Dataset Information

TrxB1 overexpression response to hydrogen peroxide stress in Lactobacillus plantarum WCFS1

ABSTRACT: Two independent chemostat cultivations were performed for both wild type and trxB1 over-expression strain, NZ7602. Three hybridization experiments, all with the same hybridization scheme (see overall design), were performed with samples obtained from these chemostats before and after treatment with hydrogen peroxide (30 minutes 2.5 mM peroxide). Two of these experiments used samples obtained from the same fermentation. In each experiment three arrays were used. Per array two cDNA labeled targets were hybridized on custom designed L. plantarum WCFS1 11K Agilent oligo microarrays (GEO Acc. Nr. GPL4318) using the Agilent 60-mer oligo microarray processing protocol version 4.1. These microarrays contained an average of 3 probes per gene. Dried slides were scanned in the Scan Array Express (PerkinElmer Life Sciences; Packard Bioscience) at 10 microns. Spot intensity data was quantified (average intensity) in ImaGene version 5.0 (BioDiscovery, Inc., El Segundo, CA). Signal intensities of all probes were corrected against background and normalized by fitting a plot of M (= 2log [cy5 intensity/cy3 intensity]) against A (= 0.5 • 2log [cy5 intensity • cy3 intensity]) using the lowess algorithm in BASE [32]. The fold change (FC) is defined as 2M. For the statistical analysis we used microarray analysis of variation (R/maanova) [33] In this maanova test we used three variables: fermentation, treatment, and genotype. We tested the model taking into consideration the interaction between genotype and treatment. Significantly regulated genes were defined as genes whose nominal adjusted pvalues were less than 10% and a FC>1.5. The maanova test resulted only in two sets of interesting data because the interaction effect did not reveal significant changes in transcript levels. One dataset representing the transcripts affected as a result of the overproduction of TR and another set representing the transcripts affected due to oxidative stress. These two datasets were denominated genotype and hydrogen peroxide datasets respectively. Keywords: hydrogen peroxide stress response

ORGANISM(S): Lactiplantibacillus plantarum WCFS1

PROVIDER: GSE8348 | GEO | 2007/07/12

SECONDARY ACCESSION(S): PRJNA101359

REPOSITORIES: GEO

ACCESS DATA

Dataset's files

Source:

			Action	DRS
		Other

Items per page:

1 - 1 of 1

Similar Datasets

Project description:To identify Six1 target genes, we chose the mK4 cell line that represents later metanephric mesenchyme of the embryonic kidney. The cells were infected with adenovirus vectors (AxCAwt) overexpressing VP16-Six1wt or VP16-Six1W171R and cultured for 24h. Total RNA was extracted using Isogen reagent (Nippon Gene), treated with RNase-free DNase (Roche Diagnostics) and purified with RNeasy Midi Kit (QIAGEN). Poly A+ RNA was selected using Oligotex-dT30 latex beads (TaKaRa). Poly A+ RNA (20 µg) was reverse transcribed using an oligo(dT) primer in the presence of aminoallyl dUTP without the addition of spike-in controls. Then, single-stranded cDNAs were coupled with Cy3 (AxCAwt VP16-Six1wt infected sample) or Cy5 (AxCAwt VP16-Six1W171R infected sample) dyes, and the labeled probes were purified with QIAquick PCR Purification kit (QIAGEN). Hybridization to the microarray was carried out at 65°C for 17h according to the manufacturer's instruction. The arrays were washed, dried and scanned using ScanArray 5000 (GSI Lumonics) at two different PMT voltage settings (high and low) to avoid signal saturation. Cy3 and Cy5 intensities for each spot on the array were determined by QuantArray software (Version 3.0.0.0, GSI Lumonics). The raw data thus obtained was processed and the Cy3 to Cy5 ratios were calculated as follows: 1) subtraction of the fluorescence intensity of negative control spots as background from the intensity of each of the Cy3 and Cy5 spots, 2) normalization of the entire data set using the global normalization method, 3) elimination of spots with high background intensity for either dye, and 4) determination of the Cy3 to Cy5 ratios. To identify Six4 target genes, we chose the mK4 cell line that represents later metanephric mesenchyme of the embryonic kidney. The cells were infected with adenovirus vectors (AxCAwt) overexpressing VP16-Six4wt or VP16-Six4W263R and cultured for 24h. Total RNA was extracted using Isogen reagent (Nippon Gene), treated with RNase-free DNase (Roche Diagnostics) and purified with RNeasy Midi Kit (QIAGEN). Poly A+ RNA was selected using Oligotex-dT30 latex beads (TaKaRa). Poly A+ RNA (20 µg) was reverse transcribed using an oligo(dT) primer in the presence of aminoallyl dUTP without the addition of spike-in controls. Then, single-stranded cDNAs were coupled with Cy3 (AxCAwt VP16-Six4wt infected sample) or Cy5 (AxCAwt VP16-Six4W263R infected sample) dyes, and the labeled probes were purified with QIAquick PCR Purification kit (QIAGEN). Hybridization to the microarray was carried out at 65°C for 17h according to the manufacturer's instruction. The arrays were washed, dried and scanned using ScanArray 5000 (GSI Lumonics) at two different PMT voltage settings (high and low) to avoid signal saturation. Cy3 and Cy5 intensities for each spot on the array were determined by QuantArray software (Version 3.0.0.0, GSI Lumonics). The raw data thus obtained was processed and the Cy3 to Cy5 ratios were calculated as follows: 1) subtraction of the fluorescence intensity of negative control spots as background from the intensity of each of the Cy3 and Cy5 spots, 2) normalization of the entire data set using the global normalization method, 3) elimination of spots with high background intensity for either dye, and 4) determination of the Cy3 to Cy5 ratios. Keywords: other

