Optical detection of radon decay in air.
Ontology highlight
ABSTRACT:
SUBMITTER: Sand J
PROVIDER: S-EPMC4751460 | biostudies-other | 2016 Feb
REPOSITORIES: biostudies-other
Similar Datasets
Project description:We experimentally demonstrate and theoretically analyze high Q-factor (~107) capillary-based optical ring resonators for non-contact detection of air-coupled ultrasound. Noise equivalent pressures in air as low as 215 mPa/√Hz and 41 mPa/√Hz at 50 kHz and 800 kHz in air, respectively, are achieved. Furthermore, non-contact detection of air-coupled photoacoustic pulses optically generated from a 200 nm thick Chromium film is demonstrated. The interaction of an acoustic pulse and the mechanical mode of the ring resonator is also studied. Significant improvement in detection bandwidth is demonstrated by encapsulating the ring resonator in a damping medium. Our work will enable compact and sensitive ultrasound detection in many applications, such as air-coupled non-destructive ultrasound testing, photoacoustic imaging, and remote sensing. It will also provide a model system for fundamental study of the mechanical modes in the ring resonator.
| S-EPMC5427941 | biostudies-literature
Project description:Considering the multitudes of people who spend their time working indoors in public premises and workplaces, it is worth knowing what their level of exposure is to natural radioactive radon gas, the second most widespread and dangerous carcinogen for lung cancer development after cigarette smoking. This state-level study covered most of the territory of Latvia and conducted 941 radon measurements with Radtrack2, placed for 4-6 months in the premises of public companies, educational institutions, medical care institutions, etc. The study found that 94.7% of samples did not exceed the national permissible limit (200 Bq/m3), the level at which preventive measures should be initiated. The median value of average specific radioactivity of radon in these premises was 48 Bq/m3 (Q1 and Q3 being 27 and 85 Bq/m3), which is below the average of the European region. Slightly higher concentrations were observed in well-insulated premises with plastic windows and poorer air exchange, mostly in schools (59 (36, 109) Bq/m3) and kindergartens (48 (32, 79) Bq/m3). Industrial workplaces had surprisingly low radon levels (28 (16, 55) Bq/m3) due to strict requirements for air quality and proper ventilation. Public premises and workplaces in Latvia mostly have low radon concentrations in the air, but more attention should be paid to adequate ventilation and air exchange.
| S-EPMC8871745 | biostudies-literature
Project description:IntroductionRadon is a major indoor air pollutant that poses a significant risk of lung cancer to those exposed in their homes. While mitigation of high radon levels in homes has been shown to be effective, home mitigation rates remain low. This study examines the barriers and facilitators to radon mitigation in homes from the perspectives of authorities responsible for radon risk management, the mitigation industry (contractors), and residents in four European countries (Belgium, Ireland, Slovenia, and the UK) with high radon risks and low mitigation rates.MethodsA multi-method approach was used to gather data from various stakeholders, including online surveys, content analysis of legal documents, group interviews, workshops, and focus groups.ResultsAuthorities, contractors, and residents identified various facilitators to radon mitigation, including legal requirements for mitigation, awareness campaigns, low mitigation costs, availability of financial support, accreditation of mitigation contractors, and a perception of radon as a health threat. However, barriers to mitigation were also identified, such as a lack of awareness, fragmented mitigation processes, and inadequate communication between stakeholders.DiscussionThe study highlights the complexity of the radon mitigation process and suggests that interventions aimed at increasing mitigation rates should target stakeholders beyond just residents, such as constructors, health professionals, and policy makers. An integrated approach to radon mitigation, from policy to provision, is necessary to effectively lower levels of this indoor air pollutant.
