Browse
Submit Data
Databases
API
Help

Dataset Information

0 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

A Study of Efficiency Droop Phenomenon in GaN-Based Laser Diodes before Lasing.

ABSTRACT: Carrier recombination behavior in c-plane GaN-based laser diodes (LDs) is numerically investigated by using the commercial software LASTIP. It is found that efficiency droop phenomenon does exist in GaN-based LDs before lasing, which is confirmed by experimental results. However, the current density corresponding to the peak efficiency of GaN-based LDs before lasing, Jmax, is nearly 40 A/cm², which is much lower than that reported by other studies. The reported Jmax, measured from the cavity facet side is modulated by the absorption of quantum wells, which shifts the Jmax to a higher value. In addition, the currents due to various recombinations are calculated. It is found that Auger recombination affects the threshold current greatly, but it only plays a small role at high current injection levels.

SUBMITTER: Feng MX

PROVIDER: S-EPMC5459086 | biostudies-other | 2017 Apr

REPOSITORIES: biostudies-other

ACCESS DATA

Json Xml

Similar Datasets

Defect-selective-etched porous GaN as a buffer layer for high efficiency InGaN/GaN light-emitting diodes.

Project description:Substrate-induced biaxial compressive stress and threading dislocations (TDs) have been recognized to severely impair the performance, stability, and reliability of InGaN/GaN light-emitting diodes (LEDs) for quite some time. In this study, a defect-selective-etched (DSE) porous GaN layer is fabricated employing electro-chemical etching and applied as a buffer layer for the development of InGaN/GaN LEDs with high quantum efficiency. Based on the analysis of photoluminescence and micro-Raman spectra, it has been revealed that the overgrown GaN epilayer on the DSE porous GaN has a relatively low TDs and relaxation of compressive stress in comparison to the conventional GaN epilayer. The remarkable improvement in the internal quantum efficiency of the InGaN/GaN LEDs is directly attributable to the strong radiative recombination in InGaN/GaN multi-quantum-wells caused by stress relaxation and TDs annihilation. Our findings indicate that the use of DSE porous GaN as a buffer layer may be a viable approach for producing crystalline GaN epilayers and high-performance LEDs.

| S-EPMC9671350 | biostudies-literature

Enhanced external quantum efficiency in GaN-based vertical-type light-emitting diodes by localized surface plasmons.

Project description:Enhancement of the external quantum efficiency of a GaN-based vertical-type light emitting diode (VLED) through the coupling of localized surface plasmon (LSP) resonance with the wave-guided mode light is studied. To achieve this experimentally, Ag nanoparticles (NPs), as the LSP resonant source, are drop-casted on the most top layer of waveguide channel, which is composed of hydrothermally synthesized ZnO nanorods capped on the top of GaN-based VLED. Enhanced light-output power and external quantum efficiency are observed, and the amount of enhancement remains steady with the increase of the injected currents. To understand the observations theoretically, the absorption spectra and the electric field distributions of the VLED with and without Ag NPs decorated on ZnO NRs are determined using the finite-difference time-domain (FDTD) method. The results prove that the observation of enhancement of the external quantum efficiency can be attributed to the creation of an extra escape channel for trapped light due to the coupling of the LSP with wave-guided mode light, by which the energy of wave-guided mode light can be transferred to the efficient light scattering center of the LSP.

| S-EPMC4776147 | biostudies-other

Vertical GaN-on-GaN Schottky Diodes as ?-Particle Radiation Sensors.

Project description:Among the different semiconductors, GaN provides advantages over Si, SiC and GaAs in radiation hardness, resulting in researchers exploring the development of GaN-based radiation sensors to be used in particle physics, astronomic and nuclear science applications. Several reports have demonstrated the usefulness of GaN as an ?-particle detector. Work in developing GaN-based radiation sensors are still evolving and GaN sensors have successfully detected ?-particles, neutrons, ultraviolet rays, x-rays, electrons and ?-rays. This review elaborates on the design of a good radiation detector along with the state-of-the-art ?-particle detectors using GaN. Successful improvement in the growth of GaN drift layers (DL) with 2 order of magnitude lower in charge carrier density (CCD) (7.6 × 1014/cm3) on low threading dislocation density (3.1 × 106/cm2) hydride vapor phase epitaxy (HVPE) grown free-standing GaN substrate, which helped ~3 orders of magnitude lower reverse leakage current (IR) with 3-times increase of reverse breakdown voltages. The highest reverse breakdown voltage of -2400 V was also realized from Schottky barrier diodes (SBDs) on a free-standing GaN substrate with 30 ?m DL. The formation of thick depletion width (DW) with low CCD resulted in improving high-energy (5.48 MeV) ?-particle detection with the charge collection efficiency (CCE) of 62% even at lower bias voltages (-20 V). The detectors also detected 5.48 MeV ?-particle with CCE of 100% from SBDs with 30-?m DL at -750 V.

| S-EPMC7281217 | biostudies-literature

Effects of GaN/AlGaN/Sputtered AlN nucleation layers on performance of GaN-based ultraviolet light-emitting diodes.

Project description:We report on the demonstration of GaN-based ultraviolet light-emitting diodes (UV LEDs) emitting at 375 nm grown on patterned sapphire substrate (PSS) with in-situ low temperature GaN/AlGaN nucleation layers (NLs) and ex-situ sputtered AlN NL. The threading dislocation (TD) densities in GaN-based UV LEDs with GaN/AlGaN/sputtered AlN NLs were determined by high-resolution X-ray diffraction (XRD) and cross-sectional transmission electron microscopy (TEM), which revealed that the TD density in UV LED with AlGaN NL was the highest, whereas that in UV LED with sputtered AlN NL was the lowest. The light output power (LOP) of UV LED with AlGaN NL was 18.2% higher than that of UV LED with GaN NL owing to a decrease in the absorption of 375 nm UV light in the AlGaN NL with a larger bandgap. Using a sputtered AlN NL instead of the AlGaN NL, the LOP of UV LED was further enhanced by 11.3%, which is attributed to reduced TD density in InGaN/AlInGaN active region. In the sputtered AlN thickness range of 10-25 nm, the LOP of UV LED with 15-nm-thick sputtered AlN NL was the highest, revealing that optimum thickness of the sputtered AlN NL is around 15 nm.

| S-EPMC5353678 | biostudies-literature

Effective suppression of efficiency droop in GaN-based light-emitting diodes: role of significant reduction of carrier density and built-in field.

Project description:A critical issue in GaN-based high power light-emitting diodes (LEDs) is how to suppress the efficiency droop problem occurred at high current injection while improving overall quantum efficiency, especially in conventional c-plane InGaN/GaN quantum well (QW), without using complicated bandgap engineering or unconventional materials and structures. Although increasing thickness of each QW may decrease carrier density in QWs, formation of additional strain and defects as well as increased built-in field effect due to enlarged QW thickness are unavoidable. Here, we propose a facile and effective method for not only reducing efficiency droop but also improving quantum efficiency by utilizing c-plane InGaN/GaN QWs having thinner barriers and increased QW number while keeping the same single well thickness and total active layer thickness. As the barrier thickness decreases and the QW number increases, both internal electric field and carrier density within QWs are simultaneously reduced without degradation of material quality. Furthermore, we found overall improved efficiency and reduced efficiency droop, which was attributed to the decrease of the built-in field and to less influence by non-radiative recombination processes at high carrier density. This simple and effective approach can be extended further for high power ultraviolet, green, and red LEDs.

| S-EPMC5069459 | biostudies-literature

Thermal and efficiency droop in InGaN/GaN light-emitting diodes: decoupling multiphysics effects using temperature-dependent RF measurements.

Project description:Multiphysics processes such as recombination dynamics in the active region, carrier injection and transport, and internal heating may contribute to thermal and efficiency droop in InGaN/GaN light-emitting diodes (LEDs). However, an unambiguous methodology and characterization technique to decouple these processes under electrical injection and determine their individual roles in droop phenomena is lacking. In this work, we investigate thermal and efficiency droop in electrically injected single-quantum-well InGaN/GaN LEDs by decoupling the inherent radiative efficiency, injection efficiency, carrier transport, and thermal effects using a comprehensive rate equation approach and a temperature-dependent pulsed-RF measurement technique. Determination of the inherent recombination rates in the quantum well confirms efficiency droop at high current densities is caused by a combination of strong non-radiative recombination (with temperature dependence consistent with indirect Auger) and saturation of the radiative rate. The overall reduction of efficiency at elevated temperatures (thermal droop) results from carriers shifting from the radiative process to the non-radiative processes. The rate equation approach and temperature-dependent pulsed-RF measurement technique unambiguously gives access to the true recombination dynamics in the QW and is a useful methodology to study efficiency issues in III-nitride LEDs.

| S-EPMC6934866 | biostudies-literature

Effects of Nanoscale V-Shaped Pits on GaN-Based Light Emitting Diodes.

Project description:This paper reviews the formation of nanoscale V-shaped pits on GaN-based light emitting diodes (LEDs) grown by the metal organic chemical vapor deposition (MOCVD) system and studies the effect of V-shaped pits on quantum efficiency. Since V-pits could provide potential barriers around threading dislocations to lessen non-radiative recombinations in such a high defect environment. In our study, multiple InGaN/GaN quantum well samples with different emission wavelengths of 380, 420, 460, and 500 nm were grown, each with different nanoscale V-shaped pits of three diameters for 150, 200, and 250 nm, respectively. It was found that the multiple quantum well (MQW) sample with larger V-pits had a lower pit density, but a relatively larger total V-pits defected area. The optimum diameter of V-pits showing the highest quantum efficiency from the MQW sample depended on the emission wavelength. MQW samples with wavelengths of 380 and 500 nm exhibited the best internal quantum efficiency (IQE) performance at the smallest V-pits area; however, the best performance for MQW samples with wavelength around 420 and 460 nm occurred when large V-pit areas were presented. Photoluminescence (PL) peak shifts and Raman shifts can provide a relationship between quantum-confined Stark effect (QCSE) and IQE, as well as a comparison between strain and IQE. The results obtained in this phenomenological study shall provide a useful guide line in making high-performance GaN-based LEDs with wide emission spectra.

| S-EPMC5459134 | biostudies-other

Barrier inhomogeneities limited current and 1/f noise transport in GaN based nanoscale Schottky barrier diodes.

Project description:The electrical behaviour of Schottky barrier diodes realized on vertically standing individual GaN nanorods and array of nanorods is investigated. The Schottky diodes on individual nanorod show highest barrier height in comparison with large area diodes on nanorods array and epitaxial film which is in contrast with previously published work. The discrepancy between the electrical behaviour of nanoscale Schottky diodes and large area diodes is explained using cathodoluminescence measurements, surface potential analysis using Kelvin probe force microscopy and 1ow frequency noise measurements. The noise measurements on large area diodes on nanorods array and epitaxial film suggest the presence of barrier inhomogeneities at the metal/semiconductor interface which deviate the noise spectra from Lorentzian to 1/f type. These barrier inhomogeneities in large area diodes resulted in reduced barrier height whereas due to the limited role of barrier inhomogeneities in individual nanorod based Schottky diode, a higher barrier height is obtained.

| S-EPMC4901317 | biostudies-literature

Stretchable Transparent Light-Emitting Diodes Based on InGaN/GaN Quantum Well Microwires and Carbon Nanotube Films.

Project description:We propose and demonstrate both flexible and stretchable blue light-emitting diodes based on core/shell InGaN/GaN quantum well microwires embedded in polydimethylsiloxane membranes with strain-insensitive transparent electrodes involving single-walled carbon nanotubes. InGaN/GaN core-shell microwires were grown by metal-organic vapor phase epitaxy, encapsulated into a polydimethylsiloxane film, and then released from the growth substrate. The fabricated free-standing membrane of light-emitting diodes with contacts of single-walled carbon nanotube films can stand up to 20% stretching while maintaining efficient operation. Membrane-based LEDs show less than 15% degradation of electroluminescence intensity after 20 cycles of stretching thus opening an avenue for highly deformable inorganic devices.

| S-EPMC8230151 | biostudies-literature

Study on Light Extraction from GaN-based Green Light-Emitting Diodes Using Anodic Aluminum Oxide Pattern and Nanoimprint Lithography.

Project description:An anodic aluminum oxide (AAO) patterned sapphire substrate, with the lattice constant of 520 ± 40 nm, pore dimension of 375 ± 50 nm, and height of 450 ± 25 nm was firstly used as a nanoimprint lithography (NIL) stamp and imprinted onto the surface of the green light-emitting diode (LED). A significant light extraction efficiency (LEE) was improved by 116% in comparison to that of the planar LED. A uniform broad protrusion in the central area and some sharp lobes were also obtained in the angular resolution photoluminescence (ARPL) for the AAO patterned LED. The mechanism of the enhancement was correlated to the fluctuations of the lattice constant and domain orientation of the AAO-pattern, which enabled the extraction of more guided modes from the LED device.

| S-EPMC4763243 | biostudies-other

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data