Fluid leakage near the percolation threshold.
Ontology highlight
ABSTRACT:
SUBMITTER: Dapp WB
PROVIDER: S-EPMC4738257 | biostudies-other | 2016
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Graphene is a promising platform for surface-enhanced Raman spectroscopy (SERS)-active substrates, primarily due to the possibility of quenching photoluminescence and fluorescence. Here we study ultrathin gold films near the percolation threshold fabricated by electron-beam deposition on monolayer CVD graphene. The advantages of such hybrid graphene/gold substrates for surface-enhanced Raman spectroscopy are discussed in comparison with conventional substrates without the graphene layer. The percolation threshold is determined by independent measurements of the sheet resistance and effective dielectric constant by spectroscopic ellipsometry. The surface morphology of the ultrathin gold films is analyzed by the use of scanning electron microscopy (SEM) and atomic force microscopy (AFM), and the thicknesses of the films in addition to the quartz-crystal mass-thickness sensor are also measured by AFM. We experimentally demonstrate that the maximum SERS signal is observed near and slightly below the percolation threshold. In this case, the region of maximum enhancement of the SERS signal can be determined using the figure of merit (FOM), which is the ratio of the real and imaginary parts of the effective dielectric permittivity of the films. SERS measurements on hybrid graphene/gold substrates with the dye Crystal Violet show an enhancement factor of ~105 and also demonstrate the ability of graphene to quench photoluminescence by an average of ~60%.
| S-EPMC7022774 | biostudies-literature
Project description:Graphene oxide (GO) is an amorphous 2D material, which has found widespread use in the fields of chemistry, physics, and materials science due to its similarity to graphene with the benefit of being far easier to synthesize and process. However, the standard of GO characterization is very poor because its structure is irregular, being sensitive to the preparation method, and it has a propensity to transform due to its reactive nature. Atomistic simulations of GO are common, but the nanostructure in these simulations is often based on little evidence or thought. We have written a computer program to generate graphene oxide nanostructures for general purpose atomistic simulation based on theoretical and experimental evidence. The structures generated offer a significant improvement to the current standard of randomly placed oxidized functional groups and successfully recreate the two-phase nature of oxidized and unoxidized graphene domains observed in microscopy experiments. Using this model, we reveal new features of GO structure and predict that a critical point in the oxidation reaction exists as the oxidized region reaches a percolation threshold. Even by a conservative estimate, we show that, if the carbon to oxygen ratio is kept above 6, a continuous aromatic network will remain, preserving many of graphene's desirable properties, irrespective of the oxidation method or the size distribution of graphene sheets. This is an experimentally achievable degree of oxidation and should aid better GO synthesis for many applications.
| S-EPMC6593394 | biostudies-literature
Project description:Magmas vesiculate during ascent, producing complex interconnected pore networks, which can act as outgassing pathways and then deflate or compact to volcanic plugs. Similarly, in-conduit fragmentation events during dome-forming eruptions create open systems transiently, before welding causes pore sealing. The percolation threshold is the first-order transition between closed- and open-system degassing dynamics. Here, we use time-resolved, synchrotron-source X-ray tomography to image synthetic magmas that go through cycles of opening and closing, to constrain the percolation threshold ? C at a range of melt crystallinity, viscosity and overpressure pertinent to shallow magma ascent. During vesiculation, we observed different percolative regimes for the same initial bulk crystallinity depending on melt viscosity and gas overpressure. At high viscosity (>?106 Pa s) and high overpressure (~?1-4 MPa), we found that a brittle-viscous regime dominates in which brittle rupture allows system-spanning coalescence at a low percolation threshold (? C ~0.17) via the formation of fracture-like bubble chains. Percolation was followed by outgassing and bubble collapse causing densification and isolation of the bubble network, resulting in a hysteresis in the evolution of connectivity with porosity. At low melt viscosity and overpressure, we observed a viscous regime with much higher percolation threshold (? C ?>?0.37) due to spherical bubble growth and lower degree of crystal connection. Finally, our results also show that sintering of crystal-free and crystal-bearing magma analogues is characterised by low percolation thresholds (? C ?=?0.04?-?0.10). We conclude that the presence of crystals lowers the percolation threshold during vesiculation and may promote outgassing in shallow, crystal-rich magma at initial stages of Vulcanian and Strombolian eruptions.
| S-EPMC7056709 | biostudies-literature
Project description:Arrhythmias in cardiac tissue are generally associated with irregular electrical wave propagation in the heart. Cardiac tissue is formed by a discrete cell network, which is often heterogeneous. Recently, it was shown in simulations of two-dimensional (2D) discrete models of cardiac tissue that a wave crossing a fibrotic, heterogeneous region may produce reentry and transient or persistent ectopic activity provided the fraction of conducting connections is just above the percolation threshold. Here, we investigate the occurrence of these phenomena in three-dimensions by simulations of a discrete model representing a thin slab of cardiac tissue. This is motivated (i) by the necessity to study the relevance and properties of the percolation-related mechanism for the emergence of microreentries in three dimensions and (ii) by the fact that atrial tissue is quite thin in comparison with ventricular tissue. Here, we simplify the model by neglecting details of tissue anatomy, e. g. geometries of atria or ventricles and the anisotropy in the conductivity. Hence, our modeling study is confined to the investigation of the effect of the tissue thickness as well as to the comparison of the dynamics of electrical excitation in a 2D layer with the one in a 3D slab. Our results indicate a strong and non-trivial effect of the thickness even for thin tissue slabs on the probability of microreentries and ectopic beat generation. The strong correlation of the occurrence of microreentry with the percolation threshold reported earlier in 2D layers persists in 3D slabs. Finally, a qualitative agreement of 3D simulated electrograms in the fibrotic region with the experimentally observed complex fractional atrial electrograms (CFAE) as well as strong difference between simulated electrograms in 2D and 3D were found for the cases where reentry and ectopic activity were triggered by the micro-fibrotic region.
| S-EPMC5119821 | biostudies-literature
Project description:Graphene-based materials are a family of carbonaceous structures that can be produced using a variety of processes either from graphite or other precursors. These materials are typically a few layered sheets of graphene in the form of platelets and maintain some of the properties of pristine graphene (such as two-dimensional platelet shape, aspect ratio, and graphitic bonding). In this work we present melt mixed graphene-based polypropylene systems with significantly reduced percolation threshold. Traditionally melt-mixed systems suffer from poor dispersion that leads to high electrical percolation values. In contrast in our work, graphene was added into an isotactic polypropylene matrix, achieving an electrical percolation threshold of ~1 wt.%. This indicates that the filler dispersion process has been highly efficient, something that leads to the suppression of the ? phase that have a strong influence on the crystallization behavior and subsequent thermal and mechanical performance. The electrical percolation values obtained are comparable with reported solution mixed systems, despite the use of simple melt mixing protocols and the lack of any pre or post-treatment of the final compositions. The latter is of particular importance as the preparation method used in this work is industrially relevant and is readily scalable.
| S-EPMC6956219 | biostudies-literature
Project description:Lateral diffusion in the plasma membrane is obstructed by proteins bound to the cytoskeleton. The most important parameter describing obstructed diffusion is the percolation threshold. The thresholds are well known for point tracers, but for tracers of nonzero radius, the threshold depends on the excluded area, not just the obstacle concentration. Here thresholds are obtained for circular obstacles on the continuum. Random obstacle configurations are generated by Brownian dynamics or Monte Carlo methods, the obstacles are immobilized, and the percolation threshold is obtained by solving a bond percolation problem on the Voronoi diagram of the obstacles. The percolation threshold is expressed as the diameter of the largest tracer that can cross a set of immobile obstacles at a prescribed number density. For random overlapping obstacles, the results agree with the known analytical solution quantitatively. When the obstacles are soft disks with a 1/r(12) repulsion, the percolating diameter is approximately 20% lower than for overlapping obstacles. A percolation model predicts that the threshold is highly sensitive to the tracer radius. To our knowledge, such a strong dependence has so far not been reported for the plasma membrane, suggesting that percolation is not the factor controlling lateral diffusion. A definitive experiment is proposed.
| S-EPMC2931735 | biostudies-other
Project description:The development of tight oil has started relatively late, and the flow mechanisms and fluid movability are still research spotlights. The goal of this paper is to investigate the percolation characteristics and fluid movability of the Chang 6 tight sandstone oil layer in the Upper Triassic Yanchang Formation, Ordos Basin, China. Results show that (1) at low flow velocity, the percolation curve of flow velocity vs pressure gradient is a concave-up nonlinear curve and does not pass through the origin. It is more difficult for oil flow than water flow in cores with similar permeability due to rock wettability and fluid apparent mobility. The application of back pressure makes the nonlinear stage eliminated and the percolation character improved. (2) Two-phase flow tests reveal that oil-phase permeability decreases faster in samples with lower permeability, and the coexistent flow region of oil and water is relatively narrow. The contribution of oil recovery mainly happens at the early stage. The permeability at the isotonic point reduces with the decrease of sample permeability. (3) Flow during water flooding can be roughly divided into four stages according to the injection pressure and flow change. The injection pressure experiences stages of increasing to a peak, then decreasing, and finally becoming stable, accompanied by an increase of oil production until water breaks through. (4) The pore throats of the target reservoir mainly range from 0.001 to 10 ?m, and the bound water mainly distributes in pores less than 0.2 ?m. The irreducible water saturation is 30-35%, and the movable fluid saturation is 65-70%, mainly distributed in pores at 0.2-10.0 ?m with a maximum of 2.0 ?m. The results will supplement the existing knowledge of percolation characters and fluid movability in tight sandstone oil reservoirs.
| S-EPMC7315431 | biostudies-literature
Project description:Subsurface sandstone deposits represent globally ubiquitous reservoirs which can potentially provide the characteristics necessary for the effective geological storage of CO2. Geological carbon storage is widely agreed to be a key asset in tackling anthropogenic emissions and climate change to reach a sustainable 'net zero', despite the present financial challenges associated with it. Therefore, improved understanding of the characteristics of the materials in which we plan to store many gigatons of CO2 is critical. Developing cheaper characterisation techniques is therefore crucial to support the global push for net zero. In this work we use digital analysis of 3D microscale X-ray images of a range of sandstone samples to constrain the porosity-permeability relationship and the upper percolation threshold; the point at which near full pore structure connectivity is achieved. This is one of the most significant controls on the viability of carbon storage as a practical solution to achieving net zero. We find that the upper percolation threshold in sandstone occurs at ca. 14% total porosity whilst the relationship between porosity ([Formula: see text]) and permeability ([Formula: see text]) can be defined as [Formula: see text]. The investigation of the upper percolation threshold may allow a target criterion to be designated when assessing potential carbon storage reservoirs, whilst investigation of the porosity-permeability relationship allows for a greater understanding of the fluid flow regimes in the subsurface. By using a digital technique to assess carbon storage reservoir potentiality we show that initial characterisation of reservoirs can be carried out rapidly and relatively economically, prior to further full reservoir characterisation studies. This approach is also non-destructive, allowing samples to be reused and multiple analytical phases performed on the same materials.
| S-EPMC9253316 | biostudies-literature
Project description:Networks based on nanoscale resistive switching junctions are considered promising for the fabrication of neuromorphic computing architectures. To date random networks of nanowires, nanoparticles, and metal clusters embedded in a polymeric matrix or passivated by shell of ligands or oxide layers have been used to produce resistive switching systems. The strategies applied to tailor resistive switching behavior are currently based on the careful control of the volume fraction of the nanoscale conducting phase that must be fixed close to the electrical percolation threshold. Here, by blending laboratory and computer experiments, we demonstrate that metallic nanostructured Au films fabricated by bare gold nanoparticles produced in the gas phase and with thickness well beyond the electrical percolation threshold, show a non-ohmic electrical behavior and complex and reproducible resistive switching. We observe that the nanogranular structure of the Au films does not evolve with thickness: this introduces a huge number of defects and junctions affecting the electrical transport and causing a dynamic evolution of the nanoscale electrical contacts under the current flow. To uncover the origin of the resistive switching behavior in Au cluster-assembled films, we developed a simple computational model for determining the evolution of a model granular film under bias conditions. The model exploits the information provided by experimental investigation about the nanoscale granular morphology of real films. Our results show that metallic nanogranular materials have functional properties radically different from their bulk counterparts, in particular nanostructured Au films can be fabricated by assembling bare gold clusters which retain their individuality to produce an all-metal resistive switching system.
| S-EPMC9417734 | biostudies-literature
Project description:An important contributing factor for the high sensitivity of sensory systems is the exquisite sensitivity of the sensory receptor cells. We report here the signaling threshold of the olfactory receptor neuron (ORN). We first obtained a best estimate of the size of the physiological electrical response successfully triggered by a single odorant-binding event on a frog ORN, which was ∼0.034 pA and had an associated transduction domain spanning only a tiny fraction of the length of an ORN cilium. We also estimated the receptor-current threshold for an ORN to fire action potentials in response to an odorant pulse, which was ∼1.2 pA. Thus, it takes about 35 odorant-binding events successfully triggering transduction during a brief odorant pulse in order for an ORN to signal to the brain.
| S-EPMC2972989 | biostudies-literature