Mechanisms of Competitive Adsorption Organic Pollutants on Hexylene-Bridged Polysilsesquioxane.
Ontology highlight
ABSTRACT:
SUBMITTER: Lin DR
PROVIDER: S-EPMC5512655 | biostudies-other | 2015 Aug
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Microplastics (MPs) are persistent tiny pieces of plastic material in the environment that are capable of adsorbing environmental organic pollutants from their surroundings. The interaction of MPs with organic pollutants alters their environmental behavior, i.e., their adsorption, degradation and toxicity, etc. Polyethylene (PE) is the most widely used plastic material. The environmental weathering of PE results in changes to its surface chemistry, making the polymer a much better vector for organic pollutants than virgin PE. In this study, a laboratory-accelerated weathering experiment was carried out with a virgin PE film and an oxidatively degradable PE (OXO-PE) film, i.e., PE modified by the addition of a pro-oxidant catalyst. The degradation of PE and OXO-PE was assessed through Fourier transform infra-red (FTIR) spectroscopy and their wettability was measured by contact angle (CA) measurements. Their thermal properties and morphology were studied using thermogravimetric analyses (TGA) and scanning electron microscopy (SEM), respectively. Further, the adsorption of two model organic pollutants onto weathered and virgin PE was analyzed. Triclosan (TCS) and methylparaben (MeP) were chosen as model organic pollutants for the adsorption experiment due to their frequent use in the cosmetics industry, their uncontrolled release into the environment and their toxicity. The adsorption of both model pollutants onto PE and OXO-PE MP was analyzed by using gas chromatography with a flame ionization detector (GC-FID). The adsorption of MeP onto OXO-PE was higher than onto PE MPs. However, TCS showed insignificant adsorption onto PE and OXO-PE. When both pollutants were present simultaneously, the adsorption of TCS onto both PE and OXO-PE was significantly influenced by the presence of MeP. This result demonstrates that the adsorption behavior of one pollutant can be significantly altered by the presence of another pollutant. Both the effect of weathering on the adsorption of organic pollutants as well as the interaction between organic pollutants adsorbing onto MPs is highly relevant to actual MP pollution in the environment, where MPs are exposed to weathering conditions and mixtures of organic pollutants.
| S-EPMC9269090 | biostudies-literature
Project description:Silica aerogels are a class of materials that can be tailored in terms of their final properties and surface chemistry. They can be synthesized with specific features to be used as adsorbents, resulting in improved performance for wastewater pollutants' removal. The purpose of this research was to investigate the effect of amino functionalization and the addition of carbon nanostructures to silica aerogels made from methyltrimethoxysilane (MTMS) on their removal capacities for various contaminants in aqueous solutions. The MTMS-based aerogels successfully removed various organic compounds and drugs, achieving adsorption capacities of 170 mg⋅g-1 for toluene and 200 mg⋅g-1 for xylene. For initial concentrations up to 50 mg⋅L-1, removals greater than 71% were obtained for amoxicillin, and superior to 96% for naproxen. The addition of a co-precursor containing amine groups and/or carbon nanomaterials was proven to be a valuable tool in the development of new adsorbents by altering the aerogels' properties and enhancing their adsorption capacities. Therefore, this work demonstrates the potential of these materials as an alternative to industrial sorbents due to their high and fast removal efficiency, less than 60 min for the organic compounds, towards different types of pollutants.
| S-EPMC10059775 | biostudies-literature
Project description:A sugar cane-converted graphene-like material (FZS900) was fabricated by carbonization and activation. The material exhibited abundant micropores, water-stable turbostratic single-layer graphene nanosheets, and a high BET-N2 surface area (2280 m2 g-1). The adsorption capacities of FZS900 toward naphthalene, phenanthrene, and 1-naphthol were 615.8, 431.2, and 2040 mg g-1, respectively, which are much higher than those of previously reported materials. The nonpolar aromatic molecules induced the turbostratic graphene nanosheets to agglomerate in an orderly manner, forming 2-11 graphene layer nanoloops, while polar aromatic compounds induced high dispersion or aggregation of the graphene nanosheets. This phase conversion of the nanosized materials after sorption occurred through coassembly of the aromatic molecules and the single-layer graphene nanosheets via large-area π-π interactions. An adsorption-induced partition mechanism was further proposed to explain the nanosize effect and nanoscale sorption sites observed. This study indicates that commonly available biomass can be converted to graphene-like material with superhigh sorption ability in order to remove pollutants from the environment via nanosize effects and a coassembly mechanism.
| S-EPMC6434681 | biostudies-literature
Project description:The presented data shows how cornstarch can be modified to a material that can effectively remove organics pollutants from a real wastewater. A low-cost adsorbent obtained from cornstarch by the crosslinking with epichlorohydrin. The prepared crossed linked starch (CLS) adsorbent characterized by X-ray diffraction, zeta potential, Fourier-transform infrared spectroscopy, atomic force microscopy, scanning electron microscopy, and Brunauer-Emmett-Teller surface area. The effects of initial chemical oxygen demand of the real wastewater, temperature and time of the adsorption of the organics on the prepared CLS were analyzed. The removal of the highest organics concentration was 89.85%. Langmuir and Freundlich isotherm models have been applied to investigate the adsorption equilibrium. The maximum adsorption capacity of the organics pollutants on the prepared CLS was 256.41?mg/g. Thermodynamic parameters show that the adsorption process of organics on CLS is more favorable at low temperature.
| S-EPMC6139389 | biostudies-literature
Project description:A leading challenge in drinking water treatment is to remove small-sized viruses from the water in a simple and efficient manner. Multi-walled carbon nanotubes (MWCNT) are new generation adsorbents with previously demonstrated potential as filter media to improve virus removal. This study therefore aimed to evaluate the field applicability of MWCNT-filters for virus removal in water containing natural organic matter (NOM) as co-solute to viruses, using batch equilibrium experiments. Contrary to previous studies, our results showed with MS2 bacteriophages single-solute systems that the affinity of MWCNT for MS2 was low, since after 3 h of equilibration only 4 log10 reduction value (LRV) of MS2 (20 mL at an initial concentration of 106 PFU MS2/mL) were reached. Single solute experiments with Suwannee river NOM (SRNOM) performed with environmentally-relevant concentrations showed MWCNT surface saturation at initial SRNOM concentrations between 10 and 15 mgC/L, for water pH between 5.2 and 8.7. These results suggested that at NOM:virus ratios found in natural waters, the NOM would competitively suppress virus adsorption onto MWCNT, even at low NOM concentrations. We confirmed this expectation with SRNOM-MS2 co-solute experiments, which showed an exponential decrease of the MS2 LRV by MWCNT with an increase in the initial SRNOM concentration. More interestingly, we showed that pre-equilibrating MWCNT with a SRNOM solution at a concentration as low as 0.4 mgC/L resulted in a LRV decrease of 3 for MS2, due to the formation of a negatively charged SRNOM adlayer on the MWCNT surface. Complementary batch experiments with natural NOM-containing waters and competition experiments with SRNOM in the presence of CaCl2 confirmed that the presence of NOM in waters challenges virus removal by MWCNT-filters, irrespective of the concentration and type of NOM and also in the presence of Ca2+. We therefore conclude that MWCNT-filters produced with commercially available pristine MWCNT cannot be considered as a viable technology for drinking water virus removal.
| S-EPMC7322093 | biostudies-literature
Project description:Transcriptional profiling of rat adipose tissue and skeletal muscle submitted to high fat diets made with either crude (HFC) or refined salmon oil (HFR). Keywords: transcriptomic analysis
2018-04-20 | GSE14968 | GEO
Project description:Oil/water separation is a field of high significance as it might efficiently resolve the contamination of industrial oily wastewater and other oil/water pollution. In this paper, an environmentally-friendly hydrophobic aerogel with high porosity and low density was successfully synthesized with renewable pomelo peels (PPs) as precursors. Typically, a series of sponge aerogels (HPSA-0, HPSA-1 and HPSA-2) were facilely prepared via high-speed dispersion, freeze-drying and silanization with methyltrimethoxysilane. Indeed, the physical properties of aerogel such as density and pore diameter could be tailored by different additives (filter paper fibre and polyvinyl alcohol). Hence, their physico-chemical properties including internal morphology and chemical structure were characterized in detail by Fourier transform infrared, Brunauer-Emmett-Teller, X-ray diffraction, scanning electron microscope, Thermal gravimetric analyzer (TG) etc. Moreover, the adsorption capacity was further determined and the results revealed that the PP-based aerogels presented excellent adsorption performance for a wide range of oil products and/or organic solvents (crude oil 49.8 g g-1, soya bean oil 62.3 g g-1, chloroform 71.3 g g-1 etc.). The corresponding cyclic tests showed the absorption capacity decreased slightly from 94.66% to 93.82% after 10 consecutive cycles, indicating a high recyclability.
| S-EPMC6408386 | biostudies-literature
Project description:This series of two papers is devoted to the effect of organic dye (methylene blue, MB; or methyl orange, MO) adsorption on the surface of either bare or citrate-coated magnetic iron oxide nanoparticles (IONPs) on their primary agglomeration (in the absence of an applied magnetic field) and secondary field-induced agglomeration. The present paper (Part I) is focused on physicochemical mechanisms of dye adsorption and adsorption-induced primary agglomeration of IONPs. Dye adsorption to oppositely charged IONPs is found to be mostly promoted by electrostatic interactions and is very sensitive to pH and ionic strength variations. The shape of adsorption isotherms is correctly reproduced by the Langmuir law. For the particular MB/citrated IONP pair, the maximum surface density of adsorbed MB seems to correspond to the packing density of an adsorbed monolayer rather than to the surface density of the available adsorption sites. MB is shown to form H-aggregates on the surface of citrate-coated IONPs. The effective electric charge on the IONP surface remains nearly constant in a broad range of surface coverages by MB due to the combined action of counterion exchange and counterion condensation. Primary agglomeration of IONPs (revealed by an exponential increase of hydrodynamic size with surface coverage by MB) probably comes from correlation attractions or π-stacking aromatic interactions between adsorbed MB molecules or H-aggregates. From the application perspective, the maximum adsorption capacity is 139 ± 4 mg/g for the MB/citrated IONP pair (pH = 4-11) and 257 ± 16 mg/g for the MO/bare IONP pair (pH ∼ 4). Citrated IONPs have shown a good potential for their reusability in water treatment, with the adsorption efficiency remaining about 99% after nine adsorption/desorption cycles.
| S-EPMC8320151 | biostudies-literature
Project description:The studies on microplastics are significant in the world. According to the literature, microplastics have greatly specific surface areas, indicating high adsorption capacities for highly toxic pollutants in aquatic and soil environments, and these could be used as adsorbents. The influencing factors of microplastic adsorption, classification of microplastics, and adsorption mechanisms using microplastics for adsorbing organic, inorganic, and mixed pollutants are summarized in the paper. Furthermore, the influence of pH, temperature, functional groups, aging, and other factors related to the adsorption performances of plastics are discussed in detail. We found that microplastics have greater advantages in efficient adsorption performance and cost-effectiveness. In this paper, the adsorptions of pollutants by microplastics and their performance is proposed, which provides significant guidance for future research in this field.
| S-EPMC9268391 | biostudies-literature
Project description:Genome-wide DNA methylation profiling was performed in human mesenchymal stem cells (hMSCs) differentiated into adipocytes (day 10) while being continuously exposed to either one of three different persistent organic pollutants (POPs), namely TCDD, PFOS, and TBT. The Illumina Infinium 450K Human DNA methylation Beadchip v1.2 was used to measure DNA methylation of unexposed differentiated adipocytes and compared to POP-exposed differentiated adipocytes. Our aims were to 1) measure genome-wide DNA methylation changes upon POP exposure during adipocyte differentiation in primary hMSCs and 2) investigate the relationship between DNA methylation and gene expression regulation after POP-exposure in a panel of 84 adipocyte-related genes.
2016-12-27 | GSE75133 | GEO