Dynamics of nano-confined water in Portland cement - comparison with synthetic C-S-H gel and other silicate materials.
Ontology highlight
ABSTRACT:
SUBMITTER: Goracci G
PROVIDER: S-EPMC5557859 | biostudies-other | 2017 Aug
REPOSITORIES: biostudies-other
Similar Datasets
Project description:This paper systematically studied the modification of cement-based materials by nano-SiO? particles with an average diameter of about 20 nm. In order to obtain the effect of nano-SiO? particles on the mechanical properties, hydration, and pore structure of cement-based materials, adding 1%, 3%, and 5% content of nano-SiO? in cement paste, respectively. The results showed that the reaction of nano-SiO? particles with Ca(OH)? (crystal powder) started within 1 h, and formed C-S-H gel. The reaction speed was faster after aging for three days. The mechanical properties of cement-based materials were improved with the addition of 3% nano-SiO?, and the early strength enhancement of test pieces was obvious. Three-day compressive strength increased 33.2%, and 28-day compressive strength increased 18.5%. The exothermic peak of hydration heat of cement increased significantly after the addition of nano-SiO?. Appearance time of the exothermic peak was advanced and the total heat release increased. Thermogravimetric-differential scanning calorimetry (TG-DSC) analysis showed that nano-SiO? promoted the formation of C-S-H gel. The results of mercury intrusion porosimetry (MIP) showed that the total porosity of cement paste with 3% nano-SiO? was reduced by 5.51% and 5.4% at three days and 28 days, respectively, compared with the pure cement paste. At the same time, the pore structure of cement paste was optimized, and much-detrimental pores and detrimental pores decreased, while less harmful pores and innocuous pores increased.
| S-EPMC5302711 | biostudies-literature
Project description:Due to the toxicity and mobility of chromium, the disposal of chromium-containing waste is a pressing issue. Co-processing of chromium-containing waste in a cement kiln is currently one of the most effective methods. However, the presence of water-soluble hexavalent chromium (Cr(VI)) in cement limits the use of this method. In this study, Na2CO3 was used to simulate alkali in industrial raw materials to investigate the pattern of influence of alkali content on water-soluble hexavalent chromium. The mechanisms associated with the oxidation and dissolution of chromium were investigated using X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and inductively coupled plasma emission spectrometry (ICP-OES). The proportion of Cr(VI) in the clinker detected by XPS increased rapidly with increasing alkali content. In the cement slurry system, alkali promotes more hexavalent chromium leaching by influencing pH and other ion concentrations (Ca2+, SO42-). Therefore, the addition of alkali to either the raw meal or to the cement slurry system will favour an increase in the water-soluble Cr(VI) content. This study may provide theoretical guidance for the preparation and use of clinkers containing chromium.
| S-EPMC9025607 | biostudies-literature
Project description:Portland cement emits bright near-infrared photoluminescence that can be excited by light wavelengths ranging from at least 500-1000 nm. The emission has a peak wavelength near 1140 nm and a width of approximately 30 nm. Its source is suggested to be small particles of silicon associated with calcium silicate phases. The luminescence peak wavelength appears independent of the cement hydration state, aggregates, and mechanical strain but increases weakly with increasing temperature. It varies slightly with the type of cement, suggesting a new non-contact method for identifying cement formulations. After a thin opaque coating is applied to a cement or concrete surface, subsequent formation of microcracks exposes the substrate's near-infrared emission, revealing the fracture locations, pattern, and progression. This damage would escape detection in normal imaging inspections. Near-infrared luminescence imaging may therefore provide a new tool for non-destructive testing of cement-based structures.
| S-EPMC8786940 | biostudies-literature
Project description:Confined water has been proven to be of great importance due to its pervasiveness and contribution to life and many fields of scientific research. However, the control and characterization of confined water are a challenge. Herein, a confined space is constructed by flexibly changing the pH of a graphene oxide dispersion under the self-assembly process of a graphene hydrogel (GH), and the confined space is adjusted with variation from 10.04 to 3.52 nm. Confined water content in GH increases when the pore diameter of the confined space decreases; the corresponding adsorption capacity increases from 243.04 to 442.91 mg g-1. Moreover, attenuated total reflectance Fourier transform infrared spectroscopy and Raman spectroscopy are utilized to analyze the hydrogen bonding structure qualitatively and quantitatively, and correlation analysis reveals that the improvement in the adsorption capacity is caused by incomplete hydrogen bonding in the confined water. Further, confined water is assembled into four typical porous commercial adsorbents, and a remarkable enhancement of the adsorption capacity is achieved. This research demonstrates the application potential for the extraordinary properties of confined water and has implications for the development of highly effective confined water-modified adsorbents.
| S-EPMC7770964 | biostudies-literature
Project description:The effect of confinement on the dynamical properties of liquid water was studied by mid-infrared ultrafast pump-probe spectroscopy on HDO:D2O in reverse micelles. By preparing water-containing reverse micelles of different well defined sizes, we varied the degree of geometric confinement in water nanodroplets with radii ranging from 0.2 to 4.5 nm. We find that water molecules located near the interface confining the droplet exhibit slower vibrational energy relaxation and have a different spectral absorption than those located in the droplet core. As a result, we can measure the orientational dynamics of these different types of water with high selectivity. We observe that the water molecules in the core show similar orientational dynamics as bulk water and that the water layer solvating the interface is highly immobile.
| S-EPMC1592463 | biostudies-literature
Project description:The mechanical properties of calcium-silicate-hydrate (C-S-H) gels in cementitious materials are mainly realized by nanoindentation experiments. There is limited research on the dynamic response of the molecular structure of C-S-H under nanoindentation conditions. This study simulated the nanoindentation on the C-S-H gel samples by the molecular dynamics method considering the essential factors of modeling and loading process. The results demonstrate that the averaged elastic moduli we obtained had slight differences from those by experiments. In contrast to the experimental results, the gels showed bi-modulus and transverse isotropic with the material principal direction perpendicular to the C-S-H layers. The modulus in a direction increased with the loading speed, which indicates that C-S-H behaves viscous due to the water motion in the sample and the propagation of stress wave. The saturation of water influenced the moduli differently because more water in C-S-H will reduce the polymerization of silicon chains and then weaken the local stiffness. The conclusions provide a deeper understanding of the mechanism on the unique mechanical response of C-S-H gels.
| S-EPMC10536101 | biostudies-literature
Project description:The objective of this study is to assess whether the carbonation process can modify the physicochemical characteristics of the natural radionuclides of the three natural radioactive series, together with 40K. Three mortar specimens with different percentages of ground granulated blast-furnace slag (GGBFS), cured under water for 1, 3, 7, 14, or 28 days, were subjected to a natural carbonation process. Activity concentrations for the solid and ground mortars were determined by gamma spectrometry and by radiochemical separation of isotopic uranium. The novelty of this paper relies principally on the study we have carried out, for the first time, of the radiological characteristics of carbonated Portland cement mortars. It was found that the chemical properties of the 3 mortar specimens were not affected by the carbonation process, with particular attention placed on uranium (238U, 235U, and 234U), the activity concentrations of which were equivalent to the 226Ra results and ranged from 5.5 ± 1.6 Bq kg−1 to 21.4 ± 1.2 Bq kg−1 for the 238U. The average activity concentrations for the 3 types of mortars were lower than 20.1 Bq kg−1, 14.5 Bq kg−1, and 120.2 Bq kg−1 for the 226Ra, 232Th (212Pb), and 40K, respectively. Annual effective dose rates were equivalent to the natural background of 0.024 mSv. In addition, it was observed that the variation rate for the 222Rn emanation was due primarily to the Portland cement hydration and not due to the pore size redistribution as a consequence of the carbonation process. This research will provide new insights into the potential radiological risk from carbonated cement-based materials. Moreover, the assessment that is presented in this study will convey valuable information for future research that will explore the activity concentration of building materials containing NORM materials.
| S-EPMC9100595 | biostudies-literature
Project description:Hybrid cement has become one of the most viable options in the reduction of CO2 emissions to the environment that are generated by the cement industry. This could be explained by the reduction of the content of clinker in the final mixture and substitution of the remaining percentage with supplementary cementitious materials with the help of an alkaline activation. Following that, properties that are provided by an Ordinary Portland Cement and of a geopolymer are mixed in this type of hybrid material and could be achieved at room temperature. Thereafter, the main objective of this research was to synthesize hybrid cements reducing the clinker content of Portland Cement up to 20% and use metakaolin and fly ash as supplementary cementitious materials in different proportions. The mixtures were alkaline activated with a mixture of sodium silicate and sodium hydroxide, calculating the amounts according to the percentage of Na2O that is present in each of the activators. The samples were then characterized using Compressive strength, X-ray diffraction, Fourier Transform Infrared Spectroscopy, and Scanning Electron Microscopy with energy-dispersive X-ray spectroscopy. The results indicated that the hybrid cements have similar mechanical properties than an Ordinary Portland Cement, and they resulted in a dense matrix of hydration products similar to those that are generated by cements and geopolymers.
| S-EPMC7084432 | biostudies-literature
Project description:Water is characterized by large molecular electric dipole moments and strong interactions between molecules; however, hydrogen bonds screen the dipole-dipole coupling and suppress the ferroelectric order. The situation changes drastically when water is confined: in this case ordering of the molecular dipoles has been predicted, but never unambiguously detected experimentally. In the present study we place separate H2O molecules in the structural channels of a beryl single crystal so that they are located far enough to prevent hydrogen bonding, but close enough to keep the dipole-dipole interaction, resulting in incipient ferroelectricity in the water molecular subsystem. We observe a ferroelectric soft mode that causes Curie-Weiss behaviour of the static permittivity, which saturates below 10?K due to quantum fluctuations. The ferroelectricity of water molecules may play a key role in the functioning of biological systems and find applications in fuel and memory cells, light emitters and other nanoscale electronic devices.
| S-EPMC5056440 | biostudies-literature
Project description:The remarkable efficiency of chemical reactions is the result of biological evolution, often involving confined water. Meanwhile, developments of bio-inspired systems, which exploit the potential of such water, have been so far rather complex and cumbersome. Here we show that surface-confined water, inherently present in widely abundant and renewable cellulosic fibres can be utilised as nanomedium to endow a singular chemical reactivity. Compared to surface acetylation in the dry state, confined water increases the reaction rate and efficiency by 8 times and 30%, respectively. Moreover, confined water enables control over chemical accessibility of selected hydroxyl groups through the extent of hydration, allowing regioselective reactions, a major challenge in cellulose modification. The reactions mediated by surface-confined water are sustainable and largely outperform those occurring in organic solvents in terms of efficiency and environmental compatibility. Our results demonstrate the unexploited potential of water bound to cellulosic nanostructures in surface esterifications, which can be extended to a wide range of other nanoporous polymeric structures and reactions.
| S-EPMC8097012 | biostudies-literature