| S-EPMC10463182 | biostudies-literature
Project description:Anomalous phenomena related to earthquakes have been studied to aid in the forecasting of large earthquakes. Radon (222Rn) concentration changes are known to be one of those phenomena. Many studies have quantified radon anomalies to identify physical aspects of radon emanations related to earthquakes. Here, we apply singular spectrum transformation, non-parametric analysis to estimate change points in time series, to atmospheric radon concentration. From 10 years of data from continuous observation of the atmospheric radon concentration over northeastern Japan and Hokkaido, we identify anomalies in the atmospheric radon concentration related to the moment releases of large earthquakes. Compared with a conventional model-based method, the singular spectrum transformation method identifies more anomalies. Moreover, we also find that change points in the atmospheric radon concentration prior to the 2011 Tohoku-Oki earthquake (Mw 9.0; 11 Mar. 2011, N38.1°, E142.9°) coincided with periods of other anomalous precursory phenomena. Our results indicate that singular spectrum transformation can be used to detect anomalies in atmospheric radon concentration related to the occurrences of large earthquakes.
| S-EPMC6115410 | biostudies-literature
Project description:Radon (Rn) and its decay products are the primary sources of natural ionizing radiation exposure for the public, posing significant health risks, including being a leading cause of lung cancer. Porous material-based adsorbents offer a feasible and efficient solution for controlling Rn concentrations in various scenes to achieve safe levels. However, due to competitive adsorption between Rn and water, finding candidates with a higher affinity and capacity for capturing Rn in humid air remains a significant challenge. Here, we conducted high-throughput computational screening of 8641 two-dimensional covalent organic frameworks (2D COFs) in moist air using grand canonical Monte Carlo simulations. We identified the top five candidates and revealed the structure-performance relationship. Our findings suggest that a well-defined cavity with an approximate spherical inner space, with a diameter matching that of Rn, is the structural basis for a proper Rn capturing site. This is because the excellent steric match between the cavity and Rn maximizes their van der Waals dispersion interactions. Additionally, the significant polarization electrostatic potential surface of the cavity can regulate the adsorption energy of water and ultimately impact Rn selectivity. Our study offers a potential route for Rn management using 2D COFs in moist air and provides a scientific basis for further experimentation.
| S-EPMC10180264 | biostudies-literature
Project description:We used an ultrasensitive, broadband optomechanical ultrasound sensor to study the acoustic signals produced by pressurized nitrogen escaping from a variety of small syringes. Harmonically related jet tones extending into the MHz region were observed for a certain range of flow (i.e., Reynolds number), which is in qualitative agreement with historical studies on gas jets emitted from pipes and orifices of much larger dimensions. For higher turbulent flow rates, we observed broadband ultrasonic emission in the ~0–5 MHz range, which was likely limited on the upper end due to attenuation in air. These observations are made possible by the broadband, ultrasensitive response (for air-coupled ultrasound) of our optomechanical devices. Aside from being of theoretical interest, our results could have practical implications for the non-contact monitoring and detection of early-stage leaks in pressured fluid systems.
| S-EPMC10304996 | biostudies-literature
Project description:This paper considers the coherent integration problem for moving target detection using frequency agile (FA) radar, involving range cell migration (RCM) and the nonuniform phase fluctuations among different pulses caused by range-agile frequency (R-AF) coupling and velocity-time-agile frequency (V-T-AF) coupling. After the analysis of the term corresponding to the phase fluctuation caused by V-T-AF coupling, the term can be regarded as related to an equivalent non-uniform slow time, and nonuniform fast Fourier transform (NUFFT) could be the solution. So a fast coherent integration method combining Radon Fourier transform (RFT) and NUFFT based on low-rank approximation, i.e., Radon-NUFFT, is proposed. In this method, the RCM is solved by Radon algorithm via target trajectory searching, the non-uniform phase fluctuation caused by R-AF coupling is compensated by constructing a compensation item corresponding to the range and agile frequency. In addition, the compensation of the non-uniform phase fluctuation caused by V-T-AF coupling is converted into a problem of spectral analysis of non-uniform sampling complex-valued signal, which is solved by the NUFFT based on low rank approximation. Compared with the existing methods, the proposed method can realize the coherent integration for FA radar accurately and quickly. The effectiveness of the proposed method is verified by simulation experiments.
| S-EPMC7218713 | biostudies-literature
Project description:Surface plasmon polaritons (SPP) can be excited on metal-coated optical fibres, enabling the accurate monitoring of refractive index changes. Configurations reported so far mainly operate in liquids but not in air because of a mismatch between permittivities of guided light modes and the surrounding medium. Here we demonstrate a plasmonic optical fibre platform that overcomes this limitation. The underpinning of our work is a grating architecture-a gold-coated highly tilted Bragg grating-that excites a spectral comb of narrowband-cladding modes with effective indices near 1.0 and below. Using conventional spectral interrogation, we measure shifts of the SPP-matched resonances in response to static atmospheric pressure changes. A dynamic experiment conducted using a laser lined-up with an SPP-matched resonance demonstrates the ability to detect an acoustic wave with a resolution of 10-8 refractive index unit (RIU). We believe that this configuration opens research directions for highly sensitive plasmonic sensing in gas.
| S-EPMC5114639 | biostudies-literature
Project description:PurposeConventional current density imaging method, which relies on the detection of the magnetic field induced by the current in an image phase, is demanding and difficult to perform. In this study, a much simpler signal-magnitude-decay (SMD)-based current detection method is proposed.MethodsConductive test and biological samples were imaged at various TE times using the gradient- or spin-echo imaging sequences with superimposed constant or bipolar currents, respectively. The SMD curve was sampled for each image voxel, which enabled voxel-vise current density calculation by fitting an appropriate SMD model curve to the measured SMD curve. Effect of the voxel size on the signal decay and precision of the current density calculation was studied as well.ResultsIt was shown theoretically, as well as verified by experiments on test and biological samples, that the current flowing though the sample creates an inhomogeneous magnetic field, which, as a consequence has a faster signal decay. Estimated current density from the measured signal decay increase agreed reasonably well with the actual current density, especially with the larger voxel sizes and longer times to signal acquisition. The sensitivity of the SMD method is up to 1/6$$ 1/\sqrt{6} $$ the sensitivity of the current density imaging method.ConclusionSMD method of current detection is not limited to any particular sample orientation or geometry, and any pulse sequence capable of acquisition of the current-induced signal evolution in a voxel can be used for it. This widens the scope of its application from tissues to in vivo studies on animals and humans.
| S-EPMC9325414 | biostudies-literature
Project description:Land use regression (LUR) has emerged as an effective means of estimating exposure to air pollution in epidemiological studies. We created the first LUR models of nitric oxide (NO), nitrogen dioxide (NO2) and nitrogen oxides (NOX) for the complex megalopolis of Los Angeles (LA), California. Two-hundred and one sampling sites (the largest sampling design to date for LUR estimation) for two seasons were selected using a location-allocation algorithm that maximized the potential variability in measured pollutant concentrations and represented populations in the health study. Traffic volumes, truck routes and road networks, land use data, satellite-derived vegetation greenness and soil brightness, and truck route slope gradients were used for predicting NOX concentrations. A novel model selection strategy known as "ADDRESS" (A Distance Decay REgression Selection Strategy) was used to select optimized buffer distances for potential predictor variables and maximize model performance. Final regression models explained 81%, 86% and 85% of the variance in measured NO, NO2 and NOX concentrations, respectively. Cross-validation analyses suggested a prediction accuracy of 87-91%. Remote sensing-derived variables were significantly correlated with NOX concentrations, suggesting these data are useful surrogates for modeling traffic-related pollution when certain land use data are unavailable. Our study also demonstrated that reactive pollutants such as NO and NO2 could have high spatial extents of influence (e.g., > 5000 m from expressway) and high background concentrations in certain geographic areas. This paper represents the first attempt to model traffic-related air pollutants at a fine scale within such a complex and large urban region.
| S-EPMC3656661 | biostudies-literature