Acoustic Behavior of Hollow Blocks and Bricks Made of Concrete Doped with Waste-Tire Rubber.
Ontology highlight
ABSTRACT:
SUBMITTER: Fraile-Garcia E
PROVIDER: S-EPMC5456962 | biostudies-other | 2016 Nov
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Masonry structures are widely used nowadays for their advantages like low-cost workmanship, efficiency and fast construction techniques. The compressive strength of the materials that compose masonry (block and mortar) is very important to the behavior of the system, but the tensile strength is even more significant for the standards and building codes. In this work, a dataset for indirect tensile tests of hollow concrete blocks is obtained. Splitting tests as described in ASTM C-1006-13 are applied. Two sets of blocks were tested, one with medium compressive strength and the other with high compressive strength. The first set was tested in three directions named A, B, and C; the second one was tested in two directions, A and B. The data was collected with a servo-hydraulic machine. The data is presented in tables and can be used by material researchers, as well as in numerical modeling.
| S-EPMC8645457 | biostudies-literature
Project description:This article presents research results relating to the potential for waste utilization in the form of polymer optical fiber (POF) scraps. This material is difficult to recycle due to its diverse construction. Three different volumes of POF were used in concrete in these tests: 1%, 2%, and 3%. The experimental studies investigated the basic properties of the concrete, the elastic and dynamic moduli, as well as deformation and deflection of reinforced beams. The microstructures, including the interfacial transition zones (ITZs), were recorded and analyzed using a scanning electron microscope. It was observed that 180 freezing-thawing cycles reduced the concrete frost resistance containing 3% POFs by half compared to the control concrete. The resistance to salt crystallization of this concrete decreased by about 55%. POFs have significant effects on the splitting tensile and flexural strengths compared to the compressive strength. The control beams were destroyed during the four-point static bending tests at half the force applied to the beams that were reinforced with POFs.
| S-EPMC7288338 | biostudies-literature
Project description:Despite the issuance of standardized garbage classification signage, the rate of garbage classification in China remains low. We conducted a pair of laboratory experiments to explore the cognitive processing differences between abstract (including recyclables, hazardous garbage, and food signs) and concrete (including paper, plastic, glass, metal, textiles, batteries, household chemicals, tubes, and food signs) classification signs. We tested a nudging strategy to enhance garbage classification behavior. In Experiment 1, we divided garbage classification signs into two conditions: an abstract condition (comprising abstract signs) and a concrete condition (comprising concrete signs). The Go/No Go task was used to simulate garbage classification behavior. Participants were instructed to press a key when the garbage stimulus matched the classification signs (Go condition) and to refrain from pressing the key when there was a mismatch (No Go condition). The results showed that responses under the concrete condition were expedited compared to those under the abstract condition. This suggests that concrete signage requires less cognitive exertion, thereby enhancing the efficiency of waste classification. In Experiment 2, we optimized the existing bin signage, which predominantly featured abstract signs (traditional condition), and transformed it into a bin signage that emphasized concrete classification signs. These concrete signs were strategically positioned on the upper part of the bins to draw attention (nudging condition). The results suggested that the nudging condition required fewer cognitive resources than the traditional condition, which in turn increased the efficiency of processing garbage classification. This study not only validates the effects of concreteness in garbage classification but also provides effective nudge strategies to complement existing garbage classification management policy tools in a realistic Chinese context.
| S-EPMC10704987 | biostudies-literature
Project description:In recent decades, several studies have considered the use of plastic waste as a partial substitute for aggregate in green concrete. Such concrete has been limited to non-structural applications due to its low strength. This raises whether such concrete can be enhanced for use in some structural applications. This paper reports an attempt to develop a structural-grade concrete containing plastic waste aggregate with high proportions of substitution and confined with carbon fiber reinforced polymer (CFRP) fabrics. Experimental research was conducted involving the casting and testing 54 plain and confined concrete cylinders. A concrete mixture was designed in which the fine aggregate was partially replaced by polyethylene terephthalate (PET) waste plastic at ratios of 0%, 25%, and 50%, and with different w/c ratios of 0.40, 0.45, and 0.55. The results show that confinement has a substantial positive effect on the compressive behavior of PET concrete. The enhancement efficiency increases by 8-190%, with higher enhancement levels for higher substitution ratios. Adding one layer of CFRP fabric raises the ultimate strength of samples that have lost compressive strength to a level close to that of unconfined samples not containing PET. This confinement is accompanied by an increase in the slope of the stress-strain curve and greater axial and lateral strain values at failure. For the specimens confined by CFRP fabric, PET aggregate can be used as a partial substitute for sand at a replacement ratio of up to 50% by volume for structural applications. This paper also considers the ability of existing models to predict the strength of confined-PET concrete circular cross-sections by comparing model predictions with experimental results. The strength of confined PET concrete elements can't be accurately predicted by any of the models that are already out there. It's important to come up with a new model for these elements.
| S-EPMC9278765 | biostudies-literature
Project description:Acoustic emission (AE) is capable of monitoring the cracking activities inside materials. In this study, embedded sensors were employed to monitor the AE behavior of early age concrete. Type 1-3 cement-based piezoelectric composites, which had lower mechanical quality factor and acoustic impedance, were fabricated and used to make sensors. Sensors made of the composites illustrated broadband frequency response. In a laboratory, the cracking of early age concrete was monitored to recognize different hydration stages. The sensors were also embedded in a mass concrete foundation to localize the temperature gradient cracks.
| S-EPMC5456007 | biostudies-other
Project description:The application of waste tire rubber as aggregates in concrete can help to reduce carbon emissions and achieve green gross domestic product (GDP). However, civil engineers still have concerns about using rubberized concrete in structural members. For the safety of structures, the bearing strength of concrete is a very important parameter to be considered in the design. This paper presented the first experimental and numerical study on the bearing strength of crumb rubber concrete. Prisms of both normal concrete and crumb rubber concrete were tested with loading plates of varying sizes. The test results show that the failure modes and deformation behavior of crumb rubber concrete specimens with different rubber contents were similar to those of normal concrete, and the bearing strength of crumb rubber concrete can be well predicted by current standards for normal concrete. Finite element analysis was performed to further determine the effect of rubber content on the bearing strength of concrete. Proper parameter values for modeling crumb rubber concrete by the concrete damaged plasticity model were investigated. Through the numerical analysis, the reason the rubber content does not have an important effect on the bearing strength of crumb rubber concrete with similar compressive strength was found to be that the influence of rubber content on the tri-axial compression behavior of concrete and the ratio of concrete tensile strength to compressive strength is small. The experimental and numerical results presented in this study provide the insights needed to guide the design of structures utilizing crumb rubber concrete.
| S-EPMC7321083 | biostudies-literature
Project description:The data presented in this research show the results of the experimental study of acoustic behaviour of coconut fibre-reinforced concrete (CFRC). The CFRC was added in percentages of 0.25%, 0.5%, 0.75% and 1% of cement. The acoustic test was conducted to determine the amount of sound that can be absorbed by the fibre. The data showed that the concrete reinforced with coconut fibre had the highest sound absorptive power, of which fibre treated absorbed more sound than other fibres, this is because washing of fibre increase the lignin content which is responsible for the sound absorbing property. The data also showed that the curing time had no effect on the absorbing property of the CFRC. The data presented will be useful in the construction of sound proof reinforced concrete slabs, walls and other elements.
| S-EPMC6222070 | biostudies-literature
Project description:Tires, conveyor belts, floor mats, and shoe soles form a main-stream of rubber waste. The amount of these used materials continuously increases due to development of the rubber market. Therefore, pro-ecological utilization (i.e., energy recycling instead of burning) and recovering valuable and recyclable materials becomes an urgent necessity. In this regard, this work was devoted to the chemical recycling of selected used rubber products, and it especially explores the possibility of limonene production. Different types of waste rubber were characterized and pyrolyzed at microgram and laboratory scales, and the results were compared. Additionally, the pyrolysis of tires, the most significant stream of rubber waste, was also conducted in a semi-technical scale reactor. The effectiveness of limonene formation in the liquid fractions obtained from different types of waste rubber was compared.
| S-EPMC7579170 | biostudies-literature
Project description:Industrial waste has been rapidly increased day by day because of the fast-growing population which results environmental pollutions. It has been recommended that the disposal of industrial waste would be greatly reduced if it could be incorporated in concrete production. In cement concrete technology, there are many possibilities to use waste materials either as cement replacement or aggregate in concrete production. Two major industrials waste are glass and marble waste. The basic objective of this investigation is to examine the characteristics of concrete waste glass (WG) as binding material in proportions 10%, 20% and 30% by weight of cement. Furthermore, to obtain high strength concrete, waste marble in proportion of 40%, 50% and 60% by weight cement as fine aggregate were used as a filler material to fill the voids between concrete ingredients. Fresh properties were evaluated through slump cone test while mechanical performance was evaluated through compressive strength and split tensile strength which were performed after 7 days, 28 days and 56 days curing. Results show that, workability of concrete decreased with incorporation of waste glass and marble waste. Furthermore, mechanical performance improved considerably up 20% and 50% substitution of waste glass and waste marble respectively. Statistical approach of Response Surface Methodology (RSM) was used optimize both waste materials in concrete. Results indicate better agreement between statistical and experimental results.
| S-EPMC8564529 | biostudies-literature
Project description:This paper presents a study of incorporation of two types of construction and demolition waste (CDW) in rendering mortars, as aggregates at 0%, 20%, 50% and 100% (by volume). Recycled concrete aggregate (RCA) and mixed recycled aggregate (MRA) were used. The former is mainly composed of cementitious waste and the latter consists of a mixture of non-segregated wastes. The performance of the cement mortars with recycled aggregates was evaluated through an extensive experimental programme. The analysis comprised workability, mechanical strength, water absorption, shrinkage, open porosity and the evaluation of durability by permeability to water under pressure after an artificial accelerated ageing test. The results are considered positive, although as the incorporation of recycled aggregates (both MRA and RCA) increased the mechanical strength, the modulus of elasticity and bulk density decreased, which leads to the production of lighter mortars that are less susceptible to cracking. The modified mortar with 20% of MRA presented the best performance, in terms of mechanical behaviour.
| S-EPMC7254318 | biostudies-literature