Project description:Using standard morphometric methods and gene expression profiling with a DNA microarray, we explored the impacts of high CO2 conditions on development of the sea urchin, Lytechinus pictus, a pelagic larvae that forms a calcium carbonate endoskeleton. Larvae were raised from fertilization to pluteus stage in seawater with elevated CO2 conditions based upon IPCC emissions scenarios B1 (540ppm CO2) and A1FI (970ppm CO2). Larval L. pictus were cultured in seawater treated with three different concentrations of CO2. We aerated water in culture chambers with air that had been mixed to different CO2 concentrations chosen from IPCC predictions of future atmospheric CO2 levels (28). The B1 scenario, one of the most optimistic, predicts a stabilization of atmospheric CO2 levels at ~540 ppm by 2100, and the A1F1 scenario, which, reflecting a more âbusiness as usualâ scenario, predicts atmospheric CO2 levels of ~970 ppm by 2100. Compressed air (~380 ppm CO2) was used as a control condition. The culture chambers were 20 L buckets medified to allow aeration bubbles of the experimental gas to mix with and gently stir the culture water without contacting the larvae. Replacement seawater (0.35 Î¼m filtered) was added at a constant rate of 0.5 L hr-1. Water pH of each chamber was monitored daily using a Radiometer Analytical PHM240 pH meter. Adult L. pictus were maintained in flowing seawater at ambient temperature (~15-18 ÂºC) and fed kelp until use. Spawning was induced by coelomic injection of 0.5 M KCl, and eggs were collected in 0.35 Î¼m-filtered seawater. Eggs from 5 females were combined in approximately equal concentrations. Sperm from a single male was collected in the same way, diluted with filtered seawater and added to the egg mixture; thus, all the larvae are half-siblings. Immediately following fertilization, embryos were split into 12 culture chambers providing four replicates of the three CO2 treatments. At the 48 hour time point, a sample of 40,000 larvae was removed from each of the 8 cultures in the 380 and 970 ppm treatments and stored in1 mL Trizol at -80 ÂºC for later RNA analysis. The larval cDNA samples from each treatment were competitively hybridized on each microarray following a balanced incomplete block design (BIBD) with respect to the assignment of treatments to arrays. In this way, differential expression between all pairs of treatments is estimated with equal precision. Although dye swaps of technical replicates were not used, treatment and dye effects are orthogonal to one another, i.e. treatment effects can be estimated independently of dye effects.

Project description:The within-tree variation in wood properties constitutes an exceptional model to study the mechanisms that adjust the different biosynthetic pathways providing substrates with the massive and variable demands of different biosynthetic reactions of cell wall polymers. Although a few genes have been reported as differentially expressed in differentiating compression wood compared to normal or opposite wood, the expression of a larger set of genes is expected to change due the broad range of features that distinguish this reaction wood. By combining the construction of different cDNA libraries with microarray analyses, using samples from different Pinus pinaster provenances collected in different years and geographic locations, we have identified a total of 496 genes that change their expression during differentiation of compression wood (331 up-regulated and 165 down-regulated compared to opposite wood). Consistent with the well-known structural and chemical characteristics of compression wood, a large number of genes involved in the biosynthesis of cell wall components were shown to be up-regulated during compression wood differentiation, including genes involved in synthesis of cellulose, hemicellulose, lignin and lignans. In particular, further analysis of a set of these genes involved in providing S-adenosylmethionine, ammonium recycling, lignin and lignans biosynthesis showed parallel expression profiles to levels of lignin accumulation in cells undergoing xylogenesis in vivo and in vitro. The comparative transcriptomic analysis of compression and opposite wood formation in this work have revealed a broad spectrum of coordinated transcriptional modulation of biosynthetic reactions for different cell wall polymers associated to within-tree variations in softwood structure and composition. In particular, it suggest the occurrence of a mechanism that modulates at transcriptional level genes encoding enzymes involved in S-adenosylmethionine synthesis and ammonium assimilation with coniferyl alcohol demand for lignin and lignan synthesis, as a key metabolic requirement in cells undergoing lignification. Two-condition experiment including dye-swap experiments, Compression Differentiating Xylem vs. Opposite Differentiating Xylem. Biological replicates: 4 compression xylem, 4 opposite xylew, harvested from four different individual pine trees. Two replicates per array.

Dataset Information

Exposure of Eucalyptus grandis and E. globulus to varied temperature and elevated CO2 concentration alone or in combination have profound effect in the expression of genes controlling cell wall formation and remodeling

Dataset's files

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets