Tuning the photo-response in monolayer MoS2 by plasmonic nano-antenna.
Ontology highlight
ABSTRACT:
SUBMITTER: Li J
PROVIDER: S-EPMC4814816 | biostudies-other | 2016 Mar
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Monolayer transition metal dichalcogenides have intrinsic spin-valley degrees of freedom, making it appealing to exploit valleytronic and optoelectronic applications at the nanoscale. Here, we demonstrate that a chiral plasmonic antenna consisting of two stacked gold nanorods can modulate strongly valley-polarized photoluminescence (PL) of monolayer MoS2 in a broad spectral range at room temperature. The valley-polarized PL of the MoS2 using the antenna can reach up to ~47%, with approximately three orders of PL magnitude enhancement within the plasmonic nanogap. Besides, the K and K' valleys under opposite circularly polarized light excitation exhibit different emission intensities and directivities in the far field, which can be attributed to the modulation of the valley-dependent excitons by the chiral antenna in both the excitation and emission processes. The distinct features of the ultracompact hybrid suggest potential applications for valleytronic and photonic devices, chiral quantum optics, and high-sensitivity detection.
| S-EPMC7239647 | biostudies-literature
Project description:In this paper, a circular hybrid plasmonic waveguide-fed nano-antenna (CHPWFNA) has been introduced for operating at the standard telecommunication wavelength of 1,550 nm. For the first time, the dispersion relation of a circular hybrid plasmonic waveguide as the feed line of the proposed nano-antenna has been derived, analytically. To verify the accuracy of the analytical solution, two numerical techniques of finite element method (FEM) and finite-difference time-domain (FDTD) method have been used. Numerical results are well-matched with the theoretical ones. The characteristics of the CHPWFNA have been studied by two mentioned methods. The obtained realized gains (directivities) by the FDTD and FEM simulations are 9.03 dB (9.38 dBi) and 10.00 dB (10.32 dBi), respectively, at 1,550 nm wavelength. For on-chip point-to-point wireless link performance, the obtained quality factor by the FDTD method (FEM) is 63.97 (100). The obtained radiation characteristics and link performance reveal that at 1,550 nm, the proposed antenna has the best performance. Besides, the frequency bandwidth of the antenna (185-200 THz) covers the low-loss optical frequency range. Also, paying attention to the laser eye safety is so important. Consequently, the wavelength of 1,550 nm has been chosen as the target wavelength. Moreover, the array configuration has been studied and the directivity and realized gain have been obtained based on the array factor theory and numerical methods, which are agree with each other. The attained realized gain by the FDTD method (FEM) for the considered single row array, at 1,550 nm, is 11.20 dB (11.30 dB). There is a little difference between the numerical results due to the total mesh size, the grid size refinement and the relative error of the numerical methods convergence. Finally, as one of the most important challenges in fabrication is the gold surface quality, we have studied the effect of gold surface roughness and its pentagonal cross section on the antenna performance.
| S-EPMC7493997 | biostudies-literature
Project description:Probing and tuning the electron tunneling in metal electrode-insulator-metal nanoparticle systems provide a unique vision for understanding the fundamental mechanism of electrochemistry and broadening the horizon in practical applications of molecular electronics in many electrochemical systems. Here we report a plasmonic imaging technique to monitor the local double-layer charging of individual Au nanoparticles deposited on gold electrode separated by monolayer of n-alkanethiol molecules. The thickness of molecular monolayer tunes the tunneling kinetics and conductivity, which predicts the heterogeneous behavior on the modified electrode surface for different electrochemical systems. We studied the distance dependence of the electron tunneling and double layer charging processes by a plasmonic-based electrical impedance microscopy. By performing fast Fourier transform analysis of the recorded plasmonic image sequences, we can quantify the interfacial impedance of single nanoparticles and the tunneling decay constant of molecular layer. We further observed the electron neutralization dynamics during single-nanoparticle collisions on different surfaces. This optical readout of electron tunneling demonstrates an imaging approach to determine the electrical properties of metal electrode-insulator-metal nanoparticle systems, which include the electron tunneling mechanism and local impedance.
| S-EPMC8549056 | biostudies-literature
Project description:The 2-D transition metal dichalcogenide (TMD) semiconductors, has received great attention due to its excellent optical and electronic properties and potential applications in field-effect transistors, light emitting and sensing devices. Recently surface plasmon enhanced photoluminescence (PL) of the weak 2-D TMD atomic layers was developed to realize the potential optoelectronic devices. However, we noticed that the enhancement would not increase monotonically with increasing of metal plasmonic objects and the emission drop after the certain coverage. This study presents the optimized PL enhancement of a monolayer MoS2 in the presence of gold (Au) nanorods. A localized surface plasmon wave of Au nanorods that generated around the monolayer MoS2 can provide resonance wavelength overlapping with that of the MoS2 gain spectrum. These spatial and spectral overlapping between the localized surface plasmon polariton waves and that from MoS2 emission drastically enhanced the light emission from the MoS2 monolayer. We gave a simple model and physical interpretations to explain the phenomena. The plasmonic Au nanostructures approach provides a valuable avenue to enhancing the emitting efficiency of the 2-D nano-materials and their devices for the future optoelectronic devices and systems.
| S-EPMC4647184 | biostudies-literature
Project description:Two-dimensional semiconductors such as MoS2 are an emerging material family with wide-ranging potential applications in electronics, optoelectronics, and energy harvesting. Large-area growth methods are needed to open the way to applications. Control over lattice orientation during growth remains a challenge. This is needed to minimize or even avoid the formation of grain boundaries, detrimental to electrical, optical, and mechanical properties of MoS2 and other 2D semiconductors. Here, we report on the growth of high-quality monolayer MoS2 with control over lattice orientation. We show that the monolayer film is composed of coalescing single islands with limited numbers of lattice orientation due to an epitaxial growth mechanism. Optical absorbance spectra acquired over large areas show significant absorbance in the high-energy part of the spectrum, indicating that MoS2 could also be interesting for harvesting this region of the solar spectrum and fabrication of UV-sensitive photodetectors. Even though the interaction between the growth substrate and MoS2 is strong enough to induce lattice alignment via van der Waals interaction, we can easily transfer the grown material and fabricate devices. Local potential mapping along channels in field-effect transistors shows that the single-crystal MoS2 grains in our film are well connected, with interfaces that do not degrade the electrical conductivity. This is also confirmed by the relatively large and length-independent mobility in devices with a channel length reaching 80 ?m.
| S-EPMC4415455 | biostudies-literature
Project description:A broadband metamaterial absorber (MA) composed of hexagonal-arranged single-sized titanium nitride (TiN) nano-disk array and monolayer molybdenum disulfide (MoS2) is studied using finite-difference time-domain (FDTD) simulations. The structure of TiN nano-disk array/dielectric silica (SiO2)/aluminum (Al) is adopted in our design. By optimizing the dimension parameters of the structure, an average absorption of 96.1% is achieved from 400 to 850 nm. In addition, by inserting a monolayer MoS2 which has high absorption at the short wavelength side underneath the TiN nano-disk array, an average absorption of 98.1% over the entire visible regime from 400 to 850 nm was achieved, with a peak absorption near 100% and absorption over 99% from 475 to 772 nm. Moreover, the absorber presented in this paper is polarization insensitive. This compact and unique design with TiN nano-disk/monolayer MoS2/ SiO2/Al structure may have great potential for applications in photovoltaics and light trapping.
| S-EPMC5526828 | biostudies-other
Project description:We report how the presence of electron-beam-induced sulfur vacancies affects first-order Raman modes and correlate the effects with the evolution of the in situ transmission-electron microscopy two-terminal conductivity of monolayer MoS2 under electron irradiation. We observe a red-shift in the E' Raman peak and a less pronounced blue-shift in the A'1 peak with increasing electron dose. Using energy-dispersive X-ray spectroscopy and selected-area electron diffraction, we show that irradiation causes partial removal of sulfur and correlate the dependence of the Raman peak shifts with S vacancy density (a few %). This allows us to quantitatively correlate the frequency shifts with vacancy concentration, as rationalized by first-principles density functional theory calculations. In situ device current measurements show an exponential decrease in channel current upon irradiation. Our analysis demonstrates that the observed frequency shifts are intrinsic properties of the defective systems and that Raman spectroscopy can be used as a quantitative diagnostic tool to characterize MoS2-based transport channels.
| S-EPMC5893938 | biostudies-literature
Project description:The conversion of chalcogen atoms to other types in transition metal dichalcogenides has significant advantages for tuning bandgaps and constructing in-plane heterojunctions; however, difficulty arises from the conversion of sulfur or selenium to tellurium atoms owing to the low decomposition temperature of tellurides. Here, we propose the use of sodium for converting monolayer molybdenum disulfide (MoS2) to molybdenum ditelluride (MoTe2) under Te-rich vapors. Sodium easily anchors tellurium and reduces the exchange barrier energy by scooting the tellurium to replace sulfur. The conversion was initiated at the edges and grain boundaries of MoS2, followed by complete conversion in the entire region. By controlling sodium concentration and reaction temperature of monolayer MoS2, we tailored various phases such as semiconducting 2H-MoTe2, metallic 1T'-MoTe2, and 2H-MoS2-x Te x alloys. This concept was further extended to WS2. A high valley polarization of ~37% in circularly polarized photoluminescence was obtained in the monolayer WS2-x Te x alloy at room temperature.
| S-EPMC5735184 | biostudies-literature
Project description:Transient electronics represents an emerging technology whose defining feature is an ability to dissolve, disintegrate or otherwise physically disappear in a controlled manner. Envisioned applications include resorbable/degradable biomedical implants, hardware-secure memory devices, and zero-impact environmental sensors. 2D materials may have essential roles in these systems due to their unique mechanical, thermal, electrical, and optical properties. Here, we study the bioabsorption of CVD-grown monolayer MoS2, including long-term cytotoxicity and immunological biocompatibility evaluations in biofluids and tissues of live animal models. The results show that MoS2 undergoes hydrolysis slowly in aqueous solutions without adverse biological effects. We also present a class of MoS2-based bioabsorbable and multi-functional sensor for intracranial monitoring of pressure, temperature, strain, and motion in animal models. Such technology offers specific, clinically relevant roles in diagnostic/therapeutic functions during recovery from traumatic brain injury. Our findings support the broader use of 2D materials in transient electronics and qualitatively expand the design options in other areas.
| S-EPMC5924366 | biostudies-literature
Project description:Monolayer molybdenum disulfide (MoS2) has received intense interest as a strong candidate for next-generation electronics. However, the observed electrical properties of monolayer MoS2 exhibit several anomalies: samples universally exhibit unexpectedly low mobilities, n-type characteristics, and large contact resistances regardless of contact metal work function. These anomalies have been attributed to the presence of defects, but the mechanism behind this link has been elusive. Here we report the ionization dynamics of sulfur monovacancy defects in monolayer MoS2 probed via noise nanospectroscopy, realized by combining noise-current analysis with atomic force microscopy. Due to the nanoscale dimension of the in situ channel defined by the tip size, we probe a few monovacancy defects at a time. Monovacancy defects exhibit switching between three distinct ionization configurations, corresponding to charge states 0, -1, and -2. The most probable charge configurations are 0 and -1, providing a plausible mechanism to explain the observed anomalies of MoS2 monolayers.
| S-EPMC5730608 | biostudies-literature