Important Parameter Groups in Thermal Protection of Polymers.
Ontology highlight
ABSTRACT:
SUBMITTER: Staggs J
PROVIDER: S-EPMC5455483 | biostudies-other | 2015 Jul
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Acryloyl based novel energetic monomers having nitro acrylates and nitro triazole acrylates were synthesized and further used for polymerization. Due to scavanging properties of nitro groups, syntheses of nitro aromatic polymers are not facile at normal conditions. In this regard, we report a simple protocol to synthesize these energetic group embeded acroloyl polymers. These polymers were characterized by FTIR, and NMR spectroscopic techniques. gel permeation chromatography (GPC) technique was employed in order to understand molecular mass of these polymers along with average molecular weight, number average weight and poly dispersity index. Glass transition temperature (Tg) was determined by using DSC analysis. It was observed that with increase in nitro groups in polymers there is a decrease in glass transition temperature. Two steps degradation were depicted in the TGA thermograph in nitro containing polymers. Heat release during this reaction was found up to 951 J/g. Increase in nitrogen content in polymer unit enhanced the heat release of polymers.
| S-EPMC5812170 | biostudies-literature
Project description:The fracture and severing of polymer chains plays a critical role in the failure of fibrous materials and the regulated turnover of intracellular filaments. Using continuum wormlike chain models, we investigate the fracture of semiflexible polymers via thermal bending fluctuations, focusing on the role of filament flexibility and dynamics. Our results highlight a previously unappreciated consequence of mechanical heterogeneity in the filament, which enhances the rate of thermal fragmentation particularly in cases where constraints hinder the movement of the chain ends. Although generally applicable to semiflexible chains with regions of different bending stiffness, the model is motivated by a specific biophysical system: the enhanced severing of actin filaments at the boundary between stiff bare regions and mechanically softened regions that are coated with cofilin regulatory proteins. The results presented here point to a potential mechanism for disassembly of polymeric materials in general and cytoskeletal actin networks in particular by the introduction of locally softened chain regions, as occurs with cofilin binding.
| S-EPMC7047574 | biostudies-literature
Project description:Materials that can be switched between low and high thermal conductivity states would advance the control and conversion of thermal energy. Employing in situ time-domain thermoreflectance (TDTR) and in situ synchrotron X-ray scattering, we report a reversible, light-responsive azobenzene polymer that switches between high (0.35 W m-1 K-1) and low thermal conductivity (0.10 W m-1 K-1) states. This threefold change in the thermal conductivity is achieved by modulation of chain alignment resulted from the conformational transition between planar (trans) and nonplanar (cis) azobenzene groups under UV and green light illumination. This conformational transition leads to changes in the ?-? stacking geometry and drives the crystal-to-liquid transition, which is fully reversible and occurs on a time scale of tens of seconds at room temperature. This result demonstrates an effective control of the thermophysical properties of polymers by modulating interchain ?-? networks by light.
| S-EPMC6442584 | biostudies-literature
Project description:The thermal transitions of confined polymers are important for the application of polymers in molecular scale devices and advanced nanotechnology. However, thermal transitions of ultrathin polymer assemblies confined in subnanometre spaces are poorly understood. In this study, we show that incorporation of polyethylene glycol (PEG) into nanochannels of porous coordination polymers (PCPs) enabled observation of thermal transitions of the chain assemblies by differential scanning calorimetry. The pore size and surface functionality of PCPs can be tailored to study the transition behaviour of confined polymers. The transition temperature of PEG in PCPs was determined by manipulating the pore size and the pore-polymer interactions. It is also striking that the transition temperature of the confined PEG decreased as the molecular weight of PEG increased.
| S-EPMC2982181 | biostudies-literature
Project description:We present a method for the direct measurement of the relative energy of interaction between a solvated polymer and a solid interface. By tethering linear chains covalently to the surface, we ensured the idealized and constant configuration of polymer molecules for measurement, modeling, and parameter estimation. For the case of amine-terminated polystyrene bound to a glycidoxypropyl silane film submerged in cyclohexane-d12, we estimated the χ parameter for the temperature range 10.7 °C to 52.0 °C, and found a downward sloping trend that crosses the χ = 0.5 threshold at 37 °C to 40 °C, in agreement with solution estimates for the same system. We simultaneously estimated the surface interaction parameter χs at each temperature, finding a decreasing affinity of the chains for the surface with increasing temperature, consistent with empirical observations. The theoretical model shows some limitations in a stronger solvent (toluene-d8) that prevent rigorous parameter estimation, but we demonstrate a qualitative change in χ and χs towards stronger solvency and weaker surface interaction with increasing temperature.
| S-EPMC5621612 | biostudies-literature
Project description:High thermal conductivity is critical for many applications of polymers (for example, packaging of light-emitting diodes), in which heat must be dissipated efficiently to maintain the functionality and reliability of a system. Whereas uniaxially extended chain morphology has been shown to significantly enhance thermal conductivity in individual polymer chains and fibers, bulk polymers with coiled and entangled chains have low thermal conductivities (0.1 to 0.4 W m-1 K-1). We demonstrate that systematic ionization of a weak anionic polyelectrolyte, polyacrylic acid (PAA), resulting in extended and stiffened polymer chains with superior packing, can significantly enhance its thermal conductivity. Cross-plane thermal conductivity in spin-cast amorphous films steadily grows with PAA degree of ionization, reaching up to ~1.2 W m-1 K-1, which is on par with that of glass and about six times higher than that of most amorphous polymers, suggesting a new unexplored molecular engineering strategy to achieve high thermal conductivities in amorphous bulk polymers.
| S-EPMC5533546 | biostudies-other
Project description:Five different 2-alkoxypropan-2-yl groups are introduced as acid-labile protecting groups for the 5'- and 3'-hydroxy groups of a 2'-deoxynucleoside. All studied protecting groups were readily introduced with good to excellent yields using the appropriate enol ether as a reagent and 0.5 to 1 mol % p-toluenesulfonic acid as a catalyst. The protected compounds could be purified by silica gel column chromatography without degradation. The compatibility of these protecting groups in parallel use with benzoyl and silyl groups was verified. The stabilities of the different alkoxy acetal protecting groups were compared by following the kinetics of their hydrolysis at 25.0 °C in buffered solutions through an HPLC method. In the pH range 4.94 to 6.82 the hydrolysis reactions are of first order in the hydronium ion. The rate of hydrolysis correlates with the electron-donating or electron-withdrawing ability of the corresponding alkoxy group. The studied 2-alkoxypropan-2-yl groups and the relative rate constants for their cleavage from the 5'-hydroxy group of 2'-deoxythymidine were: cyclohexyloxy (k rel = 7.7), isopropoxy (7.4), methoxy (1), benzyloxy (0.6) and 2,2,2-trifluoroethyloxy (0.04). The attachment of the same groups to the 3'-hydroxy group are from 1.3 to 1.9-fold more stable. The most reactive of these acetone-based acetal groups are faster removed than a dimethoxytrityl group, and they are easier to cleave completely in solution. The structural variation allows steering of the stability and lipophilicity of the compounds in some range.
| S-EPMC6444389 | biostudies-literature
Project description:BackgroundA more specific and early diagnostics for prostate cancer (PCa) is highly desirable. In this study, being inflammation the focus of our effort, serum protein profiles were analyzed in order to investigate if this parameter could interfere with the search of discriminating proteins between PCa and benign prostatic hyperplasia (BPH).MethodsPatients with clinical suspect of PCa and candidates for trans-rectal ultrasound guided prostate biopsy (TRUS) were enrolled. Histological specimens were examined in order to grade and classify the tumor, identify BPH and detect inflammation. Surface Enhanced Laser Desorption/Ionization-Time of Flight-Mass Spectrometry (SELDI-ToF-MS) and two-dimensional gel electrophoresis (2-DE) coupled with Liquid Chromatography-MS/MS (LC-MS/MS) were used to analyze immuno-depleted serum samples from patients with PCa and BPH.ResultsThe comparison between PCa (with and without inflammation) and BPH (with and without inflammation) serum samples by SELDI-ToF-MS analysis did not show differences in protein expression, while changes were only observed when the concomitant presence of inflammation was taken into consideration. In fact, when samples with histological sign of inflammation were excluded, 20 significantly different protein peaks were detected. Subsequent comparisons (PCa with inflammation vs PCa without inflammation, and BPH with inflammation vs BPH without inflammation) showed that 16 proteins appeared to be modified in the presence of inflammation, while 4 protein peaks were not modified. With 2-DE analysis, comparing PCa without inflammation vs PCa with inflammation, and BPH without inflammation vs the same condition in the presence of inflammation, were identified 29 and 25 differentially expressed protein spots, respectively. Excluding samples with inflammation the comparison between PCa vs BPH showed 9 unique PCa proteins, 4 of which overlapped with those previously identified in the presence of inflammation, while other 2 were new proteins, not identified in our previous comparisons.ConclusionsThe present study indicates that inflammation might be a confounding parameter during the proteomic research of candidate biomarkers of PCa. These results indicate that some possible biomarker-candidate proteins are strongly influenced by the presence of inflammation, hence only a well-selected protein pattern should be considered for potential marker of PCa.
| S-EPMC4061775 | biostudies-literature
Project description:Physiological processes such as protein folding and molecular recognition are intricately linked to their dynamic signature, which is reflected in their thermal coefficient. In addition, the local conformational entropy is directly related to the degrees of freedom, which each residue possesses within its conformational space. Therefore, the temperature dependence of the local conformational entropy may provide insight into understanding how local dynamics may affect the stability of proteins. Here, we analyze the temperature dependence of internal methyl group dynamics derived from the cross-correlated relaxation between dipolar couplings of two CH bonds within ubiquitin. Spanning a temperature range from 275 to 308 K, internal methyl group dynamics tend to increase with increasing temperature, which translates to a general increase in local conformational entropy. With this data measured over multiple temperatures, the thermal coefficient of the methyl group order parameter, the characteristic thermal coefficient, and the local heat capacity were obtained. By analyzing the distribution of methyl group thermal coefficients within ubiquitin, we found that the N-terminal region has relatively high thermostability. These results indicate that methyl groups contribute quite appreciably to the total heat capacity of ubiquitin through the regulation of local conformational entropy.
| S-EPMC3375756 | biostudies-literature
Project description:Here we show effect of the polyamine polymer chain length to BET isotherms. According to IUPAC classification [1], all three polymers are fitting type 1 physical adsorption isotherm with H3 hysteresis (except for EDA having H2 hysteresis). Moreover, TG and TGA analysis of polymers triazine-ethylenediamine (EDA) and triazine-triethylenetetramine (TETA) are provided. Due to the similarities of the structure, main decomposition temperatures are close to each other (between 593 K and 873 K). In order to understand change of FTIR spectra with adsorption and stripping Au(III), fresh, Au(III) adsorbed and recycled spectras of polymers measured. For further discussions about the effect of chain length to adsorption of Au(III) onto triazine polyamine polymer particles "Au (III) Uptake by Triazine Polyamine Polymers: Mechanism, Kinetic and Equilibrium Studies" Can et al. [2] (article in press).
| S-EPMC5331151 | biostudies-literature