising materials for thermoelectric applications. The incorporation of cerium into one such clathrate has recently been shown to lead to a drastic enhancement of the thermopower, another property determining the thermoelectric efficiency. Here we explore the mechanism of the incorporation of rare earth elements into type-I clathrates. Our investigation of the crystal growth and the composition of the phase Ba8-x RE x TM y Si46-y (RE = rare earth element; TM = Au, Pd, Pt) reveals that the RE content x is mainly governed by two factors, the free cage space and the electron balance.
| S-EPMC4718404 | biostudies-literature
Project description:AbstarctIn the drive to reduce the critical Heavy Rare Earth (HRE) content of magnets for green technologies, HRE-free Nd-Fe-B has become an attractive option. HRE is added to Nd-Fe-B to enhance the high temperature performance of the magnets. To produce similar high temperature properties without HRE, a crystallographically textured nanoscale grain structure is ideal; and this conventionally requires expensive "die upset" processing routes. Here, a Flash Spark Plasma Sintering (FSPS) process has been applied to a Dy-free Nd30.0Fe61.8Co5.8Ga0.6Al0.1B0.9 melt spun powder (MQU-F, neo Magnequench). Rapid sinter-forging of a green compact to near theoretical density was achieved during the 10 s process, and therefore represents a quick and efficient means of producing die-upset Nd-Fe-B material. The microstructure of the FSPS samples was investigated by SEM and TEM imaging, and the observations were used to guide the optimisation of the process. The most optimal sample is compared directly to commercially die-upset forged (MQIII-F) material made from the same MQU-F powder. It is shown that the grain size of the FSPS material is halved in comparison to the MQIII-F material, leading to a 14% increase in coercivity (1438 kA m-1) and matched remanence (1.16 T) giving a BHmax of 230 kJ m-3.
| S-EPMC5593872 | biostudies-literature
Project description:White light-emitting diode (WLED) products currently available on the market are based on the blue LED combined with yellow phosphor approach. However, these WLEDs are still insufficient for general illumination and flat panel display (FPD) applications because of their low color-rendering index (CRI < 75) and high correlated color temperature (CCT = 6000 K). Although near-ultraviolet (UV) LED chips provide more efficient excitation than blue chips, YAG:Ce(3+) phosphors have very weak excitation in the near-UV spectral region. Hence, there is an increasing demand for novel yellow phosphor materials with excitation in the near-UV region. In this work, we report novel self-activated yellow Ca(5)Zn(3.92)In(0.08)(V(0.99)Ta(0.01)O(4))(6) (CZIVT) phosphors that efficiently convert near-UV excitation light into yellow luminescence. The crystal structure and lattice parameters of these CZIVT phosphors are elucidated through Rietveld refinement. Through doping with In(3+) and Ta(5+) ions, the emission intensity is enhanced in the red region, and the Stokes shift is controlled to obtain good color rendition. When a near-UV LED chip is coated with a combination of CZIVT and commercial blue Ba(0.9)Eu(0.1)MgAl(10)O(17) phosphors, a pleasant WLED with a high CRI of 82.51 and a low CCT of 5231 K, which are essential for indoor illumination and FPDs, is achieved.
| S-EPMC4438725 | biostudies-literature