Corrosion Inhibition of Cast Iron in Arabian Gulf Seawater by Two Different Ionic Liquids.
Ontology highlight
ABSTRACT:
SUBMITTER: Sherif EM
PROVIDER: S-EPMC5455627 | biostudies-other | 2015 Jun
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Corrosion is clearly one of the more common causes of materials failure in stainless steel. To manage corrosion, chemical inhibitors are often used for prevention and control. Ionic liquids due to their hydrophobic and corrosion-resistant property are being explored as alternative protective coatings and anti-corrosion materials. In this particular study, ionic liquids containing functionalized imidazolium cations and tris(pentafluoroethyl)trifluorophosphate (FAP) anions were investigated for their ability to inhibit corrosion on stainless steel surfaces in acidic environment. Using surface characterization techniques, specifically scanning electron microscopy and energy-dispersive X-ray (EDX), the morphology and the elemental composition of the steel surfaces before and after corrosion were determined. Contact angle measurements were also performed to determine how these ionic liquids were able to wet the stainless steel surface. In addition, potentiodynamic studies were carried out to ensure that corrosion inhibition has occurred. Results show that these ionic liquids were able to inhibit corrosion on the stainless steel surfaces. This indicates promise in the use of these FAP-based ionic liquids for corrosion management in stainless steel.
| S-EPMC7428245 | biostudies-literature
Project description:Chromate free corrosion inhibitors are searched for to mitigate the economic loss caused by mid-steel corrosion. Here, we show metal-free organic inhibitors having free coumarate anions that can be used either as direct corrosion inhibitors or incorporated into a polymer coating obtained by UV-curing. Four different ionic liquid monomers and polymer coatings with hexoxycoumarate anion and different polymerizable counter cations were investigated. Potentiodynamic polarization, electrochemical impedance spectroscopy, and surface analyses have verified their corrosion inhibition performance on a mild steel AS1020 surface. In the case of the coumarate ionic liquid monomers, the most promising inhibitor is the one coupled with the ammonium cation, showing an inhibition efficiency of 99.1% in solution followed by the imidazolium, pyridinium, and anilinium. Next, the ionic liquid monomers were covalently integrated into an acrylic polymer coating by UV-photopolymerization. In this case, the barrier effect of the polymer coating is combined with the corrosion inhibitor effect of the pendant coumarate anion. Here, the best polymer coatings are those containing 20% imidazolium and pyridinium cations, presenting a greater impedance in the EIS (Electrochemical Impedance Spectroscopy) measurements and less evidence of corrosion in the scribe tests. This article shows that the cationic moiety of coumarate based ionic liquids and poly(ionic liquid)s has a significant effect on their excellent corrosion inhibition properties for a mild steel surface exposed to aqueous chloride solutions.
| S-EPMC7694658 | biostudies-literature
Project description:In the past, lives and wealth have been lost due to corrosion in almost all engineering fields. Not only this, the cost of reviving damaged equipments in the industry due to corrosion contributed a lot to the gross domestic product of a nation. Thus, all hands must be on desk to combat this harzadous act via time to time research on its final resolution. However, current research works have revealed effective and reliable corrosion inhibitors from pharmaceutical drugs, plant extracts and ionic liquids as organic green corrosion inhibitors (OGCIs) with accommodative attributes such as being environmentally friendly, readily available, biodegradable, non-harmful, relatively cheap and many others to mention a few. This paper opens readers mind into the detailed classifications, mechanisms and active functional groups of these eco-friendly OGCIs. Not only the corrosion efficiency calculation ways but also influencing factors on efficiency were presented. Plant extracts, pharmaceutical drugs, ionic liquids and synthetic inhibitors, as among major sources of OGCIs, used in preventing material corrosion in corrosive media were separately and comprehensively examined. The significance of values obtained from simulating presented mathematical models governing OGCIs kinetics, adsorption isotherm and adsorption thermodynamics was also included. In conclusion, beneficial recommendations for both current and prospective researchers in the field of Corrosion Engineering were presented.
| S-EPMC6360517 | biostudies-literature
Project description:Human neutrophil elastase (HNE) is used as diagnostic biomarker for inflammation/infection. In this work, 10 ionic liquids (ILs) and 11 ionic liquids active pharmaceutical ingredients (ILs-APIs) were tested to evaluate the inhibition effect on the activity of porcine pancreatic elastase enzyme, frequently employed as a model for HNE. The insertion of ionic liquids in some drugs is useful, as the insertion of ILs with inhibitory capacity will also slow down all processes in which this enzyme is involved. Therefore, a spectrophotometric method was performed to the determination of EC50 values of the compounds tested. EC50 values of 124 ± 4 mM to 289 ± 11 mM were obtained, with the most toxic IL for elastase being tetrabutylammonium acetate and the least toxic 1-butyl-3-methylimidazolium acetate. Moreover, sodium salicylate (raw material) presented the lower and benzethonium bistriflimide the higher EC50 when compared with all the IL-APIs tested. This work provides significant information about the effect of the studied IL and IL-APIs in elastase enzyme activity.
| S-EPMC7796259 | biostudies-literature
Project description:The study was carried out to evaluate five SiMo cast iron grades and their resistance to chemical corrosion at elevated temperature. Corrosion tests were carried out under conditions of an actual cyclic operation of a retort coal-fired boiler. The duration of the study was 3840 h. The range of temperature changes during one cycle was in the range of 300-650 °C. Samples of SiMo cast iron with Si content at the level of 5% and variable Mo content in the range 0%-2.5% were used as the material for the study. The examined material was subjected to preliminary metallographic analysis using scanning microscopy and an Energy dispersive spectroscopy (EDS) system. The chemical composition was determined on the basis of a Leco spectrometer and a Leco carbon and sulfur analyzer. The examination of the oxide layer was carried out with the use of Scanning electron microscope (SEM), EDS, and X-ray diffraction (XRD) methods. It was discovered that, in the analyzed alloys, oxide layers consisting of Fe2O3, Fe3O4, SO2, and Fe2SiO4 were formed. The analyzed oxide layers were characterized by high adhesion to the substrate material, and their total thickness was about 20 ?m.
| S-EPMC7178701 | biostudies-literature
Project description:The effects of different I2 concentrations and different ionic liquids (ILs) in the electrolyte on the performances of dye-sensitized solar cells (DSCs) containing an iron(II) N-heterocyclic carbene dye and containing the I-/I3- redox shuttle have been investigated. Either no I2 was added to the electrolyte, or the initial I2 concentrations were 0.02, 0.05, 0.10, and 0.20 M. The short-circuit current density (JSC), open-circuit voltage (VOC), and the fill factor (ff) were influenced by changes in the I2 concentration for all the ILs. For 1-hexyl-3-methylimidazole iodide (HMII), low VOC and low ff values led to poor DSC performances. Electrochemical impedance spectroscopy (EIS) showed the causes to be increased electrolyte diffusion resistance and charge transfer resistance at the counter electrode. DSCs containing 1,3-dimethylimidazole iodide (DMII) and 1-ethyl-3-methylimidazole iodide (EMII) showed the highest JSC values when 0.10 M I2 was present initially. Short alkyl substituents (Me and Et) were more beneficial than longer chains. The lowest values of the transport resistance in the photoanode semiconductor were found for DMII, EMII, and 1-propyl-2,3-dimethylimidazole iodide (PDMII) when no I2 was added to the initial electrolyte, or when [I2] was less than 0.05 M. Higher [I2] led to decreases in the diffusion resistance in the electrolyte and the counter electrode resistance. The electron lifetime and diffusion length depended upon the [I2]. Overall, DMII was the most beneficial IL. A combination of DMII and 0.1 M I2 in the electrolyte produced the best performing DSCs with an average maximum photoconversion efficiency of 0.65% for a series of fully-masked cells.
| S-EPMC8200003 | biostudies-literature
Project description:Ionic Liquids are a broad group of salts with low melting points that can be specifically tuned for a broad range of applications. Despite being initially considered “green” solvents, their better environmental friendliness compared to traditional solvents has been increasingly challenged. In this study, we aimed to investigate the molecular effects of ILs exposure by using RNA-sequencing to study differential gene expression patterns. Thus, we exposed Daphnia magna to 1-ethyl-3-methylimidazolium chloride ([C2mim]Cl), 1-dodecyl chloride-3-methylimidazolium ([C12mim]Cl) and cholinium chloride ([Chol]Cl). Results suggest that the three ILs share several mechanisms of toxicity, including cellular membrane and cytoskeleton damage, oxidative stress, inhibition of antioxidant enzymes, mitochondrial affectation, changes in protein biosynthesis and energy production, DNA damage, and ultimately, programmed cell death and disease initiation. Overall, the dataset revealed that [C2mim]Cl and [C12mim]Cl were, respectively, the least and the most toxic ILs at the transcriptional level. Also, it is reinforced that [Chol]Cl is not devoid of environmental hazardous potential. Unique gene expression signatures could also be identified for each IL.
2021-08-13 | GSE156769 | GEO
Project description:New ionic liquids with multiple Brönsted acid sites were synthesized in ?98% yield, and their inhibiting properties for the corrosion of carbon steel in 0.5?M HCl solution had been evaluated using electrochemical impedance spectroscopy, potentiodynamic polarization and weight loss method, finally the possible inhibiting mechanism was proposed according to UV-visible spectroscopic measurements and surface analysis including SEM and XPS techniques. The designed cation structure of Brönsted acid ionic liquids (BAILs), with one phenyl and two imidazolium rings, makes them good mixed-type inhibitors via the adsorption of BAILs on the steel surface to suppress both anodic and cathodic processes, obeying Langmuir adsorption isotherm. As potential acid catalysts, BAILs show nice corrosion inhibiting performance in acidic medium regardless of their Brönsted acidity, which is of great significance to enlarge the industry applications of BAILs.
| S-EPMC5562793 | biostudies-literature
Project description:The multidrug and toxin extruders 1- and 2-K (MATE1 and MATE2-K) are expressed in the luminal membrane of renal proximal tubule cells and provide the active step in the secretion of molecules that carry a net positive charge at physiologic pH, so-called organic cations. The present study tested whether structurally distinct MATE substrates can display different quantitative profiles of inhibition when interacting with structurally distinct ligands. The tested ligands were three structurally similar cationic ionic liquids (ILs, salts in the liquid state: N-butylpyridinium, NBuPy; 1-methyl-3-butylimidazolium, Bmim; and N-butyl-N-methylpyrrolidinium, BmPy). Uptake was measured using Chinese hamster ovary cells that stably expressed MATE1 or MATE2-K. By trans-stimulation, all three ILs were transported by both MATE transporters. The three ILs also inhibited uptake of three structurally distinct MATE substrates: 1-methyl-4-phenylpyridinium (MPP), triethylmethylammonium (TEMA), and N,N,N-trimethyl-2-[methyl(7-nitrobenzo[c][1,2,5]oxadiazol-4-yl)amino]ethanaminium (NBD-MTMA). MATE1 displayed a higher affinity for the pyridinium-based NBuPy (IC50 values, 2-4 µM) than for either the pyrrolidinium- (BmPy; 20-70 µM) or imidazolium-based ILs (Bmim; 15-60 µM). Inhibition of MPP, TEMA, and NBD-MTMA transport by NBuPy was competitive, with comparable Ki values against all substrates. Bmim also competitively blocked the three substrates but with Ki values that differed significantly (20 µM against MPP and 30 µM against NBD-MTMA versus 60 µM against TEMA). Together, these data indicate that renal secretion of ILs by the human kidney involves MATE transporters and suggest that the mechanism of transport inhibition is ligand-dependent, supporting the hypothesis that the binding of substrates to MATE transporters involves interaction with a binding surface with multiple binding sites.
| S-EPMC3876781 | biostudies-literature
Project description:BACKGROUND:Currently, the effect of the bacterial community on cast iron corrosion process does not reach consensus. Moreover, some studies have produced contrasting results, suggesting that bacteria can either accelerate or inhibit corrosion. RESULTS:The long-term effects of the bacterial community on cast iron corrosion in reclaimed wastewater distribution systems were investigated from both spatial (yellow layer vs. black layer) and temporal (1-year dynamic process) dimensions of the iron coupon-reclaimed wastewater microcosm using high-throughput sequencing and flow cytometry approaches. Cast iron coupons in the NONdisinfection and UVdisinfection reactors suffered more severe corrosion than did those in the NaClOdisinfection reactor. The bacterial community significantly promoted cast iron corrosion, which was quantified for the first time in the practical reclaimed wastewater and found to account for at least 30.5%?±?9.7% of the total weight loss. The partition of yellow and black layers of cast iron corrosion provided more accurate information on morphology and crystal structures for corrosion scales. The black layer was dense, and the particles looked fusiform, while the yellow layer was loose, and the particles were ellipse or spherical. Goethite was the predominant crystalline phase in black layers, while corrosion products mainly existed as an amorphous phase in yellow layers. The bacterial community compositions of black layers were distinctly separated from yellow layers regardless of disinfection methods. The NONdisinfection and UVdisinfection reactors had a more similar microbial composition and variation tendency for the same layer type than did the NaClOdisinfection reactor. Biofilm development can be divided into the initial start-up stage, mid-term development stage, and terminal stable stage. In total, 12 potential functional genera were selected to establish a cycle model for Fe, N, and S metabolism. Desulfovibrio was considered to accelerate the transfer of Fe0 to Fe2+ and speed up weight loss. CONCLUSION:The long-term effect of disinfection processes on corrosion behaviors of cast iron in reclaimed wastewater distribution systems and the hidden mechanisms were deciphered for the first time. This study established a cycle model for Fe, N, and S metabolism that involved 12 functional genera and discovered the significant contribution of Desulfovibrio in promoting corrosion.
| S-EPMC6292113 | biostudies-other