Project description:Sample groupings for this project are as follows: Cauline leaf vs Cultured Cell : - Cauline leaf, p1; Exp:Red; Ref: Green (Cy5:Cy3) - Cauline leaf, p2; Exp:Red; Ref: Green (Cy5:Cy3) - Cauline leaf, p3; Exp:Red; Ref: Green (Cy5:Cy3) Cotyledon light vs Cotyledon dark : - Cotyledon, CP1; Exp:Red; Ref: Green (Cy5:Cy3) - Cotyledon, CP2; Exp:Red; Ref: Green (Cy5:Cy3) Cotyledon light vs Cultured cell : - Cotyledon, cn1; Exp:Green; Ref: Red (Cy3:Cy5) - Cotyledon, cn2; Exp:Green; Ref: Red (Cy3:Cy5) Cotyledon dark vs Cultured cell : - Cotyledon dark, n1; Exp:Green; Ref: Red (Cy3:Cy5) - Cotyledon dark, n2; Exp:Green; Ref: Red (Cy3:Cy5) - Cotyledon dark, n3; Exp:Green; Ref: Red (Cy3:Cy5) Germinating seed vs Cultured cell : - Germinating seed, gn1; Exp:Green; Ref: Red (Cy3:Cy5) - Germinating seed, gn2; Exp:Green; Ref: Red (Cy3:Cy5) - Germinating seed, gn3; Exp:Green; Ref: Red (Cy3:Cy5) Hypocotyl light vs Hypocotyl dark : - Hypocotyl, hldn1; Exp:Red; Ref: Green (Cy5:Cy3) - Hypocotyl, hldn2; Exp:Red; Ref: Green (Cy5:Cy3) Hypocotyl light vs Cultured cell : - Hypocotyl light, hln1; Exp:Green; Ref: Red (Cy3:Cy5) - Hypocotyl light, hln2; Exp:Green; Ref: Red (Cy3:Cy5) Petal vs Cultured cell : - Petal, pn1; Exp:Green; Ref: Red (Cy3:Cy5) - Petal, pn2; Exp:Green; Ref: Red (Cy3:Cy5) - Petal, pn3; Exp:Green; Ref: Red (Cy3:Cy5) 1DBP vs Cultured cell : - Pistil 1DBP, pin1; Exp:Green; Ref: Red (Cy3:Cy5) - Pistil 1DBP, pin2; Exp:Green; Ref: Red (Cy3:Cy5) - Pistil 1DBP, pin3; Exp:Green; Ref: Red (Cy3:Cy5) Pistil 1DPP vs Cultured cell : - Pistil 1DPP, psn1; Exp:Green; Ref: Red (Cy3:Cy5) - Pistil 1DPP, psn2; Exp:Green; Ref: Red (Cy3:Cy5) - Pistil 1DPP, psn3; Exp:Green; Ref: Red (Cy3:Cy5) - Pistil 1DPP, psn4; Exp:Green; Ref: Red (Cy3:Cy5) Root dark vs Cultured cell : - Root dark, rdn1; Exp:Green; Ref: Red (Cy3:Cy5) - Root dark, rdn2; Exp:Green; Ref: Red (Cy3:Cy5) Root light vs Cultured cell : - Root light, rln1; Exp:Green; Ref: Red (Cy3:Cy5) - Root light, rlp1; Exp:Red; Ref: Green (Cy5:Cy3) Root light vs Root dark : - Root light vs dark, rldp1; Exp:Red; Ref: Green (Cy5:Cy3) - Root light vs dark, rldp2; Exp:Red; Ref: Green (Cy5:Cy3) Rosette leaf vs Cultured cell : - Rosette leaf, rfp1; Exp:Red; Ref: Green (Cy5:Cy3) - Rosette leaf, rfp2; Exp:Red; Ref: Green (Cy5:Cy3) - Rosette leaf, rfp3; Exp:Red; Ref: Green (Cy5:Cy3) Sepal vs Cultured cell : - Sepal, sn1; Exp:Green; Ref: Red (Cy3:Cy5) - Sepal, sn2; Exp:Green; Ref: Red (Cy3:Cy5) Silique 3DPP vs Cultured cell : - Silique 3DPP, s3n1; Exp:Green; Ref: Red (Cy3:Cy5) - Silique 3DPP, s3n2; Exp:Green; Ref: Red (Cy3:Cy5) - Silique 3DPP, s3n3; Exp:Green; Ref: Red (Cy3:Cy5) Silique 8DPP vs Cultured cell : - Silique 8DPP, s8n1; Exp:Green; Ref: Red (Cy3:Cy5) - Silique 8DPP, s8n2; Exp:Green; Ref: Red (Cy3:Cy5) - Silique 8DPP, s8n3; Exp:Green; Ref: Red (Cy3:Cy5) Stamen vs Cultured cell : - Stamen, smn1; Exp:Green; Ref: Red (Cy3:Cy5) - Stamen, smn2; Exp:Green; Ref: Red (Cy3:Cy5) - Stamen, smn3; Exp:Green; Ref: Red (Cy3:Cy5) Hypocotyl dark vs Cultured cell : - Hypocotyl dark, hn1; Exp:Green; Ref: Red (Cy3:Cy5) - Hypocotyl dark, hn2; Exp:Green; Ref: Red (Cy3:Cy5) Stem vs Cultured cell : - Stem, stp1; Exp:Red; Ref: Green (Cy5:Cy3) - Stem, stp2; Exp:Red; Ref: Green (Cy5:Cy3) - Stem, stp3; Exp:Red; Ref: Green (Cy5:Cy3) Keywords: other

Dataset Information

TrxB1 overexpression response to hydrogen peroxide stress in Lactobacillus plantarum WCFS1

Dataset's files

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets