A Review of the Effects of Major Atmospheric Pollutants on Pollen Grains, Pollen Content, and Allergenicity.
Ontology highlight
ABSTRACT:
SUBMITTER: Senechal H
PROVIDER: S-EPMC4706970 | biostudies-other | 2015
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Oral vaccination can offer a painless and convenient method of vaccination. Furthermore, in addition to systemic immunity it has potential to stimulate mucosal immunity through antigen-processing by the gut-associated lymphoid tissues. In this study we propose the concept that pollen grains can be engineered for use as a simple modular system for oral vaccination. We demonstrate feasibility of this concept by using spores of Lycopodium clavatum (clubmoss) (LSs). We show that LSs can be chemically cleaned to remove native proteins to create intact clean hollow LS shells. Empty pollen shells were successfully filled with molecules of different sizes demonstrating their potential to be broadly applicable as a vaccination system. Using ovalbumin (OVA) as a model antigen, LSs formulated with OVA were orally fed to mice. LSs stimulated significantly higher anti-OVA serum IgG and fecal IgA antibodies compared to those induced by use of cholera toxin as a positive-control adjuvant. The antibody response was not affected by pre-neutralization of the stomach acid, and persisted for up to 7 months. Confocal microscopy revealed that LSs can translocate into mouse intestinal wall. Overall, this study lays the foundation of using LSs as a novel approach for oral vaccination.
| S-EPMC4586069 | biostudies-literature
Project description:Background and aimsFlowering plants show a high diversity of pollen morphology, assumed to reflect not only variations in the underlying design, but also stress imposed by ecological conditions related to pollen survival and germination. Both components are expected to constrain the accumulation of pollen disparity. However, this assumption has rarely been tested using empirical data.MethodsThis study is designed to test this hypothesis by inferring the accumulation of pollen disparity in Ericaceae, a large eudicot family with recent, ongoing radiations, with focus on three functionally significant pollen characters using a dated phylogeny.Key resultsMultiple lines of evidence supported the hypothesis that pollen disparity in Ericaceae did not evolve steadily but rather pulsed over time, clearly decoupling from the relative constant rate pattern of species diversification inferred. In a 3-D pollen morphospace, most major clades appear to occupy distinct neighbouring regions, whereas the subfamily Epacridoideae overlaps extensively with other subfamilies. No evidence for correlations was found between dimension of pollen disparity and species diversity at either the subfamily or generic level. Furthermore, the distribution of species in present pollen morphospace showed a strong central tendency, with the core compartment containing a large number of species from species-rich genera.ConclusionsThe recovered evidence fits well with the expectations of limitations on available pollen morphological disparity, and suggests that innovation of pollen germination traits may have little effect on species diversification.
| S-EPMC6526368 | biostudies-literature
Project description:Upon release from the anther, pollen grains of angiosperm flowers are exposed to a dry environment and dehydrate. To survive this process, pollen grains possess a variety of physiological and structural adaptations. Perhaps the most striking of these adaptations is the ability of the pollen wall to fold onto itself to prevent further desiccation. Roger P. Wodehouse coined the term harmomegathy for this folding process in recognition of the critical role it plays in the survival of the pollen grain. There is still, however, no quantitative theory that explains how the structure of the pollen wall contributes to harmomegathy. Here we demonstrate that simple geometrical and mechanical principles explain how wall structure guides pollen grains toward distinct folding pathways. We found that the presence of axially elongated apertures of high compliance is critical for achieving a predictable and reversible folding pattern. Moreover, the intricate sculpturing of the wall assists pollen closure by preventing mirror buckling of the surface. These results constitute quantitative structure-function relationships for pollen harmomegathy and provide a framework to elucidate the functional significance of the very diverse pollen morphologies observed in angiosperms.
| S-EPMC2867878 | biostudies-other
Project description:Fourier-transform infrared (FTIR) spectroscopy enables the chemical characterization and identification of pollen samples, leading to a wide range of applications, such as paleoecology and allergology. This is of particular interest in the identification of grass (Poaceae) species since they have pollen grains of very similar morphology. Unfortunately, the correct identification of FTIR microspectroscopy spectra of single pollen grains is hindered by strong spectral contributions from Mie scattering. Embedding of pollen samples in paraffin helps to retrieve infrared spectra without scattering artifacts. In this study, pollen samples from 10 different populations of five grass species (Anthoxanthum odoratum, Bromus inermis, Hordeum bulbosum, Lolium perenne, and Poa alpina) were embedded in paraffin, and their single grain spectra were obtained by FTIR microspectroscopy. Spectra were subjected to different preprocessing in order to suppress paraffin influence on spectral classification. It is shown that decomposition by non-negative matrix factorization (NMF) and extended multiplicative signal correction (EMSC) that utilizes a paraffin constituent spectrum, respectively, leads to good success rates for the classification of spectra with respect to species by a partial least square discriminant analysis (PLS-DA) model in full cross-validation for several species. PLS-DA, artificial neural network, and random forest classifiers were applied on the EMSC-corrected spectra using an independent validation to assign spectra from unknown populations to the species. Variation within and between species, together with the differences in classification results, is in agreement with the systematics within the Poaceae family. The results illustrate the great potential of FTIR microspectroscopy for automated classification and identification of grass pollen, possibly together with other, complementary methods for single pollen chemical characterization.
| S-EPMC7442581 | biostudies-literature
Project description:BackgroundThe impact of heat waves and atmospheric oxidising pollutants on residential mortality within the framework of global climate change has become increasingly important.ObjectiveIn this research, the interactive effects of heat waves and oxidising pollutants on the risk of residential mortality in Fuzhou were examined. Methods We collected environmental, meteorological, and residential mortality data in Fuzhou from 1 January 2016, to 31 December 2021. We then applied a generalised additive model, distributed lagged nonlinear model, and bivariate three-dimensional model to investigate the effects and interactions of various atmospheric oxidising pollutants and heat waves on the risk of residential mortality.ResultsAtmospheric oxidising pollutants increased the risk of residential mortality at lower concentrations, and O3 and Ox were positively associated with a maximum risk of 2.19% (95% CI: 0.74-3.66) and 1.29% (95% CI: 0.51-2.08). The risk of residential mortality increased with increasing temperature, with a strong and long-lasting effect and a maximum cumulative lagged effect of 1.11% (95% CI: 1.01, 1.23). Furthermore, an interaction between atmospheric oxidising pollutants and heat waves may have occurred: the larger effects in the longest cumulative lag time on residential mortality per 10 µg/m3 increase in O3, NO2 and Ox during heat waves compared to non-heat waves were [-3.81% (95% CI: -14.82, 8.63)]; [-0.45% (95% CI: -2.67, 1.81)]; [67.90% (95% CI: 11.55, 152.71)]; 16.37% (95% CI: 2.43, 32.20)]; [-3.00% (95% CI: -20.80, 18.79)]; [-0.30% (95% CI: -3.53, 3.04)]. The risk on heat wave days was significantly higher than that on non-heat wave days and higher than the separate effects of oxidising pollutants and heat waves.ConclusionsOverall, we found some evidence suggesting that heat waves increase the impact of oxidising atmospheric pollutants on residential mortality to some extent.
| S-EPMC10883108 | biostudies-literature
Project description:During winter in the mid-latitudes, photochemical oxidation is significantly slower than in summer and the main radical oxidants driving formation of secondary pollutants, such as fine particulate matter and ozone, remain uncertain, owing to a lack of observations in this season. Using airborne observations, we quantify the contribution of various oxidants on a regional basis during winter, enabling improved chemical descriptions of wintertime air pollution transformations. We show that 25-60% of NOx is converted to N2O5 via multiphase reactions between gas-phase nitrogen oxide reservoirs and aerosol particles, with ~93% reacting in the marine boundary layer to form >2.5 ppbv ClNO2. This results in >70% of the oxidizing capacity of polluted air during winter being controlled, not by typical photochemical reactions, but from these multiphase reactions and emissions of volatile organic compounds, such as HCHO, highlighting the control local anthropogenic emissions have on the oxidizing capacity of the polluted wintertime atmosphere.
| S-EPMC7526063 | biostudies-literature
Project description:Successful insect pollination can be achieved by a sequence of numerous attachment and detachment events at various biological surfaces. However, the quantitative measurements of pollen adhesion on biological surfaces have been poorly studied so far. We performed atomic force microscopy adhesion measurements of pollen on two most important floral parts for Asteraceae in a course of pollination: the stigma and style of Hypochaeris radicata plant. The results indicated distinct adhesive properties of them-the pollen adhesion on stigmatic surfaces drastically increased over prolonged contact time, while the pollen adhesion increase on stylar surfaces was rather restrained. Based on the observation with cryo-scanning electron microscopy, we explained the experimental results by the presence of morphological features in form of flexible stigmatic papillae that may play a crucial role in enhancing both capillary attraction and van der Waals forces. The distinct adhesive properties seemingly originate from the unique adhesive tasks that each of the floral parts requires to achieve successful pollination. The insights into the adhesive interaction between pollen and the floral parts, obtained in the present study, may lead to better understanding of pollination mechanisms, which are strongly related to our food production. Additionally, the novel pollen adhesive mechanisms learned from the stigma of the studied Asteraceae plant can inspire biomimetic designs of spontaneous gripping systems.
| S-EPMC6731516 | biostudies-literature
Project description:It has been estimated that up to 90% of human exposure to cadmium is through food, and that cadmium within rice grains can be a major contributor to that dietary source. In this study genome wide association mapping was conducted on the Bengal and Assam Aus Panel (BAAP) of rice to identify quantitative trait loci and candidate genes for lowering grain cadmium. Field experiments were conducted over two years under two different irrigation systems: continually flooded and alternate wetting and drying (AWD). There was significant effects of water treatment, genotype, and genotype by water treatment interaction. Importantly, AWD increased grain cadmium, on average, by 49.6% and 108.8% in year 1 and 2 respectively. There was between 4.6 and 28 fold variation in cadmium concentration. A total of 58 QTLs were detected but no loci are clearly specific to one water regime despite approximately 20% of variation attributable to genotype by water regime interaction. A number of QTLs were consistent across most water treatments and years. These included QTLs on chromosome 7 (7.23-7.61, 8.93-9.04, and 29.12-29.14 Mbp), chromosome 5 (8.66-8.72 Mbp), and chromosome 9 (11.46-11.64 Mbp). Further analysis of the loci on chromosome 7 (8.93-9.04 Mbp), identified the candidate gene OsNRAMP1, where cultivars with a deletion upstream of the gene had higher concentrations of cadmium compared to the cultivars that did not have the deletion. The distribution of alleles within the BAAP suggest this QTL is easily detected in this population because it is composed of aus cultivars. Local genome cluster analysis suggest high Cd alleles are uncommon, but should be avoided in breeding.Supplementary informationThe online version contains supplementary material available at (10.1007/s10681-020-02752-1).
| S-EPMC7875855 | biostudies-literature
Project description:Oral delivery of proteins and peptides is a challenge due to their degradation in the stomach. To overcome this challenge, ragweed (Ambrosia elatior) pollen grains were engineered to serve as protective microcapsules. A matrix comprising of Eudragit L100-55, an enteric polymer was deposited on the inner surfaces of ragweed pollens to protect the encapsulated protein from gastric degradation and to achieve pH-dependent release in the intestine. The Eudragit L100-55 matrix was formed without use of organic solvents so that solvent-induced damage to protein molecules could be prevented. To demonstrate the concept, bovine serum albumin (BSA) a model protein was used. A matrix of Eudragit L100-55 embedded with BSA was prepared in ragweed pollens by optimizing their respective concentrations for maximizing BSA loading in the matrix. The ability of this optimized formulation to protect BSA in simulated gastric acid fluid was evaluated. Release studies in simulated gastric fluid (pH 1.2) showed minimal BSA release from the ragweed-Eudragit L100-55 formulation. Analysis of BSA retained in the formulation after its exposure to gastric fluid confirmed that the residual BSA had not denatured. Release studies in the simulated intestinal fluid (pH 6.8) showed that ragweed pollen offered additional controlled release mechanism within the first few hours of release by virtue of their solid wall. In conclusion, upon use of a protein-friendly solvent for Eudragit L100-55, proteins could be encapsulated in ragweed pollen without denaturing them, and the resulting formulation exhibited selective release of the proteins at intestinal pH suggesting that the ragweed pollen grain-based formulation could be promising for oral delivery of proteins.
| S-EPMC6828558 | biostudies-literature
Project description:Pollen grains are natural microcapsules comprised of the biopolymer sporopollenin. The uniformity and special tridimensional architecture of these sporopollenin structures confer them attractive properties such as high resistance and improved bioadhesion. However, natural pollen can be a source of allergens, hindering its biomedical applicability. Several methods have been developed to remove internal components and allergenic compounds, usually involving long and laborious processes, which often cannot be extended to other pollen types. In this work, we propose an abridged protocol to produce stable and pristine hollow pollen microcapsules, together with a complete physicochemical and morphological characterization of the intermediate and final products. The optimized procedure has been validated for different pollen samples, also producing sporopollenin microcapsules from Matricaria species for the first time. Pollen microcapsules obtained through this protocol presented low protein content (4.4%), preserved ornamented morphology with a nanoporous surface, and low product density (0.14 g/cm3). These features make them interesting candidates from a pharmaceutical perspective due to the versatility of this biomaterial as a drug delivery platform.
| S-EPMC8271440 | biostudies-literature