Oxygen vacancies controlled multiple magnetic phases in epitaxial single crystal Co0.5(Mg0.55Zn0.45)0.5O(1-v) thin films.
Ontology highlight
ABSTRACT:
SUBMITTER: Zhu D
PROVIDER: S-EPMC4827065 | biostudies-other | 2016 Apr
REPOSITORIES: biostudies-other
Similar Datasets
Project description:SrMnO3 has a rich epitaxial strain-dependent ferroic phase diagram, in which a variety of magnetic orderings, even ferroelectricity, and thus multiferroicity, are accessible by gradually modifying the strain. Different relaxation processes, though, including the presence of strain-induced oxygen vacancies, can severely curtail the possibility of stabilizing these ferroic phases. Here, we report on a thorough investigation of the strain relaxation mechanisms in SrMnO3 films grown on several substrates imposing varying degrees of strain from slightly compressive (-0.39%) to largely tensile ≈+3.8%. First, we determine the strain dependency of the critical thickness (t c) below which pseudomorphic growth is obtained. Second, the mechanisms of stress relaxation are elucidated, revealing that misfit dislocations and stacking faults accommodate the strain above t c. Yet, even for films thicker than t c, the atomic monolayers below t c are proved to remain fully coherent. Therefore, multiferroicity may also emerge even in films that appear to be partially relaxed. Last, we demonstrate that fully coherent films with the same thickness present a lower oxygen content for increasing tensile mismatch with the substrate. This behavior proves the coupling between the formation of oxygen vacancies and epitaxial strain, in agreement with first-principles calculations, enabling the strain control of the Mn3+/Mn4+ ratio, which strongly affects the magnetic and electrical properties. However, the presence of oxygen vacancies/Mn3+ cations reduces the effective epitaxial strain in the SrMnO3 films and, thus, the accessibility to the strain-induced multiferroic phase.
| S-EPMC8158829 | biostudies-literature
Project description:A variety of emergent phenomena are enabled by interface engineering in the complex oxides heterostructures. While extensive attention is attracted to LaMnO3 (LMO) thin films for observing the control of functionalities at its interface with substrate, the nature of the magnetic phases in the thin film is, however, controversial. Here, it is reported that the ferromagnetism in two and five unit cells thick LMO films epitaxially deposited on (001)-SrTiO3 substrates, a ferromagnetic/ferromagnetic coupling in eight and ten unit cells ones, and a striking ferromagnetic/antiferromagnetic pinning effect with apparent positive exchange bias in 15 and 20 unit cells ones are observed. This novel phenomenon in both 15 and 20 unit cells films indicates a coexistence of three magnetic orderings in a single LMO film. The high-resolution scanning transmission electron microscopy suggests a P21/n to Pbnm symmetry transition from interface to surface, with the spatial stratification of MnO6 octahedral morphology, corresponding to different magnetic orderings. These results can shed some new lights on manipulating the functionality of oxides by interface engineering.
| S-EPMC8261492 | biostudies-literature
Project description:Elemental defect in transition metal oxides is an important and intriguing subject that result in modifications in variety of physical properties including atomic and electronic structure, optical and magnetic properties. Understanding the formation of elemental vacancies and their influence on different physical properties is essential in studying the complex oxide thin films. In this study, we investigated the physical properties of epitaxial SrRuO3 thin films by systematically manipulating cation and/or oxygen vacancies, via changing the oxygen partial pressure (P(O2)) during the pulsed laser epitaxy (PLE) growth. Ru vacancies in the low-P(O2)-grown SrRuO3 thin films induce lattice expansion with the suppression of the ferromagnetic T C down to ~120?K. Sr vacancies also disturb the ferromagnetic ordering, even though Sr is not a magnetic element. Our results indicate that both A and B cation vacancies in an ABO3 perovskite can be systematically engineered via PLE, and the structural, electrical, and magnetic properties can be tailored accordingly.
| S-EPMC5599527 | biostudies-literature
Project description:In this study, we report about the occurrence of phase separation through spinodal decomposition (SD) in spinel manganese ferrite (Mn ferrite) thin films grown by Dynamic Aurora pulsed laser deposition. The driving force behind this SD in Mn ferrite films is considered to be an ion-impingement-enhanced diffusion that is induced by the application of magnetic field during film growth. The phase separation to Mn-rich and Fe-rich phases in Mn ferrite films is confirmed from the Bragg's peak splitting and the appearance of the patterned checkerboard-like domain in the surface. In the cross-sectional microstructure analysis, the distribution of Mn and Fe-signals alternately changes along the lateral (x and y) directions, while it is almost homogeneous in the z-direction. The result suggests that columnar-type phase separation occurs by the up-hill diffusion only along the in-plane directions. The propagation of a quasi-sinusoidal compositional wave in the lateral directions is confirmed from spatially resolved chemical composition analysis, which strongly demonstrates the occurrence of phase separation via SD. It is also found that the composition of Mn-rich and Fe-rich phases in phase-separated Mn ferrite thin films deposited at higher growth temperature and in situ magnetic field does not depend on the corresponding average film composition.
| S-EPMC6041787 | biostudies-literature
Project description:The transfer process of graphene onto the surface of oxide substrates is well known. However, for many devices, we require high quality oxide thin films on the surface of graphene. This step is not understood. It is not clear why the oxide should adopt the epitaxy of the underlying oxide layer when it is deposited on graphene where there is no lattice match. To date there has been no explanation or suggestion of mechanisms which clarify this step. Here we show a mechanism, supported by first principles simulation and structural characterisation results, for the growth of oxide thin films on graphene. We describe the growth of epitaxial SrTiO3 (STO) thin films on a graphene and show that local defects in the graphene layer (e.g. grain boundaries) act as bridge-pillar spots that enable the epitaxial growth of STO thin films on the surface of the graphene layer. This study, and in particular the suggestion of a mechanism for epitaxial growth of oxides on graphene, offers new directions to exploit the development of oxide/graphene multilayer structures and devices.
| S-EPMC4981861 | biostudies-literature
Project description:Actinide materials have various applications that range from nuclear energy to quantum computing. Most current efforts have focused on bulk actinide materials. Tuning functional properties by using strain engineering in epitaxial thin films is largely lacking. Using uranium dioxide (UO2 ) as a model system, in this work, the authors explore strain engineering in actinide epitaxial thin films and investigate the origin of induced ferromagnetism in an antiferromagnet UO2 . It is found that UO2+ x thin films are hypostoichiometric (x<0) with in-plane tensile strain, while they are hyperstoichiometric (x>0) with in-plane compressive strain. Different from strain engineering in non-actinide oxide thin films, the epitaxial strain in UO2 is accommodated by point defects such as vacancies and interstitials due to the low formation energy. Both epitaxial strain and strain relaxation induced point defects such as oxygen/uranium vacancies and oxygen/uranium interstitials can distort magnetic structure and result in magnetic moments. This work reveals the correlation among strain, point defects and ferromagnetism in strain engineered UO2+ x thin films and the results offer new opportunities to understand the influence of coupled order parameters on the emergent properties of many other actinide thin films.
| S-EPMC9685444 | biostudies-literature
Project description:In condensed matter physics, oxide materials show various intriguing physical properties. Therefore, many efforts are made in this field to develop functional oxides. Due to the excellent potential for tin-based perovskite oxides, an expansion of new related functional compounds is crucial. This work uses a heteroepitaxial approach supported by theoretical calculation to stabilize PbSnO3 thin films with different orientations. The analyses of X-ray diffraction and transmission electron microscopy unveil the structural information. A typical antiferroelectric feature with double hysteresis and butterfly loops is observed through electrical characterizations consistent with the theoretical prediction. The phase transition is monitored, and the transition temperatures are determined based on temperature-dependent structural and electrical characterizations. Furthermore, the microscopic antiferroelectric order is noticed under atomic resolution images via scanning transmission electron microscopy. This work offers a breakthrough in synthesizing epitaxial PbSnO3 thin films and comprehensively understanding its anisotropic antiferroelectric behavior.
| S-EPMC9762279 | biostudies-literature
Project description:Epitaxial multiferroic BaTiO₃-BiFeO₃ composite thin films exhibit a correlation between the magnetoelectric (ME) voltage coefficient αME and the oxygen partial pressure during growth. The ME coefficient αME reaches high values up to 43 V/(cm·Oe) at 300 K and at 0.25 mbar oxygen growth pressure. The temperature dependence of αME of the composite films is opposite that of recently-reported BaTiO₃-BiFeO₃ superlattices, indicating that strain-mediated ME coupling alone cannot explain its origin. Probably, charge-mediated ME coupling may play a role in the composite films. Furthermore, the chemically-homogeneous composite films show an oxygen vacancy superstructure, which arises from vacancy ordering on the {111} planes of the pseudocubic BaTiO₃-type structure. This work contributes to the understanding of magnetoelectric coupling as a complex and sensitive interplay of chemical, structural and geometrical issues of the BaTiO₃-BiFeO₃ composite system and, thus, paves the way to practical exploitation of magnetoelectric composites.
| S-EPMC5456545 | biostudies-literature
Project description:Compressively strained SrTaO2N thin films were epitaxially grown on SrTiO3 substrates using nitrogen plasma-assisted pulsed laser deposition. Piezoresponse force microscopy measurements revealed small domains (101–102?nm) that exhibited classical ferroelectricity, a behaviour not previously observed in perovskite oxynitrides. The surrounding matrix region exhibited relaxor ferroelectric-like behaviour, with remanent polarisation invoked by domain poling. First-principles calculations suggested that the small domains and the surrounding matrix had trans-type and a cis-type anion arrangements, respectively. These experiments demonstrate the promise of tailoring the functionality of perovskite oxynitrides by modifying the anion arrangements by using epitaxial strain.
| S-EPMC4023398 | biostudies-literature
Project description:Since the discovery of graphene, the quest for two-dimensional (2D) materials has intensified greatly. Recently, a new family of 2D transition metal carbides and carbonitrides (MXenes) was discovered that is both conducting and hydrophilic, an uncommon combination. To date MXenes have been produced as powders, flakes, and colloidal solutions. Herein, we report on the fabrication of ∼1 × 1 cm2 Ti3C2 films by selective etching of Al, from sputter-deposited epitaxial Ti3AlC2 films, in aqueous HF or NH4HF2. Films that were about 19 nm thick, etched with NH4HF2, transmit ∼90% of the light in the visible-to-infrared range and exhibit metallic conductivity down to ∼100 K. Below 100 K, the films' resistivity increases with decreasing temperature and they exhibit negative magnetoresistance-both observations consistent with a weak localization phenomenon characteristic of many 2D defective solids. This advance opens the door for the use of MXenes in electronic, photonic, and sensing applications.
| S-EPMC3982936 | biostudies-literature