Development and evaluation of height diameter at breast models for native Chinese Metasequoia.
Ontology highlight
ABSTRACT:
SUBMITTER: Liu M
PROVIDER: S-EPMC5560716 | biostudies-other | 2017
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Six candidate height-diameter models were used to analyze the height-diameter relationships. The common methods for estimating the height-diameter models have taken the classical (frequentist) approach based on the frequency interpretation of probability, for example, the nonlinear least squares method (NLS) and the maximum likelihood method (ML). The Bayesian method has an exclusive advantage compared with classical method that the parameters to be estimated are regarded as random variables. In this study, the classical and Bayesian methods were used to estimate six height-diameter models, respectively. Both the classical method and Bayesian method showed that the Weibull model was the "best" model using data1. In addition, based on the Weibull model, data2 was used for comparing Bayesian method with informative priors with uninformative priors and classical method. The results showed that the improvement in prediction accuracy with Bayesian method led to narrower confidence bands of predicted value in comparison to that for the classical method, and the credible bands of parameters with informative priors were also narrower than uninformative priors and classical method. The estimated posterior distributions for parameters can be set as new priors in estimating the parameters using data2.
| S-EPMC3953559 | biostudies-other
Project description:Height:diameter ratios are an important measure of stand stability. Because of the importance of height:diameter ratios for forest management, individual-tree growth models should correctly depict height:diameter ratios. In particular, (i) height:diameter ratios should not exceed that of very dense stands, (ii) height:diameter ratios should not fall below that of open-grown trees, (iii) height:diameter ratios should decrease with increasing spacing, (iv) height:diameter ratios for suppressed trees should be higher than ratios for dominant trees. We evaluated the prediction of height:diameter ratios by running four commonly used individual-tree growth models in central Europe: BWIN, Moses, Silva and Prognaus. They represent different subtypes of individual-tree growth models, namely models with and without an explicit growth potential and models that are either distance-dependent (spatial) or distance-independent (non-spatial). Note that none of these simulators predict height:diameter ratios directly. We began by building a generic simulator that contained the relevant equations for diameter increment, height increment, and crown size for each of the four simulators. The relevant measures of competition, site characteristics, and stand statistics were also coded. The advantage of this simulator was that it ensured that no additional constraint was being imposed on the growth equations, and that initial conditions were identical. We then simulated growth for a 15- and 30-year period for Austrian permanent research plots in Arnoldstein and in Litschau, which represent stands at different age-classes and densities. We also simulated growth of open-grown trees and compared the results to the literature. We found that the general pattern of height:diameter ratios was correctly predicted by all four individual-tree growth models, with height:diameter ratios above that of open-grown trees and below that of very dense stands. All models showed a decrease of height:diameter ratios with age and an increase with stand density. Also, the height:diameter ratios of dominant trees were always lower than that of mean trees. Although in some cases the observed and predicted height:diameter ratios matched well, there were cases where discrepancies between observed and predicted height:diameter ratios would be unacceptable for practical management predictions.
| S-EPMC2987550 | biostudies-literature
Project description:Mobile laser scanning (MLS) is widely used in the mapping of forest environments. It has become important for extracting the parameters of forest trees using the generated environmental map. In this study, a three-dimensional point cloud map of a forest area was generated by using the Velodyne VLP-16 LiDAR system, so as to extract the diameter at breast height (DBH) of individual trees. The Velodyne VLP-16 LiDAR system and inertial measurement units (IMU) were used to construct a mobile measurement platform for generating 3D point cloud maps for forest areas. The 3D point cloud map in the forest area was processed offline, and the ground point cloud was removed by the random sample consensus (RANSAC) algorithm. The trees in the experimental area were segmented by the European clustering algorithm, and the DBH component of the tree point cloud was extracted and projected onto a 2D plane, fitting the DBH of the trees using the RANSAC algorithm in the plane. A three-dimensional point cloud map of 71 trees was generated in the experimental area, and estimated the DBH. The mean and variance of the absolute error were 0.43 cm and 0.50, respectively. The relative error of the whole was 2.27%, the corresponding variance was 15.09, and the root mean square error (RMSE) was 0.70 cm. The experimental results were good and met the requirements of forestry mapping, and the application value and significance were presented.
