Dataset Information

Lateral movement of the saddle relative to the equine spine in rising and sitting trot on a treadmill.

ABSTRACT: Saddle slip, defined as a progressive lateral displacement of the saddle during ridden exercise, has recently been given attention in the scientific press as a potential sign of lameness. The aim of this study was to objectively quantify the normal lateral movement (oscillations) of the saddle relative to the horse in non-lame horses, and associate this movement to the movements of the horse and rider. Data from seven Warmblood dressage horses competing at Grand Prix (n = 6) or FEI Intermediate (n = 1) level, ridden by their usual riders, were used. Simultaneous kinetic, kinematic and saddle pressure measurements were conducted during sitting and rising trot on a force-measuring treadmill. The maximum lateral movement of the caudal part of the saddle relative to the horse's spine (MAX) was determined for each diagonal step. A mixed model was applied, with MAX as outcome, and T6 and S3 vertical position, rigid body rotation angles (roll, pitch, yaw) of the horse's and rider's pelvis, vertical ground reaction forces, saddle force, and rider position (rising in rising trot, sitting in rising trot or sitting in sitting trot) as explanatory variables. The least square means for MAX were 14.3 (SE 4.7) mm and 23.9 (SE 4.7) mm for rising and sitting in rising trot, and 20.3 (SE 4.7) mm for sitting trot. A 10 mm increase in maximum pelvic height at push off increased MAX by 1.4 mm (p<0.0001). One degree increase in rider pelvis roll decreased MAX 1.1 mm, and one degree increase in rider pelvis yaw increased MAX 0.7 mm (both p<0.0001). The linear relationships found between MAX and movements of both horse and rider implies that both horse and rider movement asymmetries are reflected in the lateral movements or oscillations of the saddle in non-lame horses.

SUBMITTER: Bystrom A

PROVIDER: S-EPMC6051618 | biostudies-other | 2018

REPOSITORIES: biostudies-other

ACCESS DATA

Publications

Lateral movement of the saddle relative to the equine spine in rising and sitting trot on a treadmill.

Byström A A Roepstorff L L Rhodin M M Serra Bragança F F Engell M T MT Hernlund E E Persson-Sjödin E E van Weeren R R Weishaupt M A MA Egenvall A A

PloS one 20180718 7

Saddle slip, defined as a progressive lateral displacement of the saddle during ridden exercise, has recently been given attention in the scientific press as a potential sign of lameness. The aim of this study was to objectively quantify the normal lateral movement (oscillations) of the saddle relative to the horse in non-lame horses, and associate this movement to the movements of the horse and rider. Data from seven Warmblood dressage horses competing at Grand Prix (n = 6) or FEI Intermediate ...[more]

PMID: 30020982

Similar Datasets

Project description:Adults with spinal deformity (ASD) are known to have spinal malalignment affecting their quality of life and daily life activities. While walking kinematics were shown to be altered in ASD, other functional activities are yet to be evaluated such as sitting and standing, which are essential for patients' autonomy and quality of life perception. In this cross-sectional study, 93 ASD subjects (50 ± 20 years; 71 F) age and sex matched to 31 controls (45 ± 15 years; 18 F) underwent biplanar radiographic imaging with subsequent calculation of standing radiographic spinopelvic parameters. All subjects filled HRQOL questionnaires such as SF36 and ODI. ASD were further divided into 34 ASD-sag (with PT > 25° and/or SVA >5 cm and/or PI-LL >10°), 32 ASD-hyperTK (with only TK >60°), and 27 ASD-front (with only frontal malalignment: Cobb >20°). All subjects underwent 3D motion analysis during the sit-to-stand and stand-to-sit movements. The range of motion (ROM) and mean values of pelvis, lower limbs, thorax, head, and spinal segments were calculated on the kinematic waveforms. Kinematics were compared between groups and correlations to radiographic and HRQOL scores were computed. During sit-to-stand and stand-to-sit movements, ASD-sag had decreased pelvic anteversion (12.2 vs 15.2°), hip flexion (53.0 vs 62.2°), sagittal mobility in knees (87.1 vs 93.9°), and lumbar mobility (L1L3-L3L5: -9.1 vs -6.8°, all p < 0.05) compared with controls. ASD-hyperTK showed increased dynamic lordosis (L1L3-L3L5: -9.1 vs -6.8°), segmental thoracic kyphosis (T2T10-T10L1: 32.0 vs 17.2°, C7T2-T2T10: 30.4 vs 17.7°), and thoracolumbar extension (T10L1-L1L3: -12.4 vs -5.5°, all p < 0.05) compared with controls. They also had increased mobility at the thoracolumbar and upper-thoracic spine. Both ASD-sag and ASD-hyperTK maintained a flexed trunk, an extended head along with an increased trunk and head sagittal ROM. Kinematic alterations were correlated to radiographic parameters and HRQOL scores. Even after controlling for demographic factors, dynamic trunk flexion was determined by TK and PI-LL mismatch (adj. R 2 = 0.44). Lumbar sagittal ROM was determined by PI-LL mismatch (adj. R 2 = 0.13). In conclusion, the type of spinal deformity in ASD seems to determine the strategy used for sitting and standing. Future studies should evaluate whether surgical correction of the deformity could restore sitting and standing kinematics and ultimately improve quality of life.

Project description:Introduction The cervical spine is a highly mobile segment of the spinal column, liable to a variety of diseases and susceptible to trauma. It is a complex region where many vital structures lie in close proximity. Lateral mass screw fixation has become the method of choice in stabilizing subaxial cervical spine among other posterior cervical fixation techniques whenever the posterior elements are absent or compromised. Objective This study examined cervical specimens of cadavers and cervical computed tomography (CT) scans to minimize as much as possible complications of cervical lateral mass screw placement such as vertebral artery or nerve root injuries, facet joint violations, or inadequate placement. Methods Forty normal cervical CT scans, obtained from the emergency unit as part of the trauma workup, were included in this study plus 10 cervical cadaveric specimens obtained from the Alexandria Neuro-anatomy laboratory. There were three fixed parameters for screw insertion in this study. First, the point of screw insertion was the midpoint of the lateral mass; it was the crossing point between the sagittal and axial planes of the posterior cortex of the lateral mass. Second, the direction of the screw in the craniocaudal plane was 30 degrees cranially to avoid facet joint penetration. Third, the exit point of the screw was located on the ventral cortex of the lateral mass just lateral to the root of the transverse process in the midaxial cut of each lateral mass, to make a sound bicortical fixation without injuring the vertebral artery or the nerve root. The selected screw trajectory in this study was the line drawn between the inlet and exit points. The depth and width of the lateral mass of the cervical vertebrae from C3 to C7 were measured as well as the angle of screw trajectory from the sagittal plane. All these measures were applied on the cadaveric specimens to make sure that no injury to the vertebral artery, nerve root, or facet joint occurred. Results As regards the collected measurements of the lateral mass of all subaxial cervical vertebrae, the study revealed that the average depth of the lateral mass was 12.83 ± 1.28 mm. The average width of the lateral mass was 11.92 ± 0.96 mm. The average divergent angle of bicortical screw insertion without injury to the vertebral artery or the nerve root was 19.51 ± 1.83 degrees. As regard the cadaveric specimens, based on all the collected measurements taken from the CT scans, there was no reported injury to the vertebral arteries or nerve roots or penetration to the facet joints. Conclusion Lateral mass fixation can be applied easily and safely for all levels of subaxial cervical spine from C3 to C6 with the following parameters: (1) the point of entry is the midpoint of the lateral mass; (2) the screw trajectory is directed 30 degrees cranially and 20 degrees laterally; (3) the screw length is 13 to 15 mm.

Dataset Information

Lateral movement of the saddle relative to the equine spine in rising and sitting trot on a treadmill.

Publications

Lateral movement of the saddle relative to the equine spine in rising and sitting trot on a treadmill.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets