A Carrier Estimation Method Based on MLE and KF for Weak GNSS Signals.
Ontology highlight
ABSTRACT:
SUBMITTER: Zhang H
PROVIDER: S-EPMC5539747 | biostudies-other | 2017 Jun
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Spoofing attacks are threatening the global navigation satellite system (GNSS). The maximum likelihood estimation (MLE)-based positioning technique is a direct positioning method originally developed for multipath rejection and weak signal processing. We find this method also has a potential ability for GNSS anti-spoofing since a spoofing attack that misleads the positioning and timing result will cause distortion to the MLE cost function. Based on the method, an estimation-cancellation approach is presented to detect spoofing attacks and recover the navigation solution. A statistic is derived for spoofing detection with the principle of the generalized likelihood ratio test (GLRT). Then, the MLE cost function is decomposed to further validate whether the navigation solution obtained by MLE-based positioning is formed by consistent signals. Both formulae and simulations are provided to evaluate the anti-spoofing performance. Experiments with recordings in real GNSS spoofing scenarios are also performed to validate the practicability of the approach. Results show that the method works even when the code phase differences between the spoofing and authentic signals are much less than one code chip, which can improve the availability of GNSS service greatly under spoofing attacks.
| S-EPMC5539650 | biostudies-other
Project description:The Global Navigation Satellite System is vulnerable to interference signals that can potentially disable the system, because the signal strength tends to be very weak. Interference such as jamming, which disables the receiver via excessively high signal strength in the satellite navigation frequency band, and spoofing, which induces the receiver to output erroneous position and time data via signals similar to actual navigation signals, disrupt satellite navigation systems. As the threat of interference is increasing, considerable research effort has been expended in an attempt to deal with it in various ways. Spoofing attacks are especially difficult to detect. This paper deals with a technique to detect a spoofing signal and to mitigate attacks on satellite navigation systems. The satellite navigation signal is influenced by the navigation satellite itself and errors due to environmental factors, and spoofing signal detection should be well reflected in the navigation signal. Especially, in the case of mobile receivers, it is not easy to detect a spoofing signal because the exact position of the receiver cannot be known. To detect a spoofing signal, additional hardware may be required; in some cases, heterogeneous sensors, such as inertial sensors, may be used. The technique introduced in this paper effectively discriminates spoofing signals based only on receiver measurements, without the need for additional devices. It generates test statistics based on the pseudorange, which is the measured value of the receiver position, and detects spoofing signals by setting the monitoring interval according to a "sliding window". Because the proposed method uses output data and measurements obtained from the receiver, it can be applied to general receivers at low cost.
| S-EPMC7454987 | biostudies-literature
Project description:This study presented a method of quantifying the manoeuvrability of two field-based team sport athletes and investigated its relationship with running velocity during competition. Across a season, 10 Hz Global navigation satellite system (GNSS) devices were worn during matches by 62 athletes (Australian Football League [AFL]; n = 36, 17 matches, National Rugby League [NRL]; n = 26, 21 matches). To quantify manoeuvrability, tortuosity was calculated from the X and Y coordinates from match GNSS files (converted from latitude and longitude). Tortuosity was calculated as 100 x natural logarithm of the chord distance (distance travelled between X and Y coordinates), divided by the straight-line distance. The maximal tortuosity was then quantified for each 0.5 m∙s-1 speed increment, ranging from 0 to the highest value for each game file. A quadratic model was fitted for each match file, controlling for the curvilinear relationship between tortuosity and velocity. A comparison of the quadratic coefficients between sports, and within sport between positions was investigated using linear mixed models. Resulting standard deviations (SDs) and mean differences were then assessed to establish standardized effect sizes (ES) and 90% confidence intervals (CI). A curvilinear relationship exists between maximal tortuosity and running speed, reflecting that as speed increases, athletes' ability to deviate from a linear path is compromised (i.e., run in a more linear path). Compared to AFL, NRL had a greater negative quadratic coefficient (a) (ES = 0.70; 0.47 to 0.93) for the 5 second analysis, meaning that as speed increased, NRL athletes' manoeuvrability reduced at a faster rate than when compared to AFL. There were no positional differences within each sport. GNSS derived information can be used to provide a measure of manoeuvrability tortuosity during NRL and AFL matches. The curvilinear relationship between tortuosity and speed demonstrated that as speed increased, manoeuvrability was compromised.
| S-EPMC8604331 | biostudies-literature
Project description:With the increase in GNSS user base, the studies of threats and vulnerabilities of GNSS system are also increased. Among the threats, spoofing is of particular interest because of the risk associated with it. The studies on spoofing are generally limited to simulated scenarios as the real world spoofing attack is very difficult to create or spot and record for analysis. This paper presents a method of generating baseband spoofing data using real world signals by simultaneous recordings of GNSS signals using two separate receivers, where one of them simulates the receiver under attack and the other simulates the response the spoofer will be going to produce to fabricate the attack. After taking the records and merging them to create the spoofing baseband signals, it is checked against several spoofing detection methods to verify the valid spoofing attack being present in the signal. This method produces the signal recordings that have real world disturbances in it that may be difficult to simulate. The developed method has the following advantages: •It does not require very expensive hardware to produce an intermediate spoofing signal.•The user has control over the spoofing power advantage.•The same scenario can be reproduced with varying parameters.
| S-EPMC6197700 | biostudies-literature
Project description:Nowadays, civil Global Navigation Satellite System (GNSS) signals are available in both L1 and L5 bands. A receiver does not need to acquire independently the signals in both bands coming from a same satellite, since their carrier Doppler and code delay are closely related. Therefore, the question of which one to acquire first rises naturally. Although the common thought would tell the L1 band signals which are narrowband, an accurate comparison has never been done, and the decision is not as easy as it seems. Indeed, L5 band signals have several advantages such as stronger power, lower carrier Doppler, or a pilot channel, unlike the Global Positioning System (GPS) L1 C/A signal. The goal of this paper is therefore to compare the acquisition of L1 and L5 bands signals (GPS L1 C/A and L5, Galileo E1 and E5a/b) to determine which one is more complex and by which factor, in terms of processing time and memory, considering hardware receivers and the parallel code search. The results show that overall the L5 band signals are more complex to acquire, but it depends strongly on the conditions. The E5 signal is always more complex to acquire than E1, while the L5 signal can have a complexity close to the L1 C/A in some cases. Moreover, precise assistance providing accurate Doppler could significantly reduce the L5 complexity below the L1 complexity.
| S-EPMC6165328 | biostudies-literature
Project description:Ultrasonic attenuation is important not only as a parameter for characterizing tissue but also for compensating other parameters that are used to classify tissues. Several techniques have been explored for estimating ultrasonic attenuation from backscattered signals. In the present study, a technique is developed to estimate the local ultrasonic attenuation coefficient by analyzing the time domain backscattered signal. The proposed method incorporates an objective function that combines the diffraction pattern of the source/receiver with the attenuation slope in an integral equation. The technique was assessed through simulations and validated through experiments with a tissue mimicking phantom and fresh rabbit liver samples. The attenuation values estimated using the proposed technique were compared with the attenuation estimated using insertion loss measurements. For a data block size of 15 pulse lengths axially and 15 beamwidths laterally, the mean attenuation estimates from the tissue mimicking phantoms were within 10% of the estimates using insertion loss measurements. With a data block size of 20 pulse lengths axially and 20 beamwidths laterally, the error in the attenuation values estimated from the liver samples were within 10% of the attenuation values estimated from the insertion loss measurements.
| S-EPMC3407163 | biostudies-other
Project description:Because the traditional Cholesky decomposition algorithm still has some problems such as computational complexity and scattered structure among matrices when solving the GNSS ambiguity, it is the key problem to further improve the computational efficiency of the least squares ambiguity reduction correlation process in the carrier phase integer ambiguity solution. But the traditional matrix decomposition calculation is more complex and time-consuming, to improve the efficiency of the matrix decomposition, in this paper, the decomposition process of traditional matrix elements is divided into two steps: multiplication update and column reduction of square root calculation. The column reduction step is used to perform square root calculation and column division calculation, while the update step is used for the update task of multiplication. Based on the above ideas, the existing Cholesky decomposition algorithm is improved, and a column oriented Cholesky (C-Cholesky) algorithm is proposed to further improve the efficiency of matrix decomposition, so as to shorten the calculation time of integer ambiguity reduction correlation. The results show that this method is effective and superior, and can improve the data processing efficiency by about 12.34% on average without changing the integer ambiguity accuracy of the traditional Cholesky algorithm.
| S-EPMC10023790 | biostudies-literature
Project description:Deconvolution is typically used to sharpen fluorescence images, but when the signal-to-noise ratio is low, the primary benefit is reduced noise and a smoother appearance of the fluorescent structures. 3D time-lapse (4D) confocal image sets can be improved by deconvolution. However, when the confocal signals are very weak, the popular Huygens deconvolution software erases fluorescent structures that are clearly visible in the raw data. We find that this problem can be avoided by prefiltering the optical sections with a Gaussian blur. Analysis of real and simulated data indicates that the Gaussian blur prefilter preserves meaningful signals while enabling removal of background noise. This approach is very simple, and it allows Huygens to be used with 4D imaging conditions that minimize photodamage.
| S-EPMC5553083 | biostudies-literature
Project description:Blood pressure measurements are one of the most routinely performed medical tests globally. Blood pressure is an important metric since it provides information that can be used to diagnose several vascular diseases. Conventional blood pressure measurement systems use cuff-based devices to measure the blood pressure, which may be uncomfortable and sometimes burdensome to the subjects. Therefore, in this study, we propose a cuffless blood pressure estimation model based on Monte Carlo simulation (MCS). We propose a heterogeneous finger model for the MCS at wavelengths of 905 nm and 940 nm. After recording the photon intensities from the MCS over a certain range of blood pressure values, the actual photoplethysmography (PPG) signals were used to estimate blood pressure. We used both publicly available and self-made datasets to evaluate the performance of the proposed model. In case of the publicly available dataset for transmission-type MCS, the mean absolute errors are 3.32 ± 6.03 mmHg for systolic blood pressure (SBP), 2.02 ± 2.64 mmHg for diastolic blood pressure (DBP), and 1.76 ± 2.8 mmHg for mean arterial pressure (MAP). The self-made dataset is used for both transmission- and reflection-type MCSs; its mean absolute errors are 2.54 ± 4.24 mmHg for SBP, 1.49 ± 2.82 mmHg for DBP, and 1.51 ± 2.41 mmHg for MAP in the transmission-type case as well as 3.35 ± 5.06 mmHg for SBP, 2.07 ± 2.83 mmHg for DBP, and 2.12 ± 2.83 mmHg for MAP in the reflection-type case. The estimated results of the SBP and DBP satisfy the requirements of the Association for the Advancement of Medical Instrumentation (AAMI) standards and are within Grade A according to the British Hypertension Society (BHS) standards. These results show that the proposed model is efficient for estimating blood pressures using fingertip PPG signals.
| S-EPMC8838459 | biostudies-literature
Project description:Global Navigation Satellite System (GNSS) is used in seismology to study the ground displacements as well as to monitor the ionospheric total electron content (TEC) perturbations following seismic events. The aim of this work is to combine these two observations in one real-time method based on the Total Variometric Approach (TVA) to include the GNSS real-time data stream in future warning systems and tsunami genesis estimation observing both, ground motion and TEC. Our TVA couples together the Variometric Approach for Displacement Analysis Stand-alone Engine (VADASE) with the Variometric Approach for Real-Time Ionosphere Observation (VARION) algorithms. We apply the TVA to the Mw 8.3 Illapel earthquake, that occurred in Chile on September 16, 2015, and we demonstrate the coherence of the earthquake ground shaking and the TEC perturbation by using the same GNSS data stream in a real-time scenario. Nominally, we also highlight a stronger kinetic energy released in the north of the epicenter and visible in both, the ground motion and the TEC perturbation detect at 30 s and around 9.5 min after the rupture respectively. The high spatial resolution of ionospheric TEC measurement seems to match with the extent of the seismic source. The GNSS data stream by TVA of both the ground and ionospheric measurement opens today new perspectives to real-time warning systems for tsunami genesis estimation.
| S-EPMC7862306 | biostudies-literature