| S-EPMC6679591 | biostudies-literature
Project description:The developmental variation in stem height with respect to stem diameter is related to a broad range of ecological and evolutionary phenomena in trees, but the underlying genetic basis of this variation remains elusive. We implement a dynamic statistical model, functional mapping, to formulate a general procedure for the computational identification of quantitative trait loci (QTLs) that control stem height-diameter allometry during development. Functional mapping integrates the biological principles underlying trait formation and development into the association analysis of DNA genotype and endpoint phenotype, thus providing an incentive for understanding the mechanistic interplay between genes and development. Built on the basic tenet of functional mapping, we explore two core ecological scenarios of how stem height and stem diameter covary in response to environmental stimuli: (i) trees pioneer sunlit space by allocating more growth to stem height than diameter and (ii) trees maintain their competitive advantage through an inverse pattern. The model is equipped to characterize 'pioneering' QTLs (piQTLs) and 'maintaining' QTLs (miQTLs) which modulate these two ecological scenarios, respectively. In a practical application to a mapping population of full-sib hybrids derived from two Populus species, the model has well proven its versatility by identifying several piQTLs that promote height growth at a cost of diameter growth and several miQTLs that benefit radial growth at a cost of height growth. Judicious application of functional mapping may lead to improved strategies for studying the genetic control of the formation mechanisms underlying trade-offs among quantities of assimilates allocated to different growth parts.
| S-EPMC5103235 | biostudies-literature
Project description:Height measurements are essential to manage and monitor forest biomass and carbon stocks. However, accurate estimation of this variable in tropical ecosystems is still difficult due to species heterogeneity and environmental variability. In this article, we compare and discuss six nonlinear allometric models parameterized at different scales (local, regional and pantropical). We also evaluate the height measurements obtained in the field by the hypsometer when compared with the true tree height. We used a dataset composed of 180 harvested trees in two distinct areas located in the Amapá State. The functional form of the Weibull model was the best local model, showing similar performance to the pantropical model. The inaccuracy detected in the hypsometer estimates reinforces the importance of incorporating new technologies in measuring individual tree heights. Establishing accurate allometric models requires knowledge of ecophysiological and environmental processes that govern vegetation dynamics and tree height growth. It is essential to investigate the influence of different species and ecological gradients on the diameter/height ratio.
| S-EPMC8675728 | biostudies-literature
Project description:Stem diameter at breast height (DBH) and tree height (H) are commonly used measures of tree growth. We examined patterns of height growth and diameter growth along a stem using a 20-year record of an even-aged hinoki cypress (Chamaecyparis obtusa (Siebold & Zucc.) Endl.) stand. In the region of the stem below the crown (except for the butt swell), diameter growth rates (ΔD) at different heights tended to increase slightly from breast height upwards. This increasing trend was pronounced in suppressed trees, but not as much as the variation in ΔD among individual trees. Hence, ΔD below the crown can be regarded as generally being represented by the DBH growth rate (ΔDBH) of a tree. Accordingly, the growth rate of the stem cross-sectional area increased along the stem upwards in suppressed trees, but decreased in dominant trees. The stem diameter just below the crown base (D(CB)), the square of which is an index of the amount of leaves on a tree, was an important factor affecting ΔDBH. D(CB) also had a strong positive relationship with crown length. Hence, long-term changes in the D(CB) of a tree were associated with long-term changes in crown length, determined by the balance between the height growth rate (ΔH) and the rising rate of the crown base (ΔH(CB)). Within the crown, ΔD's were generally greater than the rates below the crown. Even dying trees (ΔD ≈ 0 below the crown) maintained ΔD > 0 within the crown and ΔH > 0 until about 5 years before death. This growth within the crown may be related to the need to produce new leaves to compensate for leaves lost owing to the longevity of the lower crown. These results explain the different time trajectories in DBH-H relationships among individual trees, and also the long-term changes in the DBH-H relationships. The view that a rise in the crown base is strongly related to leaf turnover helps to interpret DBH-H relationships.
| S-EPMC3556985 | biostudies-literature
Project description:Background: Previous studies link tall stature with a reduced ischemic stroke risk. One theory posits that tall people have larger cerebral artery lumens and therefore have a lower plaque occlusion risk than those who are short. Previous studies have not critically evaluated the associations between height and cerebral artery structure independent of confounding factors. Methods: The hypothesis linking stature with cerebral artery lumen size was tested in 231 adults by measuring the associations between height and common carotid artery diameter (CCAD) and intima-media thickness (IMT) after controlling for recognized vascular influencing factors (e.g., adiposity, blood pressure, plasma lipids, etc.). Results: Height remained a significant CCAD predictor across all developed multiple regression models. These models predict a ~0.03 mm increase in CCAD for each 1-cm increase in height in this sample. This magnitude of CCAD increase with height represents over a 60% enlargement of the artery's lumen area across adults varying in stature from short (150 cm) to tall (200 cm). By contrast, IMT was non-significantly correlated with height across all developed regression models. Conclusions: People who are tall have a larger absolute CCAD than people who are short, while IMT is independent of stature. These observations potentially add to the growing cardiovascular literature aimed at explaining the lower risk of ischemic strokes in tall people.
| S-EPMC6631842 | biostudies-other
Project description:Background and purposeTreatment planning of radiotherapy is a time-consuming and planner dependent process that can be automated by dose prediction models. The purpose of this study was to evaluate the performance of two machine learning models for breast cancer radiotherapy before possible clinical implementation.Materials and methodsAn in-house developed model, based on U-net architecture, and a contextual atlas regression forest (cARF) model integrated in the treatment planning software were trained. Obtained dose distributions were mimicked to create clinically deliverable plans. For training and validation, 90 patients were used, 15 patients were used for testing. Treatment plans were scored on predefined evaluation criteria and percent errors with respect to clinical dose were calculated for doses to planning target volume (PTV) and organs at risk (OARs).ResultsThe U-net plans before mimicking met all criteria for all patients, both models failed one evaluation criterion in three patients after mimicking. No significant differences (p < 0.05) were found between clinical and predicted U-net plans before mimicking. Doses to OARs in plans of both models differed significantly from clinical plans, but no clinically relevant differences were found. After mimicking, both models had a mean percent error within 1.5% for the average dose to PTV and OARs. The mean errors for maximum doses were higher, within 6.6%.ConclusionsDifferences between predicted doses to OARs of the models were small when compared to clinical plans, and not found to be clinically relevant. Both models show potential in automated treatment planning for breast cancer.
| S-EPMC8058017 | biostudies-literature
Project description:Genome-wide association studies (GWAS) have proven highly successful in identifying single nucleotide polymorphisms (SNPs) associated with breast cancer (BC) risk. The majority of these studies are on European populations, with limited SNP association data in other populations. We genotyped 51 GWAS-identified SNPs in two independent cohorts of Singaporean Chinese. Cohort 1 comprised 1294 BC cases and 885 controls and was used to determine odds ratios (ORs); Cohort 2 had 301 BC cases and 243 controls for deriving polygenic risk scores (PRS). After age-adjustment, 11 SNPs were found to be significantly associated with BC risk. Five SNPs were present in <1% of Cohort 1 and were excluded from further PRS analysis. To assess the cumulative effect of the remaining 46 SNPs on BC risk, we generated three PRS models: Model-1 included 46 SNPs; Model-2 included 11 statistically significant SNPs; and Model-3 included the SNPs in Model-2 but excluded SNPs that were in strong linkage disequilibrium with the others. Across Models-1, -2 and -3, women in the highest PRS quartile had the greatest ORs of 1.894 (95% CI = 1.157-3.100), 2.013 (95% CI = 1.227-3.302) and 1.751 (95% CI = 1.073-2.856) respectively, suggesting a direct correlation between PRS and BC risk. Given the potential of PRS in BC risk stratification, our findings suggest the need to tailor the selection of SNPs to be included in an ethnic-specific PRS model.
| S-EPMC5849174 | biostudies-literature
Project description:Forest inventories in plantations of non-native trees are conducted every five years in Zambia. Characteristics of data collected through these inventories are presented here. The data includes diameter at breast height (d), total tree height (h) and rotation categories for trees sampled. This data supported the development of robust h-d models for planted Pinus kesiya in the country. We have also presented graphical visualization of the composition and trends of the data by site and rotation. Datasets were filtered and cleaned and are ready to be used for other purposes in order to improve understanding of P. kesiya growth. For more insight please see "Modeling the height-diameter relationship of planted Pinus kesiya in Zambia" (Ng'andwe et al., 2019).
| S-EPMC6702408 | biostudies-literature