Browse
Submit Data
Databases
API
Help

Dataset Information

0 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Trimethylamine Sensors Based on Au-Modified Hierarchical Porous Single-Crystalline ZnO Nanosheets.

ABSTRACT: It is of great significance for dynamic monitoring of foods in storage or during the transportation process through on-line detecting trimethylamine (TMA). Here, TMA were sensitively detected by Au-modified hierarchical porous single-crystalline ZnO nanosheets (HPSCZNs)-based sensors. The HPSCZNs were synthesized through a one-pot wet-chemical method followed by an annealing treatment. Polyethyleneimine (PEI) was used to modify the surface of the HPSCZNs, and then the PEI-modified samples were mixed with Au nanoparticles (NPs) sol solution. Electrostatic interactions drive Au nanoparticles loading onto the surface of the HPSCZNs. The Au-modified HPSCZNs were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and energy dispersive spectrum (EDS), respectively. The results show that Au-modified HPSCZNs-based sensors exhibit a high response to TMA. The linear range is from 10 to 300 ppb; while the detection limit is 10 ppb, which is the lowest value to our knowledge.

SUBMITTER: Meng F

PROVIDER: S-EPMC5539823 | biostudies-other | 2017 Jun

REPOSITORIES: biostudies-other

ACCESS DATA

Json Xml

Similar Datasets

Hierarchical assembly of ZnO nanowire trunks decorated with ZnO nanosheets for lithium ion battery anodes.

Project description:Hierarchical architectures composed of nanomaterials in different forms are essential to improve the performance of lithium-ion battery (LIB) anodes. Here, we systematically studied the effects of hierarchical ZnO nanostructures on the electrochemical performance of LIBs. ZnO nanowire (NW) trunks were decorated with ZnO NWs or ZnO nanosheets (NSs) by successive hydrothermal synthesis to create hierarchical three-dimensional nanostructures. The branched ZnO NSs on the ZnO NW trunk exhibited a two-fold higher specific gravimetric capacity compared to ZnO NWs and branched ZnO NWs on ZnO NW trunks after 100 cycles of charging-discharging at 0.2C (197.4 mA g-1). The improvement in battery anode performance is attributable to the increased interfacial area between the electrodes and electrolyte, and the void space of the branched NSs that facilitates lithium ion transport and volume changes during cycling.

| S-EPMC9051539 | biostudies-literature

A facile synthesis of Au-nanoparticles decorated PbI<sub>2</sub> single crystalline nanosheets for optoelectronic device applications.

Project description:This research communication presents a rapid and facile microwave-assisted synthesis of single crystalline nanosheets (SCNSs) of hexagonal lead iodide (PbI2) decorated with Au nanoparticles, a potential optoelectronics material. Homogeneous low dimensional AuNP decoration in PbI2 resulted in a new absorption band at ~604?nm and a shift in band gap from 3.23 to 3.00?eV. The significant enhancement of photoluminescent (PL) intensity observed in the AuNP-PbI2 SCNSs is attributed to the coupling of the localized surface plasmon resonanzce of AuNP leading to improved excitation and emission rates of PbI2-SCNSs in the region of the localized electromagnetic field. The Au-PbI2 SCNSs display a compelling increment in photoconductivity, and its fabricated photodetector showed a stable and switchable photo-response. Due to ease of synthesis and enhanced photoconductivity along with appealing PL features, Au-PbI2 SCNS has the potential to be used as a material of choice when fabricating an optoelectronic devices of high performance.

| S-EPMC6138657 | biostudies-literature

Single-Crystalline Rhodium Nanosheets with Atomic Thickness.

Project description:CO confinement strategy for ultrathin Rh nanosheets: CO is introduced as a confining agent to regulate the anisotropic growth of unique 2D structure. The single-crystalline Rh nanosheets have a thickness of three to five atomic layers and tunable edge length ranging from 500 to 1300 nm. By understanding the formation mechanism, surface-clean Rh nanosheets are also prepared and display better catalytic performance that their surfactant-capped nanosheets.

| S-EPMC5115410 | biostudies-literature

Epitaxially Integrated Hierarchical ZnO/Au/SrTiO3 and ZnO/Ag/Al2O3 Heterostructures: Three-Dimensional Plasmo-Photonic Nanoarchitecturing.

Project description:In this study, we fabricated three-dimensional (3D) hierarchical plasmo-photonic nanoarchitectures by epitaxially integrating semiconducting zinc oxide (ZnO) nanowires with vertically oriented plasmonic gold (Au) and silver (Ag) nanoplatforms and investigated their growth mechanisms in detail. We synthesized 3D hierarchical Au-ZnO nanostructures via a vapor-solid mechanism leading to the epitaxial growth of ZnO nanowires on vertically oriented single-crystalline Au nanowires on a strontium titanate (SrTiO3) substrate. The elongated half-octahedral Au nanowires with a rhombus cross-section were transformed into thermodynamically stable elongated cuboctahedral Au nanowires with a hexagonal cross-section during the reaction. After the transformation, ZnO thin films with six twinned domains were formed on the side planes of the elongated cuboctahedral Au nanowire trunks, and six ZnO nanowire branches were grown on the ZnO thin films. Further, 3D hierarchical Ag-ZnO nanostructures were obtained via the same vapor-solid mechanism leading to the epitaxial growth of ZnO nanowires on vertically oriented Ag nanoplates on an aluminum oxide (Al2O3) substrate. Therefore, the growth mechanism developed herein can be generally employed to fabricate 3D hierarchical plasmo-photonic nanoarchitectures.

| S-EPMC8706281 | biostudies-literature

Imparting amphiphobicity on single-crystalline porous materials.

Project description:The sophisticated control of surface wettability for target-specific applications has attracted widespread interest for use in a plethora of applications. Despite the recent advances in modification of non-porous materials, surface wettability control of porous materials, particularly single crystalline, remains undeveloped. Here we contribute a general method to impart amphiphobicity on single-crystalline porous materials as demonstrated by chemically coating the exterior of metal-organic framework (MOF) crystals with an amphiphobic surface. As amphiphobic porous materials, the resultant MOF crystals exhibit both superhydrophobicity and oleophobicity in addition to retaining high crystallinity and intact porosity. The chemical shielding effect resulting from the amphiphobicity of the MOFs is illustrated by their performances in water/organic vapour adsorption, as well as long-term ultrastability under highly humidified CO2 environments and exceptional chemical stability in acid/base aqueous solutions. Our work thereby pioneers a perspective to protect crystalline porous materials under various chemical environments for numerous applications.

| S-EPMC5095586 | biostudies-literature

Single-crystalline ZnO sheet Source-Gated Transistors.

Project description:Due to their fabrication simplicity, fully compatible with low-cost large-area device assembly strategies, source-gated transistors (SGTs) have received significant research attention in the area of high-performance electronics over large area low-cost substrates. While usually based on either amorphous or polycrystalline silicon (α-Si and poly-Si, respectively) thin-film technologies, the present work demonstrate the assembly of SGTs based on single-crystalline ZnO sheet (ZS) with asymmetric ohmic drain and Schottky source contacts. Electrical transport studies of the fabricated devices show excellent field-effect transport behaviour with abrupt drain current saturation (IDS(SAT)) at low drain voltages well below 2 V, even at very large gate voltages. The performance of a ZS based SGT is compared with a similar device with ohmic source contacts. The ZS SGT is found to exhibit much higher intrinsic gain, comparable on/off ratio and low off currents in the sub-picoamp range. This approach of device assembly may form the technological basis for highly efficient low-power analog and digital electronics using ZnO and/or other semiconducting nanomaterial.

| S-EPMC4725757 | biostudies-other

Enhanced Response for Foodborne Pathogens Detection by Au Nanoparticles Decorated ZnO Nanosheets Gas Sensor.

Project description:Listeria monocytogenes is a hazardous foodborne pathogen that is able to cause acute meningitis, encephalitis, and sepsis to humans. The efficient detection of 3-hydroxy-2-butanone, which has been verified as a biomarker for the exhalation of Listeria monocytogenes, can feasibly evaluate whether the bacteria are contained in food. Herein, we developed an outstanding 3-hydroxy-2-butanone gas sensor based on the microelectromechanical systems using Au/ZnO NS as a sensing material. In this work, ZnO nanosheets were synthesized by a hydrothermal reaction, and Au nanoparticles (~5.5 nm) were prepared via an oleylamine reduction method. Then, an ultrasonic treatment was carried out to modified Au nanoparticles onto ZnO nanosheets. The XRD, BET, TEM, and XPS were used to characterize their morphology, microstructure, catalytic structure, specific surface area, and chemical composition. The response of the 1.0% Au/ZnO NS sensors vs. 25 ppm 3-hydroxy-2-butanone was up to 174.04 at 230 °C. Moreover, these sensors presented fast response/recovery time (6 s/7 s), great selectivity, and an outstanding limit of detection (lower than 0.5 ppm). This work is full of promise for developing a nondestructive, rapid and practical sensor, which would improve Listeria monocytogenes evaluation in foods.

| S-EPMC9599186 | biostudies-literature

Variations in Crystalline Structures and Electrical Properties of Single Crystalline Boron Nitride Nanosheets.

Project description:We report the studies of (1) the basic mechanism underlying the formation of defect-free, single crystalline boron nitride nanosheets (BNNSs) synthesized using pulsed laser plasma deposition (PLPD) technique, (2) the variation in the crystalline structure at the edges of the hexagonal boron nitride (h-BN) nanosheets, and (3) the basic electrical properties related to the BNNSs tunneling effect and electrical breakdown voltage. The nanoscale morphologies of BNNSs are characterized using scanning electron microscope (SEM) and high-resolution transmission electron microscope (HRTEM). The results show that each sample consisted of a number of transparent BNNSs that partially overlapped one another. Varying the deposition duration yielded different thicknesses of sample but did not affect the morphology, structure, and thickness of individual BNNSs pieces. Analysis of the SEM and HRTEM data revealed changes in the spatial period of the B3-N3 hexagonal structures and the interlayer distance at the edge of the BNNSs, which occurred due to the limited number of atomic layers and was confirmed further by x-ray diffraction (XRD) study. The experimental results clearly indicate that the values of the electrical conductivities of the super-thin BNNSs and the effect of temperature relied strongly on the direction of observation.

| S-EPMC4643278 | biostudies-other

Improved sensitivity of polychlorinated-biphenyl-orientated porous-ZnO surface photovoltage sensors from chemisorption-formed ZnO-CuPc composites.

Project description:We report a new mechanism for the enhancement of porous-ZnO surface photovoltage (SPV) response to polychlorinated biphenyls (PCBs, a notorious class of persistent organic pollutants as global environmental hazard) based on copper phthalocyanine (CuPc) chemisorptive bonding on porous-ZnO. A new ZnO-CuPc composite is formed on the porous-ZnO surface due to the interaction between the surface ZnO and CuPc, with its valence band (VB) energy level being higher than that of the pristine porous-ZnO. So that the efficiency of the photogenerated-electron transfer from the composite VB to the adjacent ZnO's surface states is drastically increased due to the reduced energy gap between the transition states. As a result, the sensitivity of the PCB-orientated SPV sensor is much improved by showing amplified variation of the SPV-signals perturbed by PCBs adsorbed on the ZnO-CuPc@porous-ZnO sensitive material.

| S-EPMC3942701 | biostudies-literature

Ultrathin Single-Crystalline Boron Nanosheets for Enhanced Electro-Optical Performances.

Project description:Large-scale single-crystalline ultrathin boron nanosheets (UBNSs, ≈10 nm) are fabricated through an effective vapor-solid process via thermal decomposition of diborane. The UBNSs have obvious advantages over thicker boron nanomaterials in many aspects. Specifically, the UBNSs demonstrate excellent field emission performances with a low turn-on field, Eto, of 3.60 V μm-1 and a good stability. Further, the dependence of (turn-on field) Eto/(threshold field) Ethr and effective work function, Φe, on temperature is investigated and the possible mechanism of temperature-dependent field emission phenomenon has been discussed. Moreover, electronic transport in a single UBNS reveals it to be an intrinsic p-type semiconductor behavior with carrier mobility about 1.26 × 10-1 cm2 V-1 s-1, which is the best data in reported works. Interestingly, a multiconductive mechanism coexisting phenomenon has been explored based on the study of temperature-dependent conductivity behavior of the UBNSs. Besides, the photodetector device fabricated from single-crystalline UBNS demonstrates good sensitivity, reliable stability, and fast response, obviously superior to other reported boron nanomaterials. Such superior electronic-optical performances are originated from the high quality of single crystal and large specific surface area of the UBNSs, suggesting the potential applications of the UBNSs in field-emitters, interconnects, integrated circuits, and optoelectronic devices.

| S-EPMC5115407 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data