Dataset Information

Optimisation of curvilinear external shading of windows in cellular offices.

ABSTRACT: Shading of windows influences building cooling and heating loads through control of solar heat gains, and lighting load through access to available daylight. Shading shape thus presents an important factor both in building energy analysis and building aesthetics. Curvilinearity of solar paths suggests that the optimal shading shape may be curvilinear as well, and our aim here is to test this expectation. To accommodate curvilinearity of shading shape, outer edges of shading, which consists of overhang, western and eastern fins, are modeled as non-uniform rational basis spline (NURBS) curves, a widely accepted representation standard for curves in design industry. As a case study, a cellular office is considered in the Pacific Northwest National Laboratory (PNNL) office building model, with its overhang lined up by seven control points, and the fins lined up by five control points each, with two ending control points joint for the overhang and the fins. With control points allowed to take on nine different alternative depths, genetic optimisation is employed for 16 representative USA climates with respect to total equivalent source energy for heating, cooling and lighting loads. The main finding is that in a very close proximity to optimal shadings found by genetic optimisation there exist shadings with much simpler control point structure, obtained by identifying depths of successive control points, that have nearly rectangular overhangs. Since the difference between these simpler shadings and the optimal ones is less than 0.24%, this partially rejects the expectation that the optimal shading shape should be curvilinear. Structure of these near-optimal shadings also suggests a new way to partition shadings into independent regions: the lower and the upper parts of the western fin, joints of the overhang with the western and the eastern fin, the interior part of the overhang and the rest of the eastern fin.

SUBMITTER: Stevanovic S

PROVIDER: S-EPMC6128593 | biostudies-other | 2018

REPOSITORIES: biostudies-other

ACCESS DATA

Publications

Optimisation of curvilinear external shading of windows in cellular offices.

Stevanović Sanja S Stevanović Dragan D

PloS one 20180907 9

Shading of windows influences building cooling and heating loads through control of solar heat gains, and lighting load through access to available daylight. Shading shape thus presents an important factor both in building energy analysis and building aesthetics. Curvilinearity of solar paths suggests that the optimal shading shape may be curvilinear as well, and our aim here is to test this expectation. To accommodate curvilinearity of shading shape, outer edges of shading, which consists of ov ...[more]

PMID: 30192845

Similar Datasets

Project description:We studied previously optimal shape of external shading of windows in a cellular office with an outer edge modeled by a non-uniform rational basis spline (NURBS) curve whose control points were placed uniformly around western fin, overhang and eastern fin of the window, and whose depths were allowed to vary independently. We observed there that for each climate considered in the study there exists a shading shape close to the optimal one, but with a substantially simpler structure of control points for the NURBS curve. This simpler structure was reflected in partitioning control points into six groups such that all control points in the same group have equal depths, with groups corresponding to lower part of the western fin, upper part of the western fin, joint of the western fin and the overhang, internal part of the overhang, joint of the overhang and the eastern fin and the remaining part of the eastern fin. Here we confirm that shadings with control point structure restricted in such way can perform as well as shadings with unrestricted control points by optimising shape of external shading of windows in an apartment room for both restricted and unrestricted control point structure for the same range of climates, and showing that differences in heating and cooling demands between Pareto optimal shadings in both cases are negligibly small. This grouping of control points thus gives a simple and natural division of shading into a small number of basic constituents that have most impact on its heating and cooling demands. We further consider the convex hull of the Pareto front for shadings with restricted control points, as it contains shadings that minimise equivalent source energy in terms of the ratio of efficiencies and source energy conversion factors for district heating and cooling. We show that, in cases when depths of control point groups in convex hull shadings do not experience sudden changes between their extremal values, these depths can be fitted reasonably well by a sigmoid function that results in functional shadings that satisfactorily approximate heating and cooling demands of shadings in the Pareto front.

Project description:Window collisions are one of the largest human-caused causes of avian mortality in built environments and, therefore, cause population declines that can be a significant conservation issue. Applications of visibly noticeable films, patterns, and decals on the external surfaces of windows have been associated with reductions in both window collisions and avian mortality. It is often logistically difficult and economically prohibitive to apply these films and decals to external surfaces, especially if the windows are above the first floor of a building. Therefore, there is interest and incentive to apply the products to internal surfaces that are much easier to reach and maintain. However, there is debate as to whether application to the internal surface of windows renders any collision-reduction benefit, as the patterns on the films and decals may not be sufficiently visible to birds. To address this knowledge gap, we performed the first experimental study to compare the effectiveness of two distinct window films when applied to either the internal or external surface of double-glazed windows. Specifically, we assessed whether Haverkamp and BirdShades window film products were effective in promoting the avoidance of window collisions (and by inference, a reduction of collisions) by zebra finches through controlled aviary flight trials employing a repeated-measures design that allowed us to isolate the effect of the window treatments on avoidance flight behaviors. We chose these two products because they engage with different wavelengths of light (and by inference, colors) visible to many songbirds: the BirdShades film is visible in the ultraviolet (shorter wavelength) range, while the Haverkamp film includes signals in the orange (longer wavelength) range. We found consistent evidence that, when applied to the external surface of windows, the BirdShades product resulted in reduced likelihood of collision and there was marginal evidence of this effect with the Haverkamp film. Specifically, in our collision avoidance trials, BirdShades increased window avoidance by 47% and the Haverkamp increased avoidance by 39%. However, neither product was effective when the films were applied to the internal surface of windows. Hence, it is imperative that installers apply these products to exterior surfaces of windows to render their protective benefits and reduce the risk of daytime window collision.

Project description:Brominated flame retardants (BFRs) are now ubiquitous contaminants with large reservoirs and high concentrations in buildings. Most of the information documenting BFR levels has been obtained in residences, and other environments that can lead to exposure have received relatively little attention, including offices that contain numerous BFR sources and where individuals spend considerable time. The aim of this study is to characterize BFR concentrations, potential emission sources, and migration pathways in office environments. We measure BFR levels in floor dust, indoor air, ventilation filter dust, and carpets in ten commercial and institutional buildings in Michigan, U.S.A. The median concentration of total BDEs in settled dust was 8754 ng g(-1), at the upper range of levels previously reported. Especially elevated levels were found in offices in buildings that contained known or likely BFR sources, e.g., computer servers. A trends analysis in a newly constructed building showed remarkable increases in concentrations of BFRs in settled dust and indoor air, and apparent steady-state levels were reached 5 to 8 months after building completion, a particularly striking finding given that the building was constructed and furnished several years after the voluntary phase-out of the penta- and octa-mixtures. Airborne particulate matter collected in a building's HVAC system filters contained PBDEs, including BDE-209, at levels exceeding the concentration of floor dust. In conjunction with estimates of building air flow rates, filter efficiency and other parameters, mass balance calculations for this building were used to estimate the emission rates and reservoirs of PBDEs. The widespread distribution of BFRs found in offices in both new and old buildings suggests the significance of workplace exposures, the need for controls to minimize human exposure, intra-building migration, and environmental releases of these chemicals, and the need for monitoring in new buildings to confirm the effectiveness of the PBDE phase-out.

Dataset Information

Optimisation of curvilinear external shading of windows in cellular offices.

Publications

Optimisation of curvilinear external shading of windows in cellular offices